x

Can a supernode contain a resistor?

85 views

1 Answer

Answer :

contain
Like 0 like

Please log in or register to answer this question.

Related Questions


What is a supernode?
Last Answer : supernode

Show More

106 views 1 answer



Nodal Analysis with Voltage Sources dependent voltage source and two supernode
Last Answer : Nodal Analysis with Voltage Sources dependent voltage source and two supernode

Show More

218 views 1 answer



Nodal analysis example with voltage source and supernode
Last Answer : Nodal analysis example with voltage source and supernode

Show More

154 views 1 answer



Find current through resistor using nodal analysis
Last Answer : Find current through resistor using nodal analysis

Show More

933 views 1 answer



State the applications and specification of (i) Resistor (ii) Capacitor (iii)Inductor
Last Answer : Application of resistor: 1.Resistors are used in high frequency instrument. 2.Resistor is used in power control circuit. 3.It is used in DC power supplies. 4.Resistors are used ... DC Current  3.Electromagnetic Interference (EMI)  4.Magnetic Saturation Flux Density  5.Curie Temperature 

Show More

268 views 1 answer



Define resistor and draw symbol of variable resistor.
Last Answer : Resistor: A resistor is an electrical component that limits or regulates the flow of electrical current in an electronic circuit. Symbol of variable resistor:   

Show More

120 views 1 answer





Source transformation Replace the circuit with voltage source in series with a single resistor
Last Answer : Source transformation Replace the circuit with voltage source in series with a single resistor

Show More

252 views 1 answer





Which of the following is NOT a non-linear resistor? A) Varistor B) Precision resistor C) NTC thermistor D) PTC thermistor 
Last Answer : Which of the following is NOT a non-linear resistor? A) Varistor B) Precision resistor C) NTC thermistor D) PTC thermistor 

Show More

346 views 1 answer



 A resistor in which the resistance changes exponentially with change in temperature is called as A) Potentiometer B) Phototransistor C) Varactor D) Thermistor 
Last Answer :  A resistor in which the resistance changes exponentially with change in temperature is called as Thermistor 

Show More

212 views 1 answer



A 1000Ohm, 1 Watt resistor can safely pass a current of
Last Answer : A 1000 Ohm, 1 Watt resistor can safely pass a current of 30 mA

Show More

469 views 1 answer



In a 5 bit weighted resistor D/A converters, the resistor value corresponding to LSB is 40 kΩ, and the resistor value corresponding to MSB will be (A) 0.4 kΩ (B) 3 kΩ (C) 2.8 kΩ (D) 2.5 kΩ
Last Answer : In a 5 bit weighted resistor D/A converters, the resistor value corresponding to LSB is 40 kΩ, and the resistor value corresponding to MSB will be 2.5 kΩ 

Show More

107 views 1 answer



An open resistor, when checked with an ohm-meter reads?
Last Answer : An open resistor, when checked with an ohm-meter reads infinite.

Show More

117 views 1 answer




Last Answer : Standard resistor is made from maganin.

Show More

57 views 1 answer



Discuss DAC architectures based on resistor ladders.

Show More

81 views 0 answers



If the 12 Ohm resistor draws a current of 1 A as shown in the figure, the value of resistance R is
Last Answer : If the 12 Ohm resistor draws a current of 1 A as shown in the figure, the value of resistance R is

Show More

882 views 1 answer



To determine the polarity of the voltage drop across a resistor, it is necessary to know?
Last Answer : To determine the polarity of the voltage drop across a resistor, it is necessary to know direction of current through the resistor.

Show More

774 views 1 answer





48 views 0 answers



Nodal analysis problem two current source
Last Answer : Nodal analysis problem two current source

Show More

373 views 1 answer



Nodal analysis problem
Last Answer : Nodal analysis problem

Show More

165 views 2 answers



What is branch?
Last Answer : A path which connects two node is called branch.

Show More

2.6k views 1 answer



What is node?
Last Answer : A point in a circuit where two or more circuit elements are joined it is called node.

Show More

2.6k views 1 answer



What is active and passive network?
Last Answer : Active network is a network which contain one or more than one EMF source. An active network consists of an active element like battery or transistor. Passive network is a ... contain any source of energy. Passive network consists of passive element like resistance, inductance and capacitance.

Show More

132 views 1 answer



In the circuit shown below, the current through the inductor is,
Last Answer : .embed-container { position: relative; padding-bottom: 56.25%; height: 0; overflow: hidden; max-width: 100%; } .embed-container iframe, .embed-container object, .embed-container embed { position: absolute; top: 0; left: 0; width: 100%; height: 100%; }

Show More

220 views 3 answers




Last Answer : What do you mean by parameter?! In the Z-transform we find zeros and poles of a system,so we can find the revergence area of a system

Show More

189 views 1 answer



A tree of a network graph consists of (A) (n-1) nodes (B) n branches (C) one or two nodes left in isolated position (D) no closed paths 
Last Answer : The dual of a tree is sometimes called a maze Itconsists of spaces connected by links in the same way that the tree consists of nodes connected by treebranches. Duals cannot be formed for every graph. ... Consequently, only planar graphs have duals.

Show More

205 views 1 answer



To neglect a voltage source, the terminals across the source are _____
Last Answer : To neglect a voltage source, the terminals across the source are short circuited

Show More

1.5k views 1 answer



To find current in a resistance connected in a network, Thevenin's theorem is used VTH = 20 V and RTH = 5 Ω. The current through the resistance: (1) is 4 A (2) is 4 A or less (3) is less than 4 A (4) May be 4 A or less or more than 4 A
Last Answer : To find current in a resistance connected in a network, Thevenin's theorem is used VTH = 20 V and RTH = 5 Ω. The current through the resistance: is less than 4 A 

Show More

409 views 1 answer



An R-L series AC circuit has R = 10 ohm and XL = 10 ohm. It is connected to an AC voltage source, the phase angle between voltage and current is (a) 30° (b) 45° (c) 60° (d) 36.8°

Show More

153 views 0 answers



In an RLC series AC circuit, if frequency is below the resonant frequency, then (a) XC = XL (b) XC < XL (c) XC > XL (d) None of these 

Show More

148 views 0 answers



Two two-port networks are connected in cascade. The combination is to be represented as a single two-port network. The parameters of the network are obtained by multiplying the individual a. z-parameter matrix b. h-parameter matrix c. y-parameter matrix d. ABCD-parameter matrix
Last Answer : A

Show More

185 views 1 answer



In a graph, the number of independent loops is 6 and the number of independent cut sets is 5, The total number of branches in the graph is A) 9 B) 12 C) 10 D) 11
Last Answer : In a graph, the number of independent loops is 6 and the number of independent cut sets is 5, The total number of branches in the graph is 11

Show More

119 views 1 answer



A voltage signal 10 Sinwt is applied to the circuit with ideal diodes, as shown in figure. The maximum and minimum values of the output waveform vout of the circuit are respectively
Last Answer : A voltage signal 10 Sinwt is applied to the circuit with ideal diodes, as shown in figure. The maximum and minimum values of the output waveform vout of the circuit are respectively +4V and-7V

Show More

578 views 1 answer



In a series RLC circuit at resonance, the magnitude of the voltage developed across the capacitor  A) Is always zero B) Can never be greater than the input voltage C) Can be greater than the input ... input voltage D) Can be greater than the input voltage, and is in phase with the input voltage
Last Answer : In a series RLC circuit at resonance, the magnitude of the voltage developed across the capacitor Can be greater than the input voltage, however, it is 90° out of phase with the input voltage 

Show More

833 views 1 answer



Two incandescent light bulbs of 40 Wand 60 W rating are connected in series across the mains, then .  A) The bulbs together consume 100 W B) The bulbs together consume 50 W C) The 60 W bulb glows brighter D) The 40 W bulb glows brighter
Last Answer : Two incandescent light bulbs of 40 Wand 60 W rating are connected in series across the mains, then . The bulbs together consume 50 W 

Show More

964 views 1 answer



A unit step voltage is applied at t = 0 to a series RL circuit with zero initial conditions  A) It is possible for the current to be oscillatory B) The voltage across the resistor at t ... The energy stored in the inductor in the steady state is zero D) Theresistor current eventually falls to zero 
Last Answer : A

Show More

1.7k views 2 answers



A passive two port network is in a steady state. Compared to its input, the steady state output can never offer  A) Higher voltage B) Lower impedance C) Greater power D) Better regulation
Last Answer : A passive two port network is in a steady state. Compared to its input, the steady state output can never offer Greater power

Show More

318 views 1 answer



Consider the star network shown in figure. The resistance between terminals A and B with C open is 6 ohms, between terminals B and C withAopen is 11 ohms and between terminals C andAwith B open is 9 ohms. Then RA, RB, RC respectively is 
Last Answer : Consider the star network shown in figure. The resistance between terminals A and B with C open is 6 ohms, between terminals B and C withAopen is 11 ohms and between terminals C andAwith B open is 9 ohms. Then RA, RB, RC respectively is  2, 4,7

Show More

161 views 1 answer



The switch in the circuit has been closed for a long time. It is opened at t = 0. At t = 0+, the current through the 1 micro farad capacitor is A) 0A B) 1A C) 1.25A D) 5A
Last Answer : The switch in the circuit has been closed for a long time. It is opened at t = 0. At t = 0+, the current through the 1 micro farad capacitor is 1A

Show More

279 views 1 answer



As shown in the figure, 1 ohm resistance is connected across a source that has a load line v + i = 100. The current through the resistance is A) 25 A B) 50 A C) 100 A D) 200A
Last Answer : As shown in the figure, 1 ohm resistance is connected across a source that has a load line v + i = 100. The current through the resistance is 50 A

Show More

358 views 1 answer



The number of chords in the graph of the given circuit will be
Last Answer : The number of chords in the graph of the given circuit will be 3

Show More

3.4k views 1 answer



The time constant for the  given circuit is A) 1/9 S B) 1/4 S C) 4S D) 9S
Last Answer : The time constant for the given circuit is 4S

Show More

70 views 1 answer



As a network contains only independent current sources and resistors then if the values of all resistors are doubled then the values of the node voltages are   (A) will become half (B) will ... (D) cannot be determined unless the circuit configuration and the values of the resistors are known.
Last Answer : As a network contains only independent current sources and resistors then if the values of all resistors are doubled then the values of the node voltages are will become double 

Show More

1.0k views 1 answer



Consider the following statement for a 2-port network  1. Z11 =Z22  2. h12 = h21  3.Y12 = -Y21 4.BC - AD = -1   then the network is reciprocal if and only if   (A) 1 and 2 are correct (B) 2 and 3 are correct (C) 3 and 4 are correct (D) 4 alone is correct.
Last Answer : Consider the following statement for a 2-port network  1. Z11 =Z22  2. h12 = h21  3.Y12 = -Y21 4.BC - AD = -1   then the network is reciprocal if and only if   (A) 1 and 2 are correct (B) 2 and 3 are correct (C) 3 and 4 are correct (D) 4 alone is correct.

Show More

254 views 1 answer



When the graph of a network has six branches with three tree branches then the minimum number of equations required for the solution of the network is   (A) 2 (B) 3 (C) 4 (D) 5
Last Answer : When the graph of a network has six branches with three tree branches then the minimum number of equations required for the solution of the network is 3 

Show More

340 views 1 answer



With n nodes and b branches a network will have   (A) (b+n) links (B) b - n +1 links (C) b -n-1 links (D) b + n + 1 links 
Last Answer : With n nodes and b branches a network will have  b - n +1 links

Show More

176 views 1 answer



A transmission line is terminated at its characteristic impedance. The reflection coefficient is  (a) 1 (b) –1 (c) 0 (d) ∞
Last Answer : A transmission line is terminated at its characteristic impedance. The reflection coefficient is  0

Show More

955 views 1 answer



In a series RLC circuit operating below the resonant frequency the current  (a) I leads Vs (b) I lags Vs (c) I is in Phase with Vs (d) None of these
Last Answer : In a series RLC circuit operating below the resonant frequency the current  I leads Vs 

Show More

1.0k views 1 answer


Show More⇦ PreviousNext ⇨