State function of i) Ceiling rose ii) Conduit 

1 Answer

Answer :

Function of Ceiling rose: Output connection for ceiling fan or tube. 

Function of Conduit – To run the wires from switch board to appliances. 

Related questions

Description : State two factors deciding size of conduit.

Last Answer : Following factors deciding size of conduit: 1) Types of wiring method 2) No. of wires carried out through conduit 3) Size of wires required for sub circuits which is carried out through conduit 4) Future expansion.

Description : State function of ELCB.

Last Answer : Functions of ELCB: 1. Provides protection to apparatus by detecting the unsafe magnitudes of leakage currents diverting to earth. 2. Disconnect the supply to the circuit if line to ground ... 3. Provides protection to users by detecting the unsafe magnitudes of leakage currents diverting to earth.

Description : Draw a labeled block diagram of sine wave generator and state function of each block. 

Last Answer : Function Generator:  This instrument can deliver sine, triangular & square waves with frequency range of 0.01 Hz to 100 kHz.  The frequency control network is governed by a frequency ... voltage reaches a predetermined level on the negative slope of the integrator's output voltage.

Description : Draw block diagram of microprocessor and state the function of each block.

Last Answer : Registers: The 8085 includes six registers, one accumulator, and one flag register, as shown in Figure. In addition, it has two 16-bit registers: the stack pointer and the program counter. The 8085 ... , Subtraction, Increment, Decrement etc.  Logic Operations: AND, OR, X-OR, Complement etc.

Description : With the knowledge of the state variable representation of a plant the transfer function of the plant 

Last Answer : With the knowledge of the state variable representation of a plant the transfer function of the plant can be determined completely

Description : State function of starter and ELCB. (Earth Leakage Circuit Breaker)

Last Answer : i) Function of Starter:- 1. To prevent the high starting current OR to minimize the starting current. 2. To give supply failure protection 3. To give over load and short circuit protection ... an installation and cut off the circuit from power supply and avoid electrical shock to the person.

Description : State function of Busbar and which material is used for busbar?

Last Answer : Function of Busbar Bus-bar: - Distribute the load on 3-phase four wire systems. To provide number of connection of incoming line and to provide easy way to connect number of sub circuit. ... to the element. This element means busbar Material is used for busbar: 1. Copper 2. Alluminium

Description : List any four wiring accessories and its function. 

Last Answer : Following wiring accessories: 1) Lamp holder: It is the holding accessory. The different types of holders used such as angle holder, batten holder, pendent holder 2) Ceiling Rose: Ceiling rose are of two types: ... etc 9) Switch board, ICDP Main Switch 10) All types of size of VIR & PVC wire

Description : How to Texture a Ceiling

Last Answer : How to Texture a Ceiling You're thinking of painting your ceiling, but you realize it still looks boring even with the lovely color you used. If you're an artistic person, why not texture your ... adding texture to it. As long as you follow this method, your ceiling will no longer look boring.

Description : How to Remove Popcorn Ceiling

Last Answer : How to Remove Popcorn Ceiling Popcorn is yummy and delightful, but not when your ceiling starts to look like it. An unpleasant popcorn texture can ruin the look of a room, but you don't have to worry ... difficult chore, but when you see your ceiling smooth and neat, you'll feel that it's worth it.

Description : How to Install a Ceiling Fan

Last Answer : How to Install a Ceiling Fan The first step in installing is to determine the most appropriate distance between the fan blades and your floor. You will need a measuring device in order to accurately do ... respective house wires. The fan must be grounded to the metal box and to the fan itself.

Description : How to Fix a Noisy Ceiling Fan

Last Answer : How to Fix a Noisy Ceiling Fan Ceiling fans are great additions to any room: Not only do they take up minimal space, but they also provide that much-needed cool breeze in any part of the room on warm ... s a chance that it's a production glitch. Check with the ceiling fan's company as a last resort.

Description : How to Balance a Ceiling Fan

Last Answer : How to Balance a Ceiling Fan Compared to regular electric fans, ceiling fans are preferred by many people because of better air distribution and their stylish look. It's nice to walk in and turn on ... their ceiling fan to perform poorly. Just follow these easy steps and yours will work just fine.

Description : How to wire a Ceiling Fan ?

Last Answer : How to wire a Ceiling Fan To wire a ceiling fan is a relatively easy project. Usually, it is similar to working on replacing an existing light fixture. However, you will also need to check the ... have a loose wire connection. In case your fan vibrates or shakes, check if the blades are balanced.

Description : Stretch ceiling. What to look for when choosing?

Last Answer : Stretch ceiling is a great view of interior decoration. It allows you to create a pleasant aesthetic environment and to hide pronounced surface defects. However, like any finishing material, solid artificial ... that will ensure the quality not only of the coating, but also of the installation work.

Description : How to glue a ceiling plinth?

Last Answer : Ceiling plinth is used to decorate the angle between the wall and the ceiling. This decorative element is also called fillet. Installation is carried out after leveling the walls and ceiling. We ... After completing the process, the ceiling plinth is painted, usually in the color of the ceiling.

Description : Ceiling lamps. What are they and how to choose?

Last Answer : Well-chosen lighting can stimulate productive activities and can create an intimate and relaxing atmosphere. The variety of ceiling lights is not limited to traditional center chandeliers. In addition ... Their placement along the perimeter of the bathroom will visually make the room more spacious.

Description : Which ceiling to choose for the bathroom?

Last Answer : Which ceiling to choose for the bathroom? The bathroom is a room with high humidity, it requires special attention when installing ventilation, choosing appropriate furniture, materials for wall and ceiling ... ceiling an ideal solution for your bathroom. But the choice, of course, is yours!

Description : How to choose a modern stretch ceiling?

Last Answer : How to choose a modern stretch ceiling? Renovation in an apartment, which many consider to be quite messy and troublesome, today can be easily turned into a less dusty procedure. To do this ... , stretch ceilings from Swiss, Russian and Chinese manufacturers are in great demand on the market today.

Description : Which ceiling is suitable for a bathroom?

Last Answer : Which ceiling is suitable for a bathroom? If you want to make repairs in the bathroom at an affordable price and we are not talking about long-term construction, then a rack suspended ceiling ... colors and shades of such ceilings will allow you to create your own unique design in the premises.

Description : Why is a capacitor used in a ceiling fan ?

Last Answer : For splitting phase so that a rotating magnetic field will be produced & as per Lenz's law a torque will be created & rotor starts rotating. In single phase if capacitor is not used for split phase then a pulsating mag. field is produced which is unable to produce torque on rotor

Last Answer : In a ceiling fan employing capacitor run motor secondary winding surrounds the primary winding.

Last Answer : The wattage rating for a ceiling fan motor will be in the range 50 to 150 W .

Last Answer : Capacitor use in fan is made up of dielectic material which is in semi solid material having high capacity.but generation of heat in capacitor the semi solid material converted into dry solid because of ... capacity becomes lower and lower so for good result of our fan we have to change it.

Last Answer : It is simply variable resistance create opposition to flow of current and decrease or increase the speed of fan

Description : State I.E. Rule No.90 

Last Answer : I.E. Rule No.90: All metal supports of overhead lines and metallic fittings attached there to, shall be permanently and effectively earthed. For this purpose, a continuous earth wire shall be provided and ... one insulator has been placed in at a height not less than 3.3 m from the ground.

Description : Define Tender and state any three requirements of valid contract.

Last Answer : Meaning Tender:- Tender is offer or invitation of the work between any two parties. This offer may be written or non written. This offer is given by party no.1 (owner) to party no.2 ( ... . Contract should be signed by proper authorized persons. 6. It should be legally challenged in the court.

Description : Define contract and state its types.

Last Answer : Definition of Contract:- The agreement between two parties under some specific terms and conditions is known as contract.  Types of Engineering contract:- 1) Lump sum contract 2) Item rate contract 3) ... contract 11)Cost plus(+) fluctuating fees rate contract 12) Cost plus(+) fix fee contract 

Description : Define service connection and state types connection and state types of overhead service connection

Last Answer : Service Connection:- It is the input conductor or wire which is carried out from supply company (authorities) pole to consumers' main board or premises. Types of overhead service ...  1. Overhead service connection with Bare conductor 2. Overhead service connection with weather proof cable  

Description : State the location and function of i) Economizer ii) Feed water heater.

Last Answer : (i) Economizer:-  Location: - It is placed in the path of flue gases in between the exit from the furnace and the chimney. OR In The way of feed water before boiler. Function: - ... economizer. Function: - Its function is to increase the temperature of feed water by using blade steam.

Description : State at least one function and the material used for the following parts of DC Motor.

Last Answer : Part Function Material Yoke -Provides mechanical support for poles -Acts as protecting cover for machine -Provides path for magnetic flux Cast Iron OR Cast Steel Field Winding - ... Pole core  Provides mechanical support to field winding. Cast Iron OR Cast Steel

Description : State the function of super heater of a thermal power plant. 

Last Answer : Function of Super heater: -  Its function is to increase the temperature of steam by absorbing heat from exhausted hot flue gases.

Description : State the function of cooling tower and condenser in thermal power station.

Last Answer : 1. Condenser:   Function of condenser is to convert exhaust steam again into water by reducing its temperature with the help of cold water. Also it reduces back pressure of steam turbine 2 ... tower : The function of cooling tower is to reduce the temperature of water coming from condenser.

Description : State the function of superheater and economizer.

Last Answer : Function of Superheater : The steam produced in the boiler is not dry but contains some moisture. Such wet steam can damage/corrode and reduce the efficiency of the plant. Hence before supplying ... the temperature of feed water to the boiler, so that efficiency of overall system is increased.

Description : State the function of former and control spring in PMMC instrument.

Last Answer : Function of Former: To support the coil and provide eddy current damping.  Function of Control Spring: To provide control torque or force and in some instruments springs can be used as current leads.

Description : State the function of controlling torque in electrical measuring instrument.

Last Answer : Function of controlling torque  1. The function is to opposes the deflection force and increases with the increase in the deflection of the moving system, to limit its movement. 2. and brought ... set a position where the two opposing forces i.e. deflection and controlling forces are equal. 

Description : State the function of controlling torque. Write two types of it.

Last Answer : Function of Controlling Torque:  To restrict the motion of pointer / spindle and stop the pointer at the relevant position to get correct reading.  To bring back pointer to zero ... measurement is removed.  Types of Controlling Torque: 1. Spring control method 2.Gravity control method 

Description : Is the search function not working?

Last Answer : Search hasn’t been working for a while. I know that the tech mods are looking at it, but my impression is that it’s more complicated than any of the other fixes they’ve done.

Description : Draw the block diagram of regulated power supply, explain function of each block and draw waveforms of each stage.

Last Answer : 1. A step down transformer 2. A rectifier 3. A filter 4. A regulator Operation of Regulated Power Supply:- Step Down Transformer:- A step down transformer will ... regulator. A regulator will maintain the output constant even when changes at the input or any other changes occur.

Description : Draw block diagram of PLL as a FM demodulator. Explain function of each block.

Last Answer : Operation:  The FM signal which is to be demodulated is applied at the input of the PLL.  the PLL is locked to the FM  The error voltage produced at ... using PLL ensures a high Linearity, between the instantaneous input frequency and VCO control voltage (error amplifier output)

Description : Give the function of fuse and switch.

Last Answer : Functions of fuse:  * To break the circuit under fault condition.  * To provide overcurrent protection to the circuit.  * To provide short circuit protection to the circuit.  * To provide ...  * To make the electric circuit manually.  * To break the electric circuit manually.

Description : Write the function of freewheeling diode.

Last Answer : Function of Freewheeling Diode (FWD): a) Freewheeling diode is used across inductive loads such as coils, dc motor armature etc. to prevent voltage spikes across these loads when the switching ... current is shifted from switching device, it is turned off easily and regain its blocking ability.

Description : Describe the function of MUSE system for HDTV.

Last Answer : Bandwidth can be reduced by MUSE (Multiple Sub -Nyquist Sampling Encoding) system MUSE stands for Multiple Sub-Nyquist sampling encoding and is an HDTV bandwidth compression schemedeveloped by ... digital Audio system is called DANCE (Digital Audio Near-Instantaneous Compression and expansion). 

Description : applications of : (1) Function generator   (2) Video pattern generator (3) AF signal generator and (4) Pulse generator. 

Last Answer : 1) Function generator: i) As trouble shooting tool to different analog and digital circuits. ii) As a source of alignment of different receiver. iii) If rise time of square wave is ... trigger output, pulses are available. iii) The generator can be operated as free running generator.

Description : Draw neat block diagram of FM receiver and explain function of each block

Last Answer : Explanation:-  RF amplifier: There are two important functions of RF amplifier: 1) To increase the strength of weak RF signal. 2) To reject image frequency signal. In FM ... FM broadcast, the maximum modulating frequency is 15 kHz. Hence the audio amplifier must have large bandwidth.

Description : Draw and explain the function of cooling tower in TPS.

Last Answer : Cooling tower in TPS: The function of cooling tower is to reduce the temperature of water coming from condenser. Water is circulated from the basin of the cooling ... cooling Tower temperature of water is reduced either by natural or forced or induced draught method or combine

Description : What is the function of an electrical filter ?

Last Answer : Filter separates different components that are mixed together. Electrical filter can separate different frequency components. Electrical filters are the electrical circuits which are use to remove unwanted frequency components from the signal.

Description : Write function of control rods in nuclear power plant.

Last Answer : Function of control rods in nuclear power plant: The function of control rod is to control the chain reaction in reactor core by adjusting its height.

Description : What is penstock? What is its function?

Last Answer : What is Penstock:- The penstock is the long pipe line. It consists of heavy duty steel pipe.  Function of Penstock:- Function of penstock is to carry water from the water intake (reservoir) to turbine.

Description : List any four applications of function generator.

Last Answer : Applications of function generator: 1. To test the bandwidth of audio frequency amplifier. 2. Used for troubleshooting of different analog and digital circuits. 3. Acts as source for alignment of receivers 4. For generation of different waves.