Description : The state of charge of a lead-acid battery is best indicated by the ____________. A. individual cell voltage B. ampere-hour capacity C. electrolyte specific gravity D. total cell voltage
Last Answer : Answer: C
Description : Battery capacities are given in _____________. A. volts B. volt-amperes C. volt-hours D. ampere-hours
Last Answer : Answer: D
Description : Which of the following precautions should be taken when a blown fuse, rated at 10 amperes, is replaced? A. Short out the fuse before removing it from the circuit. B. Use needle-nose pliers to ... D. Fuses of 10 ampere rating and less are virtually harmless when energized and may be handled freely.
Description : The state of charge of a lead acid storage battery is best indicated by the _____________. A. testing of the individual cell voltages B. ampere hour capacity of the battery C. specific gravity of the electrolyte D. total cell voltages
Description : When charging a 100 amp-hour lead-acid battery, ___________. A. the temperature of the electrolyte should not be allowed to exceed 90°F B. the charging rate should be no greater than 125% of the ... nearing full charge and it will be necessary to reduce the charging current to a low finishing rate
Description : The capacity of a battery is expressed in terms of A. Current rating B. Voltage rating C. Ampere hour rating D. None of the above
Last Answer : C. Ampere hour rating
Description : CG Co manufactures a single product T. Budgeted production output of product T during June is 200 units. Each unit of product T requires 6 labour hours for completion and CG Co anticipates 20 per cent idle time. Labour is paid at ... for March is (a) Rs 6,720 (b) 8,400 (c) 10,080 (d) 10,500
Last Answer : (d) 10,500
Description : Which of the listed battery charging circuits is used to maintain a wet-cell, lead-acid, storage battery in a fully charged state during long periods of disuse? A. Normal charging circuit B. Quick charging circuit C. Trickle charging circuit D. High ampere charging circuit
Description : Power transformers are rated in _____________. A. kilowatts B. ampere-turns C. kilowatt-volts D. kilovolt-amperes
Description : Ampere hour capacity of an industrial battery is based on ……….hours discharge rate A. 8 B. 12 C. 16 D. 24
Last Answer : A. 8
Description : A 20 ohm resistor and a 60 ohm resistor are connected in parallel to a voltage source. If the current in the 60 ohm resistor is one ampere, the current in the 20 ohm resistor will be: w) 1/3 ampere x) 2/3 ampere y) 1 ampere z) 3 amperes
Last Answer : ANSWER: Z -- 3 AMPERES
Description : The capacity of a storage battery is measured in ______________. A. volts B. ampere-hours C. farads D. amps
Last Answer : Answer: B
Description : Ten Coulombs of charge flowing through a wire per second is equal to: w) 100 Amperes x) 10 Ampere y) 1 Amperes z) 0.1 Amperes
Last Answer : ANSWER: X -- 10 AMPERES
Description : Violent gassing developed by a lead-acid battery during charging indicates that the ____________. A. plate separators are grounded B. cell voltages are excessive C. specific gravity in insufficient D. charging rate is excessive
Description : The charge of a lead-acid battery is checked with a/an ____________. A. manometer B. hydrometer C. voltmeter D. ohmmeter
Description : A breakable, mercury-filled thermometer should not be used in a lead-acid battery to measure electrolyte temperature, as an accidental breakage can cause ____________. A. severe sparking and explosions ... battery plates C. violent gassing at the positive plates D. corrosion on the battery terminals
Last Answer : Answer: A
Description : When charging lead-acid batteries, the charging rate should be reduced as the battery nears its full charge to ____________. A. prevent damaging battery plates B. allow equalization of cell voltages C. reduce lead sulfate deposits D. increase lead peroxide formation
Description : The change in base current will be A) 0.66 micro ampere B) 6.6 micro amperes C) 66 micro amperes D) 660 micro amperes.
Last Answer : A) 0.66 micro ampere
Description : Which of the listed ranges represents specific gravity corrected for temperature for the electrolyte of a fully charged portable lead-acid battery? A. 1.100 to 1.150 B. 1.180 to 1.200 C. 1.280 to 1.300 D. 1.750 to 2.000
Description : Two 100 watt light bulbs are connected in parallel across a 100 volt power supply. The total power developed in the circuit is _______________. A. 200 watts B. 100 watts C. 50 watts D. equal to the product of the amperes times the voltage in each branch
Description : An electrical component is connected across a 120 volt 60 hertz AC supply. What is the current drawn by the component if the impedance is 200 ohms? A. 0.01 amperes B. 0.60 amperes C. 1.67 amperes D. 100 amperes
Description : According to Coast Guard Regulations (46 CFR), a battery installation must be in a room that is only for batteries or a box on deck. This would be termed a ____________. A. small installation B. moderate installation C. large installation D. high amp/hour capacity installation
Description : When choosing a battery for a particular application, major consideration should be given to the battery's ____________. A. amp-hour capacity B. terminal polarity C. stability under charge D. ambient temperature rise
Description : A lead-acid battery is considered fully charged when the ______________. A. electrolyte gasses freely B. battery charger ammeter indicates a positive reading C. terminal voltage reaches a constant value at a ... cells reaches the correct value and no longer increases over a period of 1 to 4 hours
Description : Caution must be exercised during the charging of lead-acid storage batteries as _____________. A. the acid will become weaker B. hydrogen gas is being continuously liberated C. both plates are changing chemically to lead sulfate D. lead peroxide in the negative plate is poisonous
Description : A normally consolidated clay settled 10 mm when effective stress was increased from 100 kN/m² to 200 kN/m². If the effective stress is further increased from 200 kN/m² to 400 kN/m², then the settlement of the same clay is (A) 10 mm (B) 20 mm (C) 40 mm (D) None of the above
Last Answer : (A) 10 mm
Description : Nickel-cadmium batteries are superior to lead-acid batteries at high discharge rates because they _______________. A. deliver a large amount of power and can be recharged in a shorter time B. need ... less mounting space C. have higher output voltages and require no maintenance D. all of the above
Description : How many hours will a 200 amp hour battery last at 168 watt?
Last Answer : If it is a car battery (as given in the category) it is reasonably safe to assume that under load it is about 12V. I = P/E = 168W / 12V = 14A T = 200AH / 14A = 14.29H However ... battery. This is also assuming that the car battery is not being charged at any time while the load is present.
Description : The capacity of a battery is expressed in terms of A ampere per hour B current C volt D ampere
Last Answer : A ampere per hour
Description : What current is required to light two 75 watt lamps and one 40 watt lamp when connected in series to a 120 volt power source? A. 0.161 amperes B. 0.631 amperes C. 1.583 amperes D. 6.199 amperes
Description : Two coal trains, one southbound, the other westbound, reach an over and under crossing at the same instant and each proceed at 40 kilometers per hour on their respective courses. Approximately how far apart are the lead cars two hours later, to the nearest kilometer? w) 80 x) 113 y) 136 z) 160
Last Answer : ANSWER: X -- 113
Description : A common-emitter circuit has an input voltage of 0.1 volt, an output voltage of 2.0 volts, an input current of 0.5 milliamps, and an output current of 10 milliamps. What is the power gain? A. 20 B. 40 C. 400 D. 4000
Description : How many calories are required to raise the temperature of 20 grams of water from 40 degrees to 60 degrees? w) 40 cal x) 400 cal y) 20 cal z) 200 cal
Last Answer : ANSWER: X -- 400 cal
Description : How many anodes can the 200 ampere reactor supply drive in the circuit shown in the illustration? EL-0090 A. One B. Two C. Four D. Six
Description : What power is consumed by a heating element using a current of 20 amperes at 120 volts? A. 20 watts B. 66.67 watts C. 720 watts D. 2400 watts
Description : When a battery is continuously exposed to low temperatures, the best procedure to keep it from freezing is to _________. A. remove the battery caps B. securely cover the battery C. keep the battery fully charged D. disconnect the battery
Description : Which of the following procedures represents the best method to prevent the freezing of batteries continuously exposed to low temperatures? A. The battery caps should be removed. B. The battery cap ... in a fully charged condition. D. The battery should be disconnected from its charging source.
Description : The standard procedure for maintaining the charge in an emergency diesel starting battery is to trickle charge the battery _____________. A. continuously B. at least once each week C. whenever the charge falls to 75% of full charge D. whenever the electrolyte specific gravity falls to 1.250 or lower
Description : In cranking the engine normally motor takes current about a) 300 amperes b) 400 amperesb) 5 0 0 amperes d) 600 amperes
Last Answer : b) 400 amperes
Description : On the meter scale illustrated, while using the R X 1 scale, the reading at 'E' will be ____________. EL-0047 A. 2.0 ohms B. 20 ohms C. 200 ohms D. none of the above
Description : On the meter scale illustrated, while using the R X 100 scale, the reading at 'A' will be ____________. EL-0047 A. 2,000 ohms B. 20 Kohms C. 200 Kohms D. 3 Megohms
Description : While designing hair pin bends on highways, the minimum (A) Designed speed is 20 km/hour (B) Gradient is 1 in 40 (C) Gradient is 1 in 200 (D) All the above
Last Answer : Answer: Option D
Description : Thirty men take 20 days to complete a job working 9 hours a day. How many hour a day should 40 men work to complete the job? (a) 8 hrs (b) 7 1/2 hrs (c) 7 hrs (d) 9 hrs
Last Answer : (b) 7 1/2 hrs
Description : Ravi walks to and fro to a Gym. He spends 30 minutes in gym. If he walks at speed of 20 km an hour, he returns to home at 8.00 a.m. If he walks at 30 km an hour, he returns to home at 7.30 a.m. How fast must he walk in order to return at 7.15 hours? a) 40 km/hr b) 30 km/hr c) 60 km/hr d) 50 km/hr
Last Answer : A As per the question, let D be the total distance and ‘t’ is the time taken. So we have: D=20t 20t =30(t-0.5) 20t=30t-15 10t=15 t=3/2 D= 30 km Now, for the condition given we have: 30=S(t-3/4) 30=S(3/2-3/4) 30=S((6-3)/4) 30=S(3/4) S=40 km/hr
Description : Process boiler is a type of boiler with a capacity of ____________Buts per hour a) 200,000 b) 300,000 c) 400,000 d) 50,000
Last Answer : b) 300,000
Description : Under which of the following conditions will a lead-acid battery be given a 'test discharge'? A. To determine its capacity. B. Whenever a cell cannot be brought within 10 points of full charge ... cells is found to have less than normal voltage after an equalizing charge. D. All of the above.
Description : When correcting specific gravity readings of a lead-acid battery for existing temperature conditions, you should ______________. A. add 10 points for each 4° above 80°F B. subtract 10 points for each 4° above 80°F C. add 4 points for each 10° above 80°F D. add 4 points for each 10° below 80°F
Description : How many volts are necessary to provide a current of 10 amperes to a motor with an in-line resistance of 11 ohms? A. 21 volts B. 110 volts C. 220 volts D. 240 volts
Description : A circuit breaker for a 300 KW alternator is rated at 470 amperes of full continuous load. The amount of overcurrent allowed is 125%. Which of the following conditions will trip the breaker? A. ... 10 minutes. C. Momentary starting load of 550 amperes. D. Sustained current flow of 590 amperes.
Description : Which of the following statements regarding the use of a current measuring instrument is correct? A. It must be connected in series with the circuit. B. You should always start with the lowest range ... of polarity. D. An external shunt is generally utilized where current is less than 10 amperes.