What is the device used in fiber optic communication which consist of a receiver transmitter
use to clean up and amplify digital data moving in one direction and another in the opposite
direction?
A. Optic compressors
B. Optic retarders
C. Optic isolator
D. Optic regenerators

1 Answer

Answer :

D. Optic regenerators

Related questions

Description : Referred to as a ferrite device that can be used in lieu of a duplexer to isolate a microwave transmitter and receiver when both are connected to the same antenna. A. Isolator B. Circulator C. Coupler D. Diode.

Last Answer : B. Circulator

Description : A quarter wavelength devices made of crystalline calcite that changes polarization in the optic fiber communication. A. Isolator B. Retarder C. Polarizer D. Filters

Last Answer : B. Retarder

Description : Who is responsible in the correctness and accuracy of transmitted information content over a data communication? A. The channel B. The transmitter and receiver C. The modem D. The bridge

Last Answer : B. The transmitter and receiver

Description : Main basic components of a data communication are composed of the following. A. Computer, modern and router B. Computer, bridge and gateway C. Transmitter, channel and receiver D. Transmitter, computer and modem

Last Answer : C. Transmitter, channel and receiver

Description : Calculate the total rise time for a fiber-optic system if the transmitter, receiver, and cable each have a rise time of 50 nanoseconds.

Last Answer : 86.6 nanoseconds

Description : ECE Board Exam March 1996 It is a spacecraft placed in orbit around the earth carrying onboard microwave receiver and transmitting equipments. A. Fiber optic equipment B. Communications satellite C. Wireless radio system D. Coaxial cable syste

Last Answer : B. Communications satellite

Description : How can intermodulation interference between two transmitters in close proximity reduced or eliminated? A. Through installing a band-pass filter in the antenna feed line B. Through installing terminated circulator ... high driving power D. By installing a low-pass filter in the antenna feed line

Last Answer : A. Through installing a band-pass filter in the antenna feed line

Description : The most common device used as a light detector in fiber optic communications system. A. LED B. Darlington phototransistor C. APDs D. PIN diode

Last Answer : C. APDs

Description : A component that samples the microwave signal travelling in one direction down to the transmission line A. Isolator B. Combiner C. Directional coupler D. Attenuator

Last Answer : C. Directional coupler

Description : If coils 'R1-R2-R3' at the receiver of figure 'B' shown in the illustration turned opposite of those in the transmitter, what corrective action should be taken to have both turn in the same direction? EL-0092 A ... is needed. C. Interchange leads 'R1' and 'R3'. D. Interchange leads 'R2' and 'R3'.

Last Answer : Answer: C

Description : Which type of fiber-optic cable is the best for very high speed data? a. Single-mode step-index b. Multimode step-index c. Single-mode graded-index d. Multimode graded-index

Last Answer : a. Single-mode step-index

Description : Which of the following is not a major benefit of fiber-optic cable? a. Immunity from interference b. No electrical safety problems c. Excellent data security d. Lower cost

Last Answer : b. No electrical safety problems

Description : What is meant by antenna gain? A. The final amplifier gain minus the transmission line losses (including any phasing lines present) B. The ratio of the amount of power produced by the antenna ... D. The numeric ratio relating the radiated signal strength of an antenna to that of another antenna

Last Answer : D. The numeric ratio relating the radiated signal strength of an antenna to that of another antenna

Description : The total propagation delay time from transmission to reception of signals from a ground transmitter to ground receiver with angle of elevation at 10 degrees respectively is A. 273 ms B. 239 ms C. 275 ms D. 260 ms

Last Answer : A. 273 ms

Description : What is the delay time for satellite transmissions from earth transmitter to earth receiver? A. 0.5 s B. 1s C. 5 ms D. 0.25 s

Last Answer : A. 0.5 s

Description : What is the delay time for satellite transmission from earth transmitter to earth receiver? A. 0.5 s B. 1.0 s C. 5 ms D. 0.25 ms

Last Answer : A. 0.5 s

Description : What limits the sensitivity of a receiver? A. The power supply of the receiver B. The power output of a transmitter C. The noise floor of the receiver D. The distance between the transmitter and receiver

Last Answer : C. The noise floor of the receiver

Description : Which of the following is not one of the natural ways a radio wave may travel from transmitter to receiver? A. Ground wave B. Micro wave C. Sky wave D. Space wave

Last Answer : B. Micro wave

Description : A satellite transmitter operates at 4GHz with an antenna gain of 4dBi. The receiver 40000 km away has an antenna gain of 50 dBi. If the transmitter has a power of 8 W, find (ignoring feedline losses and mismatch) the EIRP in dBW. A. 50 B. 69 C. 49 D. 30

Last Answer : C. 49

Description : What is the uplink receiver frequency if the downlink transmitter is on channel 4 (3.84 Ghz)? A. 6.065 GHz B. 6.84 GHz C. 6.65 GHz D. 6.05 GHz

Last Answer : A. 6.065 GHz

Description : What is the path attenuation between transmitter and receiver at a frequency of 1.2 Ghz and a distance of 11,000 mi? A. 119 dB B. 115dB C. 179dB D. 174dB

Last Answer : C. 179dB

Description : How can receiver desensitizing be reduced? A. Increase the receiver bandwidth B. Ensure good RF shielding between the transmitter and receiver C. Increase the transmitter audio gain D. Decrease the receiver squelch, gain.

Last Answer : D. Decrease the receiver squelch, gain.

Description : ______ is the first component of any MATV system to received broadcast signals. A. Receiver B. Antenna C. Filter D. Transmitter

Last Answer : B. Antenna

Description : ECE Board Exam March 1996 The capture area of an antenna is directly proportional to the A. frequency of the received signal B. distance between transmitter and receiver C. gain of the antenna D. power density of the signal

Last Answer : C. gain of the antenna

Description : The device that is used to convert energy from one form to another is called A : Emiter B : Transducer C : Transmitter D : Receiver

Last Answer : B : Transducer

Description : The device that is used to convert energy from one form to another is called A : Emiter B : Transducer C : Transmitter D : Receiver

Last Answer : B : Transducer

Description : The device that is used to convert energy from one form to another is called A : Emiter B : Transducer C : Transmitter D : Receiver

Last Answer : B : Transducer

Description : The device that is used to convert energy from one form to another is called A : Emiter B : Transducer C : Transmitter D : Receiver

Last Answer : B : Transducer

Description : A device that reduces the intensity of light in fiber optics communication systems. A. Reducer B. Quality factor C. Optical attenuator D. Compressor

Last Answer : C. Optical attenuator

Description : List five common fiber optic transmitter packages.

Last Answer : TO can, DIP, butterfly lead microcircuits, circuit cards, and stand-alone optical fiber converters.

Description : Which part of a fiber optic transmitter converts the processed electrical signal to an optical signal?

Last Answer : The optical source.

Description : What are the three parts of a fiber optic transmitter?

Last Answer : Interface circuit, source drive circuit, and an optical source.

Description : Fiber-optic cable cannot be used: a. in an explosive environment b. to connect a transmitter to an antenna c. to isolate a medical patient from a shock hazard d. none of the above

Last Answer : b. to connect a transmitter to an antenna

Description : Which type of fiber optic cable is most widely used? a. Single-mode step-index b. Multimode step-index c. Single-mode graded-index d. Multimode graded-index

Last Answer : a. Single-mode step-index

Description : A popular light wavelength in fiber-optic cable is a. 0.7 um b. 1.3 um c. 1.5 um d. 1.8 um

Last Answer : b. 1.3 um

Description : The core of a fiber optic is surrounded by a. Wire braid shield b. Kevlar c. Cladding d. Plastic insulation

Last Answer : c. Cladding

Description : The core of a fiber optic cable is made of a. Air b. Glass c. Diamond d. Quartz

Last Answer : b. Glass

Description : Which of the following is not a common type of fiber-optic cable? a. Single-mode step-index b. Multimode graded-index c. Single-mode graded-index d. Multimode step-index

Last Answer : c. Single-mode graded-index

Description : The operation of the fiber-optic cable is based on the principle of a. Refraction b. Reflection c. Dispersion d. Absorption

Last Answer : b. Reflection

Description : Which of the following is not a common application of fiber-optic cable? a. Computer networks b. Long-distance telephone systems c. Closed circuit TV d. Consumer TV

Last Answer : d. Consumer TV

Description : Photodiodes used as fiber optic directors are a. Unbiased to generate a voltage same as a solar cell b. Forward bias c. Reversed bias d. Thermoelectrically cooled

Last Answer : c. Reversed bias

Description : Fiber optic cables operate at frequencies near a. 20MHz b. 200MHz c. 2GHz d. 800THz

Last Answer : d. 800THz

Description : What medium is used by IBM token ring network that operates at either 4 Mbps or 16 Mbps? A. Twisted pair B. Coaxial cable C. Fiber-optic D. Parallel-wire line

Last Answer : A. Twisted pair

Description : How do you reduce the loss that is produced when light strikes a flat polished end of a fiber optic? A. By painting the surface B. By inclining the surface C. By cooling D. By application of antireflection coating

Last Answer : D. By application of antireflection coating

Description : How do you transmit through multiplexing, a thousand of voice channel information over a single fiber optic using on e wavelength? A. Polar division B. Time division C. Fiber division D. Frequency division

Last Answer : B. Time division

Description : One of the advantages of fiber optic which is referred to the volume of capacity of signals it can carry. A. Security B. Weight C. Bandwidth D. Physical size

Last Answer : C. Bandwidth

Description : An advantage of optic fiber rejecting an induced noise signals from magnetic field or solar storms flux. A. Electric hazard B. Cross talk C. Immunity to noise D. Shielding

Last Answer : C. Immunity to noise

Description : Ho w many times bigger does the bandwidth of a fiber optic multimode have over a cable? A. 50 times bigger B. 100 times bigger C. 10 times bigger D. 5 times bigger

Last Answer : B. 100 times bigger

Description : If a fiber optic system has a rise time of 38.55 ns, the source rise time is 12 ns and the detector rise time is 12 ns, what is the cable rise time? A. 34.61 ns B. 14.55 ns C. 52.55 ns D. 26.25 ns

Last Answer : A. 34.61 ns