Which configuration has the lowest current gain ?

1 Answer

Answer :

Common base configuration has the lowest current gain.

Related questions

Description : What is the current gain?

Last Answer : Current gain β = Ic/Ib

Description :  If the base current of a BJT is 250 µA and emitter current is 15 mA, then the common base current gain will be A) 0.98 B) 0.41 C) 59 D) 55  

Last Answer :  If the base current of a BJT is 250 µA and emitter current is 15 mA, then the common base current gain will be 0.98 

Description : The lowest eigenvalue of the 2x2 matrix 

Last Answer : Linear Algebra Problem The lowest eigenvalue of the 2x2 matrix https://youtu.be/QatcRTzF7EA

Description : Which of the following has the lowest electrical conductivity? A) Mercury B) Silver C) Copper D) Gold

Last Answer : Which of the following has the lowest electrical conductivity? A) Mercury B) Silver C) Copper D) Gold

Description : Which of the following waveforms has the lowest form factor? A) Sine wave B) Square wave C) Sawtooth wave D) Triangle wave

Last Answer : Which of the following waveforms has the lowest form factor? A) Sine wave B) Square wave C) Sawtooth wave D) Triangle wave

Description : Draw O/P characteristics of CB configuration and explain its working.

Last Answer : In common base configuration, emitter is the input terminal, collector is the output terminal and base terminal is connected as a common terminal for both input and output. The base-emitter ... In this region, a small collector current flows called leakage current when emitter current is zero.

Description : Draw full bridge & half bridge configuration with common cathode.

Last Answer : Half Bridge Configuration: Full Bridge Configuration: 

Description : Sketch output characteristics of CE configuration. Show all the regions.

Last Answer : Sketch output characteristics of CE configuration. Show all the regions.

Description : Compare between CB , CE & CC transistor configuration.

Last Answer : Parameter CB CE CC I/P impedance Low Or 50Ω Medium Or 600Ωto 4kΩ High Or 1 MΩ Current Gain Less than or equal to 1 High Highest Voltage Gain Medium Medium Less ... k Ω to 50 k Ω Low Or 50 Ω Phase shift between input and output 0° 360° 0° 

Description : Why common emitter configuration is commonly used?

Last Answer : Common emitter configuration is commonly used for amplifications because 1. The common emitter configuration (CE) provides maximum voltage and current gain and hence provides maximum power gain. The ... automatic impedance matching maximum power transfer will take place from one stage to other.

Description : Explain MOSFET gate drive circuit and totem pole configuration.

Last Answer : MOSFET gate drive circuit: The turning on and turning off of MOSFET can be controlled from gate to source voltage signal. If the gate to source voltage of MOSFET exceeds threshold ... this configuration, the two switches (transistors) are used in totem pole arrangement with a comparator.

Description : A differential amplifier has a differential gain of 28000 and CMRR is 60 dB. What will be the value of common mode gain? A) Ac = 0.125 B) Ac = 0.33 C) Ac = 3 D) Ac = 28 

Last Answer : A differential amplifier has a differential gain of 28000 and CMRR is 60 dB. What will be the value of common mode gain? A) Ac = 0.125 B) Ac = 0.33 C) Ac = 3 D) Ac = 28 

Description : The effect of a finite gain of an operational amplifier used in an integrator is that (A) it would not integrate (B) the slope of the output will vary with time (C) the final value of the output voltage will reduce (D) there will be instability in the circuit

Last Answer : The effect of a finite gain of an operational amplifier used in an integrator is that there will be instability in the circuit

Last Answer : The voltage gain of triode depends on plate voltage.

Description : How to Make a Weight Gain Diet Plan

Last Answer : Before you can mold your body into a defined and well-chiseled frame, you have to gain some mass, which acts like a canvas to a painter or a slab of clay to a sculptor. Gaining weight ... a nutritionist. He or she will examine your physique and determine the best components of the ideal food ratio.

Description : How to Gain Muscle

Last Answer : How to Gain Muscle Different dietary supplements, pills and drinks may promise you to grow muscles in a fast rate, but don't be fooled: These aren't the answer! Gaining muscle is not ... optimize the stress on your muscles, burns more fat and most importantly, builds your muscle even further.

Description : How to Gain Weight ?

Last Answer : How to Gain Weight It's quite strange that people who are very slim can be just as embarrassed about taking their tops off in public as people who are overweight. There's just something so appealing ... . This is your number one key to bulking up and getting the muscles you've always dreamed of!

Description : How to Make a Weight Gain Diet Plan ?

Last Answer : Before you can mold your body into a defined and well-chiseled frame, you have to gain some mass, which acts like a canvas to a painter or a slab of clay to a sculptor. Gaining weight ... a nutritionist. He or she will examine your physique and determine the best components of the ideal food ratio.

Description : Define gain and bandwidth of an amplifier.

Last Answer : Bandwidth  The range of frequency over which the voltage gain is equal to or greater than 70.7% of its maximum value Gain: The ratio of output parameter (voltage/ current /power) to the input parameter (voltage/ current /power) of an amplifier is known as gain. It is denoted by a letter A

Description : The unity gain bandwidth of an inverting amplifier is 10 MHz What would be the bandwidth if the gain is increased to 10 V/V? A) 100 MHz B) 1 MHz C) 10 MHz D) 1 kHz 

Last Answer : The unity gain bandwidth of an inverting amplifier is 10 MHz What would be the bandwidth if the gain is increased to 10 V/V? A) 100 MHz B) 1 MHz C) 10 MHz D) 1 kHz 

Description : What will happen to the gain margin if the gain of the open loop system is doubled? A) Doubled B) Becomes half C) Is not affected D) Becomes one-fourth 

Last Answer : What will happen to the gain margin if the gain of the open loop system is doubled? A) Doubled B) Becomes half C) Is not affected D) Becomes one-fourth 

Description : A differential amplifier has a differential gain of 20,000, CMRR : 80 dB. The common mode gain is given by

Last Answer : A differential amplifier has a differential gain of 20,000, CMRR : 80 dB. The common mode gain is given by 2

Description : A transfer function has a second order denominator and constant gain in the numerator

Last Answer : A transfer function has a second order denominator and constant gain in the numerator the system has two zeros at infinity

Description : An amplifier has a voltage gain of 120. To reduce distortion, 10% negative feedback is employed. The gain of the amplifier with feedback is  (1) 141 (2) 92.3 (3) 9.23 (4) 1.41

Last Answer : An amplifier has a voltage gain of 120. To reduce distortion, 10% negative feedback is employed. The gain of the amplifier with feedback is 9.23

Description : The voltage gain of a common -source JFET amplifier depends up on its  (1) Input impedance (2) Amplification factor (3) Dynamic drain resistance (4) Drain load resistance

Last Answer : B

Description : If the gain of the open loop system is doubled, the gain margin  (1) Is not affected (2) Gets doubled (3) Becomes half (4) Becomes one -forth

Last Answer : If the gain of the open loop system is doubled, the gain margin Becomes half

Description : The gain of an ideal amplifier must be

Last Answer : The gain of an ideal amplifier must be infinity

Description : What is Mason's gain formula?

Last Answer : Mason's Gain Formula

Description : Define: i) Input Offset Voltage ii) Input offset Current iii) Input Bias Current iv) Output offset voltage

Last Answer : Definition of parameters of OPAMP is follows:  i) Input Offset Voltage: Input offset voltage is defined as the voltage that must be applied between the two input terminals of an OPAMP to null or ... to ground) and output voltage is obtained non zero such voltage is output offset voltage of opamp.

Description : The leakage current of PN junction is caused by?

Last Answer : The leakage current of PN junction is caused by heat energy.

Last Answer : In Reverse bias of diode when the cathode is connected to positive and anode is connected to negative very small current flows this very small current is known as leakage current of diode.

Last Answer : In  BJT  there  is  movement  of   electrons  and  holes   accros  the  junctions  which  is  basicaly  current  flow.

Description : Analyze the effect of supply voltage on performance of LED as regards current, Lumen output, efficacy and life. 

Last Answer : 1) Effect on Current:- In LED current depends upon supply voltage, if voltage get changes then current also change but this change in current will be control by resistors which are connected in series.  2) ...   4) Effect on Life:- If supply voltage is not stable then life of LED get reduced. 

Description : With the help of N-channel JFET describe the effect of input voltage VGS on output current ID.

Last Answer : Working of N channel FET: * When a voltage is applied between the drain and source with a DC supply (VDD), the electrons flows from source to drain through narrow channel ... where the channel gets completely blocked and the drain current becomes zero is called pinch- off voltage. 

Description : Current division rule example

Last Answer : Current division rule example

Description : A linear network has a current input 4cos(ω t + 20º)A and a voltage output 10 cos(ωt +110º) V. Determine the associated impedance.

Last Answer : Solution

Description : Find current through resistor using nodal analysis

Last Answer : Find current through resistor using nodal analysis

Description : Nodal analysis problem two current source

Last Answer : Nodal analysis problem two current source

Description : Direct Current (DC) Next Topic : Alternating current (AC)

Last Answer : Direct Current (DC) is the unidirectional electric current. Uni meaning is one. And the flow of charge in same direction. We know that conventional current flow from positive terminal of battery to ... The magnitude of DC may constant or vary but direction do not change with respect to time.

Description : Alternating current (AC)

Last Answer : AC stands for Alternating Current meaning voltage or current that changes polarity or direction respectively over time. An Alternating Current (AC) is an electric current whose magnitude ... energy are known as alternators and are simpler construction than DC electromechanical generators.

Description : Does current flow through a capacitor ?

Last Answer : Imagine a pipe with a flexible diaphram in the middle separating two haves of the pipe. Now the pipe is filled with air. If you apply a pressure to one end the diaphram will deform ... capacitor, the effects on electrons will be recreated across the boundary. But theres no electrical connection...

Description : What kills, current or voltage?

Last Answer : Current would kill. You can actually have thousands of bolts going through you and not even know it. Yes you probably know already voltage is current times resistance. Since your body is a resistor it would take just a small amount of current to create a very high voltage

Description : Electric Current

Last Answer : Electric current is the flow of charges. The electrons flow from higher density area of electrons to lowers density area of electrons. The terminal of battery which we called positive terminal of ... circuit is called electric current. The unit of electric current is Coulomb per Second or Ampere.

Description : Define current. State its unit.

Last Answer : Electric current: It is a measure of the amount of electrical charge transferred per unit time. It represents the flow of electrons through a conductive material, such as a metal wire. Unit: 1 coulomb/second. OR Its unit is ampere represented by A

Description : Give two applications of each : 1) Eddy current sensor 2) Optical sensor.

Last Answer : Eddy current sensor : 1. Detection of non-magnetic but conductive materials. 2. Displacement sensing 3. Position sensing Optical sensor : 1. Position Detection 2. Velocity Detection 3. Acceleration Detection 4. Direction Detection

Description : Alternating current

Last Answer : .embed-container { position: relative; padding-bottom: 56.25%; height: 0; overflow: hidden; max-width: 100%; } .embed-container iframe, .embed-container object, .embed-container embed { position: absolute; top: 0; left: 0; width: 100%; height: 100%; }

Description : A charge of 0.1 C moves past a given point every 0.01 s. How much is the current?

Last Answer : The current is 10.0A.  1ampere = 1 Coulomb per 1 second.  0.1Coulombs ÷ 0.01seconds = 10.0amperes.

Description : Describe the difference between direct and alternating current.

Last Answer : Direct current is the flow of electricity or charge in one direction..  Alternative current is the flow of charge that doesn't flow in one direction. 

Description : A) Watt B) Volts C) Farad D) Ampere

Last Answer : Correct answer: D) Ampere

Description : Current ratio

Last Answer : Current ratio