Description : In semi-definite system one of the natural frequencies is A Zero B One C Two D Infinite
Last Answer : A Zero
Description : In semi definite system, one of the natural frequencies is found to 15 Hz. The other natural frequency will be A. 15 Hz B. 0 Hz C. 30 Hz D. None of these
Last Answer : B. 0 Hz
Description : When the frequency of external exciting force is equal to the natural frequency of the vibration of the system A. The amplitude of vibration is zero B. The amplitude of vibration is significantly small C. The amplitude of vibration is very large D. The amplitude does not change
Last Answer : C. The amplitude of vibration is very large
Description : The number of natural frequency in two rotor system is A Zero B Infinite C Two D One
Last Answer : C Two
Description : If ωmax is the frequency at which the peak amplitude occurs and ωn is the natural frequency of the system then In a forced vibration system with damping, the higher the damping, A) More will be ... and ωmax is independent of damping in this system D) The difference between ωn and ωmax will be zero
Last Answer : A) More will be the difference between ωn and ωmax
Description : The number of natural frequencies in a two rotor system is A. Infinite B. Zero C. Two D. Four
Last Answer : C. Two
Description : The external exciting frequency of the system having natural frequency 15 Hz is 10 Hz. The frequency ratio will be A. 1.500 B. 0.667 C. 0.150 D. None
Last Answer : B. 0.667
Description : The critical speed of a shaft with a disc supported in between is equal to the natural frequency of the system in A Transverse vibrations B Torsional vibrations C Longitudinal vibrations D None of the mentioned
Last Answer : A Transverse vibrations
Description : Calculate damped natural frequency, if a spring mass damper system is subjected to periodic disturbing force of 30 N. Damping coefficient is equal to 0.76 times of critical damping coefficient and undamped natural frequency is 5 rad/sec A. 3.99 rad/sec B. 2.13 rad/sec C. 4.12 rad/sec D. 3.24 rad/sec
Last Answer : D. 3.24 rad/sec
Description : Critical speed of shaft and disc system A) Is equal to natural frequency of the system in transverse vibration B) Is equal to natural frequency of the system in torsional vibration C) Is ... of the system in longitudinal vibration D) Bears no relationship to any of the system natural frequency
Last Answer : A) Is equal to natural frequency of the system in transverse vibration
Description : Which of the following condition should be satisfied in the design of a vibration absorber ? A) Natural frequency of the auxiliary system should be equal to the natural frequency of the main ... D) Natural frequency of the auxiliary system should be twice natural frequency of the main system
Last Answer : A) Natural frequency of the auxiliary system should be equal to the natural frequency of the main system
Description : The critical speed of a shaft with a disc supported in between is equal to the natural frequency of the system in a) transverse vibrations b) torsional vibrations c) longitudinal vibrations d) none of the mentioned
Last Answer : a) transverse vibrations
Description : When a body moves with simple harmonic motion, the product of its periodic time and frequency is equal to A. Zero B. One C. π/2 D. 2π
Last Answer : B. One
Description : Which of the following statements is/are true? A. Torsional vibrations do not occur in a three rotor system, if rotors rotate in same direction B. Shaft vibrates with maximum frequency when rotors ... C. Zero node behavior is observed in rotors rotating in opposite direction D. All of the above
Last Answer : A. Torsional vibrations do not occur in a three rotor system, if rotors rotate in same direction
Description : Which of the following statements is/are true? A) Torsional vibrations do not occur in a three rotor system, if rotors rotate in same direction B) Shaft vibrates with maximum frequency when rotors ... C) Zero node behavior is observed in rotors rotating in opposite direction D) All of the above
Last Answer : A) Torsional vibrations do not occur in a three rotor system, if rotors rotate in same direction
Description : Which of the following statements is/are true? a. Torsional vibrations do not occur in a three rotor system, if rotors rotate in same direction b. Shaft vibrates with maximum frequency when rotors ... c. Zero node behavior is observed in rotors rotating in opposite direction d. All of the above
Last Answer : a. Torsional vibrations do not occur in a three rotor system, if rotors rotate in same direction
Description : A car having a mass of 1000 kg deflects its springs 4 cm under its load. Determine the natural frequency of the car in vertical direction. A 5 Hz B 4.67 Hz C 9.8 Hz D 2.49 Hz
Last Answer : D 2.49 Hz
Description : A 1 kg mass is suspended by a spring having a stiffness of 0.4 N/mm. Determine the natural frequency. A 20 rad/sec B 30 rad/sec C 20 Hz D 30 Hz
Last Answer : B 30 rad/sec
Description : A car having a mass of 1000 kg deflects its springs 4 cm under its load. Determine the natural frequency of the car in vertical direction. A 5 HzB 4.67 Hz C 9.8 Hz D 2.49 Hz
Description : A cantilever shaft having 50 mm diameter and length of 300 mm has a disc of mass 100 kg at its free enD. The Young’s modulus for the shaft material is 200 GN/m 2 . Calculate the natural longitudinal frequency in Hz. A. 575B. 625 C. 525 D. 550
Last Answer : A. 575
Description : A car having a mass of 1000 kg deflects its springs 4 cm under its load. D Determine the natural frequency of the car in vertical direction. (A)5 Hz (B) 4.67 Hz (C) 9.8 Hz (D) 2.49 Hz
Last Answer : (D) 2.49 Hz
Description : A cantilever shaft having 50 mm diameter and length of 300 mm has a disc of mass 100 kg at its free end. The Young’s modulus for the shaft material is 200 GN/m 2 . Calculate the natural longitudinal frequency in Hz. a) 575 b) 625 c) 525 d) 550
Last Answer : a) 575
Description : For an under damped harmonic oscillator, resonance A Occurs when excitation frequency is greater than undamped natural frequency B Occurs when excitation frequency is less than undamped natural frequency C Occurs when excitation frequency is equal to undamped natural frequency D Never occurs
Last Answer : C Occurs when excitation frequency is equal to undamped natural frequency
Description : The accelerometer is used as a transducer to measure earthquake in Richter scale. Its design is based on the principle that A Its natural frequency is very low in comparison to the frequency ... is equal to the frequency of vibration D Measurement of vibratory motion is without any reference point
Last Answer : C Its natural frequency is equal to the frequency of vibration
Description : For an under damped harmonic oscillator, resonance a) occurs when excitation frequency is greater than undamped natural frequency b) occurs when excitation frequency is less than undamped natural frequency c) occurs when excitation frequency is equal to undamped natural frequency d) never occurs
Last Answer : c) occurs when excitation frequency is equal to undamped natural frequency
Description : The accelerometer is used as a transducer to measure earthquake in Richter scale. Its design is based on the principle that a) its natural frequency is very low in comparison to the frequency ... is equal to the frequency of vibration d) measurement of vibratory motion is without any reference point
Last Answer : c) its natural frequency is equal to the frequency of vibration
Description : The natural frequency (in Hz) of free longitudinal vibrations is equal to a) Square root (k/m) / (2π) b) Square root (g/δ) / (2π) c) 0.4985/δ d) all of the mentioned
Last Answer : d) all of the mentioned
Description : The accelerometer is used as a transducer to measure earthquake in Richter scale. Its design is based on the principle that ______. (A) its natural frequency is very low in comparison to the ... is equal to the frequency of vibration (D) measurement of vibratory motion is without any reference poin
Last Answer : (C) its natural frequency is equal to the frequency of vibration
Description : For an underdamped harmonic oscillator, resonance ______. (A) occurs when excitation frequency is greater than the undamped natural frequency (B) occurs when excitation frequency is less than the ... ) occurs when excitation frequency is equal to the undamped natural frequency (D) never occurs
Last Answer : (C) occurs when excitation frequency is equal to the undamped natural frequency
Description : The accelerometer is used as a transducer to measure earthquake in Richter scale. Its design is based on the principle that a) its natural frequency is very low in comparison to the frequency ... is equal to the frequency of vibration d) measurement of vibratory motion is without any reference poin
Description : The natural frequency (in Hz) of free longitudinal vibrations is equal to a) 1/2π√s/m b) 1/2π√g/δ c) 0.4985/δ d) all of the mentioned
Description : Which of the following is true about Stiffness matrix a. Diagonal matrix b. Symmetric matrix c. Positive Definite d. All of the above
Last Answer : d. All of the above
Description : In energy method for finding frequency of the system A The sum of kinetic and potential energy is constant B The sum of kinetic and potential energy is zero C Frequency cannot be determined by energy method D None of the mentioned
Last Answer : A The sum of kinetic and potential energy is constant
Description : In semidefinite system one of the natural frequencies is A. Zero B. Non-zero C. Infinite one D. One
Last Answer : A. Zero
Description : A mass of 1 kg is attached to two identical springs each with stiffness k = 20 kN/m as shown in the figure. Under frictionless condition, the natural frequency of the system in Hz is close to * 1 point (A) 32 (B) 23 (C) 16 (D) 11
Last Answer : (A) 32
Description : The relative amplitudes of different degrees of freedom in a two-degree-of-freedom system depend on the natural frequency.
Last Answer : True
Description : When a two-degree-of-freedom system is subjected to a harmonic force, the system vibrates at the a. frequency of applied force b. smaller natural frequency c. larger natural frequency d. None of the above
Last Answer : a. frequency of applied force
Description : If the spring mass system with m and spring stiffness k is taken to very high altitude, the natural frequency of longitudinal vibrations * 1 point (A) increases (B) decreases (C) remain unchanged (D) may increase or decrease depending upon the value of the mass
Last Answer : (C) remain unchanged
Description : The natural frequency of a spring-mass system on earth is ωn. The natural frequency of this system on the moon (g of moon = g of earth /6) is * 1 point (A) ωn (B) 0.408ωn (C) 0.204ωn (D) 0.167ωn
Last Answer : (A) ωn
Description : The static deflection of a spring under gravity, when a mass of 1 kg is suspended from it, is 1 mm. Assume the acceleration due to gravity g = 10 m/s^2. The natural frequency of this spring-mass system (in rad/s) is A 100 B 150 C 200 D 250
Last Answer : A 100
Description : Calculate natural frequency of damped vibration, if damping factor is 0.52 and natural frequency of the system is 30 rad/sec which consists of machine supported on springs and dashpots. A 25.62 rad/sec B 20.78 rad/sec C 14.4 rad/sec D 15.33 rad/sec
Last Answer : A 25.62 rad/sec
Description : Determine natural frequency of a system, which has equivalent spring stiffness of 30000 N/m and mass of 20 kg? A 12.32 Hz B 4.10 Hz C 6.16 HzD None of the above
Last Answer : C 6.16 Hz
Description : What is the effect on the undamped natural frequency of a single-degree-of-freedom system if the mass of the system is increased? A The frequency will increase B The frequency will stay the same C The frequency will decrease D None of these
Last Answer : C The frequency will decrease
Description : While calculating the natural frequency of a spring-mass system, the effect of the mass of the spring is accounted for by adding X times its value to the mass, where X is A 1/2 B 1/3 C 1/4 D 3⁄4
Last Answer : B 1/3
Description : The motion of a system executing harmonic motion with one natural frequency is known as _______ A. principal mode of vibration B. natural mode of vibration C. both a. and b. D. none of the above
Last Answer : C. both a. and b.
Description : Calculate natural frequency of damped vibration, if damping factor is 0.52 and natural frequency of the system is 30 rad/sec which consists of machine supported on springs and dashpots. A 21 rad/sec B 25.62 rad/sec C 20.22 Hz D 3.15 Hz
Last Answer : B 25.62 rad/sec
Description : A spring mass system has time period of oscillation of 0.25 sec. What will be the natural frequency of the system? A 1 Hz B 2 rad sec C 4 rad/sec D 4 Hz
Last Answer : D 4 Hz
Description : Determine natural frequency of a system, which has equivalent spring stiffness of 43200 N/m and mass of 12 kg. A 40.22 rad/sec B 40 Hz C 60 Hz D 60 rad/sec
Last Answer : D 60 rad/sec