Which of the following device is used for coupling microwave energy? 

A) Resonator B) Waveguide C) Loop D) Antenna

2 Answers

Answer :

Which of the following device is used for coupling microwave energy? 

A) Resonator B) Waveguide C) Loop D) Antenna 

Answer :

A

Related questions

Description :  Which of the following is a negative-resistance microwave device for oscillator applications? A) IMPATT Diode B) Gunn Diode C) Snap diode D) Schottky Diode 

Last Answer :  Which of the following is a negative-resistance microwave device for oscillator applications? A) IMPATT Diode B) Gunn Diode C) Snap diode D) Schottky Diode 

Last Answer : A switchgear is device used for switching, controlling and protecting the electrical circuit and equipment.

Description : Transformer coupling introduces which type of distortion?

Last Answer : Transformer coupling introduces Cross over distortion.

Description : Give the different types of amplifier coupling.

Last Answer : 1. Resistance – capacitance (RC) coupling.  2. Inductance (LC) coupling.  3. Transformer coupling (TC)  4. Direct coupling (D.C.)

Last Answer : The coupling angle or load angle of synchronous motor is defined as the angle between the rotor and the stator poles of opposite polarity.

Description : What is Capacitive coupling ?

Last Answer : Capacitive coupling is connecting a circuit to another circuit using a capacitor in order to allow only Ac signal to pass through from circuit1 to the other circuit.

Description : Phantom loading for testing of energy meter is used (A) to isolate the current and potential circuits (B) to increase power loss during testing (C) for meters having low current ratings (D) to test meters having a large current rating for which loads may not be available

Last Answer : B

Description : A snubber circuit is connected to the power semiconductor device to reduce the (A) turn-on time (B) turn-off time (C) electrical stresses (D) thermal resistance

Last Answer : A snubber circuit is connected to the power semiconductor device to reduce the electrical stresses

Last Answer : No, BJT is a current controlled device .

Description : Does anyone actually use the microwave popcorn setting?

Last Answer : Yes, it works great on my machine.

Description : Do you personally know a fool proof way to get smoke off the walls of a microwave?

Last Answer : answer:Hm, I'm not sure about smoke, never tried before With baked-on-food, I usually putting a dish of water in the microwave for a long time-enough time for the water to steam up the ... off surfaces And, since baking soda and vinegar are both edible, any leftover residue-turned-fume is fine.

Description : Would you say the microwave oven is the greatest modern invention?

Last Answer : answer:No, I would not. I don’t like it at all. It makes meat tough. It is bad for breads.

Description : What does it mean when a microwave makes a whistling noise every time it is being used?

Last Answer : Could be a leak in the seal of the door. I think I’d call a microwave store or department and ask what to do about it, if that is what it is.

Description : Have you ever cooked pasta in a microwave?

Last Answer : only the Easy Mac & Cheese!

Description : So how exactly does the "defrost" function work differently than "cook" on a microwave?

Last Answer : I'd guess that they just have different power settings and time settings which the makers have decided are best suited to those tasks. In the end, you're just heating something up with a microwave, ... those buttons do. I'm pretty sure you can achieve the same result by manually setting the time.

Description : How do I get the smell out of a microwave?

Last Answer : I have mixed baking powder with water and heated it until it boils. Let it boil a couple of minutes. Then let it cool down to warm, take the water out, and rub down the inside of the microwave with more baking powder water. That worked for me.

Description : Microwave ventilation holes are shaped like electric plugs?

Last Answer : That’s because those aren’t ventilation holds, they’re holes for plugs. They must use the same backplane worldwide and use different electrical connections in different countries. Also, the same backplane may be use for different models. Why retool when you can make one generic backplane and reuse.

Description : How to Clean a Microwave

Last Answer : How to Clean a Microwave Microwave ovens are one of the most used kitchen appliances people have in their households. As a result, it's one of the appliances that get dirty in a short span of ... of baking soda inside the microwave when not in use will also help prevent it from accumulating odors.

Description : How to Microwave Bacon ?

Last Answer : How to Microwave Bacon Do you love to eat bacon for breakfast, but you don't want to deal with dirty pans and burn marks from oil spatters? If you have a microwave in your kitchen, there ... tastes just as delicious and as crispy. Just follow these tips and enjoy a delicious bacon-filled breakfast!

Description : How to Microwave Rice ?

Last Answer : How to Microwave Rice Rice is the staple food of millions of people all over the world. For Americans, though, rice is not as popular as starchy foods like bread and potatoes, and rice has been ... perfect batch of rice to serve to friends, guests, and family members for any meal of the day.

Description : Microwave Cooking Tips

Last Answer : Microwave Cooking Tips This is a fast, easy cooking method that requires no added fat. You do not have to add fat to keep the food from sticking to the pan because foods do not tend to ... will be adding liquid for cooking. The coatings become soggy. Use quick-cooking instead of long-grain rice.

Description : How to choose a microwave oven?

Last Answer : Before you start choosing a microwave oven, you should clearly define what functions it will have to perform in your kitchen. For cooking simple dishes, heating food and defrosting, it is quite ... can even weigh products on their own. All this greatly facilitates the operation of the oven.

Description : electrical specifications of microwave oven.

Last Answer : Supply voltage: 220 volts,50 Hz. Single phase A.C. Power consumption: 1300 W approx.(power consumption vary as manufacturer from500W to 1500W) Microwave power: 700 w-850 W Microwave frequency: 2450 ... ) Timer: 60 min. - 90 min(timer can also varied) Control: Soft/one touch control

Last Answer : MOSFET  are voltage controlled devices.

Last Answer : BJT is current controlled device.

Description : State any four materials used in fabrication of semiconductor device and describe its need.

Last Answer : For fabrication of semiconductor devices like transistors diode, solar cell etc. we have to make use of following types of materials  1. Substrate: o It is used for deposition of thin ... . o Metal cans and sealed glass containers satisfy the extreme requirements of space and military users.

Description : Linear and non-linear device

Last Answer : Linear and non-linear device

Description : Why transistor is called as bipolar device.

Last Answer : BJT is called bipolar device because in BJT current conduction takes place due to majority as well as minority charge carriers that is because of electrons as well as holes.

Description : The device which allows reverse power flow and withstands highest switch frequency is (A) GTO (B) MOSFET (C) IGBT (D) Inverter grade SCR

Last Answer : The device which allows reverse power flow and withstands highest switch frequency is MOSFET

Last Answer : Wagner earthing device is used to eliminate errors due to electrostatic coupling.

Last Answer : Basically a potentiometer is a device for comparing two voltages.

Last Answer : A damping device prevents the oscillation of the moving system and enables the latter to reach its final position quickly.

Description : Is FPGA a volatile device?

Last Answer : Yes, FPGA is a volatile device.

Last Answer : No, IGBT is not the current controlled device. IGBT is a voltage controlled device. IGBT have combine qualities of MOSFET and BJT. The high switching speed of MOSFET and low conduction losses of BJT. Also, IGBT which stands for Insulated Gate Bipolar Transistor have high input impedance.

Last Answer : Thyristor can only be turned on by small gate pulse but it cannot be turn off by using gate hence thyristor is called semi controlled device.

Last Answer : Thyristor can be turn on by positive gate pulse and the current will continue to flow through the device even when the gate voltage is low hence thyristor is called latching device.

Last Answer : already answered here is mosfet current controlled device?

Description : What are the quickest ways to dry clothes at night with no dryer?

Last Answer : Just leave them hanging, and if they’re still damp in the morning you can use a hairdryer (assuming you have one) I definitely wouldn’t put them in the microwave.

Description : Am I the only one who notices that microwaves smell bad?

Last Answer : I think your nose is sensitive to odors which most people don’t detect. This is actually a very valuable asset – if it can be proven that you do have this capability, you can get a very well paying job with a perfumery or a winery.

Description : When you set something on "auto pilot" for a minute or so, do you stand there watching while it's doing it's thing, or do you fill that time with something else?

Last Answer : Good weird question. I don’t really like Microwaves, but when I do use it, yes I watch it go round, my s/o then makes fun of me and comes and watches it with me!

Description : Spring.

Last Answer : what is now?

Description : A Hartley Oscillator is used for generating (A) very low frequency Oscillation (B) radio-frequency Oscillation (C) microwave Oscillation (D) audio-frequency Oscillation

Last Answer : A Hartley Oscillator is used for generating radio-frequency Oscillation

Description : The effect of a finite gain of an operational amplifier used in an integrator is that (A) it would not integrate (B) the slope of the output will vary with time (C) the final value of the output voltage will reduce (D) there will be instability in the circuit

Last Answer : The effect of a finite gain of an operational amplifier used in an integrator is that there will be instability in the circuit

Description : Why shunt capacitor is used?

Last Answer : To improve voltage at receiving end and power factor

Description : Why capacitor bank is used?

Last Answer : In industrial or factory used E.B Power supply must be maintained above 0.90 power factor is compulsory for avoid EB Penalty. So APFC ( automatic Power factor control ) panel is used to maintained balance the load and PF maintained.

Last Answer : Transformer coupled amplifiers Direct coupled amplifiers Multistage amplifiers Darlington amplifiers Emmiter follower

Description :  An energy signal has G(f) = 20. Its energy density spectrum is A) 20 B) 100 C) 400 D) 800  

Last Answer : 400

Description : what is fermi energy

Last Answer : Fermi energy is the part of electron band diagram.Fermi energy is highest energy that the electron assume at T = 0 K. Fermi level comes in between conduction band and valance band. In case of ... , In case of semiconductor energy gap is small, And in case of conductor energy gap is overlap.

Description : Is there a device that I can plug my refrigerator into, that will cycle the fridge on and off in order to save energy?

Last Answer : Your refrigerator already has a thermostat that does just that. If you cycled it off more than the thermostat calls for, its internal temperature would rise, introducing food safety and spoilage risks.

Description : Why is it important to not mix brands of batteries in a device (whatever kind of device)

Last Answer : It is the type of battery not the brand. Types of batteries include: Carbon Zinc, Alkaline, Rechargeable Alkaline, Li-Ion or NiCD.