Wire-wound resistors are unsuitable for use at high frequencies because they?

1 Answer

Answer :

Wire-wound resistors are unsuitable for use at high frequencies because they exhibit unwanted inductive and capacitive effects.

Related questions

Description : At ______ frequencies the parallel R-L circuit behaves as purely resistive.

Last Answer : At very high frequencies the parallel R-L circuit behaves as purely resistive.

Description : At very low frequencies a series R-C circuit behaves as almost purely?

Last Answer : At very low frequencies a series R-C circuit behaves as almost purely capacitive.

Description : How to Treat an Infected Wound

Last Answer : How to Treat an Infected Wound If wounds are not managed properly, they might become infected, which can lead to various complications. Here are some steps you can follow to treat wound ... in preventing infections. Remember the signs of infection and consult your doctor if the condition worsens.

Description : How To Heal A Wound

Last Answer : How To Heal A Wound You accidentally trip and bump your leg against a sharp stone. Now your leg is bleeding, and you're at loss on what to do. Before you start swooning or before you pick up the ... but if you manage to do this properly, your wound will heal quickly, and will be gone in no time.

Description : A 400 V, 50 Hz three-phase induction motor rotates at 1440 rpm on full -load. The motor is wound for

Last Answer : A 400 V, 50 Hz three-phase induction motor rotates at 1440 rpm on full -load. The motor is wound for 4 poles

Description : The range of frequencies used in induction heating is :  (A) 0-25 Hz  (C) less than 200 Hz  (B) 50 to 100 Hz  (D) more than 1 kHz

Last Answer : The range of frequencies used in induction heating is : more than 1 kHz

Description : The frequencies and voltage used in Dielectric heating are (A) 10 – 30 MHz, upto 25 kV (B) 50 – 60 Hz, upto 25 kV (C) 10 – 30 MHz, upto 100 V (D) 50 – 60 Hz, 110 V – 230 V

Last Answer : The frequencies and voltage used in Dielectric heating are 10 – 30 MHz, upto 25 kV

Description : what is equivalent resistance when four 4 Ohm resistors are connected in i) series ii) parallel

Last Answer : equivalent resistance

Description : State any two features of carbon composition resistors.

Last Answer : Features of Carbon composition resistance: i) Low cost ii) Wide resistance range ( ohm to mega ohm) iii) Wide range of working voltage iv) Simple in construction 

Description : The colour band on the extreme left in general purpose fixed resistors represents: A) Tolerance B) First significant digit C) Wattage Rating D) Voltage Rating

Last Answer : The colour band on the extreme left in general purpose fixed resistors represents: First significant digit

Description : Three identical resistors connected in star consume 5000 W. If the resistors are connected in delta across the same supply, the power consumed will be

Last Answer : Three identical resistors connected in star consume 5000 W. If the resistors are connected in delta across the same supply, the power consumed will be 15000 W

Description : Consider a circuit with four resistors in series connected to a voltage source. What happens to the voltage across each resistor, if the value of each of the resistors is doubled? A) It will double B) It will remain the same C) It will be halved D) It will become zero

Last Answer : Consider a circuit with four resistors in series connected to a voltage source. What happens to the voltage across each resistor, if the value of each of the resistors is doubled? A) It will double B) It will remain the same C) It will be halved D) It will become zero

Description : When three resistors with unequal values are connected in parallel, _______ A) The current across the resistors is the same  B) The voltage drop across the resistors is the same C) The voltage drops across the resistors is proportional to the resistance of each resistor D) None of these

Last Answer : When three resistors with unequal values are connected in parallel, The voltage drop across the resistors is the same

Description : What is the total resistance if 5 resistors of 20 Ω each are connected in series? A) 100 Ω B) 4 Ω C) 20 Ω D) None of these

Last Answer : What is the total resistance if 5 resistors of 20 Ω each are connected in series? A) 100 Ω B) 4 Ω C) 20 Ω D) None of these

Description : Consider a circuit with four 10 Ω resistors connected in parallel and the current flowing through the circuit is 5 A. What will be the current if the above 4 resistors are connected in parallel? A) 5 A B) 50 A C) 500 A D) None of these

Last Answer : Consider a circuit with four 10 Ω resistors connected in parallel and the current flowing through the circuit is 5 A. What will be the current if the above 4 resistors are connected in parallel? A) 5 A B) 50 A C) 500 A D) None of these

Description : A network contains linear resistors and ideal voltage sources. If values of all the resistors are doubled then the voltage across each resistor will

Last Answer : A network contains linear resistors and ideal voltage sources. If values of all the resistors are doubled then the voltage across each resistor will not change

Description : The circuit has resistors, capacitors and semi-conductor diodes. The circuit will be known as

Last Answer : The circuit has resistors, capacitors and semi-conductor diodes. The circuit will be known as non-linear circuit.

Description : Voltage dependent resistors are used?

Last Answer : Voltage dependent resistors are used to supress surges.

Description : Voltage dependent resistors are usually made from?

Last Answer : Voltage dependent resistors are usually made from nichrome.

Description : Three identical resistors are first connected in parallel and then in series. The resultant resistance of the first combination to the second will be?

Last Answer : Three identical resistors are first connected in parallel and then in series. The resultant resistance of the first combination to the second will be 1/9 times.

Description : Two resistors are said to be connected in series when?

Last Answer : Two resistors are said to be connected in series when same current passes in turn through both.

Description : Aluminium is not used as winding wire for the armature of a dc machine because  (1) aluminium has low resistivity (2) a large winding space is taken by aluminium conductors and creates ... ) the thermal conductivity of aluminium is low (4) aluminium has low conductivity as compared to copper

Last Answer : Aluminium is not used as winding wire for the armature of a dc machine because  (2) a large winding space is taken by aluminium conductors and creates jointing problems (3) the thermal conductivity of aluminium is low (4) aluminium has low conductivity as compared to copper

Description : What happens when a neutral wire touches a phase wire ?

Last Answer : Maximum current flow due to Short circuit, limited value of fuse will burn else apparatus and conductor will be damaged.

Description : Which wire can carry a higher current stranded wire or solid wire?

Last Answer : From the formula R=PL/A resistance rise with the fall of surface area ,inverse proportion relation between Resistance and Area ,so stranded wire has more area that a solid wire so more area less resistance. Less resistance/less electron flow opposition,more electron flow (current)

Description : Why should switch be connected only on the live wire and never on the neutral wire?

Last Answer : Current runs from the transformer, through the protective device, through the load and back through the protective device (if on RCD).  If the protective device is only a CB the current passes ... the circuit will operate correctly but this is an unsafe practice and does not meet the standards.

Description : Increasing the number of turns of wire on the secondary of a transformer will  (A) Decrease the secondary current (B) Increase the primary current (C) Have no effect on the secondary current (D) Increase the secondary current

Last Answer : Increasing the number of turns of wire on the secondary of a transformer will Decrease the secondary current 

Description : For a round wire, the approximate value of fusing current is given by

Last Answer : For a round wire, the approximate value of fusing current is given by  K√d3

Description : lf the wire which is vertical to this page has electron flow downwards the conductor will have

Last Answer : lf the wire which is vertical to this page has electron flow downwards the conductor will have a counter-clockwise field in the plane of the paper

Description : What happens when a current flows through a wire?

Last Answer : Current can produce two effect one is heating effect and second is magnetic effect.

Last Answer : In order to achieve high accuracy, the slide wire of a potentiometer should be as long as possible.

Description : What gauge wire is in ethernet cable?

Last Answer : “Cat 5 cable typically has three twists per inch of each twisted pair of 24 gauge (AWG) copper wires within the cables.” (source)

Description : How to Wire Speakers

Last Answer : How to Wire Speakers Powerful speaker serve many purposes. Amongst these purposes are entertainment during special occasions and event sound system. To maximize its use, you need to understand how much ... long screws rather than short ones. Short screws may not be able to properly secure speakers.

Description : How to Wire a Lamp

Last Answer : How to Wire a Lamp Wiring a lamp is something you need to do just in case your lamp breaks, and it so happens you keep on forgetting to get it repaired. It's a relatively easy process, with ... by yourself will also be a great help if you found the perfect lampshade from the flea market. Good luck.

Description : How to Wire a House

Last Answer : How to Wire a House Wiring a home is a challenging but worthwhile task. Familiarize yourself with things involved in wiring a home before you start this project. Make this your first priority because ... out more by hiring someone with both experience and expertise to help you in your first attempt.

Description : How to Wire a Three-Way Switch ?

Last Answer : How to Wire a Three-Way Switch A three-way switch is the most common system installed in residential areas. This system is used to control a light and receptacle or more from two different switches ... wires for interior use. #14 wires are suggested to be used for protected circuits at 15 amperes.

Description : How to wire a Ceiling Fan ?

Last Answer : How to wire a Ceiling Fan To wire a ceiling fan is a relatively easy project. Usually, it is similar to working on replacing an existing light fixture. However, you will also need to check the ... have a loose wire connection. In case your fan vibrates or shakes, check if the blades are balanced.

Description : State functions of ; i) Cable box ii) Guard wire iii) Shackle insulator iv) Stay wire used in service connection

Last Answer : i) Function of Cable box: To hold and inspect incoming and outgoing terminals  ii) Function of Guard wire : A grounded conductor placed beneath an overhead transmission line in order to ground ... in service connection: To give mechanical Support to pole, line and prevent leakage current if any

Description : The function of steel wire in ACSR conductors is (A) To take care of surges. (B) To reduce corona. (C) To reduce inductance. (D) To provide additional mechanical strength

Last Answer : The function of steel wire in ACSR conductors is To provide additional mechanical strength

Description : A fuse wire should have :  (A) Low specific resistance and high melting point (B) Low specific resistance and low melting point (C) High specific resistance and high melting point (D) High specific resistance and low melting point

Last Answer : A fuse wire should have : High specific resistance and low melting point

Description : Nichrome wire is an alloy of?

Last Answer : Nichrome wire is an alloy of nickel and chromium.

Description : If a wire conductor of 0.2 ohm resistance is doubled in length, its resistance becomes?

Last Answer : If a wire conductor of 0.2 ohm resistance is doubled in length, its resistance becomes 0.4 ohm.

Description : The resistance of a few meters of wire conductor in closed electrical circuit is?

Last Answer : The resistance of a few meters of wire conductor in closed electrical circuit is practically zero.

Description : A trolley wire weighs 1.2 kg per meter length. The ends of the wire are attached to two poles 20 meters apart. If the horizontal tension is 1500 kg find the dip in the middle of the span?

Last Answer : A trolley wire weighs 1.2 kg per meter length. The ends of the wire are attached to two poles 20 meters apart. If the horizontal tension is 1500 kg find the dip in the middle of the span 4.0 cm.

Last Answer : The ground wire should not be smaller than No 10 copper.

Description : How do magnets and copper wire make electricity?

Last Answer : According  to  Faradays  law , a changing  magnetic  field  on  a  conductor  induses  current  in  the  conductor  through   mutual  induction.

Description : What is ACCC wire?

Last Answer : Aluminum Conductor Composite Core

Description : How is electricity passed through a wire?

Last Answer : A  wire contains  mobile  electrons  as  majority  charge  carriers  and  holes  as minority  charge carriers when  an emf  or   potential  diffrence is  provided , electrons  flow  in opposite  direction  with  holes(convection current  flow)

Description : Which color wire is neutral?

Last Answer : Black but I think it depends with the place.

Description : A booster is a (a) series wound generator (b) shunt wound generator (c) synchronous generator (d) none of the above

Last Answer : (a) series wound generator

Description : I've lost my memory, How do I caculate the value of this resistor?

Last Answer : Shoot me if I’m wrong, but don’t you need Ohm’s law for that: http://www.kpsec.freeuk.com/ohmslaw.htm?