221 views

1 Answer

Answer :

In a shaded pole single-phase motor, the revolving field is produced by the use of shading coils.

Like 0 like

Please log in or register to answer this question.

Related questions

356 views

Last Answer : In case of a shaded pole motor the direction of rotation of the motor is from main pole to shaded pole.

1 answer
110 views

Last Answer : A shaded pole motor can be used for toys, hair dryers, circulators etc.

1 answer
133 views

Last Answer : In a shaded pole motor, the shading coil usually consist of a single turn of heavy copper wire which is short-circuited and carries only induced current.

1 answer
282 views

Description : With a neat sketch give the working of shaded pole induction motor.

Last Answer : Explanation: It has squirrel cage rotor and salient pole stator. The stator poles are shaded partially by short circuited conductor band to create the phase difference between the fluxes emerging from shaded ... rotating magnetic field in the air-gap and torque is exerted on the squirrel cage rotor.

2 answers
132 views

Description : State two applications of 1) Shaded pole motor 2) Universal motor

Last Answer : (i)Applications of Shaded pole motor: 1. Small fans 2. Toy motors 3. Hair dryers 4. Ventilators 5. Electric clocks 6. Record players 7. Motorized valves 8. Gramophones 9. Photocopying ... 5. Portable Drilling Machines 6. Electric Shavers 7. Mechanical computing Machines 8. Machine Tools etc.

1 answer
87 views

Last Answer : Locked rotor current of a shaded pole motor is slightly more than full load current.

1 answer
67 views

Last Answer : The shaded pole motor is used for low starting torque.

1 answer
121 views

Last Answer : The range of efficiency for shaded pole motors is 5% to 35%.

1 answer
264 views

Last Answer : If the field winding of an unloaded salient pole synchronous motor is open circuited, the motor will stop.

1 answer
843 views

Last Answer : The torque produced in induction type relay (shaded pole structure) is inversely proportional to the square of the current.

1 answer
76 views

Last Answer : A single-phase induction motor is inherently non-self-starting with low torque.

1 answer
220 views

Last Answer : The power factor of a single-phase induction motor is usually lagging.

1 answer
234 views

Last Answer : In a capacitor start single-phase motor, when capacitor is replaced by a resistance motor will continue to run in same direction.

1 answer
91 views

Last Answer : The rotor developed by a single-phase motor at starting is zero.

1 answer
106 views

Last Answer : If the capacitor of a single-phase motor is short-circuited the motor will not start.

1 answer
102 views

Description : Salient pole rotor is use for which speed?

Last Answer : Salient pole rotor is use for low and medium speed prime movers.

1 answer
377 views

Description : what will happen when excitation of an unloaded salient pole synchronous motor suddenly gets disconnected?

Last Answer : When excitation of an unloaded salient pole synchronous motor suddenly gets disconnected the motor will stop.

1 answer
139 views

Description : In a single-phase induction motor, the operating direction is determined by the ________ A) Rotor B) Stator C) Starting circuit D) None of these

Last Answer : In a single-phase induction motor, the operating direction is determined by the Starting circuit

1 answer
158 views

Description : The no-load speed of a single-phase SCR bridge converter fed separately excited dc motor operating at a firing delay angle, α and flux, Φ (A) directly proportional to α and Φ (B) ... proportional to α and inversely proportional to Φ (D) directly proportional to Φ and inversely proportional to α

Last Answer : The no-load speed of a single-phase SCR bridge converter fed separately excited dc motor operating at a firing delay angle, α and flux, Φ directly proportional to α and inversely proportional to Φ

1 answer
98 views

Description : In a single-phase induction motor when the rotor is stationary and voltage is applied to the stator, then (A) the flux is constant (B) the flux first decreases and then increases in ... increases and decreases in the opposite direction with the same magnitude (D) current flows through the rotor

Last Answer : In a single-phase induction motor when the rotor is stationary and voltage is applied to the stator, then the flux first decreases and then increases in the same direction

1 answer
127 views

Last Answer : The starting winding of a single-phase motor is placed in stator.

1 answer
240 views

Last Answer : If starting winding of a single-phase induction motor is left in the circuit, it will draw excessive current and overheat.

1 answer
161 views

Last Answer : If a D.C. shunt motor is working at full load and if shunt field circuit suddenly opens this will make armature to take heavy current, possibly burning it.

1 answer
140 views

Last Answer : If the field of a D.C. shunt motor gets opened while motor is running the motor will attain dangerously high speed.

1 answer
189 views

Description : An electric motor in which both stator field and rotor rotates with same speed is called?

Last Answer : An electric motor in which both stator field and rotor rotates with same speed is called synchronous motor.

1 answer
508 views

Description : If the field of synchronous motor is under excited, power factor will be?

Last Answer : If the field of synchronous motor is under excited, power factor will be lagging.

1 answer
131 views

Description : Field control of DC motor

Last Answer : Field control of DC motor

2 answers
105 views

Last Answer : In capacitor start single-phase motors current in the starting winding leads the voltage.

1 answer
92 views

Description : Can we use the synchronous motor as the synchronous capacitor?

Last Answer : Yes, we can use the synchronous motor as the synchronous capacitor when the synchrnous motor is overexcited.

1 answer
68 views

Description : What is the use of synchronous motor?

0 answers
94 views

Description : What is the use of an electric motor?

Last Answer : Electrical motors are use for converting electrical energy to mechanical energy. It may be use in fans, pumps, washing machine, cranes, trains, factories, industries etc.

1 answer
203 views

Description : The armature current on symmetrical 3 phase short circuit of a synchronous machine (salient pole)  (A) has q -axis current only (B) has d -axis current only (C) has both d and q axis currents (D) cannot be divided between q and d axis currents

Last Answer : The armature current on symmetrical 3 phase short circuit of a synchronous machine (salient pole) has d -axis current only

1 answer
2.1k views

Description : A 3-phase, 4-pole, 50Hz induction motor runs at a speed of 1440 rpm. The rotating field produced by the rotor rotates at a speed of ________ rpm with respect to stator field. (A) 1500 (B) 0 (C) 1440 (D) 60

Last Answer : 0

2 answers
131 views

Last Answer : Single phase induction motor usually operates on 0.6 power factor lagging.

1 answer
244 views

Description : A capacitor-start single phase induction motor is switched on to supply with its capacitor replaced by an inductor of equivalent reactance value. It will?

Last Answer : A capacitor-start single phase induction motor is switched on to supply with its capacitor replaced by an inductor of equivalent reactance value. It will not start at all.

1 answer
117 views

Description : The running winding of a single phase motor on testing with meggar is found to be ground. Most probable location of the ground will be?

Last Answer : The running winding of a single phase motor on testing with meggar is found to be ground. Most probable location of the ground will be at the slot edge where coil enters or comes out of the slot.

1 answer
281 views

Last Answer : In a single phase motor the centrifugal switch disconnects auxiliary winding of the motor.

1 answer
9 views

Description : Pole Climbing & Attention to Street Light, Jumpers & Insulator Checking & Replacement of Insulator?

Last Answer : Ans. (a) Before pole climbing, supply to be disconnected (b) While climbing safety belt, helmet to be used. (c) While attending street light, safety board to be displayed. (d) While providing jumpers ... non-essential (g) Essential loads to be brought to single point. (h) Then connect UPS supply.

1 answer
11 views

Description : How to Rig a Fishing Pole

Last Answer : How to Rig a Fishing Pole Fishing can be a really exciting outdoor experience, not just a nap in the middle of a lake while holding a complicated stick. Rigging a fishing pole ... these steps, you can prepare your fishing equipment properly for a weekend afternoon of recreation and relaxation.

1 answer
7 views

Description : How to Build a Pole Barn ?

Last Answer : How to Build a Pole Barn How to Build a Pole Barn One of the simplest installations that you can make in your property is a pole barn. Usually found on agricultural land, a pole barn ... . Pond construction is also helpful if you want to add some extra features for your small household farm.

1 answer
1.6k views

Description : A 50 Hz, 4 pole turboalternator rated at 20 MVA. 13.2 KV has an inertia constant H = 4 KW sec/KVA. The K.E. stored in the rotor at synchronous speed is

Last Answer : A 50 Hz, 4 pole turboalternator rated at 20 MVA. 13.2 KV has an inertia constant H = 4 KW sec/KVA. The K.E. stored in the rotor at synchronous speed is 80 MJ

1 answer
354 views

Description : Explain MOSFET gate drive circuit and totem pole configuration.

Last Answer : MOSFET gate drive circuit: The turning on and turning off of MOSFET can be controlled from gate to source voltage signal. If the gate to source voltage of MOSFET exceeds threshold ... this configuration, the two switches (transistors) are used in totem pole arrangement with a comparator.

1 answer
224 views

Description : Single-phase mid-point controlled rectifier with RL load

Last Answer : Single-phase mid-point controlled rectifier with RL load : The circuit configuration of single-phase midpoint controlled rectifier is shown in the figure. During positive half-cycle of ... some part of next positive half-cycle of voltage with reversed polarity can appear across load.

1 answer
653 views

Description : Single-phase Midpoint controlled rectifier with Resistive load

Last Answer : Single-phase Midpoint controlled rectifier with Resistive load:  1) During positive half cycle of AC supply, a is positive with respect to b , this makes T1 forward biased and T2 is reverse ... voltage reverses the polarity and T2 is turned off. The operation is as shown in waveforms.

1 answer
1.4k views

Description : When the firing angle a of a single-phase, fully controlled rectifier feeding constant direct current into a load is 30°, the displacement power factor of the rectifier is

Last Answer : When the firing angle a of a single-phase, fully controlled rectifier feeding constant direct current into a load is 30°, the displacement power factor of the rectifier is √3/2

1 answer
158 views

Description : An additional condition for parallel operation of three-phase transformers over single-phase transformers is that

Last Answer : An additional condition for parallel operation of three-phase transformers over single-phase transformers is that the transformers should belong to the same vector group

1 answer
191 views

Description : A 230 V, 50 Hz phase controlled single-phase full-controlled SCR bridge converter draws 15 A constant dc current. If the source inductance is 3 mH, the drop in dc output voltage is (A) 4.5 V (B) 6.75 V (C) 9 V (D) 13.5 V

Last Answer : A 230 V, 50 Hz phase controlled single-phase full-controlled SCR bridge converter draws 15 A constant dc current. If the source inductance is 3 mH, the drop in dc output voltage is 9 V

1 answer
186 views

Description : In a 230 V, 50 Hz single-phase SCR bridge converter operating at a firing delay angle, α and with large R-L load, the input source current is (A) sinusoidal current (B) constant dc current (C) continuous rectangular pulses (D) alternating rectangular pulses

Last Answer : In a 230 V, 50 Hz single-phase SCR bridge converter operating at a firing delay angle, α and with large R-L load, the input source current is alternating rectangular pulses

1 answer
489 views

Description : The sequence components of current of a single-phase load connected to a 3-phase system are (A) equal positive and negative sequence components (B) equal positive, negative and zero sequence components (C) vector sum of sequence currents is zero (D) algebraic sum of sequence currents is zero

Last Answer : The sequence components of current of a single-phase load connected to a 3-phase system are equal positive, negative and zero sequence components

1 answer
148 views

Description : A 230 V/460 V single-phase transformer operating at 20 A and unity power factor has primary referred resistance of 0.2 Ω and reactance of 0.5 Ω. The approximate primary induced emf is (A) 216 V (B) 226 V (C) 234 V (D) 236 V

Last Answer : A 230 V/460 V single-phase transformer operating at 20 A and unity power factor has primary referred resistance of 0.2 Ω and reactance of 0.5 Ω. The approximate primary induced emf is 226 V

1 answer
...