Draw the circuit diagram of shunt capacitor filter along with full wave rectifier. Draw the waveform of full wave rectifier output and shunt capacitor filter output.

1 Answer

Answer :

image

Fig: Shunt capacitor filter along with full wave rectifier

image

Fig: Waveform of full wave rectifier output and shunt capacitor filter output.

Related questions

Description : With help of circuit diagram and waveform, explain shunt capacitor filter.

Last Answer : Circuit diagram and Waveform: OR Explanation: A filter circuit is one which removes the ac component present in the rectified output and allows the dc component to reach the ... which allows ac components. The remaining dc components present in the signal are collected at the output. 

Description : Draw and describe circuit diagram of centre tapped rectifier with LC filter along with its input and output waveforms.

Last Answer : Explanation: A centre- tap full wave rectifier drive produces the rectified voltage and it drives the LC filter. We know that the series inductor filter is preferred for low values of load resistance ( ... load RL. The output voltage waveforms are similar to that as shown in figure above.  

Description : Draw circuit diagram and waveforms for centre-tap full wave rectifier.

Last Answer : Circuit Diagram:    

Description : Draw the circuit diagram of bridge rectifier with π filter. Draw its input and output waveform. 

Last Answer : Circuit diagram of bridge rectifier with π filter : Input and output waveform:

Description : With help of circuit diagram and waveform, explain working of CLC or π- filter.

Last Answer : Circuit diagram CLC or Π filter:   Working : It consist of a filter capacitor C1 connected across the rectifier o/p , a choke L is series and another filter capacitor C2 connected across the load. ... to block. Therefore, only d.c component appears across the load and that is what we desire.  

Description : State the condition for RC differentiator. Draw the output waveform of RC integrator for square wave input.

Last Answer : Condition for RC differentiator: If the time duration T of the input waveform is comparable with the RC time constant (product of R and C) then the output waveform of the differentiator gets distorted. Hence for proper differentiator the condition is as follows: T >>RC

Description : Draw the circuit diagram of bridge rectifier and label it. 

Last Answer : Circuit Diagram Bridge rectifier

Description : State the advantages and disadvantages of series inductor and shunt capacitor filter.

Last Answer : Advantages of series inductor filter 1. It has low ripple factor at heavy load currents (i.e. low load resistance) 2. It has no surge current through the diode. 3. It reduces the ripple in the DC ... . 3. It has low output voltages for heavy loads. 4. Ripple factor is dependent on the load.

Description : Explain full wave bridged rectifier with the help of circuit diagram and input output waveform.

Last Answer : 1. In positive half cycle (0 to Π): The end A of the secondary winding becomes positive and end B negative. This makes diode D1 and D4 forward biased while diode D2 and D3 are reverse biased. These two diodes will ... D2 and D3 when it is conducting is as follows.  B - D2 - RL - D3 - A 

Description : Draw and describe working of full wave rectifier using centre tapped transformer.

Last Answer : Full wave Rectifier with Center tapped transformer(FWR): In full wave rectification, the rectifier conducts in both the cycles as two diodes are connected. Circuit diagram: Operation: 1. In ... both half-cycles of input AC voltage. Therefore DC is obtained across the load RL.

Description : With help of circuit diagram and waveform, explain working of positive series clipper.

Last Answer : Series Clipper (Positive):-   Working: For positive cycle the diode D is reverse biased. Hence there is no voltage across the load RL While for negative half wave, the diode D is forward biased. Hence ... positive cycle of the input voltage gets clipped off. Input & o/p wave form:-   

Description : Describe working of negative clamper circuit with neat diagram and waveform.

Last Answer : Working: In the first positive half cycle the capacitor will charge through the forward biased diode to peak voltage Vm as shown in circuit. Charging takes place very quickly as the ... reverse biased and stop conducting. Negative clamper adds a negative DC shift as shown in waveform.

Description : Draw & describe working of bridge rectifier with its input output waveforms

Last Answer : Four diodes are used. a)In positive half cycle Diodes D1 & D3 becomes forward biased they will conduct & current flows at that time D2 and D4 are reverse biased they will not ... at that time D1 and D3 are reverse biased they will not conduct. we get full cycle rectification.

Description : Explain the operation of a full wave bridge rectifier with π filter using a neat diagram. Draw input and output waveforms.

Last Answer : During positive half-cycle of input, the secondary voltage VAB is positive, so diodes D1 and D2 forward biased and D3 and D4 reverse biased. The load current flows from terminal A ... smooth DC voltage appears across the load. The input and output waveforms are shown in the figure.

Description : Draw and explain: bridge rectifier with shunt capacitor filter.

Last Answer : Operation of bridge rectifier with capacitor filter is explained in different intervals with the help of the following wave form. Operation in interval at 0 to A: ... filter is very close to theideal dc voltage waveform as most of the ripple is removed from rectified output.

Description : Draw and describe constructional diagram of electrolytic capacitor.

Last Answer : Electrolytic capacitor is a polarized capacitor. This type of capacitor consists of pasty, semiliquid electrolyte between aluminum foil electrodes or plates. An electrolytic capacitor is a type ... the ends closed with wax and then sealed into an aluminium container as shown in fig. 

Description : Draw the clipper circuit using series and shunt diode.

Last Answer : Fig: A series negative clipper (OR) Fig: Series positive clipper Fig: Parallel positive clipper (OR) Fig: Parallel negative clipper

Description : Define clipper. Draw circuit of negative shunt clipper.

Last Answer : Clipper: A clipper is a device designed to prevent the output of a circuit from exceeding a predetermined voltage level without distorting the remaining part of the applied waveform. OR Clipper: An ... the positive or negative peak or both from a specific level is known as clipper.

Description : Define rectifier. Draw circuit diagram and input-output waveforms of bridge type full wave rectifier 

Last Answer : Rectifier - This circuit convert AC signal into DC.

Description : Explain Center-tapped full wave rectifier with the help of circuit diagram and draw input output waveforms. 

Last Answer : Operation : During positive half cycle of an AC supply, D1 will forward biased and current starts flowing through load. The output voltage is equal to +Vs. During negative half cycle of an AC ... output voltage is equal to +Vs. In this pulsating DC waveform will be obtained at the load. 

Description : Compare half wave rectifier and full wave rectifier. 

Last Answer : half wave rectifier and full wave rectifier :

Description : State the necessity of rectifier and filter circuits.

Last Answer : Need of Rectifiers: Many electronic devices and circuits work on DC. It is then needed to convert A.C. into D.C. Rectifier is the best and cheapest way to provide D.C. for electronic devices. ... moved from the pulsating D.C. to obtain pure D.C. signal. To remove this filter circuit is used. 

Description : Draw construction of PVC gang capacitor and describe it’s working.

Last Answer :  Diagram Working  In plastic core capacitor, poly-vinyl chloride (PVC) type of plastic film is used as dielectric between the fixed & movable vanes instead of air. This increases ... & results in great reduction of size of capacitor in comparison with the air core capacitor.

Description : Draw the symbol of i) Iron core inductor ii) variable capacitor iii) resistor iv) Ferrite core inductor

Last Answer :  Iron core inductor:  Ferrite core inductor:  

Description : With help of constructional diagram, explain working of air-gang capacitor.

Last Answer : Construction of air-gang capacitor : Air gang capacitors are capacitors which use air as their dielectric. The simplest air capacitors are made of two conductive plates separated by an air gap.   ... capacitor. The rotor plates are attached to the shaft that is used to adjust the capacitance. 

Description : Draw π-filter and state its working.

Last Answer : Circuit Diagram:   Working : It consists of a filter capacitor C1 connected across the rectifier output, a choke L is series and another filter capacitor C2 connected across the load RL. The ... which the choke has failed to block. Therefore, only d.c component appears across the load. 

Description : Draw the circuit diagram and describe the working principle of full wave bridge rectifier. Draw its waveforms. 

Last Answer : During the first half cycle : During the first half cycle of the input voltage, the upper end of the transformer secondary winding is positive with respect to the lower end. Thus during the first ... , terminal D, diode D4, and terminal A back to transformer and output will positive half cycle.

Description : Draw the construction diagram of air core inductor. List two applications

Last Answer : Applications: i. It is used for construction of IF and RF tuning coils. ii. It is used for interstage coupling.

Description : Draw a label diagram of ferrite core inductor.

Last Answer : Ferrite core inductor

Description : Draw the constructional diagram of iron core inductor and write the working of it.

Last Answer : Iron core inductors allow high inductance value but are limited in high frequency capacity due to hysteresis and eddy current losses. Iron core increases the magnetic induction of a ... certain point this result in a useful increase in inductance. Beyond that point, inductance decreases.

Description : Draw labeled diagram of air core inductor.

Last Answer : Diagram of air-cored inductor :

Description : Give the operation of single phase full wave bridge controlled converter with RL load with a neat diagram. Also draw its waveform.

Last Answer : Single phase fully control bridge converter with RL load: 1. During positive half cycle of input voltage, T1 and T2 are forward biased and during negative half cycle, T3 and T4 are forward biased. Therefore, T1-T2 ... cycle till the firing of next pair of SCRs as shown in the waveform.

Description : Draw and describe working of series biased clipper with input output waveforms. 

Last Answer : Biased series positive clipper: Clipping of the signal takes place as soon as the input signal goes positive. If we want to change/adjust the clipping level of AC voltage, then external biasing voltage must be ... voltage must be used. The figure given below shows a biased (series) clipper.    

Description : Define filter. State its types. Draw any one filter with input and output waveform.

Last Answer : Defination : Filter is a circuit which remove or filtered out the AC component (ripple) Types of filter 1. Shunt Capacitor filter (C filter) 2. Series Inductor filter (L filter) 3. LC filter 4. filter (CLC filter) Shunt Capacitor filter (C filter) OR Waveforms:

Description : State the parameter of rectifier. 

Last Answer : Any two parameter of rectifier-  Average load current Average load voltage RMS load current RMS load voltage Ripple factor Voltage regulation Rectification efficiency and TUF.

Description : Give the need of rectifier. 

Last Answer : Need of Rectifiers: Many electronic devices such as diodes, transistors and IC’s works on D.C. but not on A.C. It is then needed to convert A.C. into D.C. Rectifier is the best and cheapest way to provide D.C. current for electronic devices. 

Description : Define : (i) Efficiency (ii) TUF of Rectifier

Last Answer : Rectifier efficiency (ɳ) : it is defined as the ratio of DC power to the applied input AC power. Transformer utilization factor: It is defined as the ratio of the DC power available at the load resistor and the AC rating of the secondary coil of a transformer.

Description : State the need of Rectifier circuits.

Last Answer : The DC power supply is essential for operation of many electronic devices and circuits.This DC voltage is obtained from AC source.Rectifier circuit is important circuit for this conversion.

Description : Define rectifier. State its types.

Last Answer : A rectifier is defined as an electronic device which converts alternating (AC) voltage or current into unidirectional/ pulsating (D.C) voltage or current. Types of Rectifier: 1. Half wave rectifier 2. Full wave rectifier a. Centre tapped full wave rectifier b. Full wave bridge rectifier

Description : Define given parameters and state their values for bridge rectifier (i) Ripple factor (ii) PIV of diode.

Last Answer : Ripple Factor: Ripple Factor is defined as the ratio of RMS value of the AC component of output to the DC or average value of the output. Mathematically it is expressed as, ( ... which appears across non-conducting reverse biased diode. (ii) PIV of diode for bridge rectifier-Vm

Description : List the two advantages of Bridge Rectifier. 

Last Answer : The advantages of bridge rectifier: The output is twice that of the center-tap circuit for the same secondary voltage. The PIV is one half that of the center-tap circuit. The ... and hence transformer losses are reduced. It can be used in applications allowing floating output terminals. 

Description : Draw RC differentiator circuit.

Last Answer : RC differentiator circuit :

Description : Draw negative clamper circuit and explain its working. 

Last Answer : Diagram: Working: During the positive half cycle of the input AC signal, the diode is forward biased and hence no signal appears at the output. In forward biased condition, the diode allows ... - 2Vm} which have the same polarity with each other. As a result, the signal shifted downwards. 

Description : What is need of wave shaping circuit ?

Last Answer : In electronics application, it is often needed to alter the shape of wveform like cutting off positive or negative portion of wave,generation of one wave from other,holding wave at some dc level etc.To do this waveshaping circuits are needed.

Description : State the necessity of wave-shaping circuit.

Last Answer : 1. To limit the voltage level of the waveform to some present value. 2. To shift the waveform to a particular voltage level. 3. To generate one wave from the other. 4. To cut the negative and positive portions of the waveform.

Description : Define linear and non-linear wave-shaping circuit.

Last Answer : Linear wave-shaping circuit  The circuit which makes use of only linear circuit elements is known as linear wave shaping circuits. Resistor, capacitor, inductor are used for the circuits. E.g. ... , transistor, resistors and capacitors etc. are used for the circuits. E.g. Clipper, Clamper

Description : With the help of circuit diagram and waveforms, explain working of RC differentiator.

Last Answer : Fig: RC differentiating circuit Figure shows a RC differential circuit. It is also known as high pass filter. The reactance of a capacitor decreases with increasing frequency. The higher ... i.e. the output signal is directly proportional to the derivative of the input signal.  

Description : Is a full-wave rectifier output easier to filter than that of a half-wave rectifier?

Last Answer : Yes.

Description : Is a full-wave rectifier output easier to filter than that of a half-wave rectifier?

Last Answer : Yes.

Description : Describe construction of Aluminium Electrolytic capacitor.

Last Answer : A plain foil dry electrolytic capacitor is made by forming a coating of aluminium oxide on both sides of an aluminium foil. Two strips of aluminium foil used are then separated by two layers of porous ... is rolled up the ends closed with wax and then sealed into an aluminium container.