Which rectifier can convert AC to DC? A. Half wave rectifier B. Full wave rectifier C. Bridge wave rectifier D. All of these 

1 Answer

Answer :

Which rectifier can convert AC to DC? A. Half wave rectifier B. Full wave rectifier C. Bridge wave rectifier D. All of these 

Related questions

Last Answer : NO IT ONLY CONVERT FROM AC TO DC BECAUSE DIODE WHICH ARE USED IN IT, ARE UNIDIRECTIONAL.

Last Answer : IT CHANGES NEGATIVE CYCLE IN TO POSITIVE CYCLE FROM AC CURRENT.

Description : The device which converts AC to DC is (1) Oscillator (2) Amplifier (3) Rectifier (4) None of these

Last Answer : (3) Rectifier Explanation: A rectifier is an electrical device that converts alternating current (AC). which periodically reverses direction, to direct current (DC), which flows in only one ... serving as components of DC power supplies and high-voltage direct current power transmission systems.

Description : A silicon controlled rectifier (SCR) is a solid state device used to change ________________. A. DC to AC and control relatively low load current B. AC to DC and control relatively high load ... to AC and control relatively high load current D. AC to DC and control relatively low load current

Last Answer : Answer: B

Description : The most common source of excitation for synchronous motors is a/an ______________. A. stepup transformer B. half-wave rectifier C. DC supply D. AC supply

Last Answer : Answer: C

Description : List three meter movements that can measure either ac or dc without the use of a rectifier.

Last Answer : Electrodynamic, moving vane, and hot-wire or thermocouple.

Description : The output from a full wave rectifier is (a) A pulsating uni-directional current (b) A DC voltage (c) Zero (d) An AC voltage

Last Answer : a) A pulsating uni-directional current

Description : In a half wave rectifier the rms value of AC component of the waves (a) Zero (b) Equal to DC value (c) More than DC value (d) Less than DC value

Last Answer : b) Equal to DC value

Description : The device which converts AC to DC is (1) Oscillator (2) Amplifier (3) Rectifier (4) None of these

Last Answer : Rectifier

Description : An AC supply of 230 V is applied to half wave rectifier circuit. A transformer turns ratio is 20 : 1. Find i) Output DC voltage (ii) Peak Inverse Voltage (PIV)

Last Answer : Solution:

Last Answer : Igbt alone cant convert dc to ac. igbt half bridge or full bridge or three phase topology could be used to convert dc to ac. also igbt gates should be driven by microcontroller or pwm/spwm gate driving signals ... e4(-) and g4 c2e1 and c4e3 pins are AC output pins. its name is igbt inverter.

Description : A transformer in an electric circuit serves to ____________. A. generate its own electrical power B. transform electrical energy into mechanical energy C. increase or decrease circuit voltage as required D. convert AC current to DC current

Last Answer : Answer: C

Description : The purpose of DC generator brushes is to _____________. A. neutralize armature reaction B. conduct electric current to an outside circuit C. convert DC current to AC current D. provide excitation to a DC generator

Last Answer : Answer: B

Description : An electronic device used to convert AC voltage into DC voltage is called?

Last Answer : Rectifier

Description : Which of the following are the parts of a DC generator that convert the AC in the armature to DC in the external circuit. Are these parts the: w) field poles x) slip rings and the brushes y) commutator and the brushes z) armature and the core

Last Answer : ANSWER: Y -- COMMUTATOR AND THE BRUSHES

Description : How is a thyristor used to convert AC to DC?

Last Answer : thyristor

Description : Can transformer convert AC to DC?

Last Answer : No, Transformer cannot convert AC to DC.

Description : Which device use to convert DC to AC?

Last Answer : Rectifier

Description : What is the name of the device used to convert alternating cur-rent into direct current? (1) Amreter (2) Galvanometer (3) Rectifier (4) Transformer

Last Answer : (3) Rectifier Explanation: A rectifier is an electrical device that converts alternating current (AC), which periodically reverses direction, to direct current (DC), which flows in only one direction. The process is known as rectification.

Description : Which of the listed devices is used to measure pressure and convert it to an electrical signal? A. Transducer B. Reducer C. Transformer D. Rectifier

Last Answer : Answer: A

Description : The use of four diodes, in a full-wave bridge rectifier circuit, will __________. A. provide unidirectional current to the load B. allow a very high leakage current from the load C. convert direct current to alternating current D. offer high opposition to current in two directions

Last Answer : Answer: A

Description : What is the name of the device used to convert alternating current into direct current ? (1) Ammeter (2) Galvanometer (3) Rectifier (4) Transformer

Last Answer : Rectifier

Description : As shown in the illustration, the generator field is excited with DC current provided by ____________. EL-0016 A. conductors '1', '2' and '3' B. inductor 'L1' C. rectifier 'CR1' D. winding 'S-2'

Last Answer : Answer: C

Description : The illustrated device is a _______. EL-0064 A. full wave bridge rectifier B. half wave bridge rectifier C. solid state voltage regulator D. direct current (DC) filter

Last Answer : Answer: A

Description : Which of the following statements represents an application of a silicon controlled rectifier? A. To provide DC power for a main propulsion motor. B. For use as a voltage reference diode. C. For sensing flame in an automated burner. D. To eliminate power supply hum.

Last Answer : Answer: A

Description : In a three phase controlled bridge rectifier with an increase of overlap angles the output dc voltage

Last Answer : In a three phase controlled bridge rectifier with an increase of overlap angles the output dc voltage decreases

Description : A single-phase half-controlled rectifier is driving a separately excited dc motor. The dc motor has a back emf constant of 0.5 V/rpm. The armature current is 5 A without any ripple. The armature resistance is 2 Ohm. The ... of the motor will be  (A) 339 rpm (B) 359 rpm (C) 366 rpm (D) 386 rpm

Last Answer : 359

Description : The ripple voltage in the output of a single phase half wave rectifier with 10 V rectified dc voltage with resistive load and without filter will be • 12.1 volt • 1.21 volt • 0.482 volt • 4.82 volt

Last Answer : The ripple voltage in the output of a single phase half wave rectifier with 10 V rectified dc voltage with resistive load and without filter will be 12.1 volt

Description : The dc current through each diode in a bridge rectifier equals : - a) the load current b) half the dc load current c) twice the dc load current d) one-fourth the dc load current

Last Answer : The dc current through each diode in a bridge rectifier equals : - the load current

Description : One diode of a full-wave rectifier has burned out in a shorted condition. Therefore, the output will be ____________. A. zero B. a rectified half-wave C. a rectified full-wave D. equal to the AC input

Last Answer : Answer: D

Description : A full-wave rectifier has one diode burned out in an open condition, what will be the output characteristic of the device? A. Zero B. Half-wave rectified C. Full-wave rectified D. Equal to the AC input

Last Answer : Answer: B

Description : Basically, a magnetic amplifier is a saturable reactor with the addition of _____________. A. AC to the bias winding B. variable capacitance to all windings C. eddy current protectors D. a rectifier in the load circuit

Last Answer : Answer: D

Description : operation of half wave rectifier type AC Voltmeter.

Last Answer :  Half-wave Rectifier Voltmeter The d'Arsonval meter movement only responds to the average or dc value of the current through the moving coil. In order to measure alternating ... ) input voltage signal alternating signal needs to be rectified first by using diode rectifier to produce 

Description :  An AC supply of 230 V is applied to a half-wave rectifier circuit through a transformer having primary to secondary turn’s ratio 12:1. The peak inverse voltage is A) 8.62 V B) 12 V C) 19.17 V D) 27.11 V 

Last Answer :  An AC supply of 230 V is applied to a half-wave rectifier circuit through a transformer having primary to secondary turn’s ratio 12:1. The peak inverse voltage is A) 8.62 V B) 12 V C) 19.17 V D) 27.11 V 

Last Answer : dc

Description : Why are DC motors used in trains and not AC motors ?

Last Answer : The reason is torque. torque is inversely proportional to speed..i.e when th knowe train comes to rest position to motion.. initial speed is zero..so it requires high starting torque for ... current will flow through field and armature coils then maximum torque is available at the intial condition.

Description : Why is AC considered more efficient than DC?

Last Answer : Ac is more efficient than dc because it is easy to maintain and change the voltage of ac for transmission and distribution purpose. Plant cost of ac transmission is much lower compared to dc transmission. When fault occurs it is easy to interrupt ac supply.

Description : Which is more dangerous AC or DC and why ?

Last Answer : Dc is more dangerous than Ac because in Ac the voltage  will varies but in dc the constant voltage 

Description : Why is AC better for long distance power transmission than DC ?

Last Answer : ac is more economical to transmit for long distances . wires can be made smaller by step up transformer .. since major cost are wires to transmit .. then at the end of distance step down transformer is used for commercial use.

Description : when charging a battery we use a DC supply but not an AC supply. Why ?

Last Answer : When power is supplied to the battery, electrolyte inside the battery is divided into positive and negative ions, where ions with similar pole is gained in one side. This reactionʼs flow coincides with direct current.

Description : Why can't we store AC in batteries instead of DC ?

Last Answer : Because the direction of the current changes in AC electricity, you cannot directly store the power. Placing a capacitor in an AC circuit has no effect on the alternating flow of the electricity. The only ... is indirectly, by storing DC and then using a power inverter to convert the DC to AC.

Description : What would happen if a DC motor was supplied with AC ?

Last Answer : With three phase induction motor, humming and not rotate, but if single phase universal motor like air blower, home mixture, motor run on constant speed..speed variation not possible...

Description : What is the conversion between. AC to AC ? DC to DC? AC to DC? DC to AC ?

Last Answer : 1.ac to ac is regulation 2.dc to dc is chopper 3.ac to dc is rectifier 4.dc to ac is inverter

Description : Why the Led Glow in Dc Supply ? Whenever give the Ac Supply What is Affect in Led ?

Last Answer : LEDs consume DC current to produce light; with AC current the LED will only be lit when current flow is in the proper direction. AC applied to an LED will cause it to blink on and off, and at high frequency the LED will appear to be lit continuously.

Description : Is the power line voltage available in our homes a dc or an ac voltage?

Last Answer : The power line voltage available in our homes is AC. Mobile dwellings are the most commonly DC-supplied homes and even then they tend to include AC supply for heavier loads.

Description : Compare AC & DC track circuits on i) Length of circuit ii) Application iii) Effect of stray currents. iv) Maintenance

Last Answer : Ans: i) Length of circuit - a) AC track circuit is having long length upto 3 to 5 km b) DC track circuit is having short length  ii)Application -a) AC track circuit is used ... ) Maintenance - a) AC track circuit has easier and cheaper maintenance b) DC track circuit has complicated maintenance 

Description : Distinguish between AC and DC.

Last Answer : Particulars Direct Current Alternating Current Definition It is the current whose magnitude and direction do not change with respect to time. It is the current whose ... system, electroplating, Battery charging, Traction. AC machines, Domestic and industrial supply.

Description : In practice, a current source inverter consists of an AC/ DC converter with a large inductance ‘L’ in the output. This inductance maintains a ……… …………through the switching devices over short interval of time. A) constant current B) constant voltage C) constant power D) none of the (A), (B), (C)

Last Answer : In practice, a current source inverter consists of an AC/ DC converter with a large inductance ‘L’ in the output. This inductance maintains a constant current through the switching devices over short interval of time. 

Description : AC supply system compared to DC supply system has the advantage:

Last Answer : AC supply system compared to DC supply system has the advantage: low cost of switching

Description : The main advantage of AC over DC is:  (A) Conversion flexibility from one voltage level to other (B) AC can be easily converted into DC by using a rectifier (C) AC is easy to maintain & can be easily distributed at long distances (D) All of the above

Last Answer : Ac is easy to maintain and ac can be easily converted to dc by rectifier .There is no commutator for conversion in ac that's why ac machines are weight less and more efficiency.ac machines occupy less space than dc .