How to Install a Sprinkler System
A sprinkler system promotes convenience in the normally tedious job of watering your lawn or garden. Upon activation, the sprinklers provide water for the entire garden. It can even be set to sprinkle water automatically, if the system has a built-in timer. In truth, installing the device requires time and much effort, but the task is worth it, given the convenience it provides.
Dig a Trench for the Sprinklers
The trench provides not only a casing for the sprinklers, but also a drainage system, in case too much water is sprinkled. Dig a trench, which is about six to twelve inches deep, for the sprinkler set. Make sure it runs by all the sections of your garden, so the entire area can be covered by the sprinklers.
Install PVC Pipes in the Trench
The PVC pipes are essential parts of the sprinkler system. They carry water, coming from the water source, and send them to the sprinklers. The casing also ensures the water’s cleanliness. Assemble the piping and set them in the trench. If you are not adept at connecting pipes, better leave the job to a professional. Poorly connected pipes may end up with leaks, which will certainly reflect on your water bill.
Install the Sprinkler Heads
With the pipes connected, your next job is to affix the sprinkler heads. The sprinkler system has designated openings for the sprinkler heads. So you just need to screw them in place. Remember, the heads must be well above the trench, otherwise only a limited amount of water will reach the garden.
Hook Up the System to the Water Supply
Tapping into the water supply is a delicate job. Don’t even attempt it if you’re not experienced in handling pipes. A tee must be installed past the water meter and connected to the sprinkler system. Use an electric drill to create openings, which will link the water supply to the system’s piping. Install the valves that come along with the system as well as the timer and the drainage system for the winter season.
Install the Control Box then Test
Mechanisms like the valves and the timer are powered by the control box. Set it up as stated by the instruction manual that comes with the system. Once everything is hooked up, give it a dry run. Check if all the mechanisms work and the sprinklers’ individual coverage. When everything is up and running, you can finally stop worrying about watering the plants.