The 'Choke' used with a tube light is basically – (1) an inductor (2) a capacitor (3) a transformer (4) a resistor

1 Answer

Answer :

(1) an inductor Explanation: In electronics, a choke is an inductor used to block higher-frequency alternating current (AC) in an electrical circuit, while passing lower-frequency or direct current (DC). In a tubelight, the high voltage is created by suddenly interrupting the current in choke, which is connected in series with the tubelight.

Related questions

Description : The ‘Choke’ used with a tube light is basically (1) an inductor (2) a capacitor (3) a transformer (4) a resistor

Last Answer : an inductor

Description : The component used for tuning a radio is basically a variable – (1) Resistor (2) Condenser (3) Inductor (4) Transformer

Last Answer : (2) Condenser Explanation: A tuning capacitor or tuning condenser is a variable capacitor used in an electronic circuit of a radio. It usually connects in parallel to a loop antenna and its capacitance may be intentionally and repeatedly changed mechanically or electronically.

Description : The component used for tuning a radio is basically a variable (1) Resistor (2) Condenser (3) Inductor (4) Transformer

Last Answer : Condenser

Description : Device used to store energy in electrical circuits is A. resistor B. inductor C. capacitor D. diode

Last Answer : capacitor

Description : insulator which is placed between 2 plates of capacitor isA. electric B. dielectric C. inductor D. resistor

Last Answer : dielectric

Description : A component that allows only unidirectional current to pass through it is A. resistor B. inductor C. transformer D. diode

Last Answer : diode

Description : The electric charge is stored in a device called: (1) Inductor (2) Capacitor (3) Resister (4) Transformer

Last Answer : (2) Capacitor Explanation: A capacitor is a passive twoterminal electronic component that stores electrical energy in an electric field. The effect of a capacitor is known as capacitance.

Description : The most inefficient method of voltage reduction, from the standpoint of power loss, even when placed in series with the load, is the use of a/an ____________. A. capacitor B. inductor C. resistor D. transistor

Last Answer : Answer: C

Description : The most inefficient method of voltage reduction from the stand point of power loss, is a/an _____________. A. capacitor in series with the load B. inductor in series with the load C. capacitor and inductor in series with the load D. resistor in series with the load

Last Answer : Answer: D

Description : To electrically decrease the length of an antenna. A. add an inductor in series B. add an inductor in parallel C. add a resistor in series D. add a capacitor in series

Last Answer : D. add a capacitor in series

Description : Increasing the electrical length of an antenna means A. add an inductor in parallel B. add a capacitor in series C. add an inductor series D. add a resistor is series

Last Answer : C. add an inductor series

Description : How is it possible to lower the resonant frequency of Hertz dipole antenna? A. By reducing the frequency at the transmitter B. By connecting a capacitor in series with the antenna C. By the connecting a resistor in series with the antenna D. By connecting an inductor in series with the antenna

Last Answer : D. By connecting an inductor in series with the antenna

Description : Draw the symbol of i) Iron core inductor ii) variable capacitor iii) resistor iv) Ferrite core inductor

Last Answer :  Iron core inductor:  Ferrite core inductor:  

Description : State the applications and specification of (i) Resistor (ii) Capacitor (iii)Inductor

Last Answer : Application of resistor: 1.Resistors are used in high frequency instrument. 2.Resistor is used in power control circuit. 3.It is used in DC power supplies. 4.Resistors are used ... DC Current  3.Electromagnetic Interference (EMI)  4.Magnetic Saturation Flux Density  5.Curie Temperature 

Description : The device shown in the illustration is a/an ____________. EL-0083 A. noise filtering choke B. autotransformer C. fluorescent light ballast D. power factor correction inductor

Last Answer : Answer: B

Description : A triac thyristor functions as a control device and is basically ________________. A. two NPN transistors in parallel with a common base lead B. a diode in series with a temperature sensitive capacitor C. two ... -back SCR's with a common gate lead D. a triode tube with an extra heavy grid element

Last Answer : Answer: C

Description : A series circuit consists of a two ohm RESISTOR and a one ohm INDUCTOR. The relationship between current and voltage is: w) current will lag by 30 degrees. x) current will lag by 26 degrees. y) current will lead by 26 degrees. z) current will lead by 30 degrees.

Last Answer : ANSWER: X -- CURRENT WILL LAG BY 26 DEGREES.

Description : The device which transfer the signal from low resistance region to high resistance region is – (1) diode (2) transistor (3) capacitor (4) inductor

Last Answer : (2) transistor Explanation: A transistor transfers a signal from a low resistance to high resistance. It has two PN-junctions: one junction is forward biased and other junction is reverse biased ... is introduced in the low resistance, circuit and output is taken from the high resistance circuit.

Description : The device which transfer the signal from low resistance region to high resistance region is (1) diode (2) transistor (3) capacitor (4) inductor

Last Answer : transistor

Description : How can you start-up the 40w tube light with 230v AC/DC without using any choke/Coil?

Last Answer : It’s possible by means of Electronic choke. Otherwise it's not possible to ionize the particles in tube light, with normal voltage.

Description : How can we start-up the 40w tube light with 230v AC/DC without using any choke/Coil?

Last Answer :  It is possible by means of Electronic choke. Otherwise it’s not possible to ionize the particles in tube. Light, with normal voltage.

Description : Why the choke is used with tube light?

Last Answer : Ans. Choke is used as inductance and check voltage surge at starting and limit the current in Running.

Description : An ideal choke takes a current of 8A when connectd to an AC source of 100V and 50 Hz. A pure resistor under the same condition strikes a current of 10

Last Answer : An ideal choke takes a current of 8A when connectd to an AC source of 100V and 50 Hz. A pure ... resistor and inductor `sqrt(10x)`A. Find value of x

Description : In an LC choke-input filter, what prevents the rapid charging of the capacitor?

Last Answer : The CEMF of the inductor

Description : In an LC choke-input filter, what prevents the rapid charging of the capacitor?

Last Answer : Counter electro-motive force of the inductor.

Description : What is the phase angle of an ohm inductor in series with an ohm resistor connected to a 5 KHz source?

Last Answer : You need to provide values of resistor and inductor etc to find the phase angle.

Description : A capacitor of capacity `2muF` is changed to a potential different of `12V` . It is then connected across an inductor of inductance `0.6mH` What is th

Last Answer : A capacitor of capacity `2muF` is changed to a potential different of `12V` . It is then ... potential difference across the capacitor is `6.0V` ?

Description : An L-C circuit contains a 0.60 H inductor and a `25muF` capacitor is `3.0xx10^(-5)C?`

Last Answer : An L-C circuit contains a 0.60 H inductor and a `25muF` capacitor is `3.0xx10^(-5)C?`

Description : In a computer is capable to store single binary bit. A) Capacitor B) Flip flop C) Register D) Inductor

Last Answer : Answer : B

Description : Increasing the resonant frequency of an end-fed Marconi antenna can be done by A. adding a capacitor in series and reducing the physical length B. adding an inductor in series C. adding an inductor in series D. All of these

Last Answer : A. adding a capacitor in series and reducing the physical length

Description : When a capacitor is connected in series with a Marconi antenna? A. Antenna open circuit stops transmission B. An inductor of equal value must be added C. No change occurs to antenna D. Antenna resonant frequency increases

Last Answer : D. Antenna resonant frequency increases

Description : In a Computer_________ is capable to store single binary bit. 1) Capacitor 2) Flip Flop 3) Register 4) Inductor

Last Answer : 2) Flip Flop

Description : In a Computer_________ is capable to store single binary bit. 1 Capacitor 2 Flip Flop 3 Register 4 Inductor

Last Answer : 2 Flip Flop

Description : How does a capacitor and an inductor react to (a) low frequency and (b) high frequency?

Last Answer : At low-frequency, a capacitor acts as an open and an inductor acts as a short. At high-frequency, a capacitor acts as a short and an inductor acts as an open.

Description : What is the term for the number of times per second that tank circuit energy is either stored in the inductor or capacitor?

Last Answer : Natural frequency or resonant frequency (f r).

Description : If the inductor and capacitor values are increased, what happens to the resonant frequency?

Last Answer : Decreases.

Description : In an a.c. circuit that contains both an inductor and a capacitor, what term is used for the difference between the individual reactances?

Last Answer : Resultant reactance.

Description : P-n junction when reversed biased acts as a (a) Capacitor (b) inductor (c) on switch (d) off switch

Last Answer : d) off switch

Description : State the advantages and disadvantages of series inductor and shunt capacitor filter.

Last Answer : Advantages of series inductor filter 1. It has low ripple factor at heavy load currents (i.e. low load resistance) 2. It has no surge current through the diode. 3. It reduces the ripple in the DC ... . 3. It has low output voltages for heavy loads. 4. Ripple factor is dependent on the load.

Description : An inductor of Q factor 10 is connected in series with a capacitor having a Q factor of 100. The overall Q factor of the circuit is :  (A) 100/11 (B) 11/100 (C) 110 (D) 1000

Last Answer : An inductor of Q factor 10 is connected in series with a capacitor having a Q factor of 100. The overall Q factor of the circuit is : 100/11

Description : A capacitor start, capacitor run single phase induction motor is basically a : -  a) ac series motor b) dc series motor c) 2 phase induction motor d) 3 phase induction motor

Last Answer : A capacitor start, capacitor run single phase induction motor is basically a : -  2 phase induction motor 

Description : Is it okay to shoot 12 gauge slugs out of a barrel with a modified choke tube in it?

Last Answer : Trenchcoat mafia? Of course it’s okay, try it out… let me know how it goes…

Description : Draw the wiring diagram of fluorescent tube. Explain the working of choke and starter. 

Last Answer : Fluorescent lamp:- Operation:- When switch is ON current flows through the choke-filament no1- starter-filament no. 2- to neutral, At that time choke induces high voltage which is applied to ... at the time of starting. ii) Starter: To make and break the circuit to start the tube. 

Description : The purpose of a choke in a fluorescent tube is (A) To decrease the current (B) To increase the current (C) To decrease the voltage momentarily (D) To increase the voltage momentarily

Last Answer : The purpose of a choke in a fluorescent tube is To increase the voltage momentarily

Description : To limit current in LED, resistor should be connected in A. parallel B. series C. evacuated flask D. ionized tube

Last Answer : series

Description : The following is an amplifying device : (1) a transformer (2) a transistor (3) a diode (4) a resistor

Last Answer : (2) a transistor Explanation: A transistor is a semiconductor device used to amplify or switch electronic signals and electrical power.

Description : Ratio of voltages is inverse ratio of the A. transformer B. resistor C. iron core D. current

Last Answer : current

Description : In transformer, alternating current is induced inA. primary coil B. secondary coil C. iron core D. resistor

Last Answer : primary coil

Description : A transformer has a turns ratio of two to one. If a 100 ohm resistor is connected on the high side, its resistance as measured on the low side would be: w) 25 ohms x) 50 ohms y) 100 ohms z) 400 ohms

Last Answer : ANSWER: W -- 25 OHMS

Description : Which one among the following components is used as an amplifying device? (1) Transformer (2) Diode (3) Capacitor (4) Transistor

Last Answer : (4) Transistor Explanation: An amplifier is an electronic device that increases the voltage, current, or power of a signal. Generally transistors are active devices that can be used with discrete components to amplify voltage, power or both depending upon the configuration.