For high efficiency of transfer of power, internal resistance of the source should be?

For high efficiency of transfer of power, internal resistance of the source should be?

by

1 Answer

Answer :

For high efficiency of transfer of power, internal resistance of the source should be less than the load resistance.

by

Related questions

For maximum transfer of power, internal resistance of the source should be?

Description : For maximum transfer of power, internal resistance of the source should be?

Last Answer : For maximum transfer of power, internal resistance of the source should be equal to load resistance.

Maximum Power Transfer Theorem 1

Description : Maximum Power Transfer Theorem 1

Last Answer : Maximum Power Transfer Theorem 1

State maximum power transfer theorem for DC circuit.

Description : State maximum power transfer theorem for DC circuit.

Last Answer : Maximum power transfer theorem for DC circuit: The maximum power transfer theorem states that the source or a network transfers maximum power to load only when the load resistance is equal ... removed (disconnected) ii) All internal independent sources are replaced by their internal resistances.

_______ electric power is the most common method used by electrical grids to transfer power.

Description : _______ electric power is the most common method used by electrical grids to transfer power.  (A) One-phase (B) Two-phase (C) Three-phase (D) None of the above

Last Answer : Three-phase electric power is the most common method used by electrical grids to transfer power. 

The reactive power transfer over a line mainly depends on

Description : The reactive power transfer over a line mainly depends on

Last Answer : The reactive power transfer over a line mainly depends on lVsl- lVRl

Mention The Steps In The Interrupt Driven Mode Of Data Transfer.?

Description : Mention The Steps In The Interrupt Driven Mode Of Data Transfer.?

Last Answer : Answer :The steps followed in this type of transfer are as follows: The peripheral device would request for an interrupt. The request acknowledgement for the transfer is issued at the end of ... coordinates by the ISS. Again the Interrupt system is enabled and the above steps are repeated.

How to Write a Job Transfer Request ?

Description : How to Write a Job Transfer Request ?

Last Answer : How to Write a Job Transfer Request No matter which type of industry you are in, there may come a point in your career when you would not want to settle for the current position that you have at ... push that your boss needs to finally take notice of the work that you have been doing in the past.

Heat Transfer Software

Description : Heat Transfer Software

Last Answer : The process of heat transfer is used in many industries - the scientific industry, engineering industry and every industry you can possibly think of that uses thermal heat. Because of this, there is a need ... group, so you won't have to go through the hassle of copying information down for others.

Heat Transfer Machines

Description : Heat Transfer Machines

Last Answer : Heat transfer machines are just the thing you need in order to do heat transfers on your clothing or whatever surface you want to decorate. In order for you to stick designs and precious stones on porous and ... is best. This will also give you an idea of what kind of designs you can choose from.

Heat Transfer Experiments

Description : Heat Transfer Experiments

Last Answer : Heat transfer experiments are basically experiments that deal with temperature, its characteristics and qualities. Heat transfer experiments are done for many purposes, but mainly to do investigations on the ... three are learned, it helps to have a better understanding of heat transfers as well.

Fuel Transfer Pumps

Description : Fuel Transfer Pumps

Last Answer : A fuel transfer pump is used to move fuel from one container to another. These pumps are used to fuel cars, planes, agricultural equipment and other devices. They are typically used to transfer diesel and ... for quicker fueling. These models may cost more, but they will make your job a lot easier.

How to transfer an apartment to a non-residential fund?

Description : How to transfer an apartment to a non-residential fund?

Last Answer : Can a private entrepreneur use his apartment as an office? The answer to this question depends on the type of activity. To sew, write poetry, fill out accounting documents, engage in tutoring, write ... is unacceptable. If you are not satisfied with this decision, you can appeal it in court.

Calculate the rate of heat transfer by radiation from an unlagged steam pipe, 50 mm o.d. at 393K to air at 293K emissivity e = 0.9.

Description : Calculate the rate of heat transfer by radiation from an unlagged steam pipe, 50 mm o.d. at 393K to air at 293K emissivity e = 0.9.

Last Answer : Rate of heat transfer by radiation Assume length of pipe = 1 m

Give the unit of overall heat transfer coefficient in SI and MKS.

Description : Give the unit of overall heat transfer coefficient in SI and MKS.

Last Answer : Unit of overall heat transfer coefficient 1. In SI : W/m2K 2. In MKS : kcal/hr m2K

Define film heat transfer coefficient.

Description : Define film heat transfer coefficient.

Last Answer : Film heat transfer coefficient: Film heat transfer coefficient h is defined as the quantity of heat transferred in unit time through unit area at a temperature difference of 10 between the surface and surrounding.

Define steady state heat transfer.

Description : Define steady state heat transfer.

Last Answer : Steady state heat transfer: Heat transfer where temperature remains same with respect to time and the rate of heat transfer does not vary with time.

Transfer switch

Description : Transfer switch

Last Answer : .embed-container { position: relative; padding-bottom: 56.25%; height: 0; overflow: hidden; max-width: 100%; } .embed-container iframe, .embed-container object, .embed-container embed { position: absolute; top: 0; left: 0; width: 100%; height: 100%; }

A transfer function has a second order denominator and constant gain in the numerator

Description : A transfer function has a second order denominator and constant gain in the numerator

Last Answer : A transfer function has a second order denominator and constant gain in the numerator the system has two zeros at infinity

The transfer of energy for reaction turbines is based on _______

Description : The transfer of energy for reaction turbines is based on _______ A) Newton’s first law B) Newton’s second law C) Newton’s third law D) All the above

Last Answer : The transfer of energy for reaction turbines is based on Newton’s third law

With the knowledge of the state variable representation of a plant the transfer function of the plant

Description : With the knowledge of the state variable representation of a plant the transfer function of the plant 

Last Answer : With the knowledge of the state variable representation of a plant the transfer function of the plant can be determined completely

Explain data transfer mechanism in I2C protocol.

Description : Explain data transfer mechanism in I2C protocol. Compare it with CAN and USB protocol based on bit rate and area of applications.

Last Answer : I2C (Inter-Integrated Circuit): I2C stands for Inter-Integrated Circuit. I2C is a serial protocol. It was developed by Philips Semiconductor. I2C bus have two communication lines. One is serial data ( ... Mbps this is used for lower speed devices. Using USB we can connect upto 127 devices.

"Efficiency of thermal power station is low". — Justify.

Description : "Efficiency of thermal power station is low". — Justify. 

Last Answer : Justification: Efficiency of thermal power station is low":- Overall efficiency of T.P.P depends upon efficiency of boiler, turbine and alternator. The heat produced due to combustion of coal ... losses in thermal power plant is 71%, So efficiency of thermal power plant is less about 29% 

The overall efficiency of Thermal Power Plant is equal to _______________ .

Description : The overall efficiency of Thermal Power Plant is equal to _______________ .  (A) Regenerative Cycle Efficiency (B) Renkine Cycle Efficiency (C) Carnot cycle efficiency (D) None of the above

Last Answer : The overall efficiency of Thermal Power Plant is equal to Regenerative Cycle Efficiency. 

The rankine cycle efficiency of steam power plant is

Description : The rankine cycle efficiency of steam power plant is  (1) 60-80% (3) 30-45% (2) 45-80% (4) 20-30%

Last Answer : The rankine cycle efficiency of steam power plant is 30-45%

Efficiency of a power transformer is of the order of?

Last Answer : The efficiency of a power transformer is of the order of 98 percent.

SEER: Seasonal Energy Efficiency Ratio (SEER)

Description : SEER: Seasonal Energy Efficiency Ratio (SEER)

Last Answer : SEER: Seasonal Energy Efficiency Ratio (SEER), is most commonly used to measure the efficiency of a central air conditioner. The higher the SEER, the more efficient the system OR It is the ... the ratio of total capacity to the total KW energy usage at specific humidity and temperature condition.

State why a transformer always have an efficiency of more than 90%.

Description : State why a transformer always have an efficiency of more than 90%.

Last Answer : As transformer is static device with no moving parts, the losses due to friction & windage are completely absent. Hence transformer has efficiency of more than 90%.

Compare the salient features of LED and CFL based on: i] Lamp Efficiency ii] Life span

Description :  Compare the salient features of LED and CFL based on: i] Lamp Efficiency ii] Life span 

Last Answer : Parameter LED CFL Lamp Efficiency  High (more than 70 lumen per watt) Comparatively less (50-60 lumen per watt) Life span (in working hours) 10000 3000

Define PIV, TUF, ripple factor, efficiency of rectifier.

Description : Define PIV, TUF, ripple factor, efficiency of rectifier.

Last Answer : PIV: Peak Inverse Voltage (PIV) is defined as the maximum negative voltage which appears across non-conducting reverse biased diode. TUF : Transformer Utilization Factor (TUF) is defined as the ratio of DC output ... Efficiency of rectifier: η = DC output power/ AC input power = PLdc / Pac

method for improving string efficiency

Description : method for improving string efficiency 

Last Answer : The Methods of Improving String Efficiency:-   1) By reducing value of ‘m’ or (‘k’) by using longer cross arm. 2) By Making of ‘m’ or (‘k’) equal to zero 3) By grading Insulator. 4) By Using guard ring.

Transformer efficiency

Description : Transformer efficiency

Last Answer : Transformer efficiency

What is the efficiency of Class-B amplifier?

Description : What is the efficiency of Class-B amplifier?  A) 68.50% B) 78.50% C) 88.50% D) 98.50%

Last Answer : What is the efficiency of Class-B amplifier?  A) 68.50% B) 78.50% C) 88.50% D) 98.50%

A transformer operates 24 hours day at full -load. It's full -load efficiency is :

Description : A transformer operates 24 hours day at full -load. It's full -load efficiency is :  (A) equal all day efficiency (B) more than all -day efficiency (C) less than all -day efficiency (D) equal to maximum efficiency

Last Answer : A transformer operates 24 hours day at full -load. It's full -load efficiency is : equal all day efficiency 

Transmission efficiency of a transmission line increases with the

Description : Transmission efficiency of a transmission line increases with the

Last Answer : Transmission efficiency of a transmission line increases with the increase in power factor and voltage

The efficiency of diesel locomotives is nearly?

Last Answer : The efficiency of diesel locomotives is nearly 20 to 25 percent.

The overall efficiency of steam locomotive is around?

Last Answer : The overall efficiency of steam locomotive is around 5 to 10 percent.

D.C. generators are normally designed for maximum efficiency around?

Last Answer : D.C. generators are normally designed for maximum efficiency around full-load.

The condition for maximum efficiency for a D.C. generator is?

Last Answer : The condition for maximum efficiency for a D.C. generator is variable losses equal to constant losses.

The range of efficiency for shaded pole motors is?

Last Answer : The range of efficiency for shaded pole motors is 5% to 35%.

The efficiency of a properly designed synchronous motor will usually fall in range?

Last Answer : The efficiency of a properly designed synchronous motor will usually fall in range 85 to 95%.

Generators for peak load plants are usually designed for maximum efficiency at?

Last Answer : Generators for peak load plants are usually designed for maximum efficiency at 50 to 75 percent full load.

An ideal transformer will have maximum efficiency at a load such that?

Last Answer : An ideal transformer will have maximum efficiency at a load such that copper loss equal to iron loss.

For a transformer, operating at constant load current, maximum efficiency will occur at?

Description : For a transformer, operating at constant load current, maximum efficiency will occur at?

Last Answer : For a transformer, operating at constant load current, maximum efficiency will occur at unity power factor.

The efficiency of two identical transformers under load conditions can be determined by?

Description : The efficiency of two identical transformers under load conditions can be determined by?

Last Answer : The efficiency of two identical transformers under load conditions can be determined by back-to-back test.

The efficiency of a transformer, under heavy loads, is comparatively low because?

Description : The efficiency of a transformer, under heavy loads, is comparatively low because?

Last Answer : The efficiency of a transformer, under heavy loads, is comparatively low because copper loss becomes high in proportion to the output.

Which motor have more efficiency, synchronous motor or induction motor?

Description : Which motor have more efficiency, synchronous motor or induction motor?

Last Answer : Synchronous motor has more efficiency.

String efficiency is used for measuring the?

Last Answer : String efficiency is used for measuring the degree of utilization of SCR.

is efficiency of transformer is greater than electrical machine and why?

Last Answer : The efficiency of transformer is Greater than electrical Machine because there is no rotational losses in transformer and there is no air gap losses in transformer so losses is less in transformer compare to electrical machine so efficiency is higher in case of transformer.

when will be the maximum efficiency of transformer?

Last Answer : Transformer efficiency is maximum when copper losses are equal to iron losses.

Explain with reason through which side of shell and tube heat exchanges, the following liquids are directed. (i) viscous liquid (ii) high pressure liquid (iii) corrosive liquid

Description : Explain with reason through which side of shell and tube heat exchanges, the following liquids are directed. (i) viscous liquid (ii) high pressure liquid (iii) corrosive liquid

Last Answer : Viscous liquid : Viscous liquid is passed through shell side Reason: because of the presence of baffles in the shell induce turbulence and hence increases heat transfer rate. High pressure liquid: High ... To avoid expensive alloy shells (in order to save the cost of expensive material for shell).