When DG’s start is not possible?

When DG’s start is not possible? 
by

1 Answer

Answer :

1. DG trip.

2. Turning gear engaged.

3. DG set stop push button pressed. 


by

Related questions

What are the design criteria’s of DG’s?

Description : What are the design criteria’s of DG’s?  

Last Answer : 1. 4000 starts and 4000 hrs run at full load for lifetime. 2. Operation at 45°C and high atmospheric condition. 3. Designed to run in earthquake and seismic condition. 4. Designed to start ... provided for smoothening effect in case of fire. 16. Active process water from class III is provided. 

What is requirement of having DG’s?

Description : What is requirement of having DG’s? 

Last Answer : To establish class III supply when class IV fails. Parallel operation with class IV 6.6 kV supply. DG to DG parallel operation. 

What is speed restriction on deep screening site done by BCM and tamped by machine followed with DGS? (a) 20 (b) 30 (c) 40* (d) 10

Description : What is speed restriction on deep screening site done by BCM and tamped by machine followed with DGS? (a) 20 (b) 30 (c) 40* (d) 10

Last Answer : (c) 40*

What are the possible reasons for not coming of rated speed during start?

Description : What are the possible reasons for not coming of rated speed during start?

Last Answer : In case motor does not come to its rated speed then following could be the probable causes. a. Starting load is too high. b. Broken rotor bars (look for cracks near rings). c. Open primary circuit. d. Voltage is too low.