1 Answer

Answer :

Yes BJT have internal capacitances.

Related questions

Description : An FET is a better chopper than a BJT because it has (A) lower offset voltage (B) higher series ON resistance (C) lower input current (D) higher input impedance

Last Answer : An FET is a better chopper than a BJT because it has lower offset voltage

Description : What is a BJT?

Last Answer : Bipolar Junction Transistor (BJT): BJT is a Bipolar device. (Uses both electrons and holes charge carrier for current conduction) Two Junctions (Emitter junction & collector ... mode (Current amplification) Cutoff mode (Open switch) Saturation mode (Close switch)

Last Answer : Yes IGBT is costlier than BJT and MOSFET.

Last Answer : BJT act as switch in saturation and  cutoff region ( ON state in saturation region and OFF state in cut-off region )

Last Answer : In cut-off region of BJT both the emitter-base junction and collector-base junction are reverse biased.

Last Answer : Active region of BJT act as amplifier.

Last Answer : Active , Saturation , Cut-off region of operations in BJT.

Last Answer : Yes BJT have second breakdown problem.

Last Answer : BJT is current controlled device.

Last Answer : BJT have three terminals Base, emitter and collector.

Last Answer : In  BJT  there  is  movement  of   electrons  and  holes   accros  the  junctions  which  is  basicaly  current  flow.

Last Answer : When Q-point is at cut off region means it is just above the horizontal axis VCE

Last Answer : The proper flow of zero signal collector current and the maintenance of the proper collector emmiter voltage during passage of single called as transistor biasing

Last Answer : Beta is the current gain which is the ratio of collector current to base current.

Last Answer : BJT control the flow of electron so it is a active device.

Last Answer : No, BJT is a current controlled device .

Last Answer : Bipolar junction transistor

Last Answer : Transformer coupled amplifiers Direct coupled amplifiers Multistage amplifiers Darlington amplifiers Emmiter follower

Description : what are bjt transistors?

Last Answer : Bjt transistor is a type of transistor which  uses both electrons and hole charge carrier.bjts are used as switches and amplifiers.They amplify currents.

Description : Calculate the value of equivalent capacitance of the combination.

Last Answer : Calculate the value of equivalent capacitance of the combination

Description : effect of inductance and capacitance on performance of transmission line.

Last Answer : Following are the effect on performance of transmission line:  1. Due to inductance (L) voltage drop in transmission line produces.  2. Capacitor (C) draws charging current ... , transmission line efficiency, voltage regulation & also power factor of transmission line gets affected. 

Description : Explain estimation of channel capacitance of CMOS.

Last Answer : Capacitance estimation: The dynamic response i.e. switching speed of MOS system depends on capacitance associated with the MOS devices which are formed by different layers in MOS transistors ... are due to three dimensional, distributed charge voltage relations within the device structure. 

Description : What is capacitance?

Last Answer : Capacitance is the capacity of element to store electric charge in it. The unit of capacitance is Farad. 

Description : Energy stored in electrostatic field of capacitance formula

Last Answer : Energy stored in electrostatic field of capacitance formula

Description : Capacitance

Last Answer : Capacitance formula

Description : A diode in which the change in reverse bias voltage varies the capacitance is called as A) Varactor diode B) Switching diode C) Tunnel diode D) Zener-diode  

Last Answer : A diode in which the change in reverse bias voltage varies the capacitance is called as Varactor diode

Description : Capacitance is the ability of a body to store an__________.  (A) electrical charge (B) electric current (C) voltage (D) All of the above

Last Answer : Capacitance is the ability of a body to store an electrical charge 

Description : For 11 kV line the capacitance per km per phase will be of the order of:  (A) 1 Farad (B) 0.1 Farad (C) 0.01 Farad (D) 0.01 microF

Last Answer : For 11 kV line the capacitance per km per phase will be of the order of: 0.01 Farad

Description : What is the capacitance when a capacitor passes a current of 31.43 mA when supplied with 40 V AC with a frequency of 1000 Hz? A) 0.125 F B) 0.125 μF C) 1257.2 μF D) None of these

Last Answer : What is the capacitance when a capacitor passes a current of 31.43 mA when supplied with 40 V AC with a frequency of 1000 Hz? A) 0.125 F B) 0.125 μF C) 1257.2 μF D) None of these

Description : Which of the following can be used to measure the capacitance of a capacitor? A) Rheostat B) Schering bridge C) Wheatstone bridge D) None of these

Last Answer : Which of the following can be used to measure the capacitance of a capacitor? A) Rheostat B) Schering bridge C) Wheatstone bridge D) None of these

Description : The time constant of the capacitance circuit is defined as the time during which voltage?

Last Answer : The time constant of the capacitance circuit is defined as the time during which voltage rises to 63.2% of its final steady value.

Last Answer : Shunt capacitance is neglected while considering short transmission line.

Description : What is the reciprocal of capacitance?

Last Answer : The reciprocal of capacitance is called elastance, and its unit is the reciprocal farad, also called the daraf.

Description : State 2 advantages of JFET over BJT.

Last Answer : Advantages of JFET over BJT: 1) High input impedance 2) Better thermal stability 3) Produce less noise 4) Smaller than BJT 5) Rugged in construction and simpler to fabricate 6) High degree of isolation between Input and Output. 

Description : List specification of BJT.

Last Answer : * The bipolar junction transistor (BJT) has small signal current gain, α (hfb). * Maximum collector current Ic (max). * Maximum collector to emitter voltage, VCE (max). * Collector to emitter ... . * Collector to emitter cut off voltage, VCEO. * Base emitter saturation voltage, VBE (sat).

Description : State reason BJT is called as bipolar junction transistor.

Last Answer : BJT is called bipolar junction transistor because in BJT current conduction takes place due to majority as well as minority charge carriers.

Description : List configurations of BJT. 

Last Answer : Configurations of BJT : 1) Common Base (CB) configuration 2) Common Emitter (CE) configuration 3) Common Collector (CC) configuration

Description : State the need of biasing of BJT.

Last Answer : Need of biasing: The basic need of transistor biasing is to keep the base-emitter (B-E) junction properly forward biased and the collector-emitter (C-E) junction properly reverse biased ... transistor biasing is necessary for normal and proper operation of transistor to be used for amplification. 

Description : Draw circuit diagram of voltage divider biasing list two advantages of voltage divider biasing of BJT.

Last Answer : Two advantages of voltage divider biasing of BJT. 1. It is very simple method of transistor biasing. 2. The biasing conditions can be very easily set. 3. there is no loading of ... 5. The resistor RE introduces a negative feedback. So all the advantages of negative feedback are obtained. 

Description : Compare BJT with FET

Last Answer : FET BJT It is unipolar device i.e. current in the device is carried either by electrons or holes It is bipolar device i.e. current in the device is carried either by ... from minority- carrier storage effects & therefore has lower switching speeds & cut-off frequencies. 

Description : Compare between BJT and FET on the basis of (i) Biolar/Unipolar (ii) Tharmal Runaway (iii) Noise (iv) Applications

Last Answer : Parameter BJT FET Bipolar/Unipolar It is bipolar device i.e. current in this device is carried by electrons and holes. It is unipolar device i.e. current ... in oscilloscopes, electronic voltmeters and other measuring and testing equipment because of their high input impedance.

Description :  If the base current of a BJT is 250 µA and emitter current is 15 mA, then the common base current gain will be A) 0.98 B) 0.41 C) 59 D) 55  

Last Answer :  If the base current of a BJT is 250 µA and emitter current is 15 mA, then the common base current gain will be 0.98 

Description : Which phenomenon is present in thyristors but absent in BJT, MOSFET and IGBT ? (A) forward conduction (B) latching (C) forward blocking (D) reverse breakdown

Last Answer : Which phenomenon is present in thyristors but absent in BJT, MOSFET and IGBT ? (A) forward conduction (B) latching (C) forward blocking (D) reverse breakdown

Description : What is the difference between BJT and FET?

Last Answer : BJT  is  a  current  opperated   transistor  while  FET   is  a  field   opperated  transistor.

Description : What is a BJT amplifier?

Last Answer : Bilpolar Juntion transistor , this fuction is control the current

Description : Is the input impedance of MOSFET more than BJT and FET?

Last Answer : Yes, the input impedance of MOSFET more than BJT and FET.

Description : Explain open emitter BJT drive circuit.

Last Answer : open emitter BJT drive circuit:

Description : Explain the formation of parasitic BJT and parasitic diode in Power MOSFET. Can parasitic diode be used in same power electronics applications?

Last Answer : Parasitic Diode: The parasitic diode is in between drain and source. The MOSFET structure itself contains parasitic diode or body drain diode. This parasitic diode allows the reverse flow of current when the ... of MOSFET as a BJT collector. Parasitic BJT operates in the cut-off region.

Description : Operating frequency of power MOSFET is higher than that of power BJT. Justify the statement.

Last Answer : Power MOSFET have high turning on and turning off capability high switching speed of MOSFET is due to the high rate of change of drain voltage. The switching losses of power MOSFET ... lower frequency. Hence, operating frequency of power MOSFET is higher than that of power BJT.

Description : Compare BJT, MOSFET and IGBT .

Last Answer : BJT MOSFET IGBT BJT is a current controlled device. MOSFET is a voltage controlled device. IGBT is a voltage controlled device. The input impedance of BJT is low. ... is minority carrier device. MOSFET is majority carrier device. IGBT is minority carrier device.