# when voltage drops what happens to current?

when voltage drops what happens to current?

94 views

## 2 Answers

### Answer :

Current increases

### Answer :

This depends on the power of the source.If power is kept constant then the voltage increases with decrease in current (P=VI) .But if lets say the source is replaced by new batteries then the current increases (V=IR).

## Related Questions

The total voltage of a series circuit is the _____________. A. sum of the individual voltage drops B. total resistance divided by the total current C. sum of the individual currents multiplied by the number of resistors D. total current divided by the total resistance
Last Answer : Answer: A

Show More

4 views 1 answer

main function of the current regulator is A. To prevent the reversal flow of current from the battery when dynamo speed is drops. B. To safeguard against flow of high currents to battery when armature develops ... . C. To prevent building up of high voltage in a circuit. D. None of the above
Last Answer : B. To safeguard against flow of high currents to battery when armature develops more current.

Show More

11 views 1 answer

Which is NOT a characteristic of a series circuit? w) The current is the same throughout. x) The total resistance is the sum of the individual resistance. y) The voltage of the source ... individual voltage drops. z) The total resistance is the sum of the reciprocals of the individual resistances.
Last Answer : ANSWER: Z -- THE TOTAL RESISTANCE IS THE SUM OF THE RECIPROCALS OF THE RECIPROCAL OF THE INDIVIDUAL RESISTANCES.

Show More

277 views 1 answer

The output voltage of a battery drops from 100 V with zero load current to 80 V when load current is 2 A. The internal resistance of the battery is (a) 10 Ω (b) 20 Ω (c) 40 Ω (d) 50 Ω

Show More

100 views 0 answers

In AC system, the voltage drops are due to (1) Resistance (2) Inductance (3) Capacitance (4) All of the above

Show More

43 views 0 answers

If a candidate's campaign owes more money than it has on hand, and then drops out of the race before it can raise enough cash to cover the debts, what happens?
Last Answer : Good question. Didn’t that happen with Dennis Kucinich too? I know he tried to pay it off; not sure on the outcome. I wonder how common this is?

Show More

0 views 1 answer

If voltage across a bulb rated 220 volt-100 watt drops by `2.5 %` of its value, the percentage of the rated value by which the power would decrease is
Last Answer : If voltage across a bulb rated 220 volt-100 watt drops by `2.5 %` of its value, the percentage of the rated value ... 20%` B. `2.5%` C. `5%` D. `10%`

Show More

0 views 1 answer

The illustrated motor controller _________. EL-0023 A. is a low voltage release controller because the motor will stop when voltage falls below a certain value and automaticly start when normal voltage ... with a generator or transformer bank that is 'wye' wound with T2 connected to the neutral
Last Answer : Answer: B

Show More

0 views 1 answer

The 'reset' contacts of the master switch shown in the illustration are ______________. EL-0102 A. closed only when the master switch is 'off' B. closed only when the master switch selects a 'run' condition C. opened separately by the winch operator D. opened when line voltage drops 10%
Last Answer : Answer: A

Show More

1 view 1 answer

When using Kirchhoff’s voltage law, how are voltage polarities assigned to the voltage drops across resistors?
Last Answer : The point at which current enters the resistor is assigned a negative polarity and the point at which current leaves the resistor is

Show More

25 views 1 answer

A d.c. shunt motor runs at no load speed of 1140 r.p.m. At full load, armature reaction weakens the main flux by 5% whereas the armature circuit voltage drops by 10%. The motor full load speed in r.p.m. is (A) 1080 (B) 1203 (C) 1000 (D) 1200
Last Answer : (A) 1080

Show More

130 views 1 answer

The terminal voltage of a DC shunt generator drops on load because of all of the following except : (A) Armature reaction (B) Armature resistance drop (C) Commutation (D) Field weakening due to armature reaction and armature resistance drop
Last Answer : (D) Field weakening due to armature reaction and armature resistance drop

Show More

607 views 2 answers

The magnitude of various voltage drops that occur in an alternator depends on?
Last Answer : The magnitude of various voltage drops that occur in an alternator depends on load current.

Show More

596 views 1 answer

What happens to the angle between current and voltage, when a small capacitance is added in series with a highly inductive circuit?  (A) Increases (B) Remains same as earlier angle (C) Decreases (D) Becomes indeterminant

Show More

165 views 0 answers

when voltage increases what happens to current ?
Last Answer : Decrease

Show More

70 views 1 answer

According to Ohm’s law, what happens to circuit current if the applied voltage (a) increases, (b) decreases?
Last Answer : (a) Current increases (b) Current decreases

Show More

18 views 1 answer

What happens to current flow in a capacitive circuit when the DC voltage across the capacitor is approximately equal to the source voltage?
Last Answer : Capacitor always charges up to the voltage of source. When the capacitor is charged to same as source voltage then there is no current flowing through the capacitor. The current through the capacitor is called displacement current.

Show More

528 views 2 answers

What happens insulators when high voltage passes through transmission lines whether it breaks or lose it's insulating property?
Last Answer : I think it will breaks when it crosses breakdown voltage .

Show More

188 views 1 answer

What happens to the voltage in the secondary when the frequency of the supply in the primary is decreased? A) It increases B) It decreases C) It remains the same D) Cannot say unless the actual percentage increase in the frequency is known
Last Answer : What happens to the voltage in the secondary when the frequency of the supply in the primary is decreased? A) It increases B) It decreases C) It remains the same D) Cannot say unless the actual percentage increase in the frequency is known

Show More

119 views 1 answer

Consider a circuit with four resistors in series connected to a voltage source. What happens to the voltage across each resistor, if the value of each of the resistors is doubled? A) It will double B) It will remain the same C) It will be halved D) It will become zero
Last Answer : Consider a circuit with four resistors in series connected to a voltage source. What happens to the voltage across each resistor, if the value of each of the resistors is doubled? A) It will double B) It will remain the same C) It will be halved D) It will become zero

Show More

172 views 1 answer