Description : Air fuel ratio at which a petrol engine cannot work is a. 8:1 b. 10:1 c. 20:1 and less d. 15:1
Last Answer : ANSWER c. 20:1 and less
Description : The theoretically correct air fuel ratio for petrol engine is of the order of a.6 : 1 b. 9 : 1 c. 12 : 1 d. 15 : 1
Last Answer : Answer d. 15:1
Description : The theoretically correct air fuel ratio of a petrol engine is of the order of A. 6:1 B. 10:1 C. 15:1 D. 20:1
Last Answer : ANSWER : C
Description : Air fuel ratio for idling speed of a petrol engine is approximately A. 1:1 B. 5:1 C. 20:1 D. 10:1
Last Answer : ANSWER : D
Description : The stoichiometric air fuel ration for petrol is 15:1 . What is the air fuel ratio required for maximum power? (a) 16:1 – 18:1 (b) 15:1 (c) 12:1 – 14:1 (d) 9:1 – 11:1
Last Answer : Ans :c
Description : The fuel air ratio in a petrol engine fitted with suction carburetor, operating with dirty air filter as compared to clean filter will be A. higher B. lower C. remain unaffected D. unpredictable
Last Answer : ANSWER : A
Description : The air-fuel ratio of the petrol engine is governed by A. fuel pump B. governor C. carburetor D. injector
Description : The specific fuel consumption of a petrol engine compared to diesel engine of same H.P is A. same B.more C. less D. unpredictable
Last Answer : ANSWER : B
Description : The air fuel ratio in petrol engines is controlled by a. valve opening / closing b. governing c. carburetion d. scavenging
Last Answer : ANSWER c. carburetion
Description : The air requirement of a petrol engine during starting compared to the theoretical air requirement for complete combustion is A. more B.unpredictable C. same D. less
Description : The air requirement of a petrol engine during starting compared to theoretical air required for complete combustion is a. more b. less c. same d. may be more or less depending on engine capacity
Last Answer : ANSWER b. less
Description : The specific fuel consumption per BHP hour for petrol engine is approximately a. 0.1 kg b. 0.2 kg c. 0.25 kg d. 0.35 kg
Last Answer : ANSWER c. 0.25 kg
Description : The compression ratio cannot be increased beyond certain limit as it results in a. auto-ignition of fuel b. detonation c. engine knocking d. all the above
Last Answer : ANSWER d. all the above
Description : In _____________ sensor, output voltage changes in proportion to air-fuel ratio. a) engine temperature b) exhaust gas c) air flow d) air inlet temperature
Last Answer : Answer: b Explanation: Only in exhaust gas sensor, output voltage changes in proportion to air-fuel ratio.
Description : _____________ senor senses the amount of oxygen in the engine exhaust and calculates air-fuel ratio. a) Engine temperature b) Exhaust gas c) Air flow d) Air inlet temperature
Last Answer : Answer: b Explanation: Exhaust gas senor senses the amount of oxygen in the engine exhaust and calculates airfuel ratio while engine temperature sensor senses the temperature of the engine coolant, and from this data the computer adjusts the mixture strength to rich side for cold starting.
Description : If the performance of diesel engine of different sizes, cylinder dimensions and power rating are to be compared, which of the following parameters can be used for such comparison? (a) Swept volume (b) Air fuel ratio (c) Specific brake fuel consumption (d) Volumetric efficiency
Description : The actual volume of fresh charge admitted in 4-stroke petrol engine is A. equal to stroke volume B. equal stroke volume and clearance volume C. less than stroke volume D. more than stroke volume
Description : A diesel engine compared to petrol engine, running at full load is A. less efficient B. equally efficient C. more efficient D. other factors will decide it
Description : An engine working on air standard Otto cycle has a cylinder diameter of 10 cm and stroke length of 15 cm. The ratio of specific heats for air is 1.4. If the clearance volume is 196.3 cc and the heat supplied per kg of air per ... kg of air is a. 879.1 kJ/ b. 890.2 kJ c. 895.3 kJ d. 973.5 kJ
Last Answer : ANSWER d. 973.5 kJ
Description : The back pressure of petrol engine is usually a. 1 ata b. 1.2 ata c. 0.8 ata d. 2 ata.
Last Answer : ANSWER b. 1.2 ata
Description : Cetane number of petrol is around a. 10 b. 15-20 c. 35 d. 55-70
Last Answer : ANSWER b. 15-20
Description : The specific fuel consumption for diesel engine is approximately A. 0.15 kg/kWh B. 0.2 kg/kWh C. 28 kg/kWh D. 0.36 kg/kWh
Description : HUCR is the highest compression ratio at which the A. engine can be run B. engine gives maximum output C. engine is most efficient D. fuel can be used in a test engine without detonation
Description : The tendency of a diesel engine to knock increases if a. engine speed is increased b. engine power is increased c. cetane number of the fuel is increased d. compression ratio is increased
Last Answer : ANSWER d. compression ratio is increased
Description : Use of gasoline blend like tetraethyl lead in internal combustion engine a. increases the octane rating of the fuel b. allows engine to operate at higher compression ratio c. avoids auto-ignition of fuel d. all of the above
Last Answer : ANSWER d. all of the above
Description : The fuel in diesel engine is normally injected at pressure of a. 5-10 kg/cm2 b. 20-25 kg/cm2 c 60-80 kg/cm2 d. 90-130 kg/cm2
Last Answer : ANSWER d. 90-130 kg/cm2
Description : A fuel of cetane number 40 has the same ignition quality as a mixture of a) 40% cetane and 60% alpha methyl naphthalene b) 40% alpha methyl naphthalene and 60% cetane c) 40% petrol and 60% diesel d) 40% diesel and 60% petrol
Last Answer : Answer: a Explanation: A fuel of cetane number 40 has the same ignition quality as a mixture of 40% cetane and 60% alpha methyl naphthalene as cetane number is counted on cetane percentage.
Description : A fuel of an octane number rating of 75 matches in knocking intensity as a mixture of a) 75% iso-octane and 25% normal heptane b) 75% normal heptane and 25% iso-octane c) 75% petrol and 25% diesel d) 75% diesel and 25% petrol
Last Answer : Answer: a Explanation: None.
Description : The self-ignition temperature of diesel oil compared to petrol is a. higher b. lower c. same d. depends on the quality of fuel
Last Answer : ANSWER a. higher
Description : For an engine operating on air standard Otto cycle, the clearance volume is 10% of the swept volume. The specific heat ratio of air is 1.4. The air standard cycle efficiency is a. 38.3 % b. 39.8 % c. 60.2 % d. 61.7 %
Last Answer : ANSWER d. 61.7%
Description : If diesel is used in a petrol engine a. engine will not run b. engine detonates c. engine gives smoke d. engine knocks
Last Answer : ANSWER a. engine will not run
Description : For low load operation more economical engine is a. petrol engine b. diesel engine c. muticylinder engine d. two stroke engine
Last Answer : ANSWER b. diesel engine
Description : If petrol is used in a diesel engine a. higher knocking will occur b. efficiency will be low c. low power will be obtained d. black smoke will be produced
Last Answer : ANSWER a. higher knocking will occur
Description : In a petrol engine, which of the following gas gets exhausted out without burning and without transformation? a. CO2 b. CO c. O2 d. N2
Last Answer : ANSWER d. N2
Description : The tendency of a petrol engine to knock increases by a. supercharging b. scavenging c. increasing the engine horse power d. reducing the spark advance
Last Answer : ANSWER a. supercharging
Description : Which of the following is not an internal combustion engine? a. petrol engine b. steam turbine c. diesel engine d. gas turbine
Last Answer : ANSWER b. steam turbine
Description : A spark plug is used in a. petrol engine b. diesel engine c. gas engine d. steam engine
Last Answer : ANSWER a. petrol engine
Description : For the same capacity engines, the compression ratio of diesel engine a. is lower than the compression ratio of SI engine b. is higher than the compression ratio of SI engine c. is same as the compression ratio of SI engine d. cannot say
Last Answer : ANSWER b. is higher than the compression ratio of SI engine
Description : Solid injection in CI engine means injection of A. solid fuel only B. liquid fuel only C. liquid fuel and air D. solid fuel and air
Description : In diesel engine the fuel injected would burn instantaneously at about compressed air temperature of A. 1000°C B. 250°C C. 450°C D. 2000°C
Description : Which of the following is compressed in a diesel engine cylinder A. air B. fuel C. air and fuel D. air and lub oil
Description : The output of a diesel engine can be increased without increasing the engine speed or size in the following way A. feeding more fuel B. increasing the flywheel size C. heating intake air D. supercharging
Description : In four stroke engine which of the following is also known as power stroke a. Suction stroke b. Compression stroke c. Expansion stroke d. Exhaust stroke (Ans:c) Measurements of fuel and air ... into IC engine,___________its efficiency A. increase B. decrease C. does not alter D. unpredictable on
Description : In _____________ injection system only one pump is sufficient for multi-cylinder engine. a) air b) mechanical c) compression fuel d) common rail
Last Answer : Answer: d Explanation: None.
Description : The _____________ sensor, monitors mass or volume of air flowing into the intake manifold for adjusting the quantity of fuel. a) engine temperature b) exhaust gas c) air flow d) air inlet temperature
Last Answer : Answer: c Explanation: The air flow sensor, monitors mass or volume of air flowing into the intake manifold for adjusting the quantity of fuel while exhaust gas senor senses the amount of oxygen in the engine exhaust and calculates air-fuel ratio.
Description : In a 4 S diesel engine, the term ‘squish’ refers to the (a) Injection of fuel in the precombustion chamber (b) Discharge of gases from the precombustion chamber (c) Entry of air into the combustion chamber (d) Stripping of fuel from the core
Description : Velocity of flame propagation in SI engine is maximum for a fuel air mixture which is (a) 10% richer than stoichiometric (b) Equal to stoichiometric (c) More than 10% richer than stoichiometric (d) 10% leaner than stoichiometric
Last Answer : Ans :a
Description : Mixing of air and fuel in the diesel engine occurs in a. injection pump b. carburetor c. engine cylinder d. inlet manifold
Last Answer : ANSWER c. engine cylinder
Description : Which of the following medium is compressed in a diesel engine cylinder? a. air b. air and fuel c. air and lubricating oil d. fuel
Last Answer : ANSWER a. air
Description : Supercharging is the process of a. supplying the engine with air at a density greater than the density of the surrounding atmosphere b. providing forced cooling air c. injecting excess fuel d. raising the exhaust pressure
Last Answer : ANSWER a. supplying the engine with air at a density greater than the density of the surrounding atmosphere