Please Log in or Register for more.


177 views

1 Answer

Answer :

Generating capacity connected to the bus bars and ready to take load when switched on is known as spinning reserve.

Like 0 like

Please log in or register to answer this question.

Related Questions


Sparking occurs when a load is switched off because the circuit has high?
Last Answer : Sparking occurs when a load is switched off because the circuit has high inductance.

Show More

124 views 1 answer







In a lamp load when more than one lamp are switched on the total resistance of the load?
Last Answer : In a lamp load when more than one lamp are switched on the total resistance of the load decreases.

Show More

311 views 1 answer







In load flow Study, a PV bus is treated as a PQ bus when
Last Answer : Voltage at the bus becomes high 

Show More

3.3k views 2 answers







Power station having Load factor = 70%, capacity factor = 50%, used factor = 60%, maximum demand = 20MW then annual energy production is  (1) 122.8 GWh (2) 198.55 GWh (3) 128.2 GWh (4) 188.82 GWh
Last Answer : Power station having Load factor = 70%, capacity factor = 50%, used factor = 60%, maximum demand = 20MW then annual energy production is 122.8 GWh

Show More

148 views 1 answer







The problematic pollutants in emission of coal based generating plants __________.  (A) SO₂ (B) NOx (C) CO (D) All of the above
Last Answer : The problematic pollutants in emission of coal based generating plants __________.  (A) SO₂ (B) NOx (C) CO (D) All of the above

Show More

78 views 1 answer







A Hartley Oscillator is used for generating (A) very low frequency Oscillation (B) radio-frequency Oscillation (C) microwave Oscillation (D) audio-frequency Oscillation
Last Answer : A Hartley Oscillator is used for generating radio-frequency Oscillation

Show More

305 views 1 answer








Last Answer : In a power plant if the maximum demand on the plant is equal to the plant capacity, then plant reserve capacity will be zero.

Show More

273 views 1 answer








Last Answer : Large capacity generators are invariably hydrogen cooled.

Show More

95 views 1 answer








Last Answer : For high value of diversity factor, a power station of given installed capacity will be in a position to supply more number of consumers.

Show More

169 views 1 answer













A capacitor-start single phase induction motor is switched on to supply with its capacitor replaced by an inductor of equivalent reactance value. It will?
Last Answer : A capacitor-start single phase induction motor is switched on to supply with its capacitor replaced by an inductor of equivalent reactance value. It will not start at all.

Show More

231 views 1 answer







If a transformer is switched on to a voltage more than the rated voltage?
Last Answer : If a transformer is switched on to a voltage more than the rated voltage its power factor will deteriorate.

Show More

97 views 1 answer







Thyristor Switched Capacitor (TSC)
Last Answer : Thyristor Switched Capacitor (TSC)  TSC is a static compensator. TSC is use for compensating reactive power. Compensation is required for voltage regulation, increasing stability, ... compensating device like TCS phase angle between voltage and current can be maintain.

Show More

202 views 1 answer








Last Answer : 1. Connected Load: It is the sum of load of all equipment's connected to supply system which are in use or not in use of each consumer. OR   The sum of connected load of all consumers ... is the maximum load which a consumer uses at a particular time period out of his total connected load. 

Show More

165 views 1 answer







Is it loitering to read a novel on a bus all day if you also have a monthly unlimited bus pass?
Last Answer : Unless there's a rule against it, I think it's allowed to sit on the bus reading all day, if you have an unlimited bus pass. Riding the bus for fun and exploration is also allowed with a pass. ... a nice library instead. Personally, I tend to get motion sick when I read too much in a moving vehicle.

Show More

1 view 1 answer







Have you ever taken the greyhound bus?
Last Answer : They don’t have toilet paper and water to wash your hands with. bring your own toilet paper and hand sanitizer. Bring a sweater or small pillow.

Show More

1 view 1 answer







How do bus drivers close the door when they get off the bus?
Last Answer : You can push them shut from the outside. It doesn’t really take much effort. I ride the bus a lot and see the drivers do it all the time.

Show More

1 view 1 answer







What Is Meant By A Bus?
Last Answer : Answer :A bus is a group of conducting lines that carriers data, address, & control signals.

Show More

4 views 1 answer







Bus Travel with Children
Last Answer : Taking a long bus journey with children in tow can be challenging, but with some planning, you and your child can enjoy a bus ride with a minimum of fuss and muss. When planning your trip, try ... an opportunity to spend quality time with your little ones, and they will enjoy the trip all the more.

Show More

7 views 1 answer







Bus Travel Tips
Last Answer : There's something "zen" about long bus trips; being an anonymous face in the sea of travelers, being away from all the stresses and distractions of your every day life, losing yourself in a good ... when doing so. Remember when re-boarding that seats are still on a first-come-first-serve basis.

Show More

10 views 1 answer







What are the components of system bus? A) CPU Bus, Address Bus, Data Bus B) Memory, Control Unit, ALU C) Data Bus, Address Bus, Control Bus D) Register, PC, IR
Last Answer : What are the components of system bus? A) CPU Bus, Address Bus, Data Bus B) Memory, Control Unit, ALU C) Data Bus, Address Bus, Control Bus D) Register, PC, IR

Show More

2.1k views 1 answer







Calculate the size of memory address space for a 16 bit data and 20 bit address bus. A) 1 MB B) 2 MB C) 3 MB D) 4 MB
Last Answer : Calculate the size of memory address space for a 16 bit data and 20 bit address bus. A) 1 MB B) 2 MB C) 3 MB D) 4 MB

Show More

202 views 1 answer







Which of the following is true for a bus impedance matrix ?  (A) It is sparse  (B) It has diagonally dominant elements  (C) It is the inverse of the bus admittance matrix  (D) Each element of it is the reciprocal of the corresponding element in admittance matrix
Last Answer : Which of the following is true for a bus impedance matrix ?  (A) It is sparse  (B) It has diagonally dominant elements  (C) It is the inverse of the bus admittance matrix  (D) Each element of it is the reciprocal of the corresponding element in admittance matrix

Show More

146 views 1 answer







What is the channel capacity of a noisy channel with conditional probability of error p = 1/2? A) 0 B) 1 C) Infinity D) 2  
Last Answer : What is the channel capacity of a noisy channel with conditional probability of error p = 1/2?  A) 0 B) 1 C) Infinity D) 2  

Show More

108 views 1 answer







As per Shannon’s channel capacity theorem, if samples are transmitted in ‘T’ seconds over a noisy channel which is bandlimited to ‘B’ Hz. The number of samples ‘n’ is given by (symbols/notations carry their usual meaning) A) B/T B) T/B C) 2BT D) BT/2 
Last Answer : As per Shannon’s channel capacity theorem, if samples are transmitted in ‘T’ seconds over a noisy channel which is bandlimited to ‘B’ Hz. The number of samples ‘n’ is given by ( ... /notations carry their usual meaning) A) B/T B) T/B C) 2BT D) BT/2 

Show More

107 views 1 answer







Breaking capacity of a circuit breaker is usually expressed in terms of  (1) Ampere (2) Volts (3) MW (4) MVA
Last Answer : Breaking capacity of a circuit breaker is usually expressed in terms of MVA

Show More

268 views 1 answer








Last Answer : Overload capacity of diesel engines is usually restricted to 2 percent.

Show More

128 views 1 answer







Compare base load plant with peak load plant. 
Last Answer : Sr.No. Points Base load plant Peak load plant  1 Definition The power plant which supplies base load of load curve is known as base load plant The power ... power station   Small capacity storage hydro, pumped storage hydro, gas, diesel power station. 

Show More

113 views 1 answer







In order to have a lower cost of electrical energy generation the load factor  (1) and the diversity factor should be low (2) should be low but the diversity factor should be high (3) should be high but the diversity factor should be low (4) and the diversity factor both should be high
Last Answer : In order to have a lower cost of electrical energy generation the load factor and the diversity factor both should be high

Show More

134 views 1 answer








Last Answer : Nuclear power plant is invariably used as base load plant.

Show More

120 views 1 answer








Last Answer : Generators for peak load plants are usually designed for maximum efficiency at 50 to 75 percent full load.

Show More

139 views 1 answer








Last Answer : In a load curve the highest point represents peak demand.

Show More

109 views 1 answer








Last Answer : The increased load during summer months is due to increased use of fans and air conditioners.

Show More

59 views 1 answer








Last Answer : Load curve is useful in deciding the operating schedule of generating units, sizes of generating units, total installed capacity of the plant.

Show More

126 views 1 answer








Last Answer : The area under a load curve gives energy consumed.

Show More

98 views 1 answer








Last Answer : Peak load plant can never have 100 percent load factor.

Show More

143 views 1 answer








Last Answer : In two part tariff, variation in load factor will affect operating or running charges.

Show More

79 views 1 answer








Last Answer : A load curve indicates average kWh (kW) energy consumption during the period.

Show More

79 views 1 answer








Last Answer : High load factor indicates total plant capacity is utilised for most of the time.

Show More

101 views 1 answer








Last Answer : The load factor of domestic load is usually 10 to 15%.

Show More

151 views 1 answer








Last Answer : Load factor of a power station is generally less than unity.

Show More

107 views 1 answer








Last Answer : Load factor of a power station is defined as average load/maximum demand.

Show More

321 views 1 answer







why do buses have those gigantic steering wheels?
Last Answer : big wheel gives more leverage via the steering linkage. If you watch the driver she moves the steering wheel very slightly while driving straight. When making a corner, even with power steering ... position. It also has something to do with ergonomics, semi tractor steering wheels are large also.

Show More

0 views 1 answer







Define the terms: i) Tariff ii) Fuel surcharge iii) Electricity Duty iv) Connected load
Last Answer : i) Tariff: The rate at which a consumer is charged for the consumption of electricity is called as tariff. OR The amount of money framed by the supplier for the supply of electrical energy ... is the total wattage of all appliances which are used by the consumer on his sanctioned connection. 

Show More

140 views 1 answer







Define the following terms related to tariff: (i) Connected load (ii) Unit consumed (iii) Fixed charges (iv) Electricity Tax 
Last Answer : (i) Connected load  It is the sum of the power ratings (Watts or kW or MW) of all devices and machines existing (installed) in the premises of consumer. It is used to decide the ... a percentage of the total electricity bill which includes all amounts that go to the electricity supply agency. 

Show More

433 views 1 answer







Define each of following terms: i) Connected load ii) Spinning reserve. 
Last Answer : i) Connected Load :- It is the sum of load of all equipment connected to supply system which are in use or not in use of each consumer. ii) Spinning Reserve:- It is reserved generating capacity in operation and connected to bus bar and ready to take a load.

Show More

75 views 1 answer







A balanced Delta connected load supplied with 440 V 50 Hz three phase AC supply has R=10 Ohm and L=0.6 mH in is each arm. Calculate line and phase current, active power.

Show More

252 views 0 answers







A 3-phase voltage source inverter operates in 180° conduction mode with a star connected resistive load. If input dc voltage is 100 V, then the peak to peak output line voltage is :
Last Answer : A 3-phase voltage source inverter operates in 180° conduction mode with a star connected resistive load. If input dc voltage is 100 V, then the peak to peak output line voltage is : 200 V

Show More

205 views 1 answer







The sequence components of current of a single-phase load connected to a 3-phase system are (A) equal positive and negative sequence components (B) equal positive, negative and zero sequence components (C) vector sum of sequence currents is zero (D) algebraic sum of sequence currents is zero
Last Answer : The sequence components of current of a single-phase load connected to a 3-phase system are equal positive, negative and zero sequence components

Show More

478 views 1 answer







When smoking was allowed in bars would the beer or hard alcohol chatch on fire?
Last Answer : They didn't catch from smoking, but very aromatic liquors can be lit with a high temperature flame. That's how flambé desserts work, pour brandy and light on fire. There are known cases of ... spontaneously combusting from a flame or a cigarette. The alcohol ignites and the fat burns like a candle.

Show More

0 views 1 answer






Show More⇦ PreviousNext ⇨