Description : ……………….. is a high performance fiber optic token ring LAN running at 100 Mbps over distances upto 1000 stations connected. A) FDDI B) FDDT C) FDDR D) FOTR
Last Answer : A) FDDI
Description : .is a high performance fiber optic token ring LAN running at 100 Mbps over distances up to 1000 stations connected. A) FDDI B) FDDT C) FDDR D) FOTR
Description : What medium is used by IBM token ring network that operates at either 4 Mbps or 16 Mbps? A. Twisted pair B. Coaxial cable C. Fiber-optic D. Parallel-wire line
Last Answer : A. Twisted pair
Description : Which of the following is type of LAN? (A) Ethernet (B) Token Ring (C) FDDI (D) All of the above
Last Answer : (D) All of the above
Description : What is the advantage of FDDI over a basic Token Ring?
Last Answer : Fiber distributed Data Interface. A high speed token ring networking technology designed to run over optical fiber. FDDI is able to tolerate a single break in the cable or failure of one station due ... token before it is allowed to transmit. 802.5 and FDDI are examples of token ring networks.
Description : A node X on a 10 Mbps network is regulated by a token bucket. The token bucket is filled at a rate of 2 Mbps. Token bucket is initially filled with 16 megabits. The maximum duration taken by X to transmit at full rate of 10 Mbps is ............ secs. (1) 1 (2) 2 (3) 3 (4) 4
Last Answer : (2) 2
Description : State weather the following statement is true or false for Token Bus 1).It is a linear or tree- shaped cable onto which the stations are attached. 2). the token propagates around the logical ring, with only the token holder ... 3. false C. 1. false, 2. false, 3. false D. 1. true, 2. true, 3. false
Last Answer : D. 1. true, 2. true, 3. false
Description : In a digital transmission, the receiver clock is 0.1 percent faster than the sender clock. How many extra bits per second does the receiver receive if the data rate is 1 Mbps ? (A) 10 bps (B) 100 bps (C) 1000 bps (D) 10000 bps
Last Answer : (C) 1000 bps
Description : A network that needs human beings to manually route signals is called.... A) Fiber Optic Network B) Bus Network C) T-switched network D) Ring network
Last Answer : C) T-switched network
Description : Using fiber-optic cable in a telephone system except for the connection to the subscriber’s phone is called: a. FDDI b. FTTC c. FITL d. SONET
Last Answer : b. FTTC
Description : In FDDI, data normally travel on .................. A) The primary ring B) The Secondary ring C) Both rings D) Neither ring
Last Answer : A) The primary ring
Description : FDDI used which type of physical topology? A) Bus B) Ring C) Star D) Tree
Last Answer : A) Bus
Description : FDDI stands for A) Fiber Distributed Data Interface B) Fiber Data Distributed Interface C) Fiber Dual Distributed Interface D) Fiber Distributed Data Interface
Last Answer : A) Fiber Distributed Data Interface
Description : Suppose there are n stations in a slotted LAN. Each station attempts to transmit with a probability P in each time slot. The probability that only one station transmits in a given slot is .................. (1) nP(1-P)n-1 (2) nP (3) P(1-P)n-1 (4) nP(1-P)n-1
Last Answer : nP(1-P)n-1
Description : What is the range of asynchronous user data rates provided by HIPER-LAN? a) 1-100 Mbps b) 50-100 Mbps c) 1-20 Mbps d) 500 Mbps to 1 Gbps
Last Answer : c) 1-20 Mbps
Description : Typically, repeaters are not required for fiber-optic cable lengths up to: a. 1000 miles b. 100 miles c. 100 km d. 10 km
Last Answer : c. 100 km
Description : ....... was the first step in the evolution of Ethernet from a coaxial cable bus to hub managed, twisted pair network. A) Star LAN B) Ring LAN C) Mesh LAN D) All of the above
Last Answer : A) Star LAN
Description : . The product of the bit rate and distance of a fiber-optic system is 2 Gbits-km/s. What is the maximum rate at 5 km? ∙ A. 100 Mbits/s ∙ B. 200 Mbits/s ∙ C. 400 Mbits/s ∙ D. 1000 Gbits/s
Last Answer : C. 400 Mbits/s
Description : The product of the bit rate and distance of a fiber-optic system is 2 Gbits km/s. What is the maximum rate at 5 km? ∙ a. 100 Mbits/s ∙ b. 200 Mbits/s ∙ c. 400 Mbits/s ∙ d. 1000 Gbits/s
Last Answer : c. 400 Mbits/s
Description : Maximum data transfer rate of the optical fiber is……….? a. 50 kbps b. 1000 kbps c. 1000 Mbps d. None of the these
Last Answer : c. 1000 Mbps
Description : A WAN typically spans a set of countries that have data rates less than ……………. Mbps.A) 2 B) 1 C) 4 D) 100
Last Answer : B) 1
Description : Assume that we need to download text documents at the rate of 100 pages per minute. A page is an average of 24 lines with 80 characters in each line and each character requires 8 bits. Then the required bit rate of the channel is ... ...... (A) 1.636 Kbps (B) 1.636 Mbps (C) 2.272 Mbps (D) 3.272 Kbps
Last Answer : Answer: Marks given to all
Description : ………… is another kind of fiber optic network with an active star for switching. A) S/NET B) SW/NET C) NET/SW D) FS/NE
Last Answer : A) S/NET
Description : .............. is another kind of fiber optic network with active star for switching. A) S/NET B) SW/NET C) NET/SW D) FS/NET
Description : Which one of the following media is multidrop? (A) Shielded Twisted pair cable (B) Unshielded Twisted pair cable (C) Thick Coaxial cable (D) Fiber Optic cable
Last Answer : (C) Thick Coaxial cable
Description : ECE Board Exam March 1996 The standard that specifies a balanced interface cable that will operate bit rates up to 10 Mbps with in a span distances up to 1200 m. A. RS-423A B. RS-422A C. RS-550A D. RS-449A
Last Answer : B. RS-422A
Description : An image is 1024∗800 pixels with 3 bytes/pixel. Assume the image is uncompressed. How long does it take to transmit it over a 10-Mbps Ethernet ? (A) 196.6 seconds (B) 19.66 seconds (C) 1.966 seconds (D) 0.1966 seconds
Last Answer : (C) 1.966 seconds
Description : Determine the maximum length of the cable (in km) for transmitting data at a rate of 500 Mbps in an Ethernet LAN with frames of size 10,000 bits. Assume the signal speed in the cable to be 2,00,000 km/s. b. 2 c. 2.5 d. 5
Last Answer : b. 2
Description : In which OSI layers does the FDDI protocol operate? A) Physical B) Data link C) Network D) A and B
Last Answer : D) A and B
Description : . A network that needs human beings to manually route signals is called.... A) Fiber Optic Network B) Bus Network C) T-switched network D) Ring network
Description : Fiber optic connectors can reduce system performance by increasing what two types of noise?
Last Answer : Modal and reflection.
Description : A fiber-optic cable has a loss of 15 dB/km. The attenuation in a cable 1000 ft. long is ∙ A. 4.57 dB ∙ B. 9.3 dB ∙ C. 24 dB ∙ D. 49.2 dB
Last Answer : A. 4.57 dB
Description : A commonly used fiber-based system for LANs is: a. FDDI b. high-speed Ethernet c. gigabit Ethernet d. all of the above
Last Answer : d. all of the above
Description : There are 10 users plugged into a hub running 10Mbps half-duplex.and a server connected to the switch running 10Mbps half- duplex as well. Find the bandwidth does each host have to the server? a. 100 kbps b. 1 Mbps c. 2 Mbps d. 10 Mbps
Last Answer : d. 10 Mbps
Description : What is the baud rate of the standard 10 Mbps Ethernet ? (A) 10 megabaud (B) 20 megabaud (C) 30 megabaud (D) 40 megabaud
Last Answer : (B) 20 megabaud
Description : What is the bit rate for transmitting uncompressed 800x600 pixel colour frames with 8 bits/pixel at 40 frames/second ? (A) 2.4 Mbps (B) 15.36 Mbps (C) 153.6 Mbps (D) 1536 Mbps
Last Answer : (C) 153.6 Mbps Explanation: The number of bits/sec is just 800x600x40x8 or 153.6 Mbps.
Description : A network with bandwidth of 10 Mbps can pass only an average of 15,000 frames per minute with each frame carrying an average of 8,000 bits. What is the throughput of this network ? (A) 2 Mbps (B) 60 Mbps (C) 120 Mbps (D) 10 Mbps
Last Answer : (A) 2 Mbps Explanation: In data transmission, throughput is the amount of data moved successfully from one place to another in a given period of time, and typically measured in bits per second (bps), ... second (Mbps) or gigabits per second (Gbps). Here, Throughput = 15000 x 8000/60 = 2 Mbps
Description : If link transmits 4000 frames per second and each slot has 8 bits, the transmission rate of circuit of this TDM is ............... (A) 64 Kbps (B) 32 Mbps (C) 32 Kbps (D) 64 Mbps
Last Answer : (C) 32 Kbps
Description : A network with bandwidth of 10 Mbps can pass only an average of 12,000 frames per minute with each frame carrying an average of 10,000 bits. What is the throughput of this network ? (A) 1 Mbps (B) 2 Mbps (C) 10 Mbps (D) 12 Mbps
Last Answer : (B) 2 Mbps
Description : Find out the OSI layer, which performs token management. A) Network Layer B) Transport Layer C) Session Layer D) Presentation Layer
Last Answer : C) Session Layer
Description : Which of the following is not associated with the session layer? (A) Dialog control (B) Token management (C) Semantics of the information transmitted (D) Synchronization
Last Answer : (C) Semantics of the information transmitted
Description : Ho w many times bigger does the bandwidth of a fiber optic multimode have over a cable? A. 50 times bigger B. 100 times bigger C. 10 times bigger D. 5 times bigger
Last Answer : B. 100 times bigger
Description : If all devices are connected to a central hub, then topology is called A) Bus Topology B) Ring Topology C) Star Topology D) Tree Topology
Last Answer : C) Star Topology
Description : FDDI isa A. ring network B. star network C. mesh network D. bus based network E. None of the above
Last Answer : ring network
Last Answer : B) Ring
Description : In FDDI, data normally travel on ..................A) The primary ring B) The Secondary ring C) Both rings D) Neither ring
Description : FDDI stands for: a) Fired Distributed Data Interface b) Fiber Distributed Data Interface c) Forced Distributed Data Interface d) None of These
Last Answer : b) Fiber Distributed Data Interface