x

In a double squirrel cage induction motor, good starting torque is produced as

(A) Large current flows through the outer high resistance winding.

(B) Large current flows through the inner high resistance winding.

(C) Small current flows through the outer high resistance winding.

(D) Large current flows through the inner low resistance winding.

143 views

1 Answer

Answer :

In a double squirrel cage induction motor, good starting torque is produced as Large current flows through the outer high resistance winding.

Like 0 like

Please log in or register to answer this question.

Related Questions


State starters used for i) 3-Ph squirrel cage induction motor (3HP) ii) D.C. motor 
Last Answer : Name the starters used for following motors : i) 3 H.P. 3-Ph squirrel cage I.M: i) DOL starter OR ii) Star-Delta Starter OR ii) Auto transformer starter OR iii) Soft start starter.  ii) D.C Shunt Motor : 1) Armature resistance starter (Three Point Starter) OR 2) Four Point Starter 

Show More

168 views 1 answer

Random Images

How is a three phase cage induction motor self starting?
Last Answer : Any type of induction motor is self starting. Because the reason for torqe production require two flux displaced by some angle theta.If theta is constant with time then torqe will be constant;if ... torqe also pulsating. In induction motor this angle theta is not pulsating.so it is self starting 

Show More

174 views 1 answer

Random Images

Generally, Crawling in squirrel cage induction motors is tendency to run stably at speeds as low as (A) One-third of their synchronous speed (B) One-fifth of their synchronous speed (C) One-seventh of their synchronous speed (D) One-ninth of their synchronous speed
Last Answer : Generally, Crawling in squirrel cage induction motors is tendency to run stably at speeds as low as One-seventh of their synchronous speed

Show More

108 views 1 answer

Random Images


Last Answer : Capacitor start motor has high torque in starting

Show More

146 views 1 answer

Random Images

Explain Squirrel Cage Induction Generator (SCIG) and also draw a diagram. 
Last Answer : Explanation (Operation):- In this system gearbox is used to increase the speed of high speed shaft as per design. IG require reactive power for excitation. Rotor of SCIG is ... , variable voltage output of the generator into the fixed frequency, fixed voltage output required for grid. 

Show More

2.8k views 2 answers

Random Images


Last Answer : For the same H.P. rating and full load speed, following motor has poor starting torque differentially compounded.

Show More

170 views 1 answer

Random Images

Torque developed by a three-phase, 400V, induction motor is 100 N -m. If the applied voltage is reduced to 200-V, the d'veloped torque will be
Last Answer : Torque developed by a three-phase, 400V, induction motor is 100 N -m. If the applied voltage is reduced to 200-V, the d'veloped torque will be 25 N -m

Show More

500 views 1 answer

Random Images

The torque developed by any 3-phase induction motor at 0.8 p.u. slip is (A) Full-load torque (B) unstable torque (C) starting torque (D) break down
Last Answer : The torque developed by any 3-phase induction motor at 0.8 p.u. slip is unstable torque

Show More

3.1k views 1 answer

Random Images


Last Answer : Speed torque characteristic of a repulsion induction motor is similar to that of a D.C. compound motor.

Show More

177 views 1 answer

Random Images


Last Answer : If starting winding of a single-phase induction motor is left in the circuit, it will draw excessive current and overheat.

Show More

246 views 1 answer

Random Images

Is induction motor is self starting?
Last Answer : Single phase induction motor is not self starting. Three phase induction motor is self starting.

Show More

121 views 1 answer

Random Images

Why a dc series motor has a high starting torque?
Last Answer : motor

Show More

92 views 1 answer

Random Images

Why starter is required for starting an induction motor?

Show More

118 views 0 answers

Random Images

Why does induction motor have high starting current?
Last Answer : In induction motor , the flux produce is quadrature to the applied voltage. Since when we are going to start motor , there is no flux present inside . So in order to lets say compensate it ... times of current to further increase flux. So that is reason for high starting current in induction motor

Show More

151 views 2 answers

Random Images


Last Answer : Buses, trains, trolleys, hoists, cranes require high starting torque and therefore make use of D.C. series motor.

Show More

120 views 1 answer

Random Images


Last Answer : The ratio of starting torque to full-load torque is least in case of shunt motors.

Show More

904 views 1 answer

Random Images

Why high starting torque is required?

Show More

65 views 0 answers

Random Images


Last Answer : The torque produced in induction type relay (shaded pole structure) is inversely proportional to the square of the current.

Show More

854 views 1 answer

Random Images

In an induction motor if the flux density is reduced to one-half, of its normal value then the torque will  (1) reduce to one-half (2) reduce to one-fourth (3) remain unchanged (4) increase four times
Last Answer : In an induction motor if the flux density is reduced.to one-half, of its normal value then the torque will reduce to one-fourth

Show More

417 views 1 answer

Random Images


Last Answer : The armature torque of the D.C. shunt motor is proportional to armature current.

Show More

228 views 1 answer

Random Images


Last Answer : In repulsion motor, maximum torque is developed when brush axis is at 45° electrical to the field axis.

Show More

121 views 1 answer

Random Images

Random Images


Last Answer : The starting resistance of a D.C. motor is generally low.

Show More

174 views 1 answer

Random Images


Last Answer : For starting a D.C. motor a starter is required because it limits the starting current to a safe value.

Show More

148 views 1 answer

Random Images


Last Answer : The starting winding of a single-phase motor is placed in stator.

Show More

132 views 1 answer

Random Images


Last Answer : Starting winding of a single phase motor of a refrigerator is disconnected from the circuit by means of a magnetic relay.

Show More

229 views 1 answer

Random Images

A 3-phase, 4-pole, 50Hz induction motor runs at a speed of 1440 rpm. The rotating field produced by the rotor rotates at a speed of ________ rpm with respect to stator field. (A) 1500 (B) 0 (C) 1440 (D) 60
Last Answer : 0

Show More

2.3k views 2 answers

Random Images

Split phase induction motor
Last Answer : Split phase induction motor : There are two windings used in split phase induction motor. It is a type of single-phase induction motor. There are two winding one is called main winding and ... motor have low starting torque it is used for small fans, blowers, centrifugal pumps, grinders etc.

Show More

250 views 1 answer

Random Images

A change of 4% in the supply voltage to an induction motor will produce a change of approximately
Last Answer : A change of 4% in the supply voltage to an induction motor will produce a change of approximately 8% in the rotor torque

Show More

532 views 1 answer

Random Images

The speed of a three-phase induction motor is controlled by variable voltage variable frequency control (i.e. keeping V/f constant). As the frequency is reduced, the slip at maximum torque  (1) Decreases (2) Increases (3) Remains constant (4) None of the above
Last Answer : The speed of a three-phase induction motor is controlled by variable voltage variable frequency control (i.e. keeping V/f constant). As the frequency is reduced, the slip at maximum torque Increases 

Show More

295 views 1 answer

Random Images

The slip of 400 V, three phase, 4 -pole induction motor when rotating at 1440 rpm is 
Last Answer : The slip of 400 V, three phase, 4 -pole induction motor when rotating at 1440 rpm is 4 percent

Show More

400 views 1 answer

Random Images

A 400 V, 50 Hz three-phase induction motor rotates at 1440 rpm on full -load. The motor is wound for
Last Answer : A 400 V, 50 Hz three-phase induction motor rotates at 1440 rpm on full -load. The motor is wound for 4 poles

Show More

343 views 1 answer

Random Images

In a split-phase induction motor, the resistance/reactance ratios of windings are such that (A) current in the auxiliary winding leads the current in the main winding (B) current in the ... (C) both windings develop the same starting torque (D) both windings develop high starting current
Last Answer : In a split-phase induction motor, the resistance/reactance ratios of windings are such that current in the auxiliary winding leads the current in the main winding

Show More

112 views 1 answer

Random Images

In a single-phase induction motor when the rotor is stationary and voltage is applied to the stator, then (A) the flux is constant (B) the flux first decreases and then increases in ... increases and decreases in the opposite direction with the same magnitude (D) current flows through the rotor
Last Answer : In a single-phase induction motor when the rotor is stationary and voltage is applied to the stator, then the flux first decreases and then increases in the same direction

Show More

104 views 1 answer

Random Images

An 8-pole, 50Hz, three-phase induction motor is running at 705rpm and has a rotor copper loss of 5kW. Its rotor input is (A) 5.06 kW (B) 0.3 kW (C) 100 kW (D) 83.33 kW
Last Answer : An 8-pole, 50Hz, three-phase induction motor is running at 705rpm and has a rotor copper loss of 5kW. Its rotor input is 83.33 kW

Show More

189 views 1 answer

Random Images

In a 3-phase slip-ring induction motor, the slip at some speed is 0.05. The speed is reduced by inserting an external resistance in the rotor circuit and the slip is 0.15. If the rotor winding resistance per phase is 0.2 Ω, the external resistance is (A) 0.2 Ω (B) 0.3 Ω (C) 0.4 Ω (D) 0.5 Ω
Last Answer : In a 3-phase slip-ring induction motor, the slip at some speed is 0.05. The speed is reduced by inserting an external resistance in the rotor circuit and the slip is 0.15. If the rotor winding resistance per phase is 0.2 Ω, the external resistance is 0.3 Ω

Show More

191 views 1 answer

Random Images


Last Answer : If a single phase induction motor runs slower than normal, the most likely defect is worn bearings.

Show More

179 views 1 answer

Random Images


Last Answer : The rotor slots, in an induction motor, are usually not quite parallel to the shaft because it helps in reducing the tendency of the rotor teeth to remain under the stator teeth.

Show More

152 views 1 answer

Random Images

How does a single phase induction motor work?
Last Answer : As we know that single phase induction is not self started because for self started we require atleast two revolving field but single phase induction motor has only one. So we provide extra ... 1phase IM classified as split phase IM, capacitor start capacitor run, capacitor start induction run.

Show More

132 views 1 answer

Random Images

What is the definition of induction motor?
Last Answer : its working on magnetic base made by coils and its work with 1 phase or 3 phase ac or dc supply

Show More

129 views 1 answer

Random Images

What is the function of induction motor?
Last Answer : while you give supply to motor its motor run on magnet base 

Show More

173 views 1 answer

Random Images

At which time power factor of the induction motor is low?
Last Answer : The power factor of the inducction motor is low at the time of starting as compare to while the induction motor is running.

Show More

156 views 1 answer

Random Images

What is mean by plugging in three phase induction motor?
Last Answer : Plugging in three-phase induction motor means interchanging of any two phases of a stator for quick stopping.

Show More

165 views 1 answer

Random Images

explain the working of single phase induction motor.
Last Answer : Stator has two winding namely main winding and auxiliary winding.when single phase ac supply is given to the motor,its produces alternating field.this field cut by a cage rotor.so some emf ... due to this emf,rotor flux produced.the interaction between two fluxes produce torque.so rotor rotates.

Show More

216 views 1 answer

Random Images


Last Answer : Induction motor is a AC motor it is also known as asynchronous motor .

Show More

104 views 1 answer

Random Images


Last Answer : if induction motor rotates exceed than its synchronous speed, it acts as a generator.

Show More

75 views 1 answer

Random Images

Induction motor
Last Answer : Induction Motor Inductor is a coil of wire which possess the property of inductance. Inductance is the property of an electric conductor which generate electromotive force (EMF ... motor are classified as slip ring induction motor and squirrel cage induction motor.

Show More

86 views 1 answer

Random Images

Single Phase Induction Motor
Last Answer : Single Phase Induction Motor Single phase induction motor is mostly used in home, office, shop and many single phase appliances like pumps,  ... torque and silent operation. It is uses where silent operation is required.

Show More

560 views 1 answer

Random Images

speed control methods of three phase induction motor?
Last Answer : Speed control of three phase induction motor

Show More

421 views 2 answers

Random Images

DC motor gross torque example
Last Answer : .embed-container { position: relative; padding-bottom: 56.25%; height: 0; overflow: hidden; max-width: 100%; } .embed-container iframe, .embed-container object, .embed-container embed { position: absolute; top: 0; left: 0; width: 100%; height: 100%; }

Show More

152 views 2 answers

Random Images
Show More⇦ PreviousNext ⇨