HDL2 have the density in the range of (A) 1.006–1.019 (B) 1.019–1.032 (C) 1.032–1.063 (D) 1.063–1.125

1 Answer

Answer :

Answer : D

Related questions

Description : β-lipoproteins have the density in the range of (A) 0.95–1.006 (B) 1.006–1.019 (C) 1.019–1.063 (D) 1.063–1.125

Last Answer : Answer : C

Description : IDL have the density in the range of (A) 0.95–1.006 (B) 1.006–1.019 (C) 1.019–1.032 (D) 1.032–1.163

Last Answer : Answer : B

Description : Hydrated density of HD lipoproteins is (A) 0.94 gm/ml (B) 0.94–1.006 gm/ml (C) 1.006–1.063 gm/ml (D) 1.063–1.21 gm/ml

Last Answer : Answer : D

Description : Hydrated density of (HD) lipoproteins is (A) 0.94 gm/ml (B) 0.94-1.006 gm/ml (C) 1.006-1.063 gm/ml (D) 1.063-1.21 gm/l

Last Answer : Answer : B

Description : Activated lecithin cholesterol acyl transferase is essential for the conversion of (A) VLDL remnants into LDL (B) Nascent HDL into HDL (C) HDL2 into HDL3 (D) HDL3 into HDL2

Last Answer : Answer : B

Description : Heparin releasable hepatic lipase converts (A) VLDL remnants into LDL (B) Nascent HDL into HDL (C) HDL2 into HDL3 (D) HDL3 into HDL2

Last Answer : Answer : C

Description : What number is greater 2.1 or 2.019?

Last Answer : 2.1 is the greater number

Description : The sag of 50 m tape weighing 4 kg under 5 kg tension is roughly  (A) 0.043 m  (B) 0.053 m  (C) 0.063 m  (D) 0.083 m 

Last Answer : (D) 0.083 m 

Description : Is 0.060 greater than 0.006?

Last Answer : Yes.

Description : Is 0.006 greater or 0.60?

Last Answer : What is the answer ?

Description : When the torsional pendulum vibrating the observed amplitudes on the same side of neutral axis for successive cycles are found to decay 50% of the initial value determine logarithmic decrement. A 0.065 B 0.006 C 0.693 D 0.5

Last Answer : C 0.693

Description : When the torsional pendulum vibrating, the observed amplitudes on the same side of the neutral axis for successive cycles are found to decay 50% of the initial value determine logarithmic decrement. A 0.065 B 0.006 C 0.693 D 0.5

Last Answer : C 0.693

Description : Calculate the static deflection in μm of transverse vibrations if the frequency is 200Hz. A. 6.21 B. 0.621 C. 62.1 D. 0.006

Last Answer : A. 6.21

Description : Calculate the static deflection in μm of transverse vibrations if the frequency is 200Hz. a) 6 b) 0.6 c) 60 d) 0.006

Last Answer : a) 6

Description : The concrete is assumed to reach failure with a compression strain of [ A ] 0.002 [ B ] 0.0035 [ C ] 0.0045 [ D ] 0.006

Last Answer : [ B ] 0.0035

Description : The ultimate strain of concrete at failure is [ A ] 0.002 [ B ] 0.0035 [ C ] 0.0045 [ D ] 0.006

Last Answer : [ B ] 0.0035

Description : The concrete is assumed to reach failure with a compression strain of [ A ] 0.002 [ B ] 0.0035 [ C ] 0.0045 [ D ] 0.006

Last Answer : [ B ] 0.0035

Description : The ultimate strain of concrete at failure is [ A ] 0.002 [ B ] 0.0035 [ C ] 0.0045 [ D ] 0.006

Last Answer : [ B ] 0.0035

Description : What is the recommended minimum range of illumination required by BS EN 970 for inspection of a welded surface? a) 90 to 125 lux b) 150 to 250 lux c) 350 to 500 lux d) 35 to 50 lux

Last Answer : c) 350 to 500 lux

Description : Find the flux density of a sheet of charge density 25 units in air. a) 25 b) 12.5 c) 6.25 d) 3.125

Last Answer : b) 12.5

Description : The total sulphur content of the body is (A) 25–50 gm (B) 50–75 gm (C) 100–125 gm (D) 150–200 gm

Last Answer : Answer : D

Description : Dictary deficiency of this vitamin leads to night blindness: (A) Retinol (B) Niacin (C) Ascorbic acid (D) Cholecalciferol VITAMINS 125

Last Answer : Answer : A

Description : What is the half life of Iodine-125? 

Last Answer : About 60 days.

Description : A jet of water of cross-sectional area 20 sq. cm impinges on a plate at an angle of 60? with a velocity of 10 m/sec. Neglecting the friction between the jet and plate (density of water 1000/9.81 kgm-1 sec2 per cubic meter), the ... a.15 - 20 kg b.20 - 25 kg c.5 - 10 kg d.25 - 30 kg e.10 - 15 kg

Last Answer : a. 15 - 20 kg

Description : Why are there a wide range of colours, hardness, crystal forms, luster and density found in minerals ? -SST 10th

Last Answer : A wide range of colours, hardness, crystal forms, luster, and density is found in minerals because of the high levels of variations in physical and chemical conditions under which a mineral is formed.

Description : Why are there a wide range of colours, hardness, crystal forms, lustre and density found in minerals? -SST 10th

Last Answer : The ranges found in minerals are due to physical and chemical conditions.

Description : Select the correct range of density index, ID (A) ID > 0 (B) ID < 0 (C) 0 < ID < 1 (D) 0 < ID < 1

Last Answer : Option D