In a 741 Op-Amp, there is 20 dB/decade fall-off starting at a relatively low frequency. This is due to the

In a 741 Op-Amp, there is 20 dB/decade fall-off starting at a relatively low frequency. This is due to the

(A) applied load (B) internal compensation

(C) impedance of the source (D) power dissipation in the chip
by

1 Answer

Answer :

In a 741 Op-Amp, there is 20 dB/decade fall-off starting at a relatively low frequency. This is due to the internal compensation

by

Related questions

Describe the concept of virtual ground with reference to op-Amp.

Description : Describe the concept of virtual ground with reference to op-Amp.

Last Answer : Virtual ground concept:-In circuit point A is virtual ground. Figure shows inverting amplifier using op-amp. In this circuit non-inverting terminal is connected to the actual ground. Due to ... zero potential without actually grounding is known as virtual ground concept. Circuit diagram: 

Block Diagram of op-Amp

Description : Block Diagram of op-Amp

Last Answer : Block Diagram: The OP-AMP is basically a different amplifier i.e. it will amplify the voltage which is differentially present between its input terminals.  1.Input stage: The ... normally a complementary output stage. It increases the OPAMP. It also provides a low output resistance. 

Basic Op Amp Circuits

Description : Basic Op Amp Circuits

Last Answer : In this chapter we will be examining some common uses of op amps. Where Chapter Three focused on the theory of negative feedback in a more abstract way, this chapter zeroes in on the practical ... on using op amps with a single polarity power supply and how to increase the available output current.

A 4 GHz carrier is amplitude modulated by a low-pass signal of maximum cut off frequency 1 MHz

Description : A 4 GHz carrier is amplitude modulated by a low-pass signal of maximum cut off frequency 1 MHz. lf this signal is to be ideally sampled, the minimum sampling frequency should be nearly

Last Answer : A 4 GHz carrier is amplitude modulated by a low-pass signal of maximum cut off frequency 1 MHz. lf this signal is to be ideally sampled, the minimum sampling frequency should be nearly 4 Ghz

write short notes on Low-pass filter.

Description : write short notes on Low-pass filter.

Last Answer : low-pass filter (1) filter exhibiting frequency selective characteristic that allows low-frequency components of an input signal to pass from filter input to output unattenuated all high-frequency components are ... the bandwidth of the filter. A filter whose impulse response is a low-pass signal.

Why MOSFET is used for low power applications?

Last Answer : MOSFET have high current losses due to High on state resistance. Hence MOSFET is used for low power applications.

Draw pin diagram of Op-Amp IC-741.

Description : Draw pin diagram of Op-Amp IC-741.

Last Answer : Pin diagram of Op-Amp IC-741 :

What is the frequency range of VHF electromagnetic waves?

Description : What is the frequency range of VHF electromagnetic waves? A) 30-300 kHz B) 30-3000 kHz C) 30-300 MHz D) 30-3000 MHz

Last Answer : What is the frequency range of VHF electromagnetic waves? A) 30-300 kHz B) 30-3000 kHz C) 30-300 MHz D) 30-3000 MHz

An accelerometer has input range of 0 to 10g, natural frequency 30 Hz and mass 0.001 kg. The range of the

Description : An accelerometer has input range of 0 to 10g, natural frequency 30 Hz and mass 0.001 kg. The range of the secondary displacement transducer in mm required to cover the input range is (A) 0 to 2.76 (B) 0 to 9.81 (C) 0 to 11.20 (D) 0 to 52.10

Last Answer : An accelerometer has input range of 0 to 10g, natural frequency 30 Hz and mass 0.001 kg. The range of the secondary displacement transducer in mm required to cover the input range is 0 to 2.76

Can MOSFET operate at very high frequency?

Last Answer : Yes MOSFET can operate at very high frequency.

List different starting methods of three phase synchronous motor. Explain any one of them.

Description : List different starting methods of three phase synchronous motor. Explain any one of them.

Last Answer : Different Starting Methods of Three Phase Synchronous Motor: As synchronous motor is not self starting, different methods of starting are as follows: 1) By using an Induction (Pony) motor 2) ... . The rotor gets pulled into synchronism and starts running at constant speed as a synchronous motor. 

Explain starting system in diesel electric power plant.

Description : Explain starting system in diesel electric power plant.

Last Answer : Starting system in Diesel Electric Power Plant: It includes Storage battery, compressed air tanks, self-starter etc. The purpose of engine starting system is to rotate the engine initially while ... as Ammeters, Voltmeters, Wattmeters, Thermometers, Pressure gauges, Visible and audible alarm etc.

State the functions of following elements: i) Diesel engine system ii) Air intake system iii) Engine exhaust system iv) Engine starting system.

Description : State the functions of following elements: i) Diesel engine system ii) Air intake system iii) Engine exhaust system iv) Engine starting system.

Last Answer : i) Diesel engine system:-  Four strokes Two strokes ii) Air intake system:- Air intake system is provided to supply air to engine cylinder for fuel combustion.  iii) Engine exhaust system ... provided to rotate the engine initially until the firing starts and engine run under its own power. 

In a double squirrel cage induction motor, good starting torque is produced as

Description : In a double squirrel cage induction motor, good starting torque is produced as (A) Large current flows through the outer high resistance winding. (B) Large current flows through the inner high ... the outer high resistance winding. (D) Large current flows through the inner low resistance winding.

Last Answer : In a double squirrel cage induction motor, good starting torque is produced as Large current flows through the outer high resistance winding.

Buses, trains, trolleys, hoists, cranes require high starting torque and therefore make use of?

Last Answer : Buses, trains, trolleys, hoists, cranes require high starting torque and therefore make use of D.C. series motor.

For the same H.P. rating and full load speed, following motor has poor starting torque?

Last Answer : For the same H.P. rating and full load speed, following motor has poor starting torque differentially compounded.

The starting resistance of a D.C. motor is generally?

Last Answer : The starting resistance of a D.C. motor is generally low.

The ratio of starting torque to full-load torque is least in case of?

Last Answer : The ratio of starting torque to full-load torque is least in case of shunt motors.

A direct online starter is used for starting motors?

Last Answer : A direct online starter is used for starting motors up to 5 H.P.

For starting a D.C. motor a starter is required because?

Last Answer : For starting a D.C. motor a starter is required because it limits the starting current to a safe value.

The starting winding of a single-phase motor is placed in?

Last Answer : The starting winding of a single-phase motor is placed in stator.

If starting winding of a single-phase induction motor is left in the circuit, it will?

Last Answer : If starting winding of a single-phase induction motor is left in the circuit, it will draw excessive current and overheat.

Starting winding of a single phase motor of a refrigerator is disconnected from the circuit by means of a?

Last Answer : Starting winding of a single phase motor of a refrigerator is disconnected from the circuit by means of a magnetic relay.

The value of starting capacitor of a fractional horse power motor will be?

Last Answer : The value of starting capacitor of a fractional horse power motor will be 300 uF .

A centrifugal switch is used to disconnect starting winding when motor has?

Last Answer : A centrifugal switch is used to disconnect starting winding when motor has picked up about 50 to 70 per cent of rated speed.

The rotor developed by a single-phase motor at starting is?

Last Answer : The rotor developed by a single-phase motor at starting is zero.

In a capacitor start motor, the phase displacement between starting and running winding can be nearly?

Last Answer : In a capacitor start motor, the phase displacement between starting and running winding can be nearly 90°.

A synchronous motor can be made self starting by providing?

Description : A synchronous motor can be made self starting by providing?

Last Answer : A synchronous motor can be made self-starting by providing damper bar.

How is a three phase cage induction motor self starting?

Description : How is a three phase cage induction motor self starting?

Last Answer : Any type of induction motor is self starting. Because the reason for torqe production require two flux displaced by some angle theta.If theta is constant with time then torqe will be constant;if ... torqe also pulsating. In induction motor this angle theta is not pulsating.so it is self starting 

Is induction motor is self starting?

Description : Is induction motor is self starting?

Last Answer : Single phase induction motor is not self starting. Three phase induction motor is self starting.

Why a dc series motor has a high starting torque?

Description : Why a dc series motor has a high starting torque?

Last Answer : motor

Why does induction motor have high starting current?

Description : Why does induction motor have high starting current?

Last Answer : In induction motor , the flux produce is quadrature to the applied voltage. Since when we are going to start motor , there is no flux present inside . So in order to lets say compensate it ... times of current to further increase flux. So that is reason for high starting current in induction motor

which single phase induction motor has highest starting torque?

Last Answer : Capacitor start motor has high torque in starting

The primary reason for low power factor is supply system is due to installation of?

Last Answer : The primary reason for low power factor is supply system is due to installation of induction motors.

How to Treat Low Blood Sugar ?

Description : How to Treat Low Blood Sugar ?

Last Answer : How to Treat Low Blood Sugar Low blood sugar or hypoglycemia is a condition usually experienced by diabetics but it's also possible to experience it without being a diabetic yourself. For diabetics, low ... identify the cause of the problem and help you get the proper treatment as soon as possible.

Low Fat Barbecue Chicken

Description : Low Fat Barbecue Chicken

Last Answer : Low Fat Barbecue Chicken Dinner 4 lg. chicken breasts, cubed 1 green pepper, cut up 1 onion, cut up 1/2 to 3/4 c. barbecue sauce 1 to 2 bags Minute Rice, boil-in-bags Put chicken with green ... rice in center of plate. Make a nest and put chicken in center of rice. Looks nice and tastes great.

Low-Calorie Dressing

Description : Low-Calorie Dressing

Last Answer : Low-Calorie Dressing - serves 6 salad dressing 1 6-ounce can vegetable or tomato juice 1 tbsp very finely chopped onion 1 tbsp very finely chopped celery 1 tbsp very finely chopped bell pepper ... , oregano, tarragon or herb seasoning for the parsley will give a range of flavored salad dressing.

Name two methods for measurement of low, medium and high resistance. Give one advantage and one limitation of V- I method.

Description : Name two methods for measurement of low, medium and high resistance. Give one advantage and one limitation of V- I method.

Last Answer : Methods for measurement of low resistance:  1. Ammeter voltmeter method  2. Kelvin's bridge method  3. Ohm meter method  4. Potentiometer method  5. Digital/analog multi-meter ... must be infinity for perfectly accurate measurement which is not possible.  2. Connection errors.

Name the method used to measure following resistances:- (i) Low resistance (ii) Medium resistance (iii) Insulation resistance (iv) Earth resistance.

Description : Name the method used to measure following resistances:- (i) Low resistance (ii) Medium resistance (iii) Insulation resistance (iv) Earth resistance.

Last Answer : Following are the methods used to measure resistances:-  (i) Low resistance: 1.Voltmeter-Ammeter Method 2. Kelvin's Double bridge Method  (ii) Medium resistance: 1.Voltmeter-Ammeter Method 2. ... of Charge Method  (iv) Earth resistance : 1. Fall of Potential Method 2. Earth tester

State the range for low and medium resistance.

Description : State the range for low and medium resistance.

Last Answer : Low resistances: less than 1 ohm.  Medium resistances: 1 ohm to 0.1 Mega ohm. 

Step-down transformer converts high voltage and low current into:

Description : Step-down transformer converts high voltage and low current into:  (A) How voltage and high current (B) High voltage and low current (C) Low voltage and high current (D) None of the above

Last Answer : Step-down transformer converts high voltage and low current into: Low voltage and high current

Which of the following is the least expensive protection for over current in low voltage system?

Description : Which of the following is the least expensive protection for over current in low voltage system?  (A) Rewireable fuse (B) Isolator (C) Oil Circuit breaker (D) Air break circuit breaker

Last Answer : Which of the following is the least expensive protection for over current in low voltage system?  (A) Rewireable fuse (B) Isolator (C) Oil Circuit breaker (D) Air break circuit breaker

Accurate measurement of very low resistances is possible with

Description : Accurate measurement of very low resistances is possible with (A) Megger (B) Wheatstone Bridge (C) Kelvin’s Double Bridge (D) Wagner’s Earthing Device

Last Answer : Accurate measurement of very low resistances is possible with Kelvin’s Double Bridge

Turbine used for low head is?

Last Answer : Turbine used for low head is Kaplan turbine.

At very low frequencies a series R-C circuit behaves as almost purely?

Description : At very low frequencies a series R-C circuit behaves as almost purely?

Last Answer : At very low frequencies a series R-C circuit behaves as almost purely capacitive.

In an AC. circuit, a low value of kVAR compared with kW indicates?

Description : In an AC. circuit, a low value of kVAR compared with kW indicates?

Last Answer : In an AC. circuit, a low value of kVAR compared with kW indicates high power factor.

In a low power factor wattmeter the pressure coil is connected?

Last Answer : In a low power factor wattmeter the pressure coil is connected to the load side of the current coil.

A synchronous machine with low value of short-circuit ratio has?

Last Answer : A synchronous machine with low value of short-circuit ratio has lower stability limit.

A low utilization factor for a plant indicates that?

Last Answer : A low utilization factor for a plant indicates that plant is used for stand by purpose.

To protect most of the electrical equipment handling low power, the types of relays used are?

Last Answer : To protect most of the electrical equipment handling low power, the types of relays used are thermocouple, electronic and bimetallic.