What are the disadvantages of Open loop control system?

1 Answer

Answer :

Open loop control system are less reliable.

In open loop control system Optimization is not possible.

Open loop control system are less accurate.

Related questions

Description : What are the advantages of open loop control system?

Last Answer : Open loop control system are simple to design. Open loop control system are generally stable.

Description : What will happen to the gain margin if the gain of the open loop system is doubled? A) Doubled B) Becomes half C) Is not affected D) Becomes one-fourth 

Last Answer : What will happen to the gain margin if the gain of the open loop system is doubled? A) Doubled B) Becomes half C) Is not affected D) Becomes one-fourth 

Description : If the gain of the open loop system is doubled, the gain margin  (1) Is not affected (2) Gets doubled (3) Becomes half (4) Becomes one -forth

Last Answer : If the gain of the open loop system is doubled, the gain margin Becomes half

Description : What is an example of an open loop system?

Last Answer : Open loop system. Ex. Electric heater, washing machine, fan, electric switch, etc

Description : what is open loop and close loop control system?

Last Answer : A) In open loop system the input is independent         of output but output is depends on input. A-1. no feedback path in open loop s/m    -2. less accuracy than close loop s/m. Ex. Washing ...    -3. high accuracy. Ex. Air conditioner ( AC ), rocket launcher, radar          system, etc

Description : What are some examples of a closed loop system?

Last Answer : C.L s/m. EX. Air conditioner (AC), rocket launcher, radar system, voltage stabilizer etc.

Description : What are advantages and disadvantages of Mechatronics system? 

Last Answer : Advantages of Mechatronics system:  High level of integration.  Increased functionality and better design.  More use of electronics and software instead of mechanical function.  Assumes ... Its replacement is difficult, that it is difficult to change old system to new system. 

Description : Negative feedback in a closed-loop control system DOES NOT (A) reduce the overall gain (B) reduce bandwidth (C) improve disturbance rejection (D) reduce sensitivity to parameter variation

Last Answer : Negative feedback in a closed-loop control system DOES NOT reduce bandwidth

Description : State advantages and disadvantages of radial distributor system. 

Last Answer : Advantages of radial distributor system: 1. Design of layout is simple. 2. Capital cost & Erecting cost is less as there is only one feeder. 3. Time required for completion of ... maintain supply to consumers when there is maintenance on feeder. 3. Voltage fluctuations are more.

Description : State any two commands for managing disk space and also state their use

Last Answer : There are primarily two commands that can be used for managing Disk space: 1. df 2. du 1. df - disk filesystem df command (short for disk filesystem) is used to show disk utilization ... the disk space used by files on a machine and crucial for disk space management on unix and linux systems.

Description : Draw the labeled block diagram of process control system and explain each block.

Last Answer : Explanation - Process control system consists of process or plant, sensor, error detector, automatic Controller, actuator or control element. 1) Process or plant- process means some manufacturing sequence ... process which changes the process variable. Output of this block is denoted by u .

Description : A control system having unit damping factor will give  (1) Oscillatory response (2) Undamped response (3) Critically damped response (4) No response

Last Answer : 1

Description : A differentiator is not usually used in control system, because it : - (A) reduces damping  (B) increases error  (C) reduces gain margin  (D) increases input noise

Last Answer : A differentiator is not usually used in control system, because it : - increases input noise

Description : A unity negative feedback control system is found to have a gain margin of 20 dB. The Nyquist plot of the system (A) crosses the real axis at +0.1 (B) crosses the real axis at -0.1. (C) crosses the imaginary axis at -0.1 (D) crosses the imaginary axis at +0.1

Last Answer : A unity negative feedback control system is found to have a gain margin of 20 dB. The Nyquist plot of the system crosses the real axis at -0.1.

Description : Problem number 6.30 from digital control and state variable methods by M Gopal (second edition)

Last Answer : Solution for 6.30​​​​​​

Description : (i) Bilateral Network (ii) Node (iii) Loop (iv) Branch

Last Answer : (i) Bilateral Network: If the characteristic of network (response or behavior) is independent of the direction of current through its elements in it, then the network is called as a bilateral network e. ... A part of an electric network which lies between two junctions or nodes is known as branch. 

Description : Write the application of the following antennas: 1) Rectangular antenna 2) Dish antenna 3) Horn antenna 4) Loop antenna 5) Yagi-Uda antenna. 

Last Answer : Applications:  1.Rectangular antenna  i)Used in Mobile and satellite communication ii)Used in Global Positioning System iii) Used for Radio Frequency Identification (RFID) iv) Radar  Dish ... antenna. 2. Yagi-Uda antenna is used in conditional Access System (CAS) at the decryptor.

Description : Explain how sinusoidal AC voltage is generated by using simple one loop generator.

Last Answer : An electric current produced by means of electrical machine is known as generator which converts mechanical energy into electrical energy. When conductor cuts the magnetic flux, emf induced in it. (Faraday' ... upon position of armature. The nature of emf is alternating as shown by the waveform. 

Description : Define- (i) Node (ii) Loop for a DC circuit

Last Answer : Ans: i) Node: A point or junction at which two or more elements of network are connected is called as node. ii) Loop: A closed path for flow of current in an electrical circuit is called loop.

Description : Explain the hysteresis loop of a magnetic material with neat diagram.

Last Answer : Hysteresis loop of magnetic material:  The circuit arrangement for plotting the hysteresis loop is shown in figure given below. The electromagnetic part consists of a coil wound on the iron ring ... one magnetic reversal is called hysteresis loop. Meaning of hysteresis is to lag behind.

Description :  The number of loop equations required to completely analysing a network comprising of 8 independent branches and 6 nodes including the reference node shall be A) 3 B) 2 C) 4 D) 5 

Last Answer :  The number of loop equations required to completely analysing a network comprising of 8 independent branches and 6 nodes including the reference node shall be 3 

Description : If the area of hysteresis loop of a material is large, the hysteresis loss in this material will be?

Last Answer : If the area of hysteresis loop of a material is large, the hysteresis loss in this material will be large.

Description : How to Loop a Powerpoint Slideshow ?

Last Answer : How to Loop a Powerpoint Slideshow Many conferences, presentations, and meetings tend to last quite a while, and you may need your visual cues to last a little longer. Instead of making ... and attendees occupied, entertained, and well-informed about the goals of your project or your report.

Description : The loop equation for a series RLC circuit gives

Last Answer : The loop equation for a series RLC circuit gives

Description : Which waves are demodulated by Costas loop? A) VSB B) SSB C) MSK D) DSBSC 

Last Answer : Which waves are demodulated by Costas loop? A) VSB B) SSB C) MSK D) DSBSC 

Last Answer : Murray loop test can be used for location of both the ground fault and the short-circuit fault.

Description : advantages and disadvantages of ICs.

Last Answer : Advantages of ICs: 1.The physical size of an IC is extremely small (generally thousand times smaller) than that of discrete circuits. 2. The weight of an IC is very less as compared to that of ... is high 3. Power dissipation is limited. 4. ICs are very delicate and need extra care while handling

Description : State advantages and disadvantages of fiber optic communication

Last Answer : Advantage of fiber optic communication: 1.Greater information capacity/ higher bandwidth OFC's are capable of transmitting several gigabits per second over hundreds of miles allowing millions of ... are not flexible 7.Requiring more protection around the fiber cable compared with copper cable

Description : State advantages and disadvantages of continuous wave Radar

Last Answer : Advantages continuous wave RADAR : 1.Single frequency transmission and hence narrow receiver bandwidth 2.Duty cycle is unity, so mean power can be as high as transmitters will permits. 3.Ability ... required for receiver and transmitter. 3.Cannot detect targets crossing its beam at right angles.

Description : State advantages & disadvantages of electromagnetic flow meter.

Last Answer : Advantage: Provides wide linear range. 2) Ability to measure reverses flow. 3) Gives rapid response to flow changes. 4) No obstruction is created to flow. 5) It can handle corrosive as ... and pipe networks with relatively short inside diameters. 3) It is useful for electrically conducting fluid.

Description : State the advantages and disadvantages of hydroelectric power plant.

Last Answer : Advantages of Hydroelectric power plant:-  1. There is no air pollution and other environmental problems. 2. The fuel (water) is available freely. 3. No fuel transportation cost so; there is ... , this can force the relocation of large numbers of riverside cities, towns, villages & people.

Description : State any two advantages and two disadvantages of nuclear power plant.

Last Answer : Disadvantages of Nuclear Power Plant: -   1. The capital cost of Nuclear power plant is very high as compare to other power plant of same capacity. 2. The erection & ... material could be released into the environment. Causing extensive damage to the mankind,animals and environment.

Description : State any four advantages and four disadvantages of diesel electric power plant. 

Last Answer : Advantages of Diesel electric power plant:- 1) The design and layout of Diesel electric power plant is simple. 2) It requires less space. 3) Time required for complete erection of diesel power plant is less ... . 9) The useful life is very short. 10) Availability of fuel in future may be limited.

Description : Write any four advantages and four disadvantages of thermal power plant.

Last Answer : .embed-container { position: relative; padding-bottom: 56.25%; height: 0; overflow: hidden; max-width: 100%; } .embed-container iframe, .embed-container object, .embed-container embed { position: absolute; top: 0; left: 0; width: 100%; height: 100%; }

Description : Write any two disadvantages of hydro power plant.

Last Answer : Disadvantages of hydro power plant: i) Due to high cost of civil engineering works, the capital cost per kW of hydro plants is considerably higher than that of steam plants. ii) Hydro ... ) Hydro plant reservoir submerges huge areas, uproots large population and creates social and other problems. 

Description : Write any two disadvantages of ammeter shunts.

Last Answer : Disadvantages of ammeter shunts: 1. Errors are caused because of change in temperature. 2. Most suitable for DC measurement. 3. Power loss takes place.

Description : State any two disadvantages of one wattmeter method of measurement of 3 phase power.

Last Answer : State any two disadvantages of one wattmeter method of measurement of 3 phase power. Disadvantages of one wattmeter method:- 1. Only used for balanced load 2. It can not be used for ... connection then neutral point must be available 4. Delta connection must be opened to connect current coil.

Description : Write advantages and disadvantages of positive and negative feedback.

Last Answer : Advantages of Positive Feedback: i) Voltage gain increases. ii) No phase shift is provided. iii) Feedback signal and input signal are in phase. iv) Input and Output voltage increases.  ... ii) Feedback signal and input signal are out of phase. iii) Input and Output voltage decreases.

Description : Describe the difference between an open circuit and a short circuit.

Last Answer : Open circuit means the wire is cut meaning power will not flow and close circuit means wire is not cut and hence power will flow.Short circuit is the same as close circuit

Description : Why CT is never operated with an open secondary ?

Last Answer : CT secondary should never be kept open because it will cause saturation of the core to a high level and very high voltage will appear across the secondary which can breakdown the insulation. One terminal of PT secondary is always grounded to avoid capacitive induction and for human safety

Description : A d.c. source has an open circuit voltage of 30 V and an internal resistance of 1.5 Ohm. A resistive load is connected to the source. Maximum power dissipated in the load is (A) 300 W (B) 150 W (C) 45 W (D) 20 W

Last Answer : A d.c. source has an open circuit voltage of 30 V and an internal resistance of 1.5 Ohm. A resistive load is connected to the source. Maximum power dissipated in the load is 150 W

Last Answer : Primary side is low voltage side and secondary side is high voltage side.

Description :  State the disadvantages of skin effect.

Last Answer : Disadvantages of skin effect:- 1. Full cross section of conductor is not utilized, Therefore effective area of conductor reduces so its resistance increases. 2. Due to increase in resistance, copper ... increases (Since Voltage drop = IR ) 5. So voltage regulation becomes poor (increases) 

Description : List advantages and disadvantages of MEMS.

Last Answer : Advantages : 1. Batch fabrication and hence reduced cost. 2. Reduced size and reduced power ( due to pin size and reduced package volume) 3. High precision and resolution. 4. Reduced ... cannot be loaded with large forces because brittle materials can be fractured easily under high stress.  

Description : The main disadvantages of having poor power factors are:  (A) High cost of station and distribution equipment (B) Poor voltage regulation (C) High energy loss in conductor (D) All of the above

Last Answer : The main disadvantages of having poor power factors are:  (A) High cost of station and distribution equipment (B) Poor voltage regulation (C) High energy loss in conductor (D) All of the above

Description : Explain the advantages and disadvantages of using memory I/O and standard I/O.

Last Answer : Memory mapped I/O and standard I/O are the two methods for communicating microprocessor with peripherals. Processor talks to both memory and peripheral using the same bus.Two ways to talk to a peripheral. ... of standard I/O is no loss of memory addresses to the use as I/O addresses.

Description : What are the disadvantages of the linear regulator? how are they overcome in the switching regulator? What is continuous and discontinuous mode switching regulator?

Last Answer : Disadvantages of the linear regulator: Linear regulator waste power in the form of heat. Linear regulator has very low efficiency. Linear regulator cannot be used for the step ... between continuous mode and discontinuous mode switching regulator.

Description : What are the advantages and disadvantages of tidal power?

Last Answer : Free of costPollution freeLong life Less maintenance

Description : What are the advantages and disadvantages of wave energy?

Last Answer : AdvantagesFree from pollutionAvailable for every timeThe water can reuse as drinking purposeDisadvantageMore costLarge maintenanceDifficult to constructAquatic life get affected