State advantages of Pulverized coal w.r.t. thermal power plant. 

1 Answer

Answer :

Advantages of Pulverized coal w.r.t. thermal power plant. 

1. Due to pulvarization amount of fuel required to produce same amount of heat reduces. 2. Time required for combution reduces 3. It gives more heating surface aera. 4. High temperature can be produce in furnace. 5. Due to pulvarizing low grade coal can be burn easily. 6. It requires low air pressure. 7. Efficiency of fuel incrases. 8. Firing of pulvarized coal is easy. 9. Ash produces quantity reduces. 10. The requirement of air for complete combustion is reduced, because of the increased surface area per unit mass of coal. 11. The firing can be controlled to match the load requirements. 12. Rapid and efficient starting of the boilers from cold. 13. The ash-handling problems are reduced to a minimum, i.e., practically there are no ash-handling problems. 14. Less furnace volume. 15. Because of the smaller requirement of air and thorough mixing of air and fuel, very high-combustion temperatures can be attained.

Related questions

Description : Write any four advantages and four disadvantages of thermal power plant.

Last Answer : .embed-container { position: relative; padding-bottom: 56.25%; height: 0; overflow: hidden; max-width: 100%; } .embed-container iframe, .embed-container object, .embed-container embed { position: absolute; top: 0; left: 0; width: 100%; height: 100%; }

Description : State the function of super heater of a thermal power plant. 

Last Answer : Function of Super heater: -  Its function is to increase the temperature of steam by absorbing heat from exhausted hot flue gases.

Description : Explain ash disposal and dust collection in a thermal power plant.

Last Answer : Ash disposal:-  Various methods of disposal of ash are:  Mechanical handling system.  Pneumatic system. Hydraulic system  Steam jet system  Commonly used ash handling ... be done either manually or automatically.  This removed fly ash is collected in separate container

Description : The overall efficiency of Thermal Power Plant is equal to _______________ .  (A) Regenerative Cycle Efficiency (B) Renkine Cycle Efficiency (C) Carnot cycle efficiency (D) None of the above

Last Answer : The overall efficiency of Thermal Power Plant is equal to Regenerative Cycle Efficiency. 

Description : In a thermal power plant, ash is collected in

Last Answer : In a thermal power plant, ash is collected in hoppers or bunkers

Description : State the advantages and disadvantages of hydroelectric power plant.

Last Answer : Advantages of Hydroelectric power plant:-  1. There is no air pollution and other environmental problems. 2. The fuel (water) is available freely. 3. No fuel transportation cost so; there is ... , this can force the relocation of large numbers of riverside cities, towns, villages & people.

Description : State any two advantages and two disadvantages of nuclear power plant.

Last Answer : Disadvantages of Nuclear Power Plant: -   1. The capital cost of Nuclear power plant is very high as compare to other power plant of same capacity. 2. The erection & ... material could be released into the environment. Causing extensive damage to the mankind,animals and environment.

Description : State any four advantages and four disadvantages of diesel electric power plant. 

Last Answer : Advantages of Diesel electric power plant:- 1) The design and layout of Diesel electric power plant is simple. 2) It requires less space. 3) Time required for complete erection of diesel power plant is less ... . 9) The useful life is very short. 10) Availability of fuel in future may be limited.

Description : State the function of cooling tower and condenser in thermal power station.

Last Answer : 1. Condenser:   Function of condenser is to convert exhaust steam again into water by reducing its temperature with the help of cold water. Also it reduces back pressure of steam turbine 2 ... tower : The function of cooling tower is to reduce the temperature of water coming from condenser.

Description : State any four factors governing Selection of site for thermal power station. 

Last Answer : Following Factors are to be considered:- 1. It should locate near coal mine. 2. Sufficient quantity of water should be available. 3. Sufficient large space should be available. 4. It should be located ... laws of the land and the town planning. 14. The interests of national defense must be served.

Description : Classify condensers used in thermal power station. Explain each type in brief. 

Last Answer : Types of condenser: Classification: 1. Jet Condenser (Mixing Type) 2. Surface condenser (non Mixing type)  Explanation:-   1. Jet Condenser (Mixing Type) In Jet condenser the steam ... there in no direct contact between the steam and cooling water. This condensate is reused in boiler. 

Description : "Efficiency of thermal power station is low". — Justify. 

Last Answer : Justification: Efficiency of thermal power station is low":- Overall efficiency of T.P.P depends upon efficiency of boiler, turbine and alternator. The heat produced due to combustion of coal ... losses in thermal power plant is 71%, So efficiency of thermal power plant is less about 29% 

Description : The unit heat rate characteristic of a thermal power unit shows :  (A) Heat input per kWh of output versus the megawatt output of unit  (B) Heat input per kW of output versus the megawatt output ... hour output of unit  (D) Heat input per kW of output versus the megawatt hour output of unit

Last Answer : The unit heat rate characteristic of a thermal power unit shows : Heat input per kWh of output versus the megawatt output of unit 

Description : Write any four advantages of hydropower plant.

Last Answer : Advantages of hydropower plant: 1. There is no air pollution and other environmental problems. 2. The material means of power generation (water) is available freely. 3. No fuel transportation cost so; hence there ... of a Thermal / Nuclear /Diesel Power P. 19. It is very neat & clean plant.

Description : State two advantages of interconnection of power stations. 

Last Answer : 1) Due to interconnection it is possible of wheeling of electricity instantly.  2) The reliability and continuity of the supply is improved with interconnected grid system. With fault ... interconnection, there is optimum utilization of available natural recourses in the country is possible. 

Description : Write down any two advantages of nuclear power station.

Last Answer : Advantages of nuclear power station :-  1) Fuel required: Fuel requirment of Nuclear Power Plant is less than Thermal Power Plant. So it reduces transportation cost of fuel and space required for fuel storage ... By use of nuclear fuel.,it saves the other fossile fuels like-coal, gas, oil, etc.

Description : What are the advantages and disadvantages of tidal power?

Last Answer : Free of costPollution freeLong life Less maintenance

Description : What are the advantages of hydroelectric power?

Last Answer : It is free from pollution It requires less labour to supervision Here water can use again and again

Description : Write the purpose of coal and ash handling unit. Also write different activities that arc carried out in this unit.

Last Answer : Purpose of coal and ash handling unit :-  To transport coal from coal storage to power plant. A large quantity of ash about 10 to 30 % produced in furnace, the removal of ash from boiler furnace ... disposed off.  Various methods of disposal of ash:  Mechanical system.  Pneumatic system.

Description : The problematic pollutants in emission of coal based generating plants __________.  (A) SO₂ (B) NOx (C) CO (D) All of the above

Last Answer : The problematic pollutants in emission of coal based generating plants __________.  (A) SO₂ (B) NOx (C) CO (D) All of the above

Last Answer : In case of a steam engine an average coal consumption per km is nearly 28 to 30 kg.

Description : State elements of diesel electric power plant with their functions. 

Last Answer : Elements of Diesel Power Plant with their function):   1) Diesel Engine: - This is the main component of the P.P. which develops mechanical power. 2) Engine air intake system: - Air ... fuel as per requirement. 10) Alternator: - Its function is to convert mechanical power into electrical power.

Description : State why nuclear power plants are used as base load plants and diesel power plants as a peak load plant. 

Last Answer : 1. Because of following points Nuclear power plant used as base load power plant:-  1. Nuclear power plants is very economical for producing bulk amount of electric power 2. Nuclear power plant is reliable ... . The plants can be put on load easily. 4. Diesel engines take less time to make OFF.

Description : State any four factors for selection of hydro power plant site. 

Last Answer : Following Factors to be kept while site selecting for Hydro power plant: 1) Quantity of water available :-Where high rainfall occures so that sufficent quantity of water can be stored for generation of ... be possible to divert the stream. 11. Sand, gravel, etc., should be available nearby.

Description : State the different types of engines in diesel power plant.

Last Answer : Types of engines in diesel power plant: 1) Two Stroke Diesel Engine 2) Four Stroke Diesel Engine

Description : State any four factors for selection of site of wind power plant.

Last Answer : The Factors for selection of site for Wind Mills: 1) The site should be selected where winds are strong i.e. where pressure of wind is high and there is continuity (14.4- 16.2 km/h) ... 50m of the turbine which can affect the system's overall performance 10)Possibility to connect to power grid. 

Description : State any four factors for selecting location of nuclear power plant.

Last Answer : i) Seismicity: If the area of a nuclear site is seismically active, it may not be used for nuclear power plant.  ii) Water Availability: The nuclear power plants would need a ... Therefore, the site selected for such plant should have adequate arrangement for the disposal of radioactive waste.

Description : What are the basic requirements of locating wind power plant ?

Last Answer : The basic requirements of locating wind power plant:  1) The site should be selected where winds are strong i.e. where pressure of wind is high and there is continuity. 2) Wind pressure ... the turbine which can affect the system's overall performance. 10)Possibility to connect to power grid. 

Description : Explain the nuclear chain reaction in a nuclear power plant.

Last Answer : Nuclear chain reaction in a nuclear power plant: If a slow moving neutron hits unstable heavy nucleus of nuclear fuel U235 or Pu239 , the neutron is absorbed, the nucleus splits into two more ... chain reaction can be controlled and desired heat energy can be obtained in nuclear power plant. 

Description : Explain starting system in diesel electric power plant.

Last Answer : Starting system in Diesel Electric Power Plant: It includes Storage battery, compressed air tanks, self-starter etc. The purpose of engine starting system is to rotate the engine initially while ... as Ammeters, Voltmeters, Wattmeters, Thermometers, Pressure gauges, Visible and audible alarm etc.

Description : Explain the procedure for disposal of nuclear power plant.

Last Answer : Disposal of nuclear waste: The waste products by nuclear fission may be solid, liquid or gas. i) Solid harmful disposals are packaged as required and shipped to a burial site for disposal. ii) Liquids ... and tested. If the required limits are met, these will be released to atmosphere. 

Description : Explain fuel system and air intake system in diesel electric power plant.

Last Answer : Fuel system and air intake system in diesel electric power plant :  Fuel system: It consists of storage tank, strainers, fuel transfer pump and all day fuel tank. The fuel oil is supplied ... Filters are provided to remove dust particles from air which may act as abrasive in the engine cylinder.

Description : Write any two disadvantages of hydro power plant.

Last Answer : Disadvantages of hydro power plant: i) Due to high cost of civil engineering works, the capital cost per kW of hydro plants is considerably higher than that of steam plants. ii) Hydro ... ) Hydro plant reservoir submerges huge areas, uproots large population and creates social and other problems. 

Description : List out the four applications of diesel electric power plant.

Last Answer : Applications of Diesel Power Plant: 1. It can be used as a standby (emergency) power plant to maintain continuity of supply. (Incase failure of main supply like hospital, Telephone exchange Radio stations, ... 10. Diesel plants are widely used for generating power ranging from 100 to 5,000 H.P.

Description : Distinguish between fire tube and water tube boilers in steam power plant.

Last Answer : Fire Tube boiler Water Tube boiler In fire tube boilers hot gases are passed through the tubes and water surrounds these tubes. In these boilers water is inside the tubes and hot gases are ... risk of explosion due to low pressure. Risk of explosion is more due to high pressure.

Description : Write function of control rods in nuclear power plant.

Last Answer : Function of control rods in nuclear power plant: The function of control rod is to control the chain reaction in reactor core by adjusting its height.

Last Answer : A power plant usally works on Rankine Cycle.

Description : What are the criteria for selection of site for hydroelectric power plant?

Last Answer : Following Factors to be kept while site selecting for Hydro power plant:  1. It should be located where high rain fall occurs. 2. A large catchments area must be available to store water. 3. It ... 12. Cost of land should be less. 13. Skilled and unskilled man power should be available nearby.

Description : Explain the function of different parts of a typical nuclear power plant with neat sketch. 

Last Answer : Functions of each part of Nuclear power plant:-  1) Nuclear Reactor: In nuclear reactor the fuel rod of U235 is placed through which tremendous amount of heat energy is ... is mechanically coupled with steam turbine. 8) Alternator: It converts mechanical energy into electrical energy.

Description : With a neat diagram explain pumped storage hydro power plant. 

Last Answer : Diagram of pumped storage hydro power plant: Explanation: In this power plant, generator is so designed that it Converts mechanical power into electrical power and also works as a ... helps in reducing a reserve capacity of PP as it provides additional power during peak load period. 

Description : Draw a layout of a thermo-chemical based power plant. 

Last Answer : Layout of a thermo-chemical based power plant:  In this process dry biomass fuels converted to produce gas ,liquid fuels or oil by thermo chemical conversion Thermo-Chemical conversion are of following ways:- 1. Direct combustion 2. Gasification 3. Pyrolysis

Description : With a neat diagram explain solar photovoltaic power plant. 

Last Answer : Diagram of solar photovoltaic power plant :  Explanation:  Solar power plant consists of following components:  1. Photovoltaic cell panel: Its function is to convert sunrays directly into DC ... .  5. Step-up transformer: It step-up input voltage to utilization voltage e.g. 230V

Last Answer : Because of following advantages concentrating type collector are used in solar power plant: -  1. Temperature: Temperature obtained is high because absorber area is less and collector/reflector area ... results: As tracking system is used better results are obtain than flat type collector.

Description : List the types of turbine used in hydro power plant.  

Last Answer : Following types of turbine used in hydro power plant:  1.Pelton wheel 2.Francis Turbine 3.Kaplan Turbine 4.Propeller Turbine 

Description : The capital cost of a power plant depends on  (1) Total installed capacity only. (2) Total number of units only. (3) Total installed capacity and number of units as well. (4) Neither the installed capacity nor number of units

Last Answer : The capital cost of a power plant depends on Total installed capacity and number of units as well.

Description : The rankine cycle efficiency of steam power plant is  (1) 60-80% (3) 30-45% (2) 45-80% (4) 20-30%

Last Answer : The rankine cycle efficiency of steam power plant is 30-45%

Last Answer : In a power plant if the maximum demand on the plant is equal to the plant capacity, then plant reserve capacity will be zero.

Last Answer : Maximum demand on a power plant is the greatest of all "short time interval averaged" demand during a period.

Last Answer : Annual operating expenditure of a power plant consists of fixed charges, semi-fixed charges, running charges.