Description : a tacheometer is fitted with an anal-latic lens (A) Additive constant is 100, multiplying constant is zero (B) Multiplying constant is 100, additive constant is zero (C) Both multiplying and additive constants are 100 (D) Both multiplying and additive constants are 50
Last Answer : (B) Multiplying constant is 100, additive constant is zero
Description : One of the tacheometric constants is additive, the other constant, is (A) Subtractive constant (B) Multiplying constant (C) Dividing constant (D) Indicative constant
Last Answer : (B) Multiplying constant
Description : What are the additive and multiplying constants of planimeter?
Last Answer : Area of the irregular figure measured by planimeter is given by: Where M = Multiplying constant C = Additive costant Multiplying Constant: It is the multiplier whose value is marked on ... It is taken in to consideration only when anchor point is inside the figure, else it is zero.
Description : The rate expression for a heterogeneous catalytic reaction is given by, - rA = K.KA PA(1 + KA.PA + KR.PR), where K is surface reaction rate constant and KA and KR are absorption equilibrium constants of A and R respectively. If KR PR ... R and A) (A) E (B) E + ΔHA (C) E + ΔHA - ΔHR ) (D) ΔHA + ΔHR
Last Answer : (C) E + ΔHA - ΔHR )
Description : If the intercept on a vertical staff is observed as 0.75 m from a tachometer, the horizontal distance between tachometer and staff (A) 7.5 m (B) 25 m (C) 50 m (D) 75 m
Last Answer : (D) 75 m
Description : If the focal length of the object glass is 25 cm and the distance from object glass to the trunnion axis is 15 cm, the additive constant (A) 0.1 (B) 0.4 (C) 0.6 (D) 1.33
Last Answer : (B) 0.4
Description : Rankine's deflection angle in minutes is obtained by multiplying the length of the chord by (A) Degree of the curve (B) Square of the degree of the curve (C) Inverse of the degree of the curve (D) None of these
Last Answer : (A) Degree of the curve
Description : The length of a traverse leg may be obtained by multiplying the latitude and (A) Secant of its reduced bearing (B) Sine of its reduced bearing (C) Cosine of its reduced bearing (D) Tangent of its reduced bearing
Last Answer : (A) Secant of its reduced bearing
Description : If is the stadia distance, is the focal length and is the distance between the objective and vertical axis of the techeometer, the multiplying constant, is (A) f/i (B) i/f (C) (f + d) (D) f/d
Last Answer : (A) f/i
Description : Pick up the correct statement from the following: (A) The unit hydrograph of a specified unit duration obtained from the past data can be used to obtain the hydrograph of future storms of like duration (B) ... hydrograph may be obtained by dividing the run off in mm by 25 mm (D) All the above
Last Answer : Answer: Option D
Description : If a gauge is installed perpendicular to the slope, its measurement is reduced by multiplying (A) Sine of the angle of inclination with vertical (B) Cosine of the angle of inclination with vertical (C) Tangent of the angle of inclination with vertical (D) Calibration coefficient of the gauge
Last Answer : Answer: Option B
Description : In the mid-section formula (A) The mean depth is the average of depths of two consecutive sections (B) The area of mid-sections is calculated by using mean depth (C) The volume of the ... multiplying the mid-section area by the distance between the two original sections (D) All of the above
Last Answer : (D) All of the above
Description : The grade resistance factor for an earth moving machine can be obtained by multiplying grade percentage by a factor approximately equal to (A) 2 kg/tonne (B) 6 kg/tonne (C) 9 kg/tonne (D) 20 kg/tonne
Last Answer : (C) 9 kg/tonne
Description : In hydrometer analysis for a soil mass (A) Both meniscus correction and dispersing agent correction are additive (B) Both meniscus correction and dispersing agent correction are subtractive ... is subtractive (D) Meniscus correction is subtractive and dispersing agent correction is additive
Last Answer : (C) Meniscus correction is additive and dispersing agent correction is subtractive
Description : Second order consecutive irreversible reaction as shown in the bellow figure, were carried out in a constant volume isothermal batch reactor with different initial feed compositions. Reactor temperature was same in all the cases. In experiments ... constants (k1 /k2 )? (A) 1/4 (B) 1/2 (C) 2 (D) 4
Last Answer : (A) 1/4
Description : A telephone cable has following primary constants per loop kilometer ,R=30Ω, L=20mH,C=0.06µF,G=0.If the applied signal has an angular frequency of 5000 rad/sec.., Determine (i) Characteristics impedence (ii) Attenuation constant
Last Answer : A telephone cable has following primary constants per loop kilometer ,R=30Ω, L=20mH,C=0.06µF,G=0.If the applied signal has an angular frequency of 5000 rad/sec.., Determine (i) Characteristics impedence (ii) Attenuation constant
Last Answer : Airplane / Motor Of the car Speed Diagnostic Instrument.
Description : How to find out if the car's tachometer is accurate?
Last Answer : Measure ten kilometers on the road by subway and then measure it with a tachometer.
Description : Is it possible to measure if the tachometer (not digital) in the car shows well?
Last Answer : Best GPS - it detects the speed of movement very accurately.
Description : What is the purpose of a hand held tachometer?
Last Answer : A tachometer measures RPMs, and a hand held tachometer is used to measure the speed of smaller things, like engine parts. A hand held tachometer is usually used to measure the RPMs in a car engine, but tachometers have also been used to measure the rate of blood flow in the body.
Description : The kilowatt load can be adjusted on a paralleled generator by using the _____________. A. field rheostat B. governor control C. automatic voltage regulators D. hand tachometer
Last Answer : Answer: B
Description : A handheld digital tachometer could give a bad reading if ___________________. A. aimed directly at the shaft B. partially aimed at a 60 Hz. fluorescent light C. positioned 5-10 inches from the shaft D. the tape is too shiny
Description : The diagrams shown in the illustration represent a/an _______________. EL-0093 A. engine order telegraph circuit B. rudder angle indicator arrangement C. engine speed tachometer with repeaters D. sound powered telephone system
Last Answer : Answer: D
Description : An electric tachometer receives the engine speed signal from a _______________. A. small generator mounted on the engine B. bimetallic sensing device C. stroboscopic sensing device D. vibrating reed meter generating a voltage proportionate to engine speed
Last Answer : Answer: A
Description : In Fullarton Tachometer, a thin strip with a ______ is attached at one of its ends. (A) mass (B) spring (C) damper (D) shaft
Last Answer : (A) mass
Description : Which type of frequency measuring instrument has multiple reeds of different natural frequency to measure vibrations? A. Fullarton tachometer B. Frahm Tachometer C. Both A. and B. D. None of the above
Last Answer : B. Frahm Tachometer
Description : An instrument used to measure soil compaction is: a Hydrometer b Cone penetrometer c Tachometer d Hygrometer
Last Answer : b Cone penetrometer
Description : Non-contact speed measurements can be carried out by a) Tachometer b) Stroboscope c) Oscilloscope d) Speedometer
Last Answer : Stroboscope
Description : Non contact speed measurements can be carried out bb c) Tachometer c) Stroboscope d) Stroboscope d) Speedometer
Description : Non contact speed measurements can be carried out bb a) Tachometer c) Stroboscope b) Stroboscope d) Speedometer
Description : What is an electric tachometer?*
Last Answer : A generator producing voltage proportional to speed.
Description : An a.c. tachometer is just a ________with one phase excited from the carrier frequency. (A) two-phase A.C. servomotor (B) two-phase induction motor (C) A.C. operated universal motor (D) hybrid stepper motor.
Last Answer : Ans: D This is a special purpose machine whose stator coil can be energized by electronically switched current.
Description : A tachometer is a device used to measure (1) gravitational pull (2) speed of rotation (3) surface tension (4) dispersive power
Last Answer : speed of rotation
Description : State the use of Lux Meter and Tachometer in energy audit.
Last Answer : Use of lux meter – to measure intensity of light Use of tachometer – to measure speed
Description : What is tachometer ? Explain photo electric pick-up
Last Answer : Tachometer is an instrument which is used to measure angular speed. It is measured in revolutions per minutes (RPM). Working: Working principle:The light passes through the holes available on the rotating disc with ... is given by N=f/HS N=speed f=frequency Hs=holes on the disc
Description : In an ac tachometer, the two stator field coils are mounted
Last Answer : In an ac tachometer, the two stator field coils are mounted in space quadrate
Description : Tachometer works essentially as a generator with output voltage proportional to magnitude of the : - a) Angular Velocity of the shaft b) Torque of the shaft c) Temperature of the shaft d) Back Lash of the shaft
Last Answer : Tachometer works essentially as a generator with output voltage proportional to magnitude of the : - Angular Velocity of the shaft
Last Answer : It is a device used to measure the speed of a rotating shaft. It usually gives speed in RPM.
Description : what is tachometer?
Last Answer : It is also known ad tachogenerator,it is used to measure angular speed in rpm
Description : A level when set up 25 m from peg A and 50 m from peg B reads 2.847 on a staff held on A and 3.462 on a staff held on B, keeping bubble at its centre while reading. If the reduced levels of A and B are 283.665 m ... collimation error per 100 m is (A) 0.015 m (B) 0.030 m (C) 0.045 m (D) 0.060 m
Last Answer : (D) 0.060 m
Description : Will additive inverse always equal 0?
Last Answer : When a number is added to its additive inverse, the result isalways 0.
Description : What are the constants of the universe?
Last Answer : answer:From Wikipedia: According to Michio Kaku (1994: 124-27), the Standard Model of particle physics contains nineteen arbitrary dimensionless constants that describe the masses of the particles and ... than can be modelled by the cosmological constant, yet more constants will be needed.
Description : Hello, Please help with solving the task: Ludolf's number and Euler's number and the Golden Section seven numbers of east longitude, giving the final coordinates. At the same time, the final coordinates ... wanted the coordinates of north latitude N 50 ° 12.345 ', you would look for seven 5012345.
Last Answer : Need Answer
Description : Let `0le theta le pi/2` `x=Xcos theta + Ysin theta` `y=Xsin theta - Y cos theta` such that `x^2+4xy+y^2=aX^2+bY^2` where `a,b` are constants such that
Last Answer : Let `0le theta le pi/2` `x=Xcos theta + Ysin theta` `y=Xsin theta - Y cos theta` such that `x^2+4xy+y^2=aX^2+ ... C. `a=3`, `b=-1` D. `theta=(pi)/(3)`
Description : For a linear plot of log(x/m) versus log p in a Freundlich adsorption isotherm, which of the following statements is correct ? (k and n are constants)
Last Answer : For a linear plot of log(x/m) versus log p in a Freundlich adsorption isotherm, which of the following ... Both k and 1/n appear in the slope term.
Description : State, whether all constants are dimensionless or unitless.
Last Answer : State, whether all constants are dimensionless or unitless.
Description : How does the method for solving equations with fractional or decimal coefficients and constants compare with the method for solving equations with an integer coefficients and constants?
Last Answer : The answer depends on how advanced your methods are. In general,the methods are the same except that if you have repeatingdecimals, they may cause rounding errors.
Description : What are some posture and resistance constants of an effective resistance posture.?
Last Answer : What is the answer ?
Description : What are some posture and resistance constants of an effective resistance?