Two bulbs of 500 W and 200 W rated at 250 V will have resistance ratio as?

1 Answer

Answer :

Two bulbs of 500 W and 200 W rated at 250 V will have resistance ratio as 2 : 5.

Related questions

Description : Three 60 W bulbs are in parallel across the 60 V power line. If one bulb burns open?

Last Answer : Three 60 W bulbs are in parallel across the 60 V power line. If one bulb burns open the other two bulbs will light.

Description : Ratio of the rotor reactance X to the rotor resistance R for a two-phase servo motor (A) is equal to that of a normal induction motor (B) is less than that of a normal induction motor (C) ... than that of a normal induction motor (D) may be less or greater than that of a normal induction motor

Last Answer : C

Description : Bulbs in street lighting are all connected in?

Last Answer : Bulbs in street lighting are all connected in parallel.

Description : Two light bulbs are connected in series across a 120 V battery. Bulb 1 uses 40 W of power and Bulb 2 uses 20 W of power. If bulb 1 alone is connected to the 120 V source, then it will consume (A) 90 W (B) 80 W (C) 60 W (D) 180 W

Last Answer : Two light bulbs are connected in series across a 120 V battery. Bulb 1 uses 40 W of power and Bulb 2 uses 20 W of power. If bulb 1 alone is connected to the 120 V source, then it will consume 90 W

Description : The hot resistance of the bulb's filament is higher than its cold resistance because the temperature co-efficient of the filament is?

Last Answer : This  is  because  resistance  of  a  conductor  increases  with  increase  in  temperature .

Description : How to Plant Bulbs

Last Answer : How to Plant Bulbs Flowering bulbs are a beautiful addition to any garden and are relatively easy to take care of. Here are the steps to plant flowering bulbs in your garden. Tools Bulbs ... Mark the spot where you planted your bulbs to avoid accidentally planting something else on the same spot.

Description : The ratio of mass of proton to that of electron is nearly?

Last Answer : The ratio of mass of proton to that of electron is nearly 1840.

Description : A 200 V DC machine supplies 20 A at 200 V as a generator. The armature resistance is 0.2 Ohm. If the machine is now operated as a motor at same terminal voltage and current but with the flux increased by 10%, the ratio of motor speed to generator speed is

Last Answer : A 200 V DC machine supplies 20 A at 200 V as a generator. The armature resistance is 0.2 Ohm. If the machine is now operated as a motor at same terminal voltage and current but with the flux increased by 10%, the ratio of motor speed to generator speed is 0.87

Description : A 200 V dc shunt motor is running at 1000 rpm and drawing a current of 10 A. Its armature winding resistance is 2 Ohm. It. is braked by plugging. The resistance to be connected in series with armature to restrict armature current to 10 A, is

Last Answer : A 200 V dc shunt motor is running at 1000 rpm and drawing a current of 10 A. Its armature winding resistance is 2 Ohm. It. is braked by plugging. The resistance to be connected in series with armature to restrict armature current to 10 A, is 36 Ohm

Description : Resistance

Last Answer : .embed-container { position: relative; padding-bottom: 56.25%; height: 0; overflow: hidden; max-width: 100%; } .embed-container iframe, .embed-container object, .embed-container embed { position: absolute; top: 0; left: 0; width: 100%; height: 100%; }

Description : Temperature co-efficient of resistance is expressed in terms of?

Last Answer : Degree celsius

Description : International ohm is defined in terms of the resistance of?

Last Answer : International ohm is defined in terms of the resistance of a column of mercury.

Description : When resistance element of a heater fuses and then we reconnect it after removing a portion of it, the power of the heater will?

Last Answer : When resistance element of a heater fuses and then we reconnect it after removing a portion of it, the power of the heater will increase.

Description : Resistance of a material always decreases if?

Last Answer : Resistance of a material always decreases if number of free electrons available become more.

Description : A closed switch has a resistance of?

Last Answer : A closed switch has a resistance of zero.

Description : If a wire conductor of 0.2 ohm resistance is doubled in length, its resistance becomes?

Last Answer : If a wire conductor of 0.2 ohm resistance is doubled in length, its resistance becomes 0.4 ohm.

Description : The resistance of a few meters of wire conductor in closed electrical circuit is?

Last Answer : The resistance of a few meters of wire conductor in closed electrical circuit is practically zero.

Description : With rise in temperature the resistance of semi-conductors?

Last Answer : With rise in temperature the resistance of semi-conductors decreases.

Description : With rise in temperature the resistance of pure metals?

Last Answer : With rise in temperature the resistance of pure metals increases.

Description : The resistance of a conductor varies inversely as?

Last Answer : The resistance of a conductor varies inversely as area of cross-section.

Description : The Eb/V ratio of a d.c. motor is an indication of its?

Last Answer : The Eb/V ratio of a d.c. motor is an indication of its efficiency.

Description : What do you do to replant a pot of daffodils or hyacinths, do you let the soil get dry?

Last Answer : answer:Here you go. This one is for hyacinths.

Description : If Poisson's ratio of a resistance wire strain gauge is 1.8, then neglecting piezo-resistive effects, its Gauge factor is :  (A) 2.8 (B) 2.6 (C) 4.6 (D) 3.6

Last Answer : If Poisson's ratio of a resistance wire strain gauge is 1.8, then neglecting piezo-resistive effects, its Gauge factor is : 4.6

Description : Graph indicating changes in pollutants level w.r.t air fuel ratio

Last Answer : Graph indicating changes in pollutants level w.r.t air fuel ratio

Description : In otto cycle compression ratio is 8. Calculate air standard efficiency. Will it be grater than Carnot Cycle ? Justify your answer. 

Last Answer : No, the Otto cycle efficiency 56.47% will always be lower than Carnot cycle efficiency. Justification: Carnot theorem states that keeping operating conditions same, Carnot engine is more efficient than any other engine. So, Otto cycle efficiency is lower than Carnot cycle efficiency. 

Description : Compressor pressure ratio (CPR)

Last Answer : Compressor pressure ratio (CPR), is the ratio of the air total pressure exiting the compressor to the air pressure entering the compressor. This number is always greater than 1.0.

Description : SEER: Seasonal Energy Efficiency Ratio (SEER)

Last Answer : SEER: Seasonal Energy Efficiency Ratio (SEER), is most commonly used to measure the efficiency of a central air conditioner. The higher the SEER, the more efficient the system OR It is the ... the ratio of total capacity to the total KW energy usage at specific humidity and temperature condition.

Description : Voltage ratio

Last Answer : Voltage ratio

Description : Turns ratio

Last Answer : Turns ratio formula

Description : Impedance ratio

Last Answer : Impedance ratio

Description : Current ratio

Last Answer : Current ratio

Description : Define: 1) voltage ratio, 2) current ratio, 3) transformation ratio of transformer.

Last Answer : 1) Voltage ratio: The voltages in primary and secondary winding is proportional to number of turns in primary and secondary respectively. So, the voltage ratio is same as transformation ratio. V2/V1 = N2 ... as transformation ratio of transformer. It is denoted by K. K = N2/N1

Description : What is transformation ratio?

Last Answer : Transformation Ratio (k):- It is the ratio of secondary number of turns to primary number of turns. OR It is the ratio of secondary voltage to primary voltage. OR It is the ratio of primary current to secondary current. 

Description : The ratio of the width to the height of the picture frame is called as A) Rastar B) Aspect Ratio C) Length Ratio D) Efficiency  

Last Answer : The ratio of the width to the height of the picture frame is called as Aspect Ratio

Description : If the fault current is 6000 A, the relay plug setting is 150% and the CT ratio is 400/5, the plug setting multiplier will be

Last Answer : If the fault current is 6000 A, the relay plug setting is 150% and the CT ratio is 400/5, the plug setting multiplier will be 10

Description : Given a unity feedback system with G(s)=k/s (s+4), the value of k for damping ratio of 0.5 is

Last Answer : Given a unity feedback system with G(s)=k/s (s+4), the value of k for damping ratio of 0.5 is 16

Description : A dc chopper is fed from a constant voltage mains the duty ratio of chopper is progressively increased while the chopper feeds an RL load. The per unit current ripple would  (1) increase progressively  (2 ... 0.5 and then increase  (4) increase to a maximum value at α = 0.5 and then decrease

Last Answer : A dc chopper is fed from a constant voltage mains the duty ratio of chopper is progressively increased while the chopper feeds an RL load. The per unit current ripple would increase to a maximum value at α = 0.5 and then decrease

Description : The ratio of full -load volt-amperes to short-circuit volt-amperes is equal to :

Last Answer : The ratio of full -load volt-amperes to short-circuit volt-amperes is equal to : Z (p.u)

Description : Specific energy consumption of an electric train is the ratio between (A) Specific energy output at driving wheels and efficiency of the traction motor (B) Specific energy output at driving wheels ... (D) Specific energy output at driving wheels and efficiency of the (motor + transmission gear)

Last Answer : Specific energy consumption of an electric train is the ratio between Specific energy output at driving wheels and efficiency of the (motor + transmission gear)

Description : The ratio of active power to apparent power is known as____ factor.

Last Answer : The ratio of active power to apparent power is known as power factor.

Last Answer : The form factor is the ratio of r.m.s. value to average value.

Description : The ratio of limiting friction and normal reaction is known as?

Last Answer : The ratio of limiting friction and normal reaction is known as coefficient of friction.

Last Answer : The mechanical power developed by a shunt motor will be maximum when the ratio of back e.m.f. to applied voltage is 0.5.

Last Answer : The ratio of starting torque to full-load torque is least in case of shunt motors.

Last Answer : A synchronous machine with low value of short-circuit ratio has lower stability limit.

Description : The voltage transformation ratio of a transformer is equal to the ratio of?

Last Answer : The voltage transformation ratio of a transformer is equal to the ratio of secondary induced e.m.f. to primary induced e.m.f.

Description : Auto-transformer makes effective saving on copper and copper losses, when its transformation ratio is?

Last Answer : Auto-transformer makes effective saving on copper and copper losses, when its transformation ratio is approximately equal to 1.

Description : Use of auto-transformer is economical when the transformation ratio is?

Last Answer : Use of auto-transformer is economical when the transformation ratio is near unity.

Description : Name two methods for measurement of low, medium and high resistance. Give one advantage and one limitation of V- I method.

Last Answer : Methods for measurement of low resistance:  1. Ammeter voltmeter method  2. Kelvin's bridge method  3. Ohm meter method  4. Potentiometer method  5. Digital/analog multi-meter ... must be infinity for perfectly accurate measurement which is not possible.  2. Connection errors.

Description : Explain V- I method of measurement of medium resistance. 

Last Answer : In this method, use suitable source, ammeter and voltmeter and connect them as shown in the above diagram. Take reading of voltmeter and ammeter, then value of resistance = R = V/I Ω To minimise the error take 4 to 5 observation for the same resistance and take their average.