why reactive ohm cannot converted electrical energy into heat?

2 Answers

Answer :

It can convert but it less than other loads. Main purpose of reactive loads are to hold energy, it's not consume.


Answer :

Because it describes the resistance of element that store energy rather than dissipate energy as heat

Related questions

Description : International ohm is defined in terms of the resistance of?

Last Answer : International ohm is defined in terms of the resistance of a column of mercury.

Description : If a wire conductor of 0.2 ohm resistance is doubled in length, its resistance becomes?

Last Answer : If a wire conductor of 0.2 ohm resistance is doubled in length, its resistance becomes 0.4 ohm.

Description : Explain the term reactive power. Why it is sometimes essential to measure reactive power?

Last Answer : Reactive power: The reactive power (Q) is defined as the product of voltage(V), current (I) and sine of angle between voltage(V) and current( I) Therefore Reactive power Q = V I ... power so that corrective measures can be taken accordingly to maintain systems power factor near to the unity.

Description : List any two methods of reactive power measurement in 3 phase circuit.

Last Answer : Methods of reactive power measurement in 3 phase circuit: (i) Two single phase wattmeter method (ii) One single phase wattmeter method

Description : what are the importance of reactive power?

Last Answer : Importance of Reactive Power  Voltage level control is important In power system. Varying reactive power will vary voltage level. Reactive power is directly proportional to ... power for useful work. Reactive power is required to generate magnetic flux.

Description : Use Voltmeter, ammeter, wattmeter to determine active, reactive and apparent power consumed in given R-L series circuit, draw phasor diagram.

Last Answer : Practical Significance In the industry environment Electrical Engineering diploma graduate are expected to measure basic parameters like voltage, frequency, time period etc. for R-L series circuits. Therefore ... /varying L. 7. Draw the phasor diagram for each of reading for verification.

Description : Precise control of reactive current flow entering the transmission and distribution systems can be minimized by using (A) synchronous condenser (B) static VAR capacitor (C) capacitor bank (D) thyristor switched reactor in parallel with capacitor

Last Answer : Precise control of reactive current flow entering the transmission and distribution systems can be minimized by using (A) synchronous condenser (B) static VAR capacitor (C) capacitor bank (D) thyristor switched reactor in parallel with capacitor

Description : The reactive power transfer over a line mainly depends on

Last Answer : The reactive power transfer over a line mainly depends on lVsl- lVRl

Description : What is the formula for reactive power?

Last Answer : The formula for reactive power is, Reactive power = VI sin (phi) The unit of reactive power is VAR ( Volt ampere reactive). The reactive power is denoted by 'Q'. The formula for real power is, Real power = VI cos (phi) The unit of real power is watts. The real power is denoted by 'P'.

Description : The reactive power drawn by a motor from an AC generator is the power which is _____________. A. used to establish the magnetic field of the motor B. lost in overcoming friction in the ... by current flow through the windings D. transmitted directly through the rotor shaft to perform useful work

Last Answer : Answer: A

Description : When an alternating current passes through an ohmic resistance the electrical power converted into heat is?

Last Answer : When an alternating current passes through an ohmic resistance the electrical power converted into heat is true power.

Description : In a photocell light energy is converted into – (1) Potential energy (2) Chemical energy (3) Heat energy (4) Electrical energy

Last Answer : (4) Electrical energy Explanation: Photocells are scientifically known as photo-resistors. A photo-resistor or light dependent resistor (LDR) is a resistor whose resistance decreases with increasing ... by the semiconductor give bound electrons enough energy to jump into the conduction band.

Description : Heat energy is converted into electrical energy a. solar cells b. thermocouples c. electric generators d. none

Last Answer : b. thermocouples

Description : In a photocell light energy is converted into (1) potential energy (2) chemical energy (3) heat energy (4) electrical energy

Last Answer : electrical energy

Description : A milli voltmeter of 25 milli volt range is to be converted into an ammeter of 25 ampere range. The value (in ohm) of necessary shunt will be

Last Answer : A milli voltmeter of 25 milli volt range is to be converted into an ammeter of 25 ampere range. The value (in ohm) ... 001` B. `0.01` C. 1 D. `0.05`

Description : When brakes are applied on a moving vehicle the kinetic energy is converted to A. Mechanical energy B. Heat energy C. Electrical energy D. Potential energy

Last Answer : B. Heat energy

Description : Electrical energy is converted to heat at the rate of a. IRt b. I 2R c. I 2Rt d. VIt

Last Answer : b. I 2R

Description : In fuel cell the __________ energy is converted into electrical energy.  (A) Mechanical (B) Chemical (C) Heat (D) Sound

Last Answer : In fuel cell the Chemical energy is converted into electrical energy. 

Description : Pick out the wrong statement. (A) 'Green acid' is the other name of phosphoric acid produced by the reaction of phosphate rock & sulphuric acid (B) Chemically unreactive nature of ... in the manufacture of safety matches, is converted into white phosphorous by vaporisation followed by condensation

Last Answer : (C) Red phosphorous is the most reactive allotropic form of phosphorous

Description : Which of the following statements are true? i) reactive current is necessary to build up the flux for the magnetic field of inductive devices ii) some portion of reactive current is converted into work iii) the cosine of angle ... called power factor a) i & iv b) ii & iii c) i & iii d) iii & iv

Last Answer : a) i & iv

Description : By which device mechanical energy is converted into electrical energy? -General Knowledge

Last Answer : Dynamo The device used to convert mechanical energy into electrical energy is called Dynamo.

Description : In the drill electrical energy is converted into?

Last Answer : Kinetic energy.

Description : What three related electrical factors did George Ohm investigate?

Last Answer : the answer is current, voltage, and resistance

Description : How can Ohm law be used to calculate the electrical resistance of a piece of wire?

Last Answer : Ohm's law establishes the relationship between the current flowing in a conductor (represented by I), the potential difference across the two ends of the conductor (represented by P), and the resistance offered ... all materials. This is not true, as it only applies to 'linear' or 'ohmic' materials.

Description : What is unit of Electrical Capacity? (1) henry (2) farad (3) volt (4) ohm

Last Answer : (2) farad Explanation: Henry is unit of Magnetic Induction, volt is unit of Potential Difference, ohm is unit of Electric Resistance.

Description : The unit of electrical resistance is the _____________. A. ampere B. volt C. watt D. ohm

Last Answer : Answer: D

Description : Electrical conductivities of semi-conductors are of the order of __________ ohm/cm. (A) 10-3 (B) 103 (C) 10-15 (D) 1015

Last Answer : OptionA

Description : The potential difference across a 4 ohm resistor is 20 volts. Assuming that all of the energy dissipated by this resistor is in the form of heat, how many joules of heat are radiated in 10 seconds?  

Last Answer : ANSWER: 1000 JOULES

Description : Complete maintenance of electrical motors should include periodic checks for machine _____________. A. vibration B. watertight integrity C. speed droop D. reactive power

Last Answer : Answer: A

Description : The energy consumed by an AC motor, as strictly reactive power, is _____________. A. used to do mechanical work B. used to establish the magnetic field of the motor C. lost as heat generated by the windings D. lost in doing work to turn the motor itself

Last Answer : Answer: B

Description : Three resistors of resistance R are connected in various ways, which of the following cannot be obtained? a. 3R ohm b. 2R/4 ohm c. R/3 ohm d. 2R/3 ohm

Last Answer : b. 2R/4 ohm

Description : The principle that energy may be converted from one form to another but it cannot be either created or destroyed is: w) First Law of Thermodynamics. x) Second Law of Thermodynamics. y) Third Law of Thermodynamics. z) Principle of photoelectricity.

Last Answer : ANSWER: W -- FIRST LAW OF THERMODYNAMICS.

Description : What converts electrical energy into heat energy?

Last Answer : High  resistance  conductor  which  will  dessipate  heat  energy  in  form  of  (I^2R)

Description : What energy is converted into heat energy when heat is applied at the junction of two different metals ?

Last Answer : When heat is applied at the junction of two different metals, heat energy is converted into electrical energy.

Description : The temperature of water at the bottom of a large waterfall is higher than that of the water at the top, because - (1) the falling water absorbs heat from the Sun. (2) the water at the bottom has ... of the falling water is converted into heat. (4) rocks on the bed of the river give out heat.

Last Answer : (3) the kinetic energy of the falling water is converted into heat. Explanation: The water gains kinetic energy as it falls down and loses its potential energy. Assuming no other losses, part of the kinetic energy gain of water is converted into heat, raising the temperature of water.

Description : How is solar energy converted into heat energy?

Last Answer : Solar energy falling on the surface of the earth is converted into thermal energy. The heat generated is stored in solar collectors. It is used for purposes like heating of water and cooking of food.

Description : Boiler efficiency is a measure of how effectively _______ energy in fuel is converted into heat energy in steam going to the turbines A Chemical energy B Heat energy C Thermal energy D All of the above

Last Answer : A Chemical energy

Description : A block of wood initially at rest slides down an inclined plane. Neglecting friction, the kinetic energy of the block at the bottom of the plane is: w) all converted into heat x) equal to its ... kinetic energy at the top of the plane z) dependant on the materials of which the block is made 

Last Answer : ANSWER: X -- EQUAL TO ITS POTENTIAL ENERGY (WITH RESPECT TO THE BOTTOM OF PLANE) WHEN IT WAS AT THE TOP OF THE PLANE.

Description : The temperature of water at the bottom of a large waterfall is higher than that of the water at the top. because (1) the falling water absorbs heat from the Sun. (2) the water at the bottom has greater ... of the falling water is converted into heat. (4) rocks on the bed of the river give out heat.

Last Answer : the kinetic energy of the falling water is converted into heat.

Description : Which file format cannot be converted into STL file format? a..prt b..sld c..dwg d..stp

Last Answer : c..dwg

Description : A voltmeter of range 2 V and resistance `300 Omega` cannot be converted into ammeter of range

Last Answer : A voltmeter of range 2 V and resistance `300 Omega` cannot be converted into ammeter of range A. `1 A` B. `1 mA` C. `100 mA` D. `10 mA`

Description : Glucose-1-phosphate liberated from glycogen cannot be converted into free glucose in (A) Liver (B) Kidneys (C) Muscles (D) Brain

Last Answer : Answer : C

Description : All the following statements about phenylketonuria are correct except (A) Phenylalanine cannot be converted into tyrosine (B) Urinary excretion of phenylpyruvate and phenyllactate is increased (C) It ... diet (D) It leads to decreased synthesis of thyroid hormones, catecholamines and melanin

Last Answer : Answer : D

Description : Fatty acids cannot be converted into carbohydrates in the body as the following reaction is not possible. (A) Conversion of glucose-6-phosphate into glucose (B) Fructose 1,6-bisphosphate to fructose- ... (C) Transformation of acetyl CoA to pyruvate (D) Formation of acetyl CoA from fatty acids

Last Answer : C

Description : Which one of the following statements is false ? (A) A Demat Share' is held by the depository on behalf of the investor whereas a Physical Share' is held by the investor himself (B) There is no ... number like a Physical Share' (D) The Demat Share' cannot be converted into a Physical Share'

Last Answer : Answer: The ‘Demat Share’ cannot be converted into a ‘Physical Share’

Description : In the conversion of line integral of H into surface integral, which theorem is used? a) Green theorem b) Gauss theorem c) Stokes theore d) It cannot be converted

Last Answer : c) Stokes theorem

Description : An intangible asset a. does not have physical substance, yet often is very valuable. b. is worthless because it has no physical substance. c. is converted into a tangible asset during the operating cycle. d. cannot be classified on the balance sheet because it lacks physical substance.

Last Answer : a. does not have physical substance, yet often is very valuable.

Description : Who shows that heat is a kind of energy and can be converted ?

Last Answer : In 1798 , scientist Count Rumford showed the subject.

Description : The first law of thermodynamics may be expressed in the following equivalent  a. the net heat transfer id equal to the network  b. the sum of the total energy forms leaving the system boundary is ... neither be created nor destroyed but only converted from one form to another  d. all of the above

Last Answer : all of the above