Which one of the following applications software’s is used to obtain an accurate root locus for? a) LISP b) MATLAB c) dBase d) Oracle Ans: B   6.Lenz devised a rule to find out direction of a)current induced in a circuit b)electromagneticdifference c)potential difference d)flow of power in fuse

1 Answer

Answer :

Ans: A

Related questions

Description : The induced emf in a material opposes the flux producing it. This is a) Faraday law b) Ampere law c) Lenz law d) Curie law

Last Answer : c) Lenz law

Description : A circuit breaker and a fuse have a basic similarity in that they both _____________. A. can be reset to energize the circuit B. should open the circuit when overloaded C. will burn out when an over current flow develops D. all of the above

Last Answer : Answer: B

Description : Flemings right hand rule is used to find the direction of the – (1) Alternate current (2) Direct current (3) Induced current (4) Actual current

Last Answer : (3) Induced current Explanation: Fleming's right hand rule shows the direction of induced current when a conductor moves in a magnetic field. The right hand is held with the thumb, first ... finger mutually perpendicular to each other. The rule is named after British engineer John Ambrose Fleming.

Description : The left hand rule correlates to (a) current, induced e.m.f. and direction of force on a conductor (b) magnetic field, electric field and direction of force on a conductor (c) self induction, ... and direction of force on a conductor (d) current, magnetic field and direction of force on a conductor

Last Answer : (d) current, magnetic field and direction of force on a conductor

Description : “The direction of induced current is always so as to oppose the change which causes the Current” is the statement of: a. Faraday’s law b. Lenz’s Law c. Ohm’s Law d. Kirchoff’s rule.

Last Answer : c. Ohm’s Law

Description : Fleming’s right hand rule is used to find the direction of the (1) Alternate current (2) Direct current (3) Induced current (4) Actual current

Last Answer : Induced current

Description : When troubleshooting electronic equipment, you should use a high impedance multimeter ________________. A. to prevent excess current flow through the meter that would damage it B. for AC measurements only ... being tested D. so as not to load down the circuit and obtain erroneous voltage readings

Last Answer : Answer: D

Description : What is the difference between softwares and applications?

Last Answer : Oftentimes, a program have different names depending on what platform it run on. Windows tried to merge software with apps when they first launched Windows 8 a couple years back, but my general knowledge is that software runs on computers and applications runs on portable devices.

Description : 3. Overhead projector is superior to short circuit TV in a classroom teaching because (a) It is cheap and self devised (6) Pictures in it may be shown in a desired sequence and with a minimum of lost motion (material) (c) Information presented though it is easily retained (d) it is easy to use

Last Answer : (c) Information presented though it is easily retained

Description : Capacitance in an AC circuit will _____________. A. stop current flow once the capacitor is fully charged B. allow current flow in only one direction C. oppose any change in circuit voltage D. rectify the current

Last Answer : Answer: C

Description : In which direction the induced current will flow in an AND WHY?

Last Answer : The direction of an induced current in a conductor is determined by the direction of the changing magnetic field that is inducing the current, as well as the direction of the movement of the ... induction that is based on the interaction between a magnetic field and the movement of a conductor.

Description : A fuse will 'blow' if _____________. A. an electric motor is stopped suddenly by opening a switch B. the flow of current to the protection device is reversed C. the electrical current exceeds the rated value of the fuse D. unequal resistors are connected in parallel

Last Answer : Answer: C

Description : An instantaneous-trip-type fuse will _____________. A. open as soon as the load current exceeds its set point B. allow a preset delay between overcurrent and melting C. open a circuit by using a time delay element with a magnetic trip D. reset itself when the overcurrent is corrected

Last Answer : Answer: A

Description : What rule should you use to determine the direction of induced emf in a coil?

Last Answer : The left-hand rule for generators.

Last Answer : While applying Fleming's right-hand rule to And the direction of induced e.m.f., the thumb points towards direction of motion of conductor, if forefinger points along the lines of flux.

Last Answer : Fleming's right-hand rule regarding direction of induced e.m.f., correlates magnetic flux, direction of motion and the direction of e.m.f. induced.

Description : According to Fleming's right-hand rule for finding the direction of induced e.m.f., when middle finger points in the direction of induced e.m.f., forefinger will point in the direction of?

Last Answer : According to Fleming's right-hand rule for finding the direction of induced e.m.f., when middle finger points in the direction of induced e.m.f., forefinger will point in the direction of lines of force.

Description : Which one of the following statements is not correct? A Since voltage depends on concentrations, using standard conditions makes it easier to compare different electrochemical reactions. B We have ... half-reactions are determined by combining the relevant half-cell with a standardised half-cell.

Last Answer : C The direction of a redox reaction can only be determined experimentally. 

Description : The function of fuse in an electrical circuit is (a) avoid electric shocks (b) regulate the flow of current (c) break the circuit in case of overloading or short circuiting (d) switch off current

Last Answer : Ans:(c)

Description : Windows is an operating system that lets you use different types of applications or softwares. -Technology

Last Answer : TrueWindows allows us to use a Word processing application to write a letter. It also lets you to use different types of applications or softwares.

Description : Electric current produces magnetic field was suggested by: a. Faraday b. Lenz c. Ohm d. Oerested

Last Answer : c. Ohm

Description : __________ is theclear leader for personal databases. A) Microsoft Access B) Microsoft FoxPro C) Borland dBase D) MySQL

Last Answer : Microsoft Access

Description : Which of the following packages is used for composition in printing press? 1) Lotus 2) dBase 3) Page Maker 4) Word Perfect

Last Answer : 3) Page Maker

Description : In order to safely carry out repairs to a generator circuit breaker, it must be isolated from the bus. This is accomplished by opening the _____________. A. reverse power relay B. bus disconnect link C. generator bus fuse connections D. power directional relay

Last Answer : Answer: B

Description : How to find the crossing point of root locus in imaginary axis.

Last Answer : Method (i) by Routh Hurwitz criterion Method (ii) by letting s=jw in the characteristics equation.

Description : How will you find root locus on real axis.

Last Answer : To find the root locus on real axis, choose a test point on real axis. If the total number of poles and zeros on the real axis to the right of this rest point is odd number then the rest point lies on the root locus. If it is even then the test point does not lie on the root locus.

Description : What are the main significances of root locus?

Last Answer : i. The main root locus technique is used for stability analysis. ii. Using root locus technique the range of values of K, for as table system can be determined

Description : In root locus plot, a point on the real axis lies on the locus, if the number of open loop poles plus zeros on real axis to the a) left of the point is odd b) left of the point is even . c) right of the pointis odd d) right of the point is even

Last Answer : In root locus plot, a point on the real axis lies on the locus, if the number of open loop poles plus zeros on real axis to the right of the pointis odd

Description : After drawing the Root-Locus, the closed-loop poles corresponding to a specified value of gain K can be determined from which of the following criterion ? (A) Magnitude criterion alone (B) Angle criterion alone (C) Both Magnitude and Angle criteria (D) Angle of departure and angle of arrival.

Last Answer : After drawing the Root-Locus, the closed-loop poles corresponding to a specified value of gain K can be determined from which of the following criterion ? (A) Magnitude criterion alone (B) Angle ... (C) Both Magnitude and Angle criteria (D) Angle of departure and angle of arrival.

Description : Whether a given point in the S-plane lies on the Root Locus of a system can be determined by (A) Magnitude criterion (B) Angle Criterion (C) Both Magnitude and Angle Criteria (D) Break-in and Break-away Criteria

Last Answer : Whether a given point in the S-plane lies on the Root Locus of a system can be determined by Angle Criterion

Description : The true power indicated by a wattmeter depends on the current flow through the load, the magnitude of the potential across the load, and the _____________. A. power factor of the load B. angle of coil displacement C. inertia of the movable coil D. high resistance from the load

Last Answer : Answer: A

Description : The true power indicated by the pointer movement of a wattmeter depends on the current flow through the load, the magnitude of the potential across the load, and the ____________. A. power factor of the ... B. angle of coil displacement C. inertia of the movable coil D. high resistance from the load

Last Answer : Answer: A

Description : The apparent power in a purely inductive circuit is also known as _____________. A. true power B. lead power C. induced power D. reactive power

Last Answer : Answer: D

Description : A commutator in a d.c. machine (A) Reduces power loss in armature. (B) Reduces power loss in field circuit. (C) Converts the induced a.c armature voltage into direct voltage. (D) Is not necessary.

Last Answer : Ans: C As name suggests, it commutes ac into dc.

Description : In the illustrated electronic governor, the circuit card connected to the potential and current transformers is for ________. EL-0046 A. increasing the signal strength to the governor to ... from motorization D. conditioning the load through the use of a magnetic amplifier current transformer

Last Answer : Answer: A

Description : The purpose of resistor bank 'R1-R5' in the winch circuit shown in the illustration is to ______________. EL-0102 A. limit armature current in lower and 'series field' current in hoist to ... required speeds D. regulate the strength of the brake solenoid 'B1-B2' in both directions of operation

Last Answer : Answer: C

Description : When the current in a power transmission line is increased, the power loss _____________. A. increases as the square of the current B. decreases as the square root of the current C. remains the same, as it is independent of current flow D. increases in direct proportion as the current

Last Answer : Answer: A

Description : How we can find the direction of induced emf? 

Last Answer : The direction of induced emf can be find out by the Fleming's right hand rule', and lenz's law' Fleming's right hand rule : Fleming's right hand rule states that, if ... that the action of magnetic field set up by induced current tends to opposes the root cause which produces it. 

Description : In the illustrated motor controller, the motor fails to start. A voltmeter reading between 1 and 6 reads line voltage, while the voltmeter reading between 2 and 6 reads 0 VAC. The problem is __________. EL- ... in the 'M' coil, 'Ma' contact/start switch or overload contacts D. fuse '10a' is blown

Last Answer : Answer: B

Description : Which of the following precautions should be taken when a blown fuse, rated at 10 amperes, is replaced? A. Short out the fuse before removing it from the circuit. B. Use needle-nose pliers to ... D. Fuses of 10 ampere rating and less are virtually harmless when energized and may be handled freely.

Last Answer : Answer: C

Description : In the lighting distribution circuit shown in the illustration, if all switches are closed and fuse 'F2' were to open, all lights on branches ____________. EL-0013 A. '1', '2', and '3' would go out B. '1' ... and '3' would burn dimly D. '1' and '3' would go out, while branch '2' would remain lit

Last Answer : Answer: D

Description : In LISP, the square root of X is referenced as _____________ a) sqrt(x) b) (sqrt x) c) x/2 d) x/3

Last Answer : b) (sqrt x)

Description : If a voltage tester is being used to check for defective fuses in the circuit, shown in the illustration, which of the readings will indicate that fuse #2 is open? EL-0062 A. C-B full voltage B. A-D full voltage C. A-D no voltage D. C-B no voltage

Last Answer : Answer: C

Description : The schematic diagram shown in the illustration uses symbol 'A' to represent a/an _________. EL-0011 A. non-renewable fuse link B. circuit breaker coil C. overload relay coil D. thermal overload heater

Last Answer : Answer: D

Description : If an electric motor fails to start, you should FIRST check the _____________. A. phase sequence B. ampere load C. fuse or circuit breaker D. line frequency

Last Answer : Answer: C

Description : When testing for blown fuses in a three-phase supply circuit to a motor, you should first ___________________. A. apply the megger across the tops of the line fuses B. apply an ammeter diagonally across ... of the line fuses D. ensure the circuit is de-energized, and then use a continuity tester

Last Answer : Answer: D

Description : When an AC or a DC motor fails to start, the FIRST step in troubleshooting should be to check the ____________. A. motor windings for obvious opens B. motor controller leads for continuity C. fuse or circuit breaker D. motor controller leads for grounds

Last Answer : Answer: C

Description : In the illustration if BRANCH NO. 1 is a lighting circuit for crew's berthing, Federal Regulations (46 CFR) require the maximum fuse rating for that branch to be _________. EL-0013 A. 80% of the connected load B. 15 amps C. 20 amps D. 30 amps

Last Answer : Answer: C

Description : A circuit with a blown fuse would be described as a/an _____________. A. short circuit B. open circuit C. bonded circuit D. grounded circuit

Last Answer : Answer: B

Description : In the illustration if BRANCH NO. 1 is a lighting circuit for crew's berthing, 46 CFR requires the maximum fuse rating for that branch to be _________. EL-0013 A. 15 amps B. 80% of the connected load C. 20 amps D. 30 amps

Last Answer : Answer: C