Please Log in or Register for more.


98 views

1 Answer

Answer :

Maximum demand on a power plant is the greatest of all "short time interval averaged" demand during a period.

Like 0 like

Please log in or register to answer this question.

Related Questions



Last Answer : In a power plant if the maximum demand on the plant is equal to the plant capacity, then plant reserve capacity will be zero.

Show More

277 views 1 answer














Last Answer : Approximate estimation of power demand can be made by load survey method, statistical methods, mathematical method, economic parameters.

Show More

110 views 1 answer







What is the maximum value of power factor?
Last Answer : 1 is the maximum value of power factor.

Show More

119 views 1 answer








Last Answer : In Hopknison demand rate or two part tariff the demand rate or fixed charges are dependent upon the maximum demand of the consumer.

Show More

76 views 1 answer








Last Answer : Demand factor is defined as maximum demand/connected load.

Show More

76 views 1 answer







What are the criteria for selection of site for hydroelectric power plant?
Last Answer : Following Factors to be kept while site selecting for Hydro power plant:  1. It should be located where high rain fall occurs. 2. A large catchments area must be available to store water. 3. It ... 12. Cost of land should be less. 13. Skilled and unskilled man power should be available nearby.

Show More

2.7k views 1 answer







Explain the function of different parts of a typical nuclear power plant with neat sketch. 
Last Answer : Functions of each part of Nuclear power plant:-  1) Nuclear Reactor: In nuclear reactor the fuel rod of U235 is placed through which tremendous amount of heat energy is ... is mechanically coupled with steam turbine. 8) Alternator: It converts mechanical energy into electrical energy.

Show More

2.8k views 1 answer







With a neat diagram explain pumped storage hydro power plant. 
Last Answer : Diagram of pumped storage hydro power plant: Explanation: In this power plant, generator is so designed that it Converts mechanical power into electrical power and also works as a ... helps in reducing a reserve capacity of PP as it provides additional power during peak load period. 

Show More

837 views 1 answer







Draw a layout of a thermo-chemical based power plant. 
Last Answer : Layout of a thermo-chemical based power plant:  In this process dry biomass fuels converted to produce gas ,liquid fuels or oil by thermo chemical conversion Thermo-Chemical conversion are of following ways:- 1. Direct combustion 2. Gasification 3. Pyrolysis

Show More

2.4k views 1 answer







With a neat diagram explain solar photovoltaic power plant. 
Last Answer : Diagram of solar photovoltaic power plant :  Explanation:  Solar power plant consists of following components:  1. Photovoltaic cell panel: Its function is to convert sunrays directly into DC ... .  5. Step-up transformer: It step-up input voltage to utilization voltage e.g. 230V

Show More

376 views 1 answer








Last Answer : Because of following advantages concentrating type collector are used in solar power plant: -  1. Temperature: Temperature obtained is high because absorber area is less and collector/reflector area ... results: As tracking system is used better results are obtain than flat type collector.

Show More

99 views 1 answer







List the types of turbine used in hydro power plant.  
Last Answer : Following types of turbine used in hydro power plant:  1.Pelton wheel 2.Francis Turbine 3.Kaplan Turbine 4.Propeller Turbine 

Show More

100 views 1 answer







The overall efficiency of Thermal Power Plant is equal to _______________ .  (A) Regenerative Cycle Efficiency (B) Renkine Cycle Efficiency (C) Carnot cycle efficiency (D) None of the above
Last Answer : The overall efficiency of Thermal Power Plant is equal to Regenerative Cycle Efficiency. 

Show More

449 views 1 answer







In a thermal power plant, ash is collected in
Last Answer : In a thermal power plant, ash is collected in hoppers or bunkers

Show More

112 views 1 answer







The rankine cycle efficiency of steam power plant is  (1) 60-80% (3) 30-45% (2) 45-80% (4) 20-30%
Last Answer : The rankine cycle efficiency of steam power plant is 30-45%

Show More

111 views 1 answer








Last Answer : Annual operating expenditure of a power plant consists of fixed charges, semi-fixed charges, running charges.

Show More

69 views 1 answer







What is the largest power plant in the world?
Last Answer : japam

Show More

85 views 2 answers







How many watts does a power plant produce?

Show More

114 views 0 answers







What is the most common type of power plant?
Last Answer : Hydroelectric  power  plant.

Show More

118 views 1 answer







How much electricity is produced by a power plant?

Show More

98 views 0 answers








Last Answer : Hydroelectric power plant is expected to have the longest life.

Show More

80 views 1 answer







Maximum Power Transfer Theorem 1
Last Answer : Maximum Power Transfer Theorem 1

Show More

94 views 1 answer







State maximum power transfer theorem for DC circuit.
Last Answer : Maximum power transfer theorem for DC circuit: The maximum power transfer theorem states that the source or a network transfers maximum power to load only when the load resistance is equal ... removed (disconnected) ii) All internal independent sources are replaced by their internal resistances.

Show More

111 views 1 answer







 An independent voltage source in series with an impedance ZS=R+jXS delivers a maximum average power to a load impedance ZL when A) ZL = R B) ZL = jXS C) ZL = R-jXS D) ZL = R+jXS 
Last Answer :  An independent voltage source in series with an impedance ZS=R+jXS delivers a maximum average power to a load impedance ZL when ZL = R-jXS

Show More

4.0k views 1 answer







A certain power MOSFET has a maximum junction temperature specification of 1500o C, a junction-to-case thermal resistance of 1.00 C/W, and a junction-to ambient thermal resistance of 600 C/W. If the ambient temperature is 300o C ... the device will be A) 1.52 W B) 1.72 W C) 1.92W D) 2.00 W
Last Answer : A certain power MOSFET has a maximum junction temperature specification of 1500o C, a junction-to-case thermal resistance of 1.00 C/W, and a junction-to ambient thermal resistance of  ... 300o C, then the maximum allowable power dissipation in the device will be 2.00 W 

Show More

148 views 1 answer







The maximum reluctance power of a salient-pole synchronous motor having direct-axis reactance, 1.0 pu and quadrature-axis reactance, 0.5 pu, and input voltage, 1.0 pu is (A) 0.25 pu (B) 0.5 pu (C) 1.0 pu (D) 1.5 pu
Last Answer : The maximum reluctance power of a salient-pole synchronous motor having direct-axis reactance, 1.0 pu and quadrature-axis reactance, 0.5 pu, and input voltage, 1.0 pu is 0.5 pu

Show More

98 views 1 answer







For maximum transfer of power, internal resistance of the source should be?
Last Answer : For maximum transfer of power, internal resistance of the source should be equal to load resistance.

Show More

371 views 1 answer







"Maximum power output is obtained from a network when the load resistance is equal to the output resistance of the network as seen from the terminals of the load". The above statement is associated with?
Last Answer : "Maximum power output is obtained from a network when the load resistance is equal to the output resistance of the network as seen from the terminals of the load". The above statement is associated with Maximum power transfer theorem.

Show More

397 views 1 answer








Last Answer : (b) Clostridium butylicum Lipase Removal of oil stains

Show More

107 views 1 answer








Last Answer : The mechanical power developed by a shunt motor will be maximum when the ratio of back e.m.f. to applied voltage is 0.5.

Show More

324 views 1 answer








Last Answer : In a D.C. shunt motor, under the conditions of maximum power, the current in the armature will be more than full-load current.

Show More

367 views 1 answer







The maximum load that a power transformer can carry is limited by its?
Last Answer : The maximum load that a power transformer can carry is limited by its voltage ratio.

Show More

133 views 1 answer







The synchronous motor will develop maximum power when the load angle is?
Last Answer : The synchronous motor will develop maximum power when the load angle is 900.

Show More

226 views 1 answer








Last Answer : Generators for peak load plants are usually designed for maximum efficiency at 50 to 75 percent full load.

Show More

141 views 1 answer







What are the basic requirements of locating wind power plant ?
Last Answer : The basic requirements of locating wind power plant:  1) The site should be selected where winds are strong i.e. where pressure of wind is high and there is continuity. 2) Wind pressure ... the turbine which can affect the system's overall performance. 10)Possibility to connect to power grid. 

Show More

137 views 1 answer







State elements of diesel electric power plant with their functions. 
Last Answer : Elements of Diesel Power Plant with their function):   1) Diesel Engine: - This is the main component of the P.P. which develops mechanical power. 2) Engine air intake system: - Air ... fuel as per requirement. 10) Alternator: - Its function is to convert mechanical power into electrical power.

Show More

99 views 1 answer







State advantages of Pulverized coal w.r.t. thermal power plant. 
Last Answer : Advantages of Pulverized coal w.r.t. thermal power plant.  1. Due to pulvarization amount of fuel required to produce same amount of heat reduces. 2. Time required for combution reduces ... of air and thorough mixing of air and fuel, very high-combustion temperatures can be attained.

Show More

99 views 1 answer







State the function of super heater of a thermal power plant. 
Last Answer : Function of Super heater: -  Its function is to increase the temperature of steam by absorbing heat from exhausted hot flue gases.

Show More

87 views 1 answer







State why nuclear power plants are used as base load plants and diesel power plants as a peak load plant. 
Last Answer : 1. Because of following points Nuclear power plant used as base load power plant:-  1. Nuclear power plants is very economical for producing bulk amount of electric power 2. Nuclear power plant is reliable ... . The plants can be put on load easily. 4. Diesel engines take less time to make OFF.

Show More

120 views 1 answer







State the advantages and disadvantages of hydroelectric power plant.
Last Answer : Advantages of Hydroelectric power plant:-  1. There is no air pollution and other environmental problems. 2. The fuel (water) is available freely. 3. No fuel transportation cost so; there is ... , this can force the relocation of large numbers of riverside cities, towns, villages & people.

Show More

87 views 1 answer







Explain the nuclear chain reaction in a nuclear power plant.
Last Answer : Nuclear chain reaction in a nuclear power plant: If a slow moving neutron hits unstable heavy nucleus of nuclear fuel U235 or Pu239 , the neutron is absorbed, the nucleus splits into two more ... chain reaction can be controlled and desired heat energy can be obtained in nuclear power plant. 

Show More

97 views 1 answer







Explain starting system in diesel electric power plant.
Last Answer : Starting system in Diesel Electric Power Plant: It includes Storage battery, compressed air tanks, self-starter etc. The purpose of engine starting system is to rotate the engine initially while ... as Ammeters, Voltmeters, Wattmeters, Thermometers, Pressure gauges, Visible and audible alarm etc.

Show More

125 views 1 answer







Explain the procedure for disposal of nuclear power plant.
Last Answer : Disposal of nuclear waste: The waste products by nuclear fission may be solid, liquid or gas. i) Solid harmful disposals are packaged as required and shipped to a burial site for disposal. ii) Liquids ... and tested. If the required limits are met, these will be released to atmosphere. 

Show More

63 views 1 answer







State any two advantages and two disadvantages of nuclear power plant.
Last Answer : Disadvantages of Nuclear Power Plant: -   1. The capital cost of Nuclear power plant is very high as compare to other power plant of same capacity. 2. The erection & ... material could be released into the environment. Causing extensive damage to the mankind,animals and environment.

Show More

167 views 4 answers







Explain fuel system and air intake system in diesel electric power plant.
Last Answer : Fuel system and air intake system in diesel electric power plant :  Fuel system: It consists of storage tank, strainers, fuel transfer pump and all day fuel tank. The fuel oil is supplied ... Filters are provided to remove dust particles from air which may act as abrasive in the engine cylinder.

Show More

123 views 1 answer







State any four advantages and four disadvantages of diesel electric power plant. 
Last Answer : Advantages of Diesel electric power plant:- 1) The design and layout of Diesel electric power plant is simple. 2) It requires less space. 3) Time required for complete erection of diesel power plant is less ... . 9) The useful life is very short. 10) Availability of fuel in future may be limited.

Show More

123 views 1 answer







State any four factors for selection of hydro power plant site. 
Last Answer : Following Factors to be kept while site selecting for Hydro power plant: 1) Quantity of water available :-Where high rainfall occures so that sufficent quantity of water can be stored for generation of ... be possible to divert the stream. 11. Sand, gravel, etc., should be available nearby.

Show More

223 views 2 answers







Write any four advantages and four disadvantages of thermal power plant.
Last Answer : .embed-container { position: relative; padding-bottom: 56.25%; height: 0; overflow: hidden; max-width: 100%; } .embed-container iframe, .embed-container object, .embed-container embed { position: absolute; top: 0; left: 0; width: 100%; height: 100%; }

Show More

169 views 3 answers







State the different types of engines in diesel power plant.
Last Answer : Types of engines in diesel power plant: 1) Two Stroke Diesel Engine 2) Four Stroke Diesel Engine

Show More

67 views 1 answer






Show More⇦ PreviousNext ⇨