1 Answer

Answer :

For the parallel operation of two or more D.C. compound generators, we should ensure that series fields of all generators should be either on positive side or negative side of the armature.

Related questions

Last Answer : If  equalising bar is connected to the 2 DC generators  the current will be equal in 2 generators irrespective of parallel connection so that we connect equaliser bar

Last Answer : In D.C. generators the polarity of the interpoles is the same as that of the main pole ahead.

Last Answer : Compensating windings are used in D.C. generators to neutralise the cross-magnetising effect of the armature reaction.

Last Answer : D.C. generators are connected to the busbars or disconnected from them only under the floating condition to avoid sudden loading of the primemover, to avoid mechanicaljerk to the shaft, to avoid burning of switch contacts.

Last Answer : In D.C. generators, the brushes on commutator remain in contact with conductors which lie under interpolar region.

Last Answer : In D.C. generators, current to the external circuit from armature is given through commutator commutator.

Last Answer : In D.C. generators the pole shoes are fastened to the pole core by counter sunk screws.

Last Answer : D.C. generators are installed near the load centres to reduce line losses.

Last Answer : D.C. generators are normally designed for maximum efficiency around full-load.

Description : parallel operation of MOSFET can be done more easily as compared to thyristor. why?

Last Answer : Parallel operation of MOSFET can be done more easily as compared to thyristor because the resistance of MOSFET is increases with increase in temperature. MOSFET have the positive temperature coefficient. In ... the parallel operation of MOSFET can be done more easily as compared to the thyristor.

Description : An additional condition for parallel operation of three-phase transformers over single-phase transformers is that

Last Answer : An additional condition for parallel operation of three-phase transformers over single-phase transformers is that the transformers should belong to the same vector group

Last Answer : Necessary conditions required to be satisfied in order to ensure successful parallel operation of single phase transformers:  1. Only transformers having the same phase displacement between primary and secondary ... . 7. The phase sequence must be followed strictly on HV and LV side connection.

Description : Explain the series and parallel operation of MOSFET. Which is suitable and why?

Last Answer : Series operation of MOSFET: To increase voltage handling capability MOSFETs are connected in series. When the MOSFETs are connected in series each MOSFET should turn on and turn off ... on and turn off time and transconductance. Each MOSFET should share current equally.  

Description : Also, highlight the problem faced during parallel operation.

Last Answer : Parallel operation of IGBT: Parallel operation of IGBT is done for obtaining high current rating. Paralleling of IGBT reduces conduction losses and thermal stress. IGBT combines the qualities of ... . IGBTs must share losses equally otherwise IGBT may get failure due to thermal differences.

Last Answer : Differentially compound D.C. motors can find applications requiring low starting torque.

Description : DC GENERATORS MCQ

Last Answer : 101. Wave winding is composed of (a) any even number of conductors (b) any odd number of conductors (c) that even number which is exact multiple of poles + 2 (d) that even number ... increase the field resistance (c) increase the speed of primemover (d) check armature insulation resis¬tance Ans: a

Description : Identify the increasing order of voltage regulation of the following dc generators a same load :  (A) differential compound, shunt and under compound  (B) shunt, differential compound and ... C) under compound, shunt and differential compound  (D) shunt, under compound and differential compound

Last Answer : Identify the increasing order of voltage regulation of the following dc generators a same load : under compound, shunt and differential compound 

Description : In DC generators lamination core are generally made of?

Last Answer : In DC generators lamination core are generally made of silicon steel.

Description : Consider a circuit with three parallel branches connected across a DC supply. What is the ratio of the branch currents I1 : I2 : I3 if the branch resistances are in the ratio of 2 : 3 : 4 respectively? A) 2 : 3 : 4 B) 6 : 4 : 3 C) 4 : 3 : 2 D) None of these

Last Answer : Consider a circuit with three parallel branches connected across a DC supply. What is the ratio of the branch currents I1 : I2 : I3 if the branch resistances are in the ratio of 2 : 3 : 4 respectively? A) 2 : 3 : 4 B) 6 : 4 : 3 C) 4 : 3 : 2 D) None of these

Description : The field coils of D.C. generator are usually made of (a) mica (b) copper (c) cast iron (d) carbon

Last Answer : Ans: b (b) copper

Description : Two synchronous generators G1, G2 are operating in parallel and are equally sharing KVAR (Lag) component of load. To shift part of KVAR from G2 to G1, while keeping terminal voltage fixed, the following action must be done

Last Answer : Two synchronous generators G1, G2 are operating in parallel and are equally sharing KVAR (Lag) component of load. To shift part of KVAR from G2 to G1, while keeping terminal voltage fixed, the following action must be done Raise If1 and lower If2

Description : Two synchronous generators operating in parallel supply a common load of 2.5 MW. The frequency-power characteristics have a common slope of 1 MW/Hz and the no-load frequencies of the generators are 51.5 Hz and 51.0 Hz, ... system frequency is (A) 50 Hz (B) 51 Hz (C) 51.25 Hz (D) 51.5 Hz

Last Answer : Two synchronous generators operating in parallel supply a common load of 2.5 MW. The frequency-power characteristics have a common slope of 1 MW/Hz and the no-load frequencies of the generators are 51.5 Hz and 51.0 Hz, respectively. Then the system frequency is 50 Hz

Description : What is the smallest unit of a compound with the same chemical characteristics?

Last Answer : The molecule is the smallest unit of a compound with the same chemical characteristics.

Description : How Generators Work

Last Answer : How Generators Work Generators are devices which produce electricity. They produce electricity by converting mechanical energy from power sources. Examples would be steam, water, wind and gasoline. These ... can also be used for recreational purposes. Examples would be camping, boating or fishing.

Description : Why are generators rated in kVA not in kW ?

Last Answer : Because It's rating of generator kva is apparent power. Kw is active power which we use. And one is kvar reactive power.

Last Answer : Large capacity generators are invariably hydrogen cooled.

Last Answer : Generators for peak load plants are usually designed for maximum efficiency at 50 to 75 percent full load.

Last Answer : In D.C. generators on no-load, the air gap flux distribution in space is flat topped.

Description : Two non-collinear parallel equal forces acting in opposite direction?

Last Answer : Two non-collinear parallel equal forces acting in opposite direction constitute a couple.

Description : How To Parallel Park ?

Last Answer : How To Parallel Park Every eager driver must know how to parallel park. This is a cinch for expert drivers who've been on the road for years, but if you're a newbie behind the wheel, this can ... good driver must know how to parallel park properly. Learn how to do this, by following these easy tips.

Description : Explain with neat diagram series and parallel magnetic circuits. 

Last Answer : Series magnetic circuit: When different magnetic materials having different lengths, cross sectional areas and permeability are connected one after another, in which same flux is established in different sections, then it is called series ... flux, Φ = Φ1 + Φ2  Path 1: BAFE  Path 2: BACD

Description : A parallel RLC circuit has the node equation Determine v(t) using the phasor method.

Last Answer : A parallel RLC circuit has the node equation Determine v(t) using the phasor method.

Description : Series parallel resistances problem solution

Last Answer : Series parallel resistances problem solution

Description : what is equivalent resistance when four 4 Ohm resistors are connected in i) series ii) parallel

Last Answer : equivalent resistance

Description : Parallel rc circuit

Last Answer : Parallel rc circuit

Description : Parallel circuit rules

Last Answer : Parallel circuit rules

Description : Parallel Reactance and Resistance Example 1

Last Answer : Parallel Reactance and Resistance Example 1

Description : XL and XC in parallel

Last Answer : https://youtu.be/fCN95EiEWDI

Description : Series and parallel capacitor problem

Last Answer : Series and parallel capacitor problem 1 : https://youtu.be/MSl5mRwtjAE Series and parallel capacitor problem 2 : https://youtu.be/yGwbpyEtIyw Series and parallel capacitor problem 3 : https:// ... https://youtu.be/_7KwEwWqiNU Series and parallel capacitor problem 10 : https://youtu.be/et8MCWV_OyE

Description : State the principle of solar cell. What is necessity of series and parallel connection of solar cells.

Last Answer : Principle of solar cell:-  Working:- Solar cell operates on principle of Photo-voltaic effect Solar cell works in following steps:  The solar cell is composed of a P-type ... of Voltage & Current rating it is necessity of connecting series and parallel connection of solar cells.

Description : State necessity of series connection and parallel connection of batteries.

Last Answer : Necessity of series connection of batteries: 1. The batteries are available with some specific terminal voltages. e. g. 6V, 12V, 24V, 48V etc. 2. If we want to have some terminal voltage other than ... batteries of capacities I1, I2, I3, I4 . are connected in parallel, all having identical emfs.

Description : In parallel RLC resonance circuit at resonance the current will be  (1) Minimum (2) Maximum (3) Zero (4) Infinite

Last Answer : In parallel RLC resonance circuit at resonance the current will be Minimum 

Description : When three resistors with unequal values are connected in parallel, _______ A) The current across the resistors is the same  B) The voltage drop across the resistors is the same C) The voltage drops across the resistors is proportional to the resistance of each resistor D) None of these

Last Answer : When three resistors with unequal values are connected in parallel, The voltage drop across the resistors is the same

Description : While keeping the excitation constant, if the steam supply of an alternator running in parallel with another identical alternator is increased, then (A) It would over-run the other alternator (B) Its rotor ... (C) Its portion of share in load will increase (D) Its power factor would be decreased.

Last Answer : While keeping the excitation constant, if the steam supply of an alternator running in parallel with another identical alternator is increased, then Its portion of share in load will increase

Description : Explain parallel and wireless protocols.

Last Answer : Parallel protocols: PCI bus (Peripheral Components Interconnect): PCI stands for Peripheral Components Interconnect. PCI bus is used as a communication line to transmit signals and data ... provide the basis for wireless network products using the Wi-Fi brand.

Description :  With three resistances connected in parallel, if each dissipates 20 W the total power supplied by the voltage source equals?

Last Answer : Power is the only thing which is additive in both connection whether it is parallel or series connection so total power consumed will addition of all individual power =20+20+20 = 60 watt

Description : When one leg of parallel circuit is opened out the total current will?

Last Answer : When one leg of parallel circuit is opened out the total current will decrease.

Description : Three 60 W bulbs are in parallel across the 60 V power line. If one bulb burns open?

Last Answer : Three 60 W bulbs are in parallel across the 60 V power line. If one bulb burns open the other two bulbs will light.

Description : If a parallel circuit is opened in the main line, the current?

Last Answer : If a parallel circuit is opened in the main line, the current is zero in all branches.

Description : An A.C. voltage is impressed across a pure resistance of 3.5 ohms in parallel with a pure inductance of impedance of 3.5 ohms?

Last Answer : An A.C. voltage is impressed across a pure resistance of 3.5 ohms in parallel with a pure inductance of impedance of 3.5 ohms, both resistance and inductance carry equal currents.