A circuit that binds the upper or lower extreme of a waveform to a fixed DC voltage level is called ______

A) DC voltage restorer B) Clamping circuit

C) Both A and B D) None of these

1 Answer

Answer :

A circuit that binds the upper or lower extreme of a waveform to a fixed DC voltage level is called ______

A) DC voltage restorer B) Clamping circuit

C) Both A and B D) None of these

Related questions

Description : The colour band on the extreme left in general purpose fixed resistors represents: A) Tolerance B) First significant digit C) Wattage Rating D) Voltage Rating

Last Answer : The colour band on the extreme left in general purpose fixed resistors represents: First significant digit

Last Answer : In a level compounded D.C. generator, full load terminal voltage is equal to no-load terminal voltage.

Description : Explain lagging quantity and leading quantity, explain this concept with voltage and current waveform

Last Answer : When two alternating quantities attain their respective zero or peak values simultaneously, the quantities are said to be in-phase quantities. When the quantities do not attain their respective zero or ... current is leading the voltage or the voltage is said to be lagging behind the current.

Description : A DC voltage source is connected across a series RLC circuit. Under steady-state conditions, the applied DC voltage drops entirely across the

Last Answer : A DC voltage source is connected across a series RLC circuit. Under steady-state conditions, the applied DC voltage drops entirely across the C only

Description : A d.c. source has an open circuit voltage of 30 V and an internal resistance of 1.5 Ohm. A resistive load is connected to the source. Maximum power dissipated in the load is (A) 300 W (B) 150 W (C) 45 W (D) 20 W

Last Answer : A d.c. source has an open circuit voltage of 30 V and an internal resistance of 1.5 Ohm. A resistive load is connected to the source. Maximum power dissipated in the load is 150 W

Description : List standard voltage level used in India. 

Last Answer : Standard voltage level used in India: * Generation Voltage : 3.3KV, 6.6KV,11KV and 17.5 KV,21KV (Now a days generation voltage is in the range of 11KV- 33KV) * Primary Transmission voltage :- 220 ... voltages in India are 765 KV (750KV), 400KV, 220KV, 132KV, 110KV, 66KV, 33KV, 22KV, 11KV.

Description : Explain full wave bridged rectifier with the help of circuit diagram and input output waveform.

Last Answer : 1. In positive half cycle (0 to Π): The end A of the secondary winding becomes positive and end B negative. This makes diode D1 and D4 forward biased while diode D2 and D3 are reverse biased. These two diodes will ... D2 and D3 when it is conducting is as follows.  B - D2 - RL - D3 - A 

Description : Draw the structural diagram of GTO. Explain briefly the switching behavior of GTO with the help of appropriate voltage and current waveform.

Last Answer : Gate Turn Off Thyristor (GTO) Conventional Thyristor can be turned on with gate terminal but can not turn off from gate terminal. But in case of Gate Turn Off Thyristor (GTO), we can turn it on and off ... subdivided as storage period (Ts), fall period (Tp) and tail period (Tt).

Description : An unshielded moving iron voltmeter is used to measure the voltage in an AC circuit. The stray DC magnetic field having a component along the axis will be  (1) unaffected (2) decreased (3) increased (4) either decreased or increased depending on the direction of the DC field

Last Answer : An unshielded moving iron voltmeter is used to measure the voltage in an AC circuit. The stray DC magnetic field having a component along the axis will be either decreased or increased depending on the direction of the DC field

Description : Define the terms related to a.c. supply with waveform : i) Instantaneous value ii) Time period iii) Amplitude iv) Phase difference. 

Last Answer : i) Instantaneous value: The instantaneous value is the value of an alternating quantity (it may ac voltage or ac current or ac power) at a particular instant of time in the cycle .  OR  ... difference: Phase difference is the difference in phase angle between two sinusoids or phasors. 

Description : State maximum power transfer theorem for DC circuit.

Last Answer : Maximum power transfer theorem for DC circuit: The maximum power transfer theorem states that the source or a network transfers maximum power to load only when the load resistance is equal ... removed (disconnected) ii) All internal independent sources are replaced by their internal resistances.

Description : Define- (i) Node (ii) Loop for a DC circuit

Last Answer : Ans: i) Node: A point or junction at which two or more elements of network are connected is called as node. ii) Loop: A closed path for flow of current in an electrical circuit is called loop.

Description : For a DC circuit capacitor is

Last Answer : For a DC circuit capacitor is virtually an open circuit

Description : Consider a circuit with three parallel branches connected across a DC supply. What is the ratio of the branch currents I1 : I2 : I3 if the branch resistances are in the ratio of 2 : 3 : 4 respectively? A) 2 : 3 : 4 B) 6 : 4 : 3 C) 4 : 3 : 2 D) None of these

Last Answer : Consider a circuit with three parallel branches connected across a DC supply. What is the ratio of the branch currents I1 : I2 : I3 if the branch resistances are in the ratio of 2 : 3 : 4 respectively? A) 2 : 3 : 4 B) 6 : 4 : 3 C) 4 : 3 : 2 D) None of these

Description : Limitation and application of High Voltage DC (HVDC)

Last Answer : Limitation and application of High Voltage DC (HVDC) :  Limitation:- 1) It is difficult to step up and step down DC voltage like AC voltage. 2) Special cooling ... conventional/non-conventional) 12) Increasing existing grid utilization. 13) Interconnection of different grids or networks

Description : Is the power line voltage available in our homes a dc or an ac voltage?

Last Answer : The power line voltage available in our homes is AC. Mobile dwellings are the most commonly DC-supplied homes and even then they tend to include AC supply for heavier loads.

Description : What is the RMS voltage in a series RL circuit, if the voltage across R and L is 256 V and 192 V respectively? A) 320 V B) 448 V C) 64 V D) None of these

Last Answer : What is the RMS voltage in a series RL circuit, if the voltage across R and L is 256 V and 192 V respectively? A) 320 V B) 448 V C) 64 V D) None of these

Description : Explain the concept of lagging and leading phase angle by waveform.

Last Answer : i) Leading phase angle :  When two ac quantities of same frequency do not attain their respective zero or peak values simultaneously, then the quantities are said to be out-of-phase quantities. The ... Similarly, in the second diagram, the voltage is said to be lagging the current by  Φ.

Description : Which of the following circuits converts any arbitrary waveform into square waveform? A) Hartley oscillator B) Schmitt trigger C) Differentiator D) RC phase shift oscillator 

Last Answer : Which of the following circuits converts any arbitrary waveform into square waveform? A) Hartley oscillator B) Schmitt trigger C) Differentiator D) RC phase shift oscillator 

Description : Explain DC coupled drive circuit with unipolar output.

Last Answer : DC coupled drive circuit with unipolar output: The figure shows the circuit and waveforms

Description : A dc chopper is fed from a constant voltage mains the duty ratio of chopper is progressively increased while the chopper feeds an RL load. The per unit current ripple would  (1) increase progressively  (2 ... 0.5 and then increase  (4) increase to a maximum value at α = 0.5 and then decrease

Last Answer : A dc chopper is fed from a constant voltage mains the duty ratio of chopper is progressively increased while the chopper feeds an RL load. The per unit current ripple would increase to a maximum value at α = 0.5 and then decrease

Description : Identify the increasing order of voltage regulation of the following dc generators a same load :  (A) differential compound, shunt and under compound  (B) shunt, differential compound and ... C) under compound, shunt and differential compound  (D) shunt, under compound and differential compound

Last Answer : Identify the increasing order of voltage regulation of the following dc generators a same load : under compound, shunt and differential compound 

Description : Source transformation Replace the circuit with voltage source in series with a single resistor

Last Answer : Source transformation Replace the circuit with voltage source in series with a single resistor

Description : The arc voltage in a circuit breaker is :

Last Answer : The arc voltage in a circuit breaker is : in phase with the arc current

Last Answer : The arc voltage produced in A.C. circuit breaker is always in phase with the arc current.

Last Answer : The voltage appearing across the contacts after opening of the circuit breaker is called recovery voltage.

Description : The power factor of a D.C. circuit is always?

Last Answer : The power factor of a D.C. circuit is always unity.

Description : All the rules and laws of D.C. circuit also apply to A.C. circuit containing?

Last Answer : All the rules and laws of D.C. circuit also apply to A.C. circuit containing resistance only.

Last Answer : If a D.C. shunt motor is working at full load and if shunt field circuit suddenly opens this will make armature to take heavy current, possibly burning it.

Last Answer : The voltage used for suburban trains in D.C. system is usually 600 to 750 V.

Last Answer : The armature voltage control of D.C. motor provides constant torque drive.

Description : Define the following terms related to tariff: (i) Connected load (ii) Unit consumed (iii) Fixed charges (iv) Electricity Tax 

Last Answer : (i) Connected load  It is the sum of the power ratings (Watts or kW or MW) of all devices and machines existing (installed) in the premises of consumer. It is used to decide the ... a percentage of the total electricity bill which includes all amounts that go to the electricity supply agency. 

Description : In a synchronous generator if the excitation increased from a low value to normal value, with a fixed load  (A) The armature current increases and the power factor decreases  (B) The armature ... but is lagging  (D) The armature current decreases and the power factor increases and is leading

Last Answer : In a synchronous generator if the excitation increased from a low value to normal value, with a fixed load The armature current decreases and the power factor increases and is leading

Last Answer : The operating speed of a synchronous motor can be changed to new fixed value by changing frequency.

Last Answer : In Hopknison demand rate or two part tariff the demand rate or fixed charges are dependent upon the maximum demand of the consumer.

Last Answer : A consumer has to pay lesser fixed charges in maximum demand tariff.

Description : How to Strengthen Your Lower Back

Last Answer : How to Strengthen Your Lower Back Your lower back is usually the most common body part taken for granted when working out. Most people concentrate more on their extremities and abdomen that they forget to ... lower ab exercises and as an addition, learn the Top 10 ways to stay motivated to exercise.

Description : How to Lower Triglycerides

Last Answer : How to Lower Triglycerides Eating fatty food is okay, as long as it is duly maintained at a healthy level. Going beyond the body's requirements consistently has a series of adverse effects, including obesity ... You'll certainly consider it as one of your life's defining moments, so don't give up.

Description : How to Lower Sugar in Your Diet

Last Answer : How to Lower Sugar in Your Diet Sugar may give you a temporary high, but when taken in big amounts than recommended, have negative long-term effects on your body. These include pre-diabetes, ... out meals can help the body absorb the sugar more slowly, without changing the sugar levels drastically.

Description : How to Exercise Your Lower Abs

Last Answer : How to Exercise Your Lower Abs Want gorgeous abs that you can flaunt once you hit the beach? Put some action in your lower abs and exercise your lower abs today. Keep in mind, though, that in ... you have a back injury, make sure that you check first with a doctor before attempting these exercises.

Description : How to Lower Your Grocery Bill

Last Answer : How to Lower Your Grocery Bill There are many people who shop for groceries carelessly; they enter the store without a list, then start grabbing items at random, whether they need them or not. ... is by lowering grocery bills. Remember these simple, but effective tips whenever you're out shopping.

Description : How to Lower Blood Pressure ?

Last Answer : How to Lower Blood Pressure It is absolutely vital that you learn how to lower blood pressure, especially if your doctor says that your blood pressure is a little high. This is due to the fact that ... quick 5 minute check up will be enough for you to start on your journey to lower blood press

Description : How to Lower Fat in Your Diet ?

Last Answer : How to Lower Fat in Your Diet The blood test results are in, and your doctor tells you that it's time to cut out the fat in your diet. To have a truly healthy lifestyle, lower fat in ... that are labeled hydrogenated . Remember that good fat should make up only 35% of your daily dietary intake.

Description : How to Lower Your Electric Bill ?

Last Answer : How to Lower Your Electric Bill The electric bill captures a huge brunt of your monthly expenses. It contains the accumulated cost of using every electrical device. Lowering the electric bill is clearly ... . Use each of them to your full advantage, preserving your monthly budget in the process.

Description : In order to have a lower cost of electrical energy generation the load factor  (1) and the diversity factor should be low (2) should be low but the diversity factor should be high (3) should be high but the diversity factor should be low (4) and the diversity factor both should be high

Last Answer : In order to have a lower cost of electrical energy generation the load factor and the diversity factor both should be high

Description : State the use of RADAR type level transducer & list two advantages.

Last Answer : Applications of radar type transducer: i) RADAR type level transducer is suitable for large tanks with range upto 200m for level measurement. ii) It is used for continuous level measurement. ... iii) Not affected by corrosive materials. iv) Can be used for hard to handle' applications.

Last Answer : Req= (1/1200 +1/560 + 1/2.1)^-1        = 2.1 ohms RT= 2.1 + 7.8      = 9.9 ohms IT = V/R = 24/9.9                = 2.4 A Veq= R I =  2.1 2 ... 7.8         = 12.096 w                 = 44.928 w _________________________________________ By: Ellis-Junior Kamatjipose [email protected]

Description : How to Test Soil pH Level

Last Answer : How to Test Soil pH Level Every good gardener knows that one of the key players in getting healthy plants is the quality of the soil. It's important to know your soil's chemistry, especially ... right readings. If you enjoyed reading this article, you might as well read how to garden organically.

Description : How to Level a Yard

Last Answer : How to Level a Yard Leveling a yard is a time consuming task. To free yourself from problems and save time doing the job, your first task should be to decide on the equipment you plan to ... the land. Check your drainage plan, and make sure that the elevation doesn't cause any drainage problems.

Description : How to Use a Level

Last Answer : How to Use a Level Do it yourself tasks such as framing a door, hanging a picture, or installing a chair rail, will turn out great if you use a level. This handy tool makes sure that the surface you ... is a must handyman. Just learn how to use it properly, and all do-it-yourself tasks will be easy.