Sixteen different levels (symbols) are used to  encode binary data. The channel bandwidth  is 36 MHz. The maximum channel capacity  is

1 Answer

Answer :

288 Mbps

Related questions

Description : A 4.5-MHz signal which is equal to the difference between the picture and sound RF carrier frequencies in a 6-MHz TV channel.

Last Answer : Intercarrier frequencY

Description : It is used to encode the minimum amount of speech information necessary to reproduce a perceptible message with a fewer bits that those needed by a conventional encoder/decoder

Last Answer : vocoders

Description : The phase relationship between signaling elements for BPSK is the optimum signaling format and occurs only when two binary signal levels are allowed and when one signal is the exact negative of the other

Last Answer : Antipodal signaling

Description : For the 16-PSK and a transmission system with a 10kHz bandwidth, determine the maximum bit rate

Last Answer : 40,000 bps

Description : A base-16 number system that uses sixteen distinct symbols 0-9 and A-F to represent numbers from 0 to 15. A. Binary B. Decimal C. Hexadecimal D. Hepadeximal

Last Answer : A. Binary

Description : In the Philippine color television system, the intercarrier frequency, in MHz, is

Last Answer : 4.5

Description : In the Philippine color television system, the intercarrier frequency, in MHz, is

Last Answer : 4.5

Description : A transmission of binary data which involves the transmission of two non – zero voltage level

Last Answer : Bipolar

Description : Category of data transmission if the binary pulse is maintained for the entire bit time?

Last Answer : Return to zero

Description : An image uses 512 x 512 picture elements. Each element can take any of eight distinguishable levels. The maximum entropy in the above image will be:

Last Answer : 786432 bits

Description : The total bandwidth of an NTSC TV signal is:

Last Answer : . 6 MHz

Description : An FDM hierarchy which is formed by frequency – division multiplexing five groups containing 12 channels each for a combined bandwidth of 240 kHz

Last Answer : Supergroup

Description : The total bandwidth of an NTSC TV signal is:

Last Answer : 6 MHz

Description : The bandwidth required for a modulated carrier depends on:

Last Answer : the baseband frequency range

Description : It is the ratio of the transmission bit rate to the minimum bandwidth required for a particular modulation scheme

Last Answer : Bandwidth efficiency, Information density, or Spectral efficiency

Description : It is the thermal noise power normalized to 1- Hz bandwidth:

Last Answer : noise power density

Description : What is the typical bandwidth of a satellite band? A. 36 MHz B. 40 MHz C. 70 MHz D. 500 MHz

Last Answer : D. 500 MHz

Description : What is the bandwidth available in the commercial C-band? A. 1000 MHz B. 36 MHz C. 250 MHz D. 500 MHz

Last Answer : D. 500 MHz

Description : What is the typical satellite transponder bandwidth? A. 24 MHz B. 500 MHz C. 36 MHz D. 48 MHz

Last Answer : C. 36 MHz

Description : In the case of a 70–MHz IF carrier for a transponder bandwidth of 36 MHz, energy must lie between MHz: (1) 34 and 106 (2) 52 and 88 (3) 106 and 142 (4) 34 and 142

Last Answer : In the case of a 70–MHz IF carrier for a transponder bandwidth of 36 MHz, energy must lie between MHz: 52 and 88

Description : It involves converting standard logic levels to a form more suitable to telephone transmission lines

Last Answer : igital line encoding

Description : The channel spacing in the Philippine FM broadcast standards

Last Answer : 800 kHz

Description : The channel spacing in the Philippine FM broadcast standards.

Last Answer : 800 kHz

Description : The ISDN channel D designates _____ which contains control information

Last Answer : Data

Description : The PCM code for each channel occupies a fixed time slot called:

Last Answer : Epoch

Description : The ISDN channel B designates _____

Last Answer : Bearer

Description : __________ defines how a user gets control of the channel so as to allow transmission.

Last Answer : channel access

Description : The ________ is a function of three values: average data rate, peak data rate, and maximum burst size.

Last Answer : Effective bandwidth

Description : The upper pulse rate and information carrying capacity of a cable is limited by:

Last Answer : modal dispersion

Description : An FDM hierarchy which is formed by frequency – division multiplexing 10 super groups together for a combined capacity of 600 voice band message channels.

Last Answer : Mastergroup

Description : What is the type of mastergroup used for low – capacity microwave systems?

Last Answer : L600

Description : How many users are supported in IS-95 for each 1.25 MHz? a) Eight b) Sixty four c) Sixteen d) Twenty five

Last Answer : b) Sixty four

Description : What is the maximum color TV bandwidth? A. 1.6 MHz B. 0.5 MHz C. 1.0 MHz D. 1.3 MHz

Last Answer : D. 1.3 MHz

Description : How many symbols are used in the hexadecimal number system? 15) A) sixteen B) six C) ten D) twelve

Last Answer : A) sixteen

Description : State the Shannon Hartley’s theorem for channel capacity. Explain the effect of S/N ratio and bandwidth on channel capacity.

Last Answer : In information theory, the Shannon-Hartley theorem tells the maximum rate at which information can be transmitted over a communications channel of a specified bandwidth in the presence of noise. According to Shannon, ... value of S/N with increase in B,assuming the signal power S to be constant.

Description : The line bisecting the major lobe, or pointing from the center of the antenna in the direction of maximum radiation is called _____

Last Answer : line of shoot

Description : The maximum angle in which external light rays may strike the air/glass interface and still propagate down the fiber.

Last Answer : Acceptance cone half-angle

Description : In changing the frequency of a cavity, what is accomplished by placing a nonmagnetic slug in the area of maximum H lines

Last Answer : Inductive Coupling

Description : What is the maximum theoretical data rate of the above problem if one transponder is used for binary transmission? A. 36 Mbps B. 72 Mbps C.18 Mbps D. 144 Mbps

Last Answer : B. 72 Mbps

Description : ____ is a process-to-process protocol that adds only port addresses, checksum error control, and length information to the data from the upper layer.

Last Answer : UDP

Description : _______ refers to the structure or format of the data, meaning the order in which they are presented.

Last Answer : Semantics

Description : A ________ is a set of rules that governs data communication

Last Answer : protocol

Description : It is proposed network designed by major telephone companies in conjunction with the ITU-T with the intent of providing worldwide telecommunications support for voice, data, video and facsimile information within the same networ

Last Answer : ISDN

Description : The characters making up the message in a synchronous transmission are collectively referred to as the data

Last Answer : block

Description : It is how the primary designates the secondary as the designation of recipient of data

Last Answer : Selection

Description : Variation of biphase that is used for encoding SMPTE time code data and for recording on video tapes

Last Answer : Biphase – M

Description : Set rules implementing and governing an orderly exchange of data between layers of two devices, such as line control units and front – end processors.

Last Answer : Data Link Protocol

Description : A modulation technique where data rates in excess of 56 kbps can be achieved over telephone circuits

Last Answer : Trellis Code Modulation

Description : Data rate at which serial PCM bits are clocked out of the PCM encoder onto the transmission line.

Last Answer : line speed

Description : Classification of protocol that interprets a frame of data as a group of successive bit combined into predetermined pattern of fixed length, usually 8 bits each.

Last Answer : Character and Byte-oriented protocols