State the static and dynamic characteristics of instruments. 

1 Answer

Answer :

Static characteristics: i. Accuracy ii. Sensitivity iii. Reproducibility iv. Drift v.Static error vi. Dead zone vii. Repeatability viii. Precision ix Linearity 

Dynamic characteristics: i. Speed of response ii. Measuring lag iii. Fidelity iv. Dynamic error

Related questions

Description : List dynamic characteristics of instruments.

Last Answer : Speed of Response: It is the rapidity with which a measurement system responds to changes in the measured quantity.  Measuring Lag: It is the retardation or delay in the response of a ... quantity changing with time and the value indicated by the measurement system if there is no static error.

Description : List four dynamic characteristics of instruments. Define any two of them.

Last Answer : Dynamic characteristics of instruments are: 1. Speed of response 2. Fidelity 3. Lag 4. Dynamic error. Definition: 1. Speed of response: The rapidity with which instrument responds to make ... and the value indicated by the instrument if no static error is assumed is called as dynamic error.

Description : Draw V-I characteristics of p-n junction diode? Define static and dynamic resistance of diode.

Last Answer : Static Resistance: The resistance offered by a p-n junction diode when it is connected to a DC circuit is called static resistance.  (OR) It is the ratio of DC voltage applied across diode ... The dynamic resistance of a diode is the ratio of change in voltage to the change in current. 

Description : Equilibrium of a chemical reaction as viewed by kinetics is a __________ state. (A) Dynamic steady (B) Static steady (C) Dynamic unsteady (D) None of these

Last Answer : (A) Dynamic steady

Description : List any 4 undesirable characteristics of instruments.

Last Answer : 1. Drift 2. Dead zone 3. Static error 4. Dynamic error 5. Lag 

Description : Which of the following instruments require inputs of both pitot and static pressure? a. Airspeed indicator, machmeter and vertical speed indicator b. Airspeed indicator, vertical speed indicator, altimeter c. Airspeed indicator only d. Airspeed indicator and machmeter

Last Answer : d. Airspeed indicator and machmeter

Description : Which of the following instruments require inputs of both pitot and static pressure? a. Airspeed indicator, machmeter and vertical speed indicator b. Airspeed indicator, vertical speed indicator, altimeter c. Airspeed indicator only d. Airspeed indicator and machmeter

Last Answer : d. Airspeed indicator and machmeter

Description : Where can I find dynamic (animated) comics (NOT the static pictures!), if possible free?

Last Answer : hmmmmmm. Not exactly what you’re looking for, but you might check out the current MSPA

Description : To solve the FEM problem, it subdivides a large problem into smaller, simpler parts that arecalled a.static elements b.dynamic elements c.infinite elements d.finite elements

Last Answer : d.finite elements

Description : A uniform cylinder of weight W is rolling while slipping on a rough horizontal surface under the influence of a horizontal force. The force of friction between the cylinder and the surface is a. ... c.Indeterminate d.Determinate but depends on the acceleration of the cylinder e.None of the above

Last Answer : c. Indeterminate

Description : A uniform cylinder of weight W is rolling while slipping on a rough horizontal surface under the influence of a horizontal force. The force of friction between the cylinder and the surface is a. ... on the acceleration of the cylinder d.107 dynes e.Proportional to the coefficient of static friction

Last Answer : c. Determinate but depends on the acceleration of the cylinder

Description : Static friction is always a.greater than the dynamic driction b.either greater or more than the dynamic friction c.less than the dynamic friction d.107 dynes e.equal to the dynamic friction

Last Answer : a. greater than the dynamic driction

Description : Show the difference between a static website and a dynamic website. ?

Last Answer : answer:

Description : Static Website And Dynamic Of the website In The difference What ?

Last Answer : Static Website: That The web On the site Data The value On the webpage Loading Or On To do After Change To do Goes No. Him Static The web Site Says. Static Of the website Features : # Cost Less ... is. # Cost More #comparable _ Way More Safe #attractive _, Interactive Lay - out Made To do Goes.

Description : What is the difference between static and dynamic website?

Last Answer : The static web pages display the same content each time when someone visits it, whereas in dynamic web pages takes more time while loading.

Description : Difference between static, responsive, dynamic and a CMS websites?

Last Answer : Static websites are just files which do not interact with the database or does not require active requests from the CDN or the server. Responsive websites are those who adjust their layout ... the active connection with the data and requires constant request and response approach with the server.

Description : What's the difference between a dynamic site and a static one?

Last Answer : Static Web pages often look the same, and rarely change the text. You must create the page yourself or request a Web designer to make a change for you. You must then upload the newly ... sites will reduce the ongoing maintenance costs. Typically they cost more to build, because they require m

Description : Which term is used to describe RAM? A) Dynamic RAM (DRAM) B) Static RAM (SRAM) C) Video RAM (VRAM) D) All of the above

Last Answer : Answer : D

Description : Which of the following memories must be refreshed many times per second? A) Static RAM B) Dynamic RAM C) EPROM D) ROM

Last Answer : Answer : B

Description : Which is a semi conductor memory? A) Dynamic B) Static C) Bubble D) Both a & b

Last Answer : Answer : D

Description : Friction can be reduced by changing over from _____. A. Sliding to rolling B. Dynamic to static C. Potential energy to kinetic energy D. Rolling to sliding

Last Answer : ANSWER: A

Description : Cache and main memory will not be able to hold their contents when the power is off. They are ________ A. Static B. Dynamic C. Non Volatile D. Volatile

Last Answer : D. Volatile

Description : What is the difference between static and dynamic lov

Last Answer : The static lov contains the predetermined values while the dynamic lov contains values that come at run time

Description : The RUP is normally described from three perspectives- dynamic, static& practice. What does static perspective do? a) It shows the process activities that are enacted. b) It suggests good practices to be used during the process. c) It shows the phases of the model over time.

Last Answer : a) It shows the process activities that are enacted.

Description : The endurance or fatigue limit is defined as the maximum value of the stress which a polished standard specimen can withstand without failure, for infinite number of cycles, when subjected to (a) static load (b) dynamic load (c) static as well as dynamic load (d) completely reversed load

Last Answer : (d) completely reversed load

Description : ____________ is/are useful when the original formulation of a problem is altered in some way, typically because the set of constraints to consider evolves because of the environment. a) Static CSPs b) Dynamic CSPs c) Flexible CSPs d) None of the mentioned

Last Answer : b) Dynamic CSPs

Description : Magnification factor is the ratio of the maximum displacement due to forced vibrations to the deflection due to _______ A Static force B Dynamic force C Torsion D Compression

Last Answer : A Static force

Description : Magnification factor is the ratio of the maximum displacement due to forced vibrations to the deflection due to _______ a) Static force b) Dynamic force c) Torsion d) Compression

Last Answer : a) Static force

Description : A computer having writable control memory is known as_ a. Static micro programmable b. Dynamic micro programmable c. Botha & b d. None of these

Last Answer : b. Dynamic micro programmable

Description : During program execution content of main memory undergo changes and, but control memory has _ microprogram: a. Static b. Dynamic c. Compile time d. Fixed

Last Answer : d. Fixed

Description : In _______, a tableassociating a logicaladdress with a physical address is updated manually. A) static mapping B) dynamic mapping C) physical mapping D) noneof the above

Last Answer : static mapping

Description : A _______routingtable is updated periodically using one of the dynamic routingprotocols. A) static B) dynamic C) hierarchical D) none of the above

Last Answer : dynamic

Description : A _______routingtable contains information entered manually. A) static B) dynamic C) hierarchical D) none of the above

Last Answer : static

Description : The simple Pitot tube measures the __________ pressure. (A) static (B) Dynamic (C) Total (D) None of these

Last Answer : (C) Total

Description : The simple Pitot tube does not measure the (A) Static pressure (B) Dynamic pressure (C) Velocity at the stagnation point (D) All (A), (B) and (C)

Last Answer : (D) All (A), (B) and (C)

Description : The __________ is measured by a piezometric opening. (A) Dynamic pressure (B) Static pressure (C) Total pressure (D) Point velocity

Last Answer : (C) Total pressure

Description : A piezometer opening measures the __________ fluid pressure. (A) Static (B) Undisturbed (C) Total (D) Dynamic

Last Answer : (B) Undisturbed

Description : The pitot static tube does not measure the __________ pressure. (A) Static (B) Total (C) Difference in static & dynamic (D) All (A), (B) and (C)

Last Answer : (D) All (A), (B) and (C)

Description : A piezometer provided in the pipe measures (A) Friction factor (B) Static pressure (C) Dynamic pressure (D) None of these

Last Answer : (B) Static pressure

Description : A ……………………….. is built from the information exchanged by routing protocols. A. static routing table B. dynamic routing table C. both a and b D. neither a nor b

Last Answer : B. dynamic routing table

Description : . A ………………………... is constructed manually by the system administrator using the route command. A. static routing table B. dynamic routing table C. both a and b D. neither a nor b

Last Answer : A. static routing table

Description : The __________ pressure is measured by a static tube. (A) Dynamic (B) Static (C) Total (D) None of these

Last Answer : (B) Static

Description : Distance Vector Routing is a……... routing algorithm, it consists of a data structure called a ……… A. Static , routing table B. Dynamic, look-up table C. Dynamic, routing table D. Static, look-up table

Last Answer : C. Dynamic, routing table

Description : Flooding is also a……... algorithm, usually generates ………... of duplicate packets. A. Static, vast number B. dynamic , vast number C. Static, less number D. dynamic , less number

Last Answer : A. Static, vast number

Description : Which type of channel it is where the number of users are stable and the traffic is not bursts? A. static channel B. dynamic channel C. free channel D. both a and c

Last Answer : A. static channel

Description : I've a website containing all static pages. Now I want to provide a simple Feedback form for end users. I don't have software developers, and would like to spend minimum time and money. What should I ... form, and embed in html page. C. Use Google App Engine (GAE) to build and deploy dynamic page.

Last Answer : Use ZOHO creator to build the required form, and embed in html page

Description : is a semi conductor memory. 1) Dynamic 2) Static 3) Bubble 4) Both a & b

Last Answer : 4) Both a & b

Description : Cache and main memory will lose their contents when the power is off. They are-- 1) Dynamic 2) Faulty 3) Volatile 4) Static

Last Answer : 3) Volatile

Description : SaaS does not necessarily mean that the software is? A. dynamic B. static C. sololithic D. diolithic

Last Answer : static

Description : Which of the following is correct? a) The dynamic structure of the Layered style is to partition software units into modular layers b) The static structure of the Layered style is nothing more than ... interactions between layers c) All of the mentioned CSE-R17.BLOGSPOT.COM d) None of the mentioned

Last Answer : None of the mentioned