In a full-wave voltage doubler, are the capacitors connected  in series or in parallel with the output load?

1 Answer

Answer :

In parallel.

Related questions

Description : If a half-wave rectifier is added to a half-wave voltage doubler, the resulting circuit is a voltage ___

Last Answer : Trippler.

Description : A half-wave voltage doubler is made up of how many half wave rectifiers?

Last Answer : Two.

Description : A shunt type voltage regulator is connected in series/parallel with the load resistance.

Last Answer : Parallel

Description : What is Full Wave Voltage Doubler ?

Last Answer : The voltage multiplier circuit input AC . Using a full voltage cycle, double the amount of DC output. Providing voltage is called full wave voltage doubleler.

Description : What is Half Wave Voltage Doubler ?

Last Answer : The voltage multiplier circuit input AC . Using half a cycle of voltage, double the amount of DC output. Providing voltage is called half wave voltage doubleler.

Description : Three capacitors 15µf, 18µf and 12µf are connected in a circuit. Find equivalent capacitance when they are connected in – 1) Series 2) Parallel

Last Answer : Ans: Value of equivalent capacitance: Given: C1= 15μF, C2=18 µF, C3= 12µF  i)For Series combination of capacitors: 1/Cs = (1/C1)+( 1/C2) +(1/C3) = (1/15)+( 1/18)+( 1/12) 1/Cs = 0.0666+0.0555+0. ... Cs = 4.868 µF   ii) For parallel combination of capacitors: Cp = C1 + C2 + C3 = 15 +18+ 12 = 45 µF 

Description : For a diode to act as a rectifier, should it be connected in series or parallel with the load?

Last Answer : Series.

Description : Three capacitors with different capacitances are connected in series. Which of the following statements is TRUE? w) All three of the capacitors have the same potential difference between their plates. x ... y) The capacitance of the system depends on the voltage applied across the three capacitors.

Last Answer : ANSWER: X -- THE MAGNITUDE OF THE CHARGE IS THE SAME ON ALL OF THE CAPACITOR PLATES

Description : A shunt-type voltage regulator is connected in serial/parallel (which one) with the load resistance.

Last Answer : In parallel.

Description : Capacitors are used on the output of the power supply in today's consoles to _____________. A. filter out 'ripple' B. prevent overloads C. act as a permanent load D. decrease the average value of the output voltage

Last Answer : Answer: A

Description : What will be the total output voltage if four 1.5 volt batteries are connected in a series-parallel arrangement as shown in the illustration? EL-0039 A. 1.5 volts B. 3.0 volts C. 4.5 volts D. 6.0 volts

Last Answer : Answer: B

Description : How are synchro capacitors connected in a circuit?

Last Answer : They are delta-connected across the stator windings.

Description : What is the average voltage (Eavg) Output of a full-wave rectifier with an output of 100 volts peak?

Last Answer : 63.7 volts.

Description : What is the average voltage (Eavg) output of a full-wave rectifier that has an output of 100 volts peak?

Last Answer : 63.6 volts.

Description : If the capacitors are connected in parallel, then the potential difference across each capacitor is A. same B. different C. zero D. infinite

Last Answer : same

Description : How will the total capacitance change, when two capacitors are connected in parallel?

Last Answer : The  capacitance  will  increase  if  connected  in  parallel  because  it  will  be  like  you  have  increase  surface  area  of  a  plate  by  connecting  it  to   another.

Description : Equivalent capacitance ‘C’ of a system of capacitors C1,C2,C3 connected in parallel is

Last Answer : Equivalent capacitance ‘C’ of a system of capacitors C1,C2,C3 connected in parallel is C = C1+C2+C3

Last Answer : Two capacitors connected in parallel results in More capacitance.

Description : what will be the capacitance if three capacitors connected in parallel each having value of 0.5 micro Farad ?

Last Answer : the total capacitace when connected in parallel Tc=total capacitor c1=c2=c3=0.5uf Tc=c1+c2+c3 Tc=1.5uf

Last Answer : The capacity of capacitor is added and it becomes multiple of no of capacitors capacity

Description : Is an ammeter connected in series or in parallel with the circuit under test?

Last Answer : . In series.

Description : Which portion of a sine-wave input is retained in the output of a series-negative limiter?

Last Answer : Positive.

Description : Which portion of a sine-wave input is retained in the output of a series-positive limiter?

Last Answer : Negative.

Description : The effective capacitance of four, 5-microfarad capacitors connected in series is: w) 0.20 microfarad x) 0.5 microfarad y) 1.0 microfarad z) 1.25 microfarad

Last Answer : ANSWER: Z -- 1.25 MICROFARAD

Description : If the output of a half-wave rectifier is 50-volts peak, what is the average voltage

Last Answer : 15.9 volts.

Description : What characteristic is determined by the time required for a voltage wave to travel from the input end of an artificial transmission line to the output end and back again?

Last Answer : Pulse width

Description : What characteristic is determined by the time required for a voltage wave to travel from the input end of an artificial transmission line to the output end and back again?

Last Answer : Pulse width.

Description : What is the condition of the diode in a series limiter when an output is developed? In a parallel limiter?

Last Answer : Conducting, cutoff.

Description : Heat flux through several resistances in series in analogous to the current flowing through several (A) Resistances in parallel (B) Capacitors in series (C) Resistances in series (D) None of these

Last Answer : (C) Resistances in series

Description : Do capacitors in parallel have the same voltage?

Last Answer : Not same but we will get addition of both values when capacitors are connected in parallel...

Description : A circuit has a source voltage of 100 volts and two 50-ohm resistors connected in series. If the reference point for this circuit is placed between the two resistors, what would be the voltage at the reference point?

Last Answer : 50 volts.

Description : In a capacitor filter, is the capacitor in series or in parallel with the load?

Last Answer : Parallel.

Description : In a capacitor filter, is the capacitor in series or parallel with the load?

Last Answer : Parallel.

Description : Series capacitors on transmission lines are of little use when the load VAR requirement is (a) large (b) small (b) fluctuating (d) any of the above

Last Answer : (b) small

Last Answer : Series capacitors on transmission lines are of little use when the load VAR requirement is small.

Description : When a series voltage regulator is used to control output voltages, any increase in the input voltage results in an increase/a decrease (which one) in the resistance of the regulating device.

Last Answer : An increase.

Description : When a series voltage regulator is used to control output voltages, any increase in the input voltage results in an increase/a decrease in the resistance of the regulating device.

Last Answer : Increase.

Description : Series capacitors are used to (a) compensate for line inductive reactance (b) compensate for line capacitive reactance (c) improve line voltage (d) none of the above

Last Answer : (a) compensate for line inductive reactance

Description : The variation in output voltage as the load changes is referred to as what? How is it expressed?

Last Answer : Voltage regulation. As a percentage.

Description : Which of the methods listed is used to maintain the division of load between two compound-wound, DC generators operating in parallel? A. The shunt fields are interconnected. B. The shunt ... generators are connected in series. D. The equalizer connection parallels the series fields of all machines.

Last Answer : Answer: D

Description : Which of the following meters uses a shunt connected in series with the load, but parallel with the meter movement? A. voltmeter B. power factor meter C. wattmeter D. ammeter

Last Answer : Answer: D

Description : The shunt of a DC ammeter should be connected in __________. A. series with the load and in parallel with the meter movement B. parallel with the load and in series with the meter movement C. ... and in parallel with the meter movement D. series with the load and in series with the meter movement

Last Answer : Answer: A

Description : Which of the listed meters uses a shunt connected in series with the load, but parallel with the meter movement? A. Voltmeter B. Power factor meter C. Ammeter D. Wattmeter

Last Answer : Answer: C

Description : Which of the methods listed is used to maintain equal load sharing between two compound wound DC generators operating in parallel? A. The shunt fields are interconnected. B. The shunt field rheostats ... are connected in series. D. The series fields of both generators are connected in parallel.

Last Answer : Answer: D

Description : The shunt used in an ammeter should be connected in ____________. A. series with the load and in parallel with the meter movement B. parallel with the load and in series with the meter movement C. ... in parallel with the meter movement D. series with the load and in series with the meter movement

Last Answer : Answer: A

Description : Which of the following statements represents the main difference between a relay and a contactor? A. Contactors control current and relays control voltage. B. A relay is series connected and a contactor ... loads than relays. D. Contactors are made from silver and relays are made from copper.

Last Answer : Answer: C

Last Answer : Req= (1/1200 +1/560 + 1/2.1)^-1        = 2.1 ohms RT= 2.1 + 7.8      = 9.9 ohms IT = V/R = 24/9.9                = 2.4 A Veq= R I =  2.1 2 ... 7.8         = 12.096 w                 = 44.928 w _________________________________________ By: Ellis-Junior Kamatjipose [email protected]

Description : A change in field excitation of an alternator operating in parallel will cause a change in its _____________. A. alternator frequency B. kilowatt load C. voltage output D. all of the above

Last Answer : Answer: C

Description : The simplest method of controlling the terminal voltage of compound-wound DC generator is with a _____________. A. hand-operated field rheostat connected in series with the shunt field circuit B. ... in series with the load D. balance coil diverting neutral current through the shunt field

Last Answer : Answer: A

Description : Is a full-wave rectifier output easier to filter than that of a half-wave rectifier?

Last Answer : Yes.