Source free RL circuit 1

1 Answer

Answer :

Source free RL circuit 1


Related questions

Description : Source free RL circuit 8

Last Answer : Source free RL circuit 8

Description : Source free RL circuit 7

Last Answer : Source free RL circuit 7

Description : Source free RL circuit 6

Last Answer : Source free RL circuit 6

Description : Source free RL circuit 2

Last Answer : Source free RL circuit 2

Description : Source free RL circuit 3

Last Answer : Source free RL circuit 3

Last Answer : Source free RL circuit 4

Last Answer : Source free RL circuit 5

Description : Source free RC circuit 2

Last Answer : Source free RC circuit 2

Description : Source free RC circuit 3

Last Answer : Source free RC circuit 3

Description : Source free RC circuit 4

Last Answer : Source free RC circuit 4

Description : Source free RC circuit 5

Last Answer : Source free RC circuit 5

Description : Source free RC circuit 6

Last Answer : Source free RC circuit 6

Description : Source free RC circuit 7

Last Answer : Source free RC circuit 7

Description : Source free RC circuit 8

Last Answer : Source free RC circuit 8

Description : What is the RMS voltage in a series RL circuit, if the voltage across R and L is 256 V and 192 V respectively? A) 320 V B) 448 V C) 64 V D) None of these

Last Answer : What is the RMS voltage in a series RL circuit, if the voltage across R and L is 256 V and 192 V respectively? A) 320 V B) 448 V C) 64 V D) None of these

Description : At ______ frequencies the parallel R-L circuit behaves as purely resistive.

Last Answer : At very high frequencies the parallel R-L circuit behaves as purely resistive.

Description : If resistance is 20 Q. and inductance is 27 in a R-L series circuit, then time constant of this circuit will be?

Last Answer : 0.1s

Description : Can An Rc Circuit Be Used As Clock Source For 8085?

Last Answer : Answer :Yes, it can be used, if an accurate clock frequency is not required. Also, the component cost is low compared to LC or Crystal.

Description : Source transformation Replace the circuit with voltage source in series with a single resistor

Last Answer : Source transformation Replace the circuit with voltage source in series with a single resistor

Description : A DC voltage source is connected across a series RLC circuit. Under steady-state conditions, the applied DC voltage drops entirely across the

Last Answer : A DC voltage source is connected across a series RLC circuit. Under steady-state conditions, the applied DC voltage drops entirely across the C only

Description : Single-phase mid-point controlled rectifier with RL load

Last Answer : Single-phase mid-point controlled rectifier with RL load : The circuit configuration of single-phase midpoint controlled rectifier is shown in the figure. During positive half-cycle of ... some part of next positive half-cycle of voltage with reversed polarity can appear across load.

Description : Two resistances Rl and Ri are connected in series across the voltage source where Rl>Ri. The largest drop will be across?

Last Answer : Two resistances Rl and Ri are connected in series across the voltage source where Rl>Ri. The largest drop will be across Rl.

Description : Consider a circuit with four resistors in series connected to a voltage source. What happens to the voltage across each resistor, if the value of each of the resistors is doubled? A) It will double B) It will remain the same C) It will be halved D) It will become zero

Last Answer : Consider a circuit with four resistors in series connected to a voltage source. What happens to the voltage across each resistor, if the value of each of the resistors is doubled? A) It will double B) It will remain the same C) It will be halved D) It will become zero

Description : State the material used for making (1) Magnetic Core (2) Fuse element  

Last Answer : The material used for making of:  (1) Magnetic Core : Iron, cobalt, Nickel, CRGO, HRGO , silicon steel  (2) Fuse Element: Tin- lead wire, Tinned copper wire 

Description : A charge of 0.1 C moves past a given point every 0.01 s. How much is the current?

Last Answer : The current is 10.0A.  1ampere = 1 Coulomb per 1 second.  0.1Coulombs ÷ 0.01seconds = 10.0amperes.

Description : Parallel Reactance and Resistance Example 1

Last Answer : Parallel Reactance and Resistance Example 1

Description : Maximum Power Transfer Theorem 1

Last Answer : Maximum Power Transfer Theorem 1

Description : Problem on temperature coefficient of resistance 1

Last Answer : Problem on temperature coefficient of resistance 1

Description : Problem on resistance and resistivity 1

Last Answer : Problem on resistance and resistivity 1

Description : Problem on electrical power and energy 1

Last Answer : Problem on electrical power and energy 1

Description : Give the circuit analysis of current source inverter with resistive load. What are the main difference between voltage source inverter and current source inverter?

Last Answer : Current source inverter (CSI): In current source inverter, the output current is independent of load. The input current of current source inverter is constant. Current source converter converts DC input current to ... are connected in parallel. In CSI diodes are connected in series.

Description : What is renewable source of energy? State two examples for the same.

Last Answer : Renewable (Primary) Energy sources: It is defined as the sources that can be used again and again for the generation of electrical energy are called renewable.  Following are the some list ... ) and carbon dioxide  6. Geothermal Energy  Geothermal Electricity Production  7. Fuel Cells

Description :  An independent voltage source in series with an impedance ZS=R+jXS delivers a maximum average power to a load impedance ZL when A) ZL = R B) ZL = jXS C) ZL = R-jXS D) ZL = R+jXS 

Last Answer :  An independent voltage source in series with an impedance ZS=R+jXS delivers a maximum average power to a load impedance ZL when ZL = R-jXS

Description : A 3-phase voltage source inverter operates in 180° conduction mode with a star connected resistive load. If input dc voltage is 100 V, then the peak to peak output line voltage is :

Last Answer : A 3-phase voltage source inverter operates in 180° conduction mode with a star connected resistive load. If input dc voltage is 100 V, then the peak to peak output line voltage is : 200 V

Description : A current controlled voltage source is equivalent to :  (A) series voltage feed -back amplifier (B) shunt current feed -back amplifier (C) shunt voltage feed -back amplifier (D) series current feed -back amplifier

Last Answer : A current controlled voltage source is equivalent to : shunt voltage feed -back amplifier

Description : A network that consists of at least a voltage source or current source is called A) Active network B) Ideal network C) Sourced network D) Outsourced network

Last Answer : A network that consists of at least a voltage source or current source is called Active network

Description : what is the source of energy for satellite ?

Last Answer : The source of energy for the satellites are its solar panels which generate power by themselves. But, to reach the orbit , it uses the fuel to push the rocket . It needs fuel to power the ... solar panels , hence solar power is produced which is ud=sed to power the internal use of satellite.

Description : what is ideal voltage source?

Last Answer : every voltage source have their own resistance that is called as internal resistance it is because of the resistance of electrodes and electrolytes in the battery interms of other supplyit have ... in universe it means ideal voltage source is this voltage source having internal resistance zero

Description : Is Telos real?

Last Answer : answer:Of course. I read about it on the internet, thus it has to be true.~ http://www.diannerobbins.com/telos.html http://www.galacticmessages.com/blog/2010/07/telos-the-underground-city-of-mount-shasta-2/ http://lightworkers.org/blog/78455/telos-the-underground-city-of-mount-shasta

Description : Nodal analysis example 1

Last Answer : Nodal analysis example 1

Description : Sinusoids find amplitude, period, frequency, voltage (Problem 1)

Last Answer : Sinusoids find amplitude, period, frequency, voltage (Problem 1)

Description : Alternating voltages and phasors (Problem 1)

Last Answer : Alternating voltages and phasors (Problem 1)

Description : James May discovers the true source of the Nile. Will you take a few moments to celebrate this historic moment in historic history?

Last Answer : answer:Yes. I shall. I was going to say more, but I think it’s all done now,.

Description : Why Crystal Is A Preferred Clock Source?

Last Answer : Answer :Because of high stability, large Q (Quality Factor) & the frequency that doesn’t drift with aging. Crystal is used as a clock source most of the times.

Description : Nodal Analysis with Voltage Sources dependent voltage source and two supernode

Last Answer : Nodal Analysis with Voltage Sources dependent voltage source and two supernode

Description : Nodal analysis example with voltage source and supernode

Last Answer : Nodal analysis example with voltage source and supernode

Description : Source shifting problem solution

Last Answer : Source shifting problem solution

Description : Find power delivered by voltage source

Last Answer : Find power delivered by voltage source

Description : Nodal analysis problem two current source

Last Answer : Nodal analysis problem two current source

Description : A voltage source inverter will have better performance if its  (1) load inductance is small and source inductance is large.  (2) both load and source inductance are small.  (3) both load and source inductances are large.  (4) load inductance is large and source inductance is small. 

Last Answer : A voltage source inverter will have better performance if its load inductance is large and source inductance is small.