_________ detects the satellite signal relayed from the feed and converts it to an electric
current, amplifies and lower its frequency.
A. Horn antenna
B. LNA
C. Satellite receiver
D. Satellite dish

1 Answer

Answer :

B. LNA

Related questions

Description : _______ detects the satellite signal relayed from the feed and converts it to an electric current, amplifies and lower its frequency. A. Feedhorn B. Satellite dish C. Satellite receiver D. LNB

Last Answer : D. LNB

Description : Collects very weak signals from a broadcast satellite A. Helical antenna B. Satellite dish C. LNA D. TWT

Last Answer : B. Satellite dish

Description : Collects very weak signal from a broadcast satellite A. Satellite dish B. LNB C. Yagi-Uda antenna D. Satellite receiver

Last Answer : A. Satellite dish

Description : What do you call the single booster installed on the antenna dish of satellite receiver? A. Low noise amplifier B. Single amplifier C. Noise amplifier D. Rectifier

Last Answer : A. Low noise amplifier

Description : An antenna with very high gain and very narrow beamwidth. A. Helical antenna B. Discone antenna C. Horn antenna D. Parabolic dish antenna

Last Answer : D. Parabolic dish antenna

Description : ECE Board Exam March 1996 The capture area of an antenna is directly proportional to the A. frequency of the received signal B. distance between transmitter and receiver C. gain of the antenna D. power density of the signal

Last Answer : C. gain of the antenna

Description : Which circuit detects frequency modulated signal? A. Modulator B. Discriminator C. Demodulator D. Modem

Last Answer : B. Discriminator

Description : The satellite communications channels in a transponder are defined by the A. LNA B. bandpass filter C. mixer D. input signals

Last Answer : B. bandpass filter

Description : A device that converts high frequency current into electromagnetic wave. A. Antenna B. Loudspeaker C. Microphone D. Transducer

Last Answer : A. Antenna

Description : . Which part of the receiver amplifies the electrical signal to a level suitable for further signal processing?

Last Answer : Amplifier.

Description : In shipboard satellite dish antennas system, azimuth is referred as the _______. A. 0 to 90 degrees B. Vertical aiming of the antenna C. North to East D. Horizontal aiming of the antenna

Last Answer : D. Horizontal aiming of the antenna

Description : A satellite transmitter operates at 4GHz with an antenna gain of 4dBi. The receiver 40000 km away has an antenna gain of 50 dBi. If the transmitter has a power of 8 W, find (ignoring feedline losses and mismatch) the EIRP in dBW. A. 50 B. 69 C. 49 D. 30

Last Answer : C. 49

Description : Refers to one of the front end circuit of a VHF TV superheterodyne receiver which is usually a separate circuit coupled to the mixer. A. Antenna feed B. AGC C. RF amplifier D. Local oscillator

Last Answer : D. Local oscillator

Description : Which of the following parts of the radio receiver represent the component that extracts the desire RF signal from the electromagnetic wave? A. AF amplifier B. Antenna C. Detector D. Crystal

Last Answer : B. Antenna

Description : ECE Board Exam March 1996 What is the purpose of the receiver's squelch circuit? A. To overcome fluctuations in the level the RF signal arriving at the receiver antenna B. To prevent ... signals D. To prevent amplified noise from reaching the loudspeaker during the absence of an incoming signal

Last Answer : D. To prevent amplified noise from reaching the loudspeaker during the absence of an incoming signal

Description : The signal path from satellite to earth-based receiver. A. Downlink signal B. Uplink signal C. Incident signal D. Reflected signal

Last Answer : A. Downlink signal

Description : How does the gain of a parabolic dish type antenna change when the operating frequency is doubled? A. Gain does not change B. Gain is multiplied by 0.707 C. Gain increases 6 dB D. Gain increases 3 dB

Last Answer : C. Gain increases 6 dB

Description : Consider the following statements: 1. In a direct-to-home (DTH) system, the viewer dish antenna picks up signals from the satellite directly. 2. Cable operators receive signal from the satellite on large community dish antennas and ... ? (a) Only 1 (b) Only 2 (c) Both 1 and 2 (d) Neither 1 nor 2

Last Answer : Ans:(c)

Description : What is meant by the term radiation resistance for an antenna? A. The resistance in the trap coils to received signal B. An equivalent resistance that would dissipate the same amount of power as ... antenna C. The specific impedance of the antenna D. Losses in the antenna elements and feed line

Last Answer : B. An equivalent resistance that would dissipate the same amount of power as that radiated from an antenna

Description : A dipole antenna requires to be feed with 20 kW of power to produce a given signal strength to a particular distant point. If the addition of a reflector makes the same field strength available with an input power of 11 ... ( Gain referred to this particular dipole) A. 4.24 B. 1.81 C. 4.75 D. 2.6

Last Answer : D. 2.6

Description : Deemphasis in the receiver in effect attenuates modulating signal components and noise in what frequency range? A. dc B. low C. intermediate D. high

Last Answer : D. high

Description : A parabolic dish antenna isa(n)_______ antenna. A) omnidirectional B) bidirectional C) unidirectional D) horn

Last Answer : unidirectiona

Description : Write one application of following antenna i. Rectangular antenna ii. Dish antenna iii. Yagi-Uda antenna iv. Horn antenna 

Last Answer : i. Rectangular antenna is used in direction finding in portable recievers. ii. Dish antenna is used to transmit and receive signal from satellite. iii. Yagi-Uda antenna is used in HF and VHF range as a TV receiving antenna. iv. Horn antenna is used in satellite tracking.

Description : Draw radiation pattern for following antenna i) Yagi-Uda antenna ii) Loop antenna iii) Dish antenna iv) Horn antenna

Last Answer : Type of antenna Radiation Patteren  Yagi-Uda antenna Loop antenna Dish antenna Horn antenna 

Description : Write the application of the following antennas: 1) Rectangular antenna 2) Dish antenna 3) Horn antenna 4) Loop antenna 5) Yagi-Uda antenna. 

Last Answer : Applications:  1.Rectangular antenna  i)Used in Mobile and satellite communication ii)Used in Global Positioning System iii) Used for Radio Frequency Identification (RFID) iv) Radar  Dish ... antenna. 2. Yagi-Uda antenna is used in conditional Access System (CAS) at the decryptor.

Description : Which antenna radiates an omnidirectional pattern in the horizontal plane with vertical polarization? A. Marconi antenna B. Discone antenna C. Horn antenna D. Helical antenna

Last Answer : A. Marconi antenna

Description : A special horn antenna consisting of a parabolic cylinder joined to a pyramidal horn. A. Hoghorn B. Cass-horn C. Pyramidal horn D. Conical horn

Last Answer : A. Hoghorn

Description : Which of the following is not usually a part of a transponder are defined by the A. LNA B. Mixer C. Modulator D. HPA

Last Answer : C. Modulator

Description : The most common device used as an LNA is A. zener diode B. tunnel diode C. IMPATT D. Shockley diode

Last Answer : B. tunnel diode

Description : What determines the ability of radar to determine the bearing to a target? A. Speed of light B. Speed of target C. Antenna directivity D. Frequency of signal

Last Answer : C. Antenna directivity

Description : What type of transmission is radiated from an aircraft’s radio altimeter antenna? A. An amplitude modulated continuous wave B. A pulse position modulated UHF signal C. A differential phase shift keyed UHF signal D. A frequency modulated continuous wave

Last Answer : D. A frequency modulated continuous wave

Description : One of the following prevents a transmitter from emitting a signal that interferes with other stations on frequency during the test. A. Use of low height antenna B. Use of grounded antenna C. Use of dummy antenna D. Use of shielded antenna radiator

Last Answer : C. Use of dummy antenna

Description : As the height of a satellite orbit gets lower, the speed of the satellite _________. A. increases B. decreases C. remains the same D. None of the above

Last Answer : A. increases

Description : Where are the current nodes in a half-wave antenna? A. At the ends B. At the center C. Three-quarters of the way from the feed point toward the end D. One-half of the way from the feed point toward the end

Last Answer : A. At the ends

Description : A final amplifier of a radio transmitter draws 250 mA of plate current when the plate supply voltage is 1400 volts. If the plate circuit efficiency is 80% and the transmitter is connected to an antenna having a feed impedance of 70 ohms, ... at the feed-point? A. 4.0 A B. 2.2 A C. 1.25 A D. 2.0 A

Last Answer : D. 2.0 A

Description : How is it possible to lower the resonant frequency of Hertz dipole antenna? A. By reducing the frequency at the transmitter B. By connecting a capacitor in series with the antenna C. By the connecting a resistor in series with the antenna D. By connecting an inductor in series with the antenna

Last Answer : D. By connecting an inductor in series with the antenna

Description : A receiver connected to an antenna whose resistance is 50 Ω has an equivalent noise resistance of 30Ω. Calculate its equivalent noise temperature if the noise figure is equal to 1.6. A. 17.4 K B. 174K C. 1.74K D. 17K

Last Answer : B. 174K

Description : What determines antenna polarization? A. The frequency of the radiated wave B. The direction of the radiated wave C. The direction of the magnetic field vector D. The direction of the electric field vector

Last Answer : D. The direction of the electric field vector

Description : Calculate the noise figure of the receiver whose RF amplifier has an input resistance of 1000Ω and an equivalent shot-noise resistance of 2000Ω, a gain of 25 and load resistance of 125 kΩ. Given that the bandwidth is 1. ... to an antenna with an impedance of 75Ω. A. 30.3 B. 3.03 C. 303 D. .303

Last Answer : A. 30.3

Description : A receiver is located 64 km from a space wave transmitting antenna that is 100 meters high. Find the required height of the receiving antenna. A. 36 meters high B. 64 meters high C. 100 meters high D. 182.25 meters high

Last Answer : A. 36 meters high

Description : What is the maximum line-of-sight distance between a paging antenna 250 ft high and a pager receiver 3.5ft of the ground? A. 25 km B.25mi C. 70.73 km D. 70.73 mi

Last Answer : B.25mi

Description : What consists the front-end circuit of a VHF TV superheterodyne receiver? A. Mixer, RF amplifier and AFC? B. RF amplifier, Band pass filter and mixer C. Local oscillator, mixer and RF amplifier D. Local oscillator, AGC and antenna

Last Answer : C. Local oscillator, mixer and RF amplifier

Description : Referred to as a ferrite device that can be used in lieu of a duplexer to isolate a microwave transmitter and receiver when both are connected to the same antenna. A. Isolator B. Circulator C. Coupler D. Diode.

Last Answer : B. Circulator

Description : ______ is the first component of any MATV system to received broadcast signals. A. Receiver B. Antenna C. Filter D. Transmitter

Last Answer : B. Antenna

Description : ECE Board Exam March 1996 A receiver connected to an antenna whose resistance is 50 ohms has an equivalent noise resistance of 30 ohms. What is the receiver’s noise temperature? A. 754 K B. 464 K C. 174 K D. 293 K

Last Answer : C. 174 K

Description : A function of an optic isolator ∙ a. Cancels reflective waves ∙ b. Amplifies signal transmitted ∙ c. Filters unnecessary signals ∙ d. All of these

Last Answer : a. Cancels reflective waves

Description : What is the delay time for satellite transmissions from earth transmitter to earth receiver? A. 0.5 s B. 1s C. 5 ms D. 0.25 s

Last Answer : A. 0.5 s

Description : What is the delay time for satellite transmission from earth transmitter to earth receiver? A. 0.5 s B. 1.0 s C. 5 ms D. 0.25 ms

Last Answer : A. 0.5 s

Description : Which of the following is the basic component of a communications satellite receiver? A. On-board computer B. Reflector C. Telemetry D. Transponder

Last Answer : D. Transponder

Description : What satellite system parameter represents the quality of a satellite or an earth station receiver? A. Gain-to-Equivalent Noise Temperature Ratio (G/Te) B. Energy of Bit-to-Noise Density Ratio (Eb/No) C. Carrier-to-Noise Density Ratio (C/No) D. Bit energy

Last Answer : A. Gain-to-Equivalent Noise Temperature Ratio (G/Te)