Description : What is the input impedance of a transmission line if its characteristic impedance is 300 Ω and the load is 600 Ω? Assume a quarter wavelength section only. A. 150 kΩ B. 150 mΩ C. 150 Ω D. 2 Ω
Last Answer : C. 150 Ω
Description : What is the impedance in ohms of a transformer marked for 25V, 4W, when the secondary is correctly loaded? A. 150 Ω B. 156 Ω C. 160 Ω D. 165 Ω
Last Answer : B. 156 Ω
Description : To couple a coaxial line to parallel line, it is better to use a ______. A. Slotted line B. Quarter-wave transformer C. Directional Coupler D. Balun
Last Answer : D. Balun
Description : To connect coaxial line to a parallel-wire _________ is the best to use. A. directional coupler B. quarter-wave transformer C. balun D. slotted line
Last Answer : C. balun
Description : ___________ is device that measures the internal open circuit voltage of an equivalent noise generator having an impedance of 600Ω and delivering noise power to a 600 Ω load. A. Psophometer B. Barometer C. Reflectometer D. Voltmeter
Last Answer : A. Psophometer
Description : In order to get maximum radiation to all surrounding points in the horizontal plane, the antenna used is a A. vertical loop B. vertical quarter-wavelength rod C. array which includes parasitic elements D. a horizontal Hertz dipole
Last Answer : B. vertical quarter-wavelength rod
Description : A shunt-fed quarter-wavelength Marconi antenna A. has maximum RF impedance to ground at its feedpoint B. has a current null at its feedpoint C. has a zero DC resistance to ground D. has zero RF resistance to ground
Last Answer : C. has a zero DC resistance to ground
Description : Which of the following is and impedance matching ration of coax balun? A. 2:8 B. 1:2 C. 4:1 D. 2:1
Last Answer : C. 4:1
Description : Impedance inversionmaybe obtainedwith a. a short-circuited stub b. an open-circuited stub c. a quarter-wave line d. a half-wave line
Last Answer : c. a quarter-wave line
Description : What quarterwave transformer will match a 100Ω line to an antenna whose value is 175Ω? A. 132.29 Ω B. 150 Ω C. 16.58 Ω D. 137.5 Ω
Last Answer : A. 132.29 Ω
Description : The input terminal impedance at the center of a folded dipole antenna is A. 72 Ω B. 300 Ω C. 50 Ω D. 73 Ω
Last Answer : B. 300 Ω
Description : What is the characteristic impedance of a single wire with a diameter d= 0.25 mm placed at the center between grounded parallel planes separated by 1 mm apart. The wire is held by a material with a velocity factor of 0.75. A. 85 Ω B. 63 Ω C. 50 Ω D. 75 Ω
Last Answer : D. 75 Ω
Description : What is the impedance of a balance 4-wire with a diameter of 0.25 cm and spaced 2.5 cm apart using an insulator with a dielectric constant of 2.56? A. 100Ω B. 65Ω C. 75 Ω D. 50 Ω
Last Answer : A. 100Ω
Description : A convenient method of determining antenna impedance. A. Stub matching B. Reactance circle C. Smith chart D. Trial and error
Last Answer : C. Smith chart
Description : Fortransmission-line loadmatchingover a range offrequencies,itisbesttouse a a. balun b. broadband directional coupler c. double stub d. single stub of adjustable position
Last Answer : c. double stub
Description : To couple a coaxialline toa parallel-wire line,itisbesttouse a a. slotted line b.balun c. directional coupler d. quarter-wave transformer
Last Answer : b.balun
Description : A transmitted signal 5 meters in wavelength is received by an antenna coil having a 50-Ω resistance and a 0.01 H inductance. What is the capacitance of the tuner shunting the antenna coil at this point? A. 0.704 fF B. 0.704 μF C. 0.704 nF D. 0.704 mF
Last Answer : A. 0.704 fF
Description : What type of balun (balanced-to-unbalanced) is used in high frequency applications? A. Transformer type balun B. A specially configured coaxial transmission line C. A specially configured parallel-wire line D. A λ/2 transformer balun
Last Answer : B. A specially configured coaxial transmission line
Description : The switching from one element to the other element in a typical mobile satellite array. A. Series B. Radial C. Matrix D. Shunt
Last Answer : D. Shunt
Description : What circuit is responsible in activating and deactivating adjacent antenna elements in a mobile satellite array? A. Radial divider B. Divider/combiner C. Radial combiner D. Radial multiplexer
Last Answer : A. Radial divider
Description : In a typical mobile satellite array antenna if three elements are activated, how many elements are deactivated? A. 3 B. 11 C. 5 D. 9
Last Answer : B. 11
Description : A mobile satellite array has usually how many elements? A. 6 B. 88 C. 12 D. 14
Last Answer : D. 14
Description : What is the end impedance of a half-wave dipole? A. 73 Ω B. 72 Ω C. 250 Ω D. 2500 Ω
Last Answer : D. 2500 Ω
Description : A transmission line of unknown impedance is terminated with two different resistances, and an SWR is measured each time. With a 75 Ω termination, the SWR measures 1.5. With a 300 Ω termination, it measures 2.67. What is the impedance of the line? A. 100 Ω B. 212 Ω C. 300 Ω D. 112 Ω
Last Answer : D. 112 Ω
Description : A dielectric waveguide for the propagation of electromagnetic energy at light frequencies a. Stripline b. Microstrip c. Laser beam d. Fiber optics
Last Answer : d. Fiber optics
Description : What do you call a cable consisting of twisted pairs of conductors, each separately insulated? A. Microstrip line B. Strip line C. Quad D. Coaxial cable
Last Answer : C. Quad
Description : A single conductor running from the transmitter to the antenna. A. RG-8/U B. Single line wire C. Twin-lead D. MIcrostrip
Last Answer : B. Single line wire
Description : Draw waveform for standing waves on an open and shorted line. Prove that impedance is inverted at every quarter wavelength interval.
Last Answer : Waveform- Explanation When the transmission line is short circuited voltage is zero and current is maximum.The variation is according to the wavelength. When the ... The pattern repeats for every half wavelength. Thus impedance is inverted at every quarter wavelength interval.
Description : In the case if Marconi antenna, the actual length if the radiating element is A. one-half wavelength B. one-quarter wavelength C. one wavelength D. one-eight wavelength
Last Answer : B. one-quarter wavelength
Description : Actual height of antenna should be at least A. one wavelength B. half wavelength C. quarter wavelength D. three-fourth wavelength
Last Answer : C. quarter wavelength
Description : A one-quarter wavelength shunt-fed vertical Marconi antenna A. has maximum radiation in a vertical direction B. must have a horizontal receiving antenna for the best reception C. must use a receiving antenna for the best reception D. must have a vertical receiving antenna for the best reception
Last Answer : D. must have a vertical receiving antenna for the best reception
Description : Which of the following antennas receive signals in the horizontal plane equality well from all directions? A. Horizontal Hertz antenna B. Vertical loop antenna C. Vertical Yagi antenna D. A vertical antenna which is a quarter-wavelength long
Last Answer : D. A vertical antenna which is a quarter-wavelength long
Description : What is the reactance property at the input of a shorted quarter wavelength line? A. A parallel LC circuit B. A pure inductive reactance C. A series LC circuit D. A pure capacitive reactance
Last Answer : A. A parallel LC circuit
Description : What would be the physical length of a tpical coaxial transmission line that is electrically one-quarter wavelength long at 14.1 MHz? A. 20 meters B. 3.51 meters C. 2.33 meters D. 0.25 meter
Last Answer : B. 3.51 meters
Description : What is the seventh harmonic of a 100 MHz quarter wavelength antenna? A. 14.28 MHz B. 107 MHz C. 149 MHz D. 700 MHz
Last Answer : D. 700 MHz
Description : What is the actual length in feet of a one-quarter wavelength of a coax with a velocity factor of 0.68 to 30 MHz? A. 19.26 B. 5.6 C. 17.82 D. 16.97
Last Answer : B. 5.6
Description : What is the actual length in feet of a one-quarter wavelength of a coax with a velocity factor of 0.695 at 45 MHz? A. 17.82 B. 19.26 C. 16.28 D. 16.97
Last Answer : C. 16.28
Description : A quarter wavelength devices made of crystalline calcite that changes polarization in the optic fiber communication. A. Isolator B. Retarder C. Polarizer D. Filters
Last Answer : B. Retarder
Description : Best choice of transmission line component to couple a coaxial line to a parallel-wire line A. Shorting B. Balun C. Slotted line D. Directional coupler
Last Answer : B. Balun
Description : Characteristics impedance of a transmission line is the impedance measured at the ___________ when its length is infinite. A. input B. shorted end of the line C. output D. midsection
Last Answer : A. input
Description : If the terminating impedance is exactly equal to the characteristic impedance of the transmission line the return loss is ___________. A. zero B. one C. infinite D. None of these
Last Answer : C. infinite
Description : Receives and collects satellite signals form a broadcast satellite. A. LNB B. Yagi-Uda array C. Satellite receiver D. Satellite disk
Last Answer : D. Satellite disk
Description : The parameters of Transmission line are R = 50 Ω/ km, L= 1mH/km ,C = 0.1µf/km, G = 2µV/km. calculate characteristic impedance.
Last Answer : The parameters of Transmission line are R = 50 Ω/ km, L= 1mH/km ,C = 0.1µf/km, G = 2µV/km. calculate characteristic impedance.
Description : A load of 200 ohm is used to match 300 ohm transmission line to achieve SWR=1. Find out the required characteristic impedance of a quarter of a quarter wave transformer connected directly to the load.
Last Answer : Solution :
Description : How quarter wave transformer is used for impedance matching.
Last Answer : In all applications of transmission line, it is required that the load be matched to line, Which requires tuning out the unwanted load reactance and the transformation of resulting impedance to the required value ... Step down transformer If ZL <Zo then it acts as a Step up transformer
Description : A receiver connected to an antenna whose resistance is 50 Ω has an equivalent noise resistance of 30Ω. Calculate its equivalent noise temperature if the noise figure is equal to 1.6. A. 17.4 K B. 174K C. 1.74K D. 17K
Last Answer : B. 174K
Description : In transmission line, which of the following is the first step in the procedure of using stub matching? A. Calculate stub susceptance. B. Calculate load admittance C. Connect stub to load D. Transform conductance to resistance
Last Answer : B. Calculate load admittance
Description : When the elevation angle of a geostationary satellite is 23˚ and the transmitting frequency is 3840 MHz, what is the free space loss in dB? A. 196 dB B. 200 dB C. 150 dB D. 100 dB
Last Answer : A. 196 dB
Description : Essentially a satellite ___________ is a radio repeater in the sky A. transponder B. comparator C. duplexer D. billboard
Last Answer : A. transponder
Description : What is the approximate path loss from satellite-to-earth station? A. 100 dB B. 150 dB C. 175 dB D. 200 dB
Last Answer : D. 200 dB