1 Answer

Answer :

In a Schering bridge the potential of the detector above earth potential is a few volts only.

Related questions

Description : How to choose a metal detector?

Last Answer : How to choose a metal detector? Before you arm yourself with a metal detector, you need to decide what exactly needs to be found and where. A metal detector (aka metal detector) is a device ... metal detector, after you gain experience with this device, you can move on to more professional models.

Description : Draw & explain operation of phase detector.

Last Answer : In phase detector, the op-Amp basically acts as a zero crossing detector. If a sine wave is applied at the i/p, we get square wave at the op-Amp o/p (at point ... to two channel of the CRO. The time duration between the pulses corresponding to voltages represent the phase between them. 

Description : A dummy strain gage is used in a quarter bridge strain gage circuit to :  (A) compensate for changes in temperature and lead wire resistance  (B) produce more output voltage from the bridge  (C) increase the sensitivity of the bridge  (D) compensate lead wire resistance only

Last Answer : A dummy strain gage is used in a quarter bridge strain gage circuit to : compensate for changes in temperature and lead wire resistance 

Description : The bridge method commonly used for finding mutual inductance is (A) Heaviside Campbell bridge (B) Schering bridge (C) De Sauty bridge (D) Wien bridge

Last Answer : The bridge method commonly used for finding mutual inductance is Heaviside Campbell bridge

Description : The bridge most suited for measurement of a four-terminal resistance in the range of 0.001 Ohm to 0.1 Ohm (A) Wien’s bridge (B) Kelvin double bridge (C) Maxwell’s bridge (D) Shering Bridge

Last Answer : The bridge most suited for measurement of a four-terminal resistance in the range of 0.001 Ohm to 0.1 Ohm (A) Wien’s bridge (B) Kelvin double bridge (C) Maxwell’s bridge (D) Shering Bridge

Last Answer : If an inductance is connected in one arm of bridge and resistances in the remaining three arms the bridge cannot be balanced.

Last Answer : In an Anderson bridge, the unknown inductance is measured in terms of known capacitance and resistance.

Last Answer : For measurements on high voltage capacitors, the suitable bridge is Schering bridge.

Description : A universal RLC bridge uses?

Last Answer : A universal RLC bridge uses Maxwell Wein bridge for measurement of inductance and modified De Santy's bridge for measurement of capacitance.

Description : The potential coil of a single phase dynamometer wattmeter has 4840 Ohm resistance. Voltage across the load is 220 V. With the potential coil connected on the load side, the meter indicates 100 W. Approximate percentage error due to wattmeter connection is (A) 11% (B) 9% (C) 1.1% (D) 3%

Last Answer : The potential coil of a single phase dynamometer wattmeter has 4840 Ohm resistance. Voltage across the load is 220 V. With the potential coil connected on the load side, the meter indicates 100 W. Approximate percentage error due to wattmeter connection is 11%

Description : Is electric potential zero when electric field is zero?

Last Answer : Yes  .If  electric  field  is  zero  then  electric  potential  is  zero  ,  not  even  one.

Description : What is the potential barrier of metal?

Last Answer : Potential barrier of metal is zero.

Description : How to Build a Bridge

Last Answer : How to Build a Bridge How to Build a Bridge Building a bridge is not an every day task, you do not see bridges going up overnight and it takes a skilled engineer to master this craft. Bridges ... this can be one of the most satisfying moments of your life to know that you have achieved your goal.

Description : How to Become a Bridge Inspector

Last Answer : How to Become a Bridge Inspector Bridge Inspectors are construction professionals who are well versed in a number of building disciplines. Among the talents of a bridge inspector are such ... secure employment in a variety of different settings, both in government agencies and private business.

Description : How to Become a Bridge Engineer

Last Answer : How to Become a Bridge Engineer Bridge Engineers are construction professionals that bear a major part of the responsibility for the safety and stability of bridges. Consequently, a bridge engineer ... new business. A well-established reputation is vital to the success of bridge engineering career.

Description : Draw circuit diagram of symmetrical configuration of bridge converter.

Last Answer : circuit diagram of symmetrical configuration of bridge converter

Description : List out advantages and disadvantages of bridge rectifier.

Last Answer : Advantages :  1. Bridge rectifier can be used in applications allowing floating output terminals i.e. not output terminal is grounded.  2. The need of center-tapped transformer is eliminated.  ... The value of the diodes used should be precise , else there will be an error in rectification

Description : Draw full bridge & half bridge configuration with common cathode.

Last Answer : Half Bridge Configuration: Full Bridge Configuration: 

Description :  operation of whetstone bridge. 

Last Answer : A Wheatstone bridge is widely used to measure the electrical resistance. This circuit is built with two known resistors, one unknown resistor and one variable resistor connected in the form of bridge. ... using a Wheatstone Bridge the unknown electrical resistance value can easily measure.

Description : tern null as it applies to bridge measurement.

Last Answer : Null measurements balance voltages so that there is no current flowing through the measuring device and, therefore, no alteration of the circuit being measured. Null measurements are generally more ... the use of standard voltmeters and ammeters, and they still have limits to their precision.

Description : Give the operation of single phase full wave bridge controlled converter with RL load with a neat diagram. Also draw its waveform.

Last Answer : Single phase fully control bridge converter with RL load: 1. During positive half cycle of input voltage, T1 and T2 are forward biased and during negative half cycle, T3 and T4 are forward biased. Therefore, T1-T2 ... cycle till the firing of next pair of SCRs as shown in the waveform.

Description : Wheatstone bridge

Last Answer : Wheatstone bridge

Description : Which of the following is true with respect to Wien Bridge? A) It does not require equal values of R or C  B) It requires that R and C values of all components must be equal C) It requires that all resistors should have equal values D) None of these

Last Answer : Which of the following is true with respect to Wien Bridge? A) It does not require equal values of R or C  B) It requires that R and C values of all components must be equal C) It requires that all resistors should have equal values D) None of these

Description : The no-load speed of a single-phase SCR bridge converter fed separately excited dc motor operating at a firing delay angle, α and flux, Φ (A) directly proportional to α and Φ (B) ... proportional to α and inversely proportional to Φ (D) directly proportional to Φ and inversely proportional to α

Last Answer : The no-load speed of a single-phase SCR bridge converter fed separately excited dc motor operating at a firing delay angle, α and flux, Φ directly proportional to α and inversely proportional to Φ

Description : A 230 V, 50 Hz phase controlled single-phase full-controlled SCR bridge converter draws 15 A constant dc current. If the source inductance is 3 mH, the drop in dc output voltage is (A) 4.5 V (B) 6.75 V (C) 9 V (D) 13.5 V

Last Answer : A 230 V, 50 Hz phase controlled single-phase full-controlled SCR bridge converter draws 15 A constant dc current. If the source inductance is 3 mH, the drop in dc output voltage is 9 V

Description : In a 230 V, 50 Hz single-phase SCR bridge converter operating at a firing delay angle, α and with large R-L load, the input source current is (A) sinusoidal current (B) constant dc current (C) continuous rectangular pulses (D) alternating rectangular pulses

Last Answer : In a 230 V, 50 Hz single-phase SCR bridge converter operating at a firing delay angle, α and with large R-L load, the input source current is alternating rectangular pulses

Description : The bridge most suited for accurate measurement of relative permittivity of dielectric materials is (A) Carey Foster Bridge (B) Anderson’s bridge (C) Heaviside Bridge modified by Campbell. (D) Schering Bridge.

Last Answer : The bridge most suited for accurate measurement of relative permittivity of dielectric materials is Schering Bridge.

Description : Explain three phase bridge inverter.

Last Answer : Three phase bridge inverter: Three phase bridge inverter converts DC voltage input to three-phase variable frequency variable voltage output. DC voltage source can be a DC source or output of the rectifier. ... in proper sequence. The switch may be thyristor or IGBT etc.

Description : Explain the operation of full bridge converters with their different operating modes. State its advantages and disadvantages.

Last Answer : Full bridge converter: Full bridge converter provides isolation between input and output. Full bridge converter is used for step up or step down the input voltage. Full bridge converter consists of four power semiconductor ... Require filter on both input and output.

Description : explain blanking times for Bridge circuit?

Last Answer : Blanking time is provided by driver circuit to power switch. Blanking time is important because the turn on input of one transistor must be delayed with turn off input of another transistor if both ... are connected in one converter leg. This blanking time helps in avoiding cross conduction.

Last Answer : Meggar is an instrument which measures the insulation resistance of an electric circuit relative to earth and one another.

Description : Hays bridge is used to measure___________ and Schering bridge is used to measure____________ a) Inductance, Inductance b) Inductance, Capacitance c) Capacitance, Inductance d) Resistance, Capacitance

Last Answer : Ans: Inductance, Capacitance

Description : Schering bridge is used to measure  (1) Frequency (2) Inductance (3) Capacitance (4) Mutual Inductance

Last Answer : 3

Description : Could you go to the beach and enter the water safely billions of years ago here on earth? In the sense that there used to be different species of marine animals and fish that could be dangerous to humans.

Last Answer : Just going back 1 billion yeas will put you in the Protozoic Era. It would be pretty safe for humans. There were harmless sponges and single cell animals at that time. No fish, reptiles or marine mammals.

Description : How would you feel if interplanetary visitors came to Earth, visited us, and then said "Too weird for us"?

Last Answer : Better than if they came here and said: “Oooh, they look so tasty!”

Description : What are some real first contact situations in Earth?

Last Answer : https://youtu.be/kOx7UQ0mD3E Sentinelese tribe’s first contact with modern humans. I don’t think our first meet with extraterrestrials will be that simple tho. Maybe, they are already in contact

Description : According to you, microexpressions could be used to endanger the humans on Earth?

Last Answer : Microexpressions can be used to annoy humans on Earth: https://www.scienceofpeople.com/microexpressions/

Description : If the Earth has over 80 times the mass of the moon, why does it only have about 6 times as much gravity?

Last Answer : The equation for gravitational attractive force is F = G * m1 * m2 / r^2. m2 is your mass. You got the mass ratio right: m1 for Earth is 80x m1 for the Moon. But when you stand on the surface, r ... Earth is 6370 km. if you take the square of the distance ratio you get 0.075. Multiply by 80 => 6

Description : What is the terminal velocity of the moon crashing into Earth?

Last Answer : answer:The Newtonian equation is F = G x (m1.m2)/r^2. It's hard to write equations on here, so see http://en.wikipedia.org/wiki/Newton's_law_of_universal_gravitation if that is unclear. ... mass of both objects, the gravitational force between the Earth and the Moon is dependent on both masses.

Description : Does Earth have a flag and anthem?

Last Answer : UN..flag, yes. Anthem, no.

Description : How concerned and prepared should we be about an Asteroid hitting Earth?

Last Answer : I see zero point in being concerned. It will either destroy us or not, and there little to nothing we can do about it.

Description : If all gravity on earth ceased to be, what would be the outcome?

Last Answer : Everything that wasn’t tied down would be flung into space by centrifugal force, including the oceans and the atmosphere.

Description : You're the last human on Earth. What do you do to keep yourself sane?

Last Answer : Holy smokes! Hmmm, first of all I would probably strip down naked since nobody is there. Secondly, I would love to drive all the $$$$ cars out there… Jee where can i start. The list goes on….

Description : If you could get rid of one thing on this earth, what would it be?

Last Answer : Religion.

Description : Who are the meek and what will be left of the earth they inherit?

Last Answer : The meek are those people who have all those footprints on their butts. They will inherit nothing.

Description : If you had the ability to create your own planet, how would it differ from earth?

Last Answer : No gender norms, no sexuality labels, no religion.

Description : How fast is the earth traveling through space in MPH?

Last Answer : I’m far from a scientist. But from what I know, we’re rotating. We’re orbiting. The solar system is moving. The galaxy is stretching. The universe is expanding. We’re going fast, dude.

Description : What practices of Earth etiquette do you think will prove most helpful in the fight against environmental degradation?

Last Answer : I would say the overall decrease in carbon emissions and pollution (making companies green and making more fuel efficient cars) is going to help the most. The recycling idea is nice but the truth ... coolest looking thing ever! if I do say so myself Being green can be cost efficient and stylish.

Description : Okay, you have the attention of all the ears on Earth. What will you say?

Last Answer : Hello

Description : who was the first person to say the earth is round

Last Answer : The concept of a spherical Earth dates back to around the 6th century BC in ancient Greek philosophy and Indian philosophy. In Greece, the concept was espoused by Pythagoras, apparently on ... concept of a spherical Earth was recognized in the Shatapatha Brahmana and Aitareya Brahmana. Wikipedia