# Even at no-load, a transformer draws current from the mains. Why?

Even at no-load, a transformer draws current from the mains. Why?

118 views

## Related Questions

Why does the speed of a DC shunt motor decrease as the load increases?
Last Answer : Because if the load is increasing then the torque must also be increase. If not then the speed of motor will decrease. Explain why potential difference is necessary to produce current in a circuit. A charge of 0.1 C moves past a given point every 0.01 s. How much is the current?
Last Answer : The current is 10.0A.  1ampere = 1 Coulomb per 1 second.  0.1Coulombs ÷ 0.01seconds = 10.0amperes. A no-load test is performed on a transformer to determine?
Last Answer : A no-load test is performed on a transformer to determine magnetizing current and loss. Define armature reaction in an alternator. Explain the effect of armature reaction at various P.F. of loads of alternator.
Last Answer : Armature Reaction: The effect of armature flux on main flux is called as armature reaction.  Armature Reaction at Various Power Factors: When armature is loaded, the armature flux modifies ... lagging p.f. For capacitive loads the effect of flux is partly distorting and partly strengthening. For a transformer, operating at constant load current, maximum efficiency will occur at?
Last Answer : For a transformer, operating at constant load current, maximum efficiency will occur at unity power factor. In a step-down transformer, there is a change of 15 A in the load current. This results in change of supply current of?
Last Answer : In a step-down transformer, there is a change of 15 A in the load current. This results in change of supply current of less than 15A. Explain Briefing the half yearly schedule maintenance of OH mains?
Last Answer : Ans. "(a) Check all the jumper connections (b) Check any connections of the strands of the conductor (c ) Check and ensure proper earth connection (d) Check proper fixation of insulators, stay wires, guard wires, etc. (e) Check proper tensioning and connection of service wires." When secondary of a current transformer is open-circuited its iron core will be?
Last Answer : When secondary of a current transformer is open-circuited its iron core will be hot because of heavy iron losses taking place in it due to high flux density. The secondary of a current transformer is always short-circuited under operating conditions because it?
Last Answer : The secondary of a current transformer is always short-circuited under operating conditions because it avoids core saturation and high voltage induction. With a neat sketch give the working of shaded pole induction motor.
Last Answer : Explanation: It has squirrel cage rotor and salient pole stator. The stator poles are shaded partially by short circuited conductor band to create the phase difference between the fluxes emerging from shaded ... rotating magnetic field in the air-gap and torque is exerted on the squirrel cage rotor. A parallel RLC circuit has the node equation Determine v(t) using the phasor method.
Last Answer : A parallel RLC circuit has the node equation Determine v(t) using the phasor method. The loop equation for a series RLC circuit gives
Last Answer : The loop equation for a series RLC circuit gives Source transformation Replace the circuit with voltage source in series with a single resistor
Last Answer : Source transformation Replace the circuit with voltage source in series with a single resistor Briefly define each of the following: (a) 1 coulomb (b) 1 volt (c) 1 ampere (d) 1 ohm. Briefly describe the electric field of a static charge. Is the power line voltage available in our homes a dc or an ac voltage?
Last Answer : The power line voltage available in our homes is AC. Mobile dwellings are the most commonly DC-supplied homes and even then they tend to include AC supply for heavier loads. Describe the difference between an open circuit and a short circuit.
Last Answer : Open circuit means the wire is cut meaning power will not flow and close circuit means wire is not cut and hence power will flow.Short circuit is the same as close circuit How does the resistance of a conductor compare to that of an insulator?
Last Answer : The resistance of a conductor can be significantly lower than the resistance of an insulator, depending on each material's atomic properties. What is the smallest unit of a compound with the same chemical characteristics?
Last Answer : The molecule is the smallest unit of a compound with the same chemical characteristics. Why inductor current lags inductor voltage ?
Last Answer : Inductor is a wire wounding structure having a core material it induces emf which is opposite to the voltage supply and proportional to rate of change of current so current lags the voltage in inductor The inrush current of a transformer at no load is maximum if the supply voltage is switched on  (1) at peak voltage value (2) at zero voltage value (3) at half voltage value (4) at 0.866 time voltage value
Last Answer : At 0.866 time voltage value What are even and odd harmonics? Analyze the effect of supply voltage on performance of LED as regards current, Lumen output, efficacy and life.
Last Answer : 1) Effect on Current:- In LED current depends upon supply voltage, if voltage get changes then current also change but this change in current will be control by resistors which are connected in series.  2) ...   4) Effect on Life:- If supply voltage is not stable then life of LED get reduced. With the help of N-channel JFET describe the effect of input voltage VGS on output current ID.
Last Answer : Working of N channel FET: * When a voltage is applied between the drain and source with a DC supply (VDD), the electrons flows from source to drain through narrow channel ... where the channel gets completely blocked and the drain current becomes zero is called pinch- off voltage. Find the current through 4 ohm resistor by source transformation The operating point of a protective current transformer is near the
Last Answer : The operating point of a protective current transformer is near the Ankle point Step-down transformer converts high voltage and low current into:  (A) How voltage and high current (B) High voltage and low current (C) Low voltage and high current (D) None of the above
Last Answer : Step-down transformer converts high voltage and low current into: Low voltage and high current In a single-phase transformer, the magnetizing current is (A) in phase with the no-load current (B) in quadrature with the no-load current (C) the product of no-load current and power factor (D) in phase with the flux in the core
Last Answer : In a single-phase transformer, the magnetizing current is in phase with the flux in the core Last Answer : The inverse definite mean time relays are used for over current and earth fault protection of transformer against internal short-circuits. How eddy current is produced in a transformer? Explain the procedure to perform Short Circuit test on single phase transformer with circuit diagram. In a battery, the difference between the no-load voltage and the measured voltage output is called ________ A) Internal voltage B) Internal resistance C) External resistance D) All the above
Last Answer : In a battery, the difference between the no-load voltage and the measured voltage output is called Internal resistance The no-load speed of a single-phase SCR bridge converter fed separately excited dc motor operating at a firing delay angle, α and flux, Φ (A) directly proportional to α and Φ (B) ... proportional to α and inversely proportional to Φ (D) directly proportional to Φ and inversely proportional to α
Last Answer : The no-load speed of a single-phase SCR bridge converter fed separately excited dc motor operating at a firing delay angle, α and flux, Φ directly proportional to α and inversely proportional to Φ  Which profile to choose windows from?
Last Answer : Which profile to choose when choosing plastic windows? The window profile plays a key role in the most important consumer characteristics, including heat preservation, sound insulation, tightness and ... according to which profile systems used in construction must have a width of 70 mm. Application one lamp controlled from two places
Last Answer : Application one lamp controlled from two places: 1. For Stair case wiring 2. Hospital Wiring ( For operating the lamp in room and nursing station) 3. Bedroom Lighting. List at least two examples that show how static electricity can be generated.
Last Answer : Examples of how static electricity can be generated include combing your hair, walking across a carpeted room, or sliding two pieces of plastic across each other.  Last Answer : The no load current in a transformer lags behind the applied voltage by an angle of about 75°. Last Answer : No-load current of a transformer has small magnitude and low power factor. In an actual transformer the iron loss remains practically constant from no load to full load because?
Last Answer : In an actual transformer the iron loss remains practically constant from no load to full load because core flux remains practically constant. Last Answer : The full-load copper loss of a trans¬former is 1600 W. At half-load, the copper loss will be 400 W. Last Answer : An ideal transformer will have maximum efficiency at a load such that copper loss equal to iron loss. In a given transformer for a given applied voltage, losses which remain constant irrespective of load changes are?
Last Answer : In a given transformer for a given applied voltage, losses which remain constant irrespective of load changes are hysteresis and eddy current losses. The maximum load that a power transformer can carry is limited by its?
Last Answer : The maximum load that a power transformer can carry is limited by its voltage ratio. Last Answer : The magnetising current of a transformer is usually small because it has small air gap. Last Answer : Class A: Load Commutation: The class A or load commutation (also called self-commutation or resonant commutation) is employed in thyristor circuits supplied from DC source. The commutating components include ... biased. Thus the zero-current and reverse-bias cause the thyristor to turn-off. Explain the effect of Harmonics on the Transformer.
Last Answer : Effect of Harmonics on the Transformer:  1. Core loss: Harmonic voltage increases the hysteresis and eddy current losses in the lamination. The amount of the core loss depends on ... small core vibrations.  5. Saturation problem: Sometimes additional harmonic voltage causes core saturation.  