Description : In the circuit shown in Fig. 4.64, the battery has an emf of 12.0 V and an internal resistance of `5R//11`. If the ammeter reads 2.0 A, what is the va
Last Answer : In the circuit shown in Fig. 4.64, the battery has an emf of 12.0 V and an internal resistance of ` ... ammeter reads 2.0 A, what is the value of R ?
Description : A 0-10 mA PMMC ammeter reads 5mA in a circuit; its bottom control spring snaps out suddenly the meter will now read. a) 5mA b) 10mA c) 2.5mA d) 0
Last Answer : Ans: 0
Description : A 0 -10 mAPMMC ammeter reads 5 mA in a circuit; its bottom control spring snaps out suddenly the meter will now read:- a) 5 mA b) 10 mA c) 2.5 mA d). 0
Last Answer : A 0 -10 mAPMMC ammeter reads 5 mA in a circuit; its bottom control spring snaps out suddenly the meter will now read:- 0
Description : A infinite resistance is considered as a/an a) Closed path(short circuit) b) Open path c) Not defined d) Ammeter with zero reading
Last Answer : b) Open path
Description : In the circuit shown in Fig. 4.67, the resistance of the ammeter A is negligible and that of thevoltmeter V is very high. When the switch S is open, t
Last Answer : In the circuit shown in Fig. 4.67, the resistance of the ammeter A is negligible and that of ... internal resistance of the cell (iii) value of R.
Description : The illustrated circuit is a wheatstone bridge. If the meter 'G' reads 0 with the switch closed then ________. EL-0024 A. the current through R1 - R2 is equal to the current through R3 - Rx B. the voltage ... of E C. the resistance of Rx is equal to the resistance of R2 D. all the above are true
Last Answer : Answer: A
Description : During the start-up of the circuit shown in the illustration, it is noted that the ends of component 'C' remain lighted but the tube does not illuminate. The cause of this problem is ____________. EL- ... ' is closed C. component 'C' is the wrong wattage D. component 'B' contacts are stuck closed
Last Answer : Answer: D
Description : A moving coil galvanometer is converted into an ammeter reads upto `0.03 A` by connecting a shunt of resistance `4r` across it and ammeter reads up `0
Last Answer : A moving coil galvanometer is converted into an ammeter reads upto `0.03 A` by connecting a shunt of resistance `4r` ... `0.02A` C. `0.03A` D. `0.04A`
Description : An ammeter reads slightly above 'zero' when its leads are disconnected, this is a result of ___________. A. mechanical misalignment of the meter pointer B. a poor ground for the meter case C. static electricity in the air D. resistors inside the meter storing charges
Description : In the circuit diagram shown in Fig. 4.53, a voltmeter reads 30 V when connected across `400 Omega` resistance. Calculate what the same voltmeter read
Last Answer : In the circuit diagram shown in Fig. 4.53, a voltmeter reads 30 V when connected across `400 ... when it is connected across `300 Omega` resistance.
Description : In order to take a current reading with a 'clamp-on' ammeter, the instrument's jaws _________________. A. should remain open B. cannot touch the adjacent conductor C. must be fully closed D. will act as a transformer primary
Last Answer : Answer: C
Description : In the lighting distribution circuit shown in the illustration, if all switches are closed and fuse 'F2' were to open, all lights on branches ____________. EL-0013 A. '1', '2', and '3' would go out B. '1' ... and '3' would burn dimly D. '1' and '3' would go out, while branch '2' would remain lit
Description : In order to prevent the winch shown in the illustration from turning while troubleshooting the controller circuit, _________________. EL-0102 A. set the dynamic brake by clamping contact 'DB' closed B. set the ... at 'B1' and 'B2' D. open the test link preventing current flow to the armature
Description : As shown in the illustration, 'H1' and 'H2' are ___________. EL-0058 A. fixed capacitors B. variable capacitors C. contacts, closed when the circuit is energized D. contacts, open when the circuit is energized
Description : An open-circuit fault between the pressure switch and the 'annunciator module' shown in the illustration would cause the alarm circuit to react in the same manner as if ___________. EL-0094 A. 3.5 ... below switch setting C. 50 PSI were applied to the 'setpoint module' D. the pressure switch closed
Last Answer : Answer: B
Description : A circuit is connected as shown in the figure with the switch S open. When the switch is closed, the total amount of charge that flows from Y to X is
Last Answer : C
Description : Componds `(A)` and `B` are treated with dilute `HCl` separately. The gases liberated are `Y` and `Z` respectively. `Y` turns acidified `K_2 Cr_2 O_7`
Last Answer : Componds `(A)` and `B` are treated with dilute `HCl` separately. The gases liberated are `Y` and `Z` ... )SO_(4)` D. `NaC1 and Na_(2)CO_(3)`
Description : Which is the highest mountain in the world? a. K_2 B. Nanga Parbat C. Everest D. Siachen
Last Answer : C. Everest
Description : In the circuit shown in figure ammeter and voltmeter are ideal. If `E=4 V,R=9Omega` and `r=1Omega` then readings of ammeter and voltmeter are
Last Answer : In the circuit shown in figure ammeter and voltmeter are ideal. If `E=4 V,R=9Omega` and `r=1Omega` then readings of ... V C. 3 A, 4 V D. 4 A, 4 V
Description : A potentiometer circuit is setup as shown. The potential gradient across the potentiometer wire is `k "volt"//cm` and the ammeter present in the circu
Last Answer : A potentiometer circuit is setup as shown. The potential gradient across the potentiometer wire is `k "volt"//cm` and ... (2)` D. `kl_(1)"and"kl_(2)`
Description : In the circuit shown here, the readings of the ammeter and voltmeter are
Last Answer : In the circuit shown here, the readings of the ammeter and voltmeter are A. 6 A, 60 V B. `0.6` A, 6 V C. 6 A, 6 V D. 6/11 A, 6/11 V
Description : The proper method of connecting an ammeter in a circuit is demonstrated by which of the diagrams shown in the illustration? EL-0041 A. A B. B C. C D. All of the above
Description : What is the direction of current through the load resistor in the circuit shown in the illustration? EL-0085 A. Always from point 'Z' to the grounded end. B. Always from the grounded end to ... on the instantaneous polarity at point 'W'. D. It cannot be determined without a directional ammeter.
Description : A wattmeter is connected as shown in the figure. The wattmeter reads
Last Answer : A wattmeter is connected as shown in the figure. The wattmeter reads Power consumed by Z2
Description : In the circuit shown in the figure, the capacitor C is charged to a potential Vo. The heat generated in the circuit when the switch S is closed, is
Last Answer : In the circuit shown in the figure, the capacitor C is charged to a potential Vo. The heat generated in the circuit when ... )^(2)` D. `8 CV _(0)^(2)`
Description : In the circuit diagram shown in figure match the following two columns when switch S is closed.
Last Answer : In the circuit diagram shown in figure match the following two columns when switch S is closed.
Description : As the switch `S` is closed in the circuit shown in figure, current passed through it is.
Last Answer : As the switch `S` is closed in the circuit shown in figure, current passed through it is. A. `4.5A` B. `6.0A` C. `3.0A` D. zero
Description : In the circuit shown in figure switch S is closed at time t=0 Takin left to right current through the indcutor as apositive current, current through i
Last Answer : In the circuit shown in figure switch S is closed at time t=0 Takin left to right current through the ... inductor varies with time as A. B. C. D.
Description : In the circuit shown in figure switch S is closed at time t=0 At what time current through `3Omega` resistance and 1H inductor are equal?
Last Answer : In the circuit shown in figure switch S is closed at time t=0 At what time current through `3Omega` resistance and ... 5)/(3))` D. `Insqrt((8)/(3))`
Description : In the circuit shown in figure switch S is closed at time t=0 Potential difference across `3Omega` resistance at time t is given by
Last Answer : In the circuit shown in figure switch S is closed at time t=0 Potential difference across `3Omega` resistance at time t ... 2t)` D. `18(1-e^(-t//9))`
Description : In the circuit shown in figure switch S is closed at time t=0 Current I from the battery at time t is given by
Last Answer : In the circuit shown in figure switch S is closed at time t=0 Current I from the battery at time t is given by A. ` ... 3(1-e^(-t//9)) D. `3-e^(-2t)`
Description : In the circuit diagram shown in Figure E=18V , L=2H, `R_(1)=3Omega , R_(2)=6Omega`. Switch S is closed at t=0 Match the following:
Last Answer : In the circuit diagram shown in Figure E=18V , L=2H, `R_(1)=3Omega , R_(2)=6Omega`. Switch S is closed at t=0 Match the following:
Description : In the circuit shown the cell is ideal. The codil has an inductance of 2H and will blow when the current through it reaches 5a. The switch is closed a
Last Answer : In the circuit shown the cell is ideal. The codil has an inductance of 2H and will blow when the ... Find the time (in second)n when fuse will blow.
Description : When replacing component 'B' of the circuit shown in the illustration, it is important to know that ____________. EL-0081 A. it is polarity sensitive and must be inserted as indicated on its ... provide the capacitor's initial charge D. it must match the circuit voltage and component 'C' wattage
Description : When changing out component 'B' of the circuit shown in the illustration, it is important to know that ____________. EL-0081 A. it is polarity sensitive and must be inserted as indicated on its ... provide the capacitor's initial charge D. it must match the circuit voltage and component 'C' wattage
Description : As shown in the illustration, the symbol is used in electrical drawings to designate a ____________. EL-0026 A. limit switch with one set of normally open contacts B. maintaining type ... type push button with a mechanical interlock D. normally closed contact held open mechanically by an interlock
Description : If the three-phase motor, shown in the illustrated schematic diagram, is running in the forward direction, which of the following actions must occur before the motor will reverse rotation? EL-0011 A. Normally-closed ... 'L1' and 'L3' must be interchanged via the 'R' contacts. D. All of the above.
Description : When 'selector switch' 'SEL8' shown in the illustration is in the 'TEST' position, contacts '3,4' and '7,8' are respectively ____________. EL-0100 A. open; closed B. closed; open C. open; open D. closed; closed
Description : In the system shown in the illustration, the station at section I is unable to signal any other station nor is any other station able to signal the station in section I. The station can, however, ring ... only a single station to respond to itself. D. The switch at component 'C' is stuck open.
Description : When 'selector switch' 'SEL8' shown in the illustration is in the 'OFF' position, contacts '3,4' and '7,8' are respectively ____________. EL-0100 A. open; closed B. closed; open C. open; open D. closed; closed
Description : When 'selector switch' 'SEL8' shown in the illustration is in the 'ON' position, contacts '3,4' and '7,8' are respectively ______________. EL-0100 A. open; closed B. closed; open C. open; open D. closed; closed
Description : 'A-1', as shown in the illustration, is/are ____________. EL-0017 A. normally-closed overload relay contacts B. a double pole knife switch C. normally-open overload relay contacts D. a single pole knife switch
Description : As shown in the illustration, what happens when 'A' is closed, 'B' is in position '2' and component 'E2' burns out? EL-0058 A. 'H' energizes and 'D' makes contact. B. 'F' goes out allowing 'G' to disconnect. C. 'G' sounds an alarm and 'F' illuminates. D. 'C' opens causing 'A' to also open.
Description : Find the ammeter reading in the cirucit shown in Fig. 4.65.
Last Answer : Find the ammeter reading in the cirucit shown in Fig. 4.65.
Description : The reading of the ammeter as per figure shown is
Last Answer : The reading of the ammeter as per figure shown is A. `(1)/(2)A` B. `(3)/(4)A` C. `(1)/(8)A` D. `2A`
Description : In the schematic diagram of the DC compound generator shown in the illustration, the positive ammeter reading is 500 amps and the negative ammeter reading is 475 amps. What is the current flow through the neutral bus? EL-0037 A. 0 amp B. 12.5 amp C. 25 amp D. 975 amp
Description : X, Y and Z are ammeters and Y reads 0.5 A. (i) What are the readings in ammeters X and Z ? (ii) What is the total resistance of the circuit ?
Last Answer : X, Y and Z are ammeters and Y reads 0.5 A. (i) What are the readings in ammeters X and Z ? (ii) What is the total resistance of the circuit ?
Description : In the illustrated motor controller, the motor fails to start. A voltmeter reading between 1 and 6 reads line voltage, while the voltmeter reading between 2 and 6 reads 0 VAC. The problem is __________. EL- ... in the 'M' coil, 'Ma' contact/start switch or overload contacts D. fuse '10a' is blown
Description : An open resistor, when checked with an ohm-meter reads?
Last Answer : An open resistor, when checked with an ohm-meter reads infinite.
Description : A resistance in a circuit of unknown value is to be tested using the voltmeter/ammeter method. Therefore, the meters should be connected with _____________. A. both meters in series with the ... parallel with the resistance D. the ammeter in parallel and the voltmeter in series with the resistance