Description : Is 0.006 greater or 0.60?
Last Answer : What is the answer ?
Description : A level when set up 25 m from peg A and 50 m from peg B reads 2.847 on a staff held on A and 3.462 on a staff held on B, keeping bubble at its centre while reading. If the reduced levels of A and B are 283.665 m ... collimation error per 100 m is (A) 0.015 m (B) 0.030 m (C) 0.045 m (D) 0.060 m
Last Answer : (D) 0.060 m
Description : For lapped joints, which of the following is the minimum finished height of face? a) Not less than the nominal pipe wall. b) Not less than .25". c) At least .060". d) 3/8".
Last Answer : a) Not less than the nominal pipe wall.
Description : What is 42.060 rounded to the nearest tenth?
Last Answer : 42
Description : An aircraft heading 017° (T) has a small island showing on the AWR at 45nm range on the 60° left azimuth line. To obtain a fix from this information you should plot: a. Range 45nm and QTE 060 from ... QTE 317 from the center of the island d. Range 45nm and QTE 137 from the center of the island
Last Answer : d. Range 45nm and QTE 137 from the center of the island
Description : Hydrated density of HD lipoproteins is (A) 0.94 gm/ml (B) 0.94–1.006 gm/ml (C) 1.006–1.063 gm/ml (D) 1.063–1.21 gm/ml
Last Answer : Answer : D
Description : Hydrated density of (HD) lipoproteins is (A) 0.94 gm/ml (B) 0.94-1.006 gm/ml (C) 1.006-1.063 gm/ml (D) 1.063-1.21 gm/l
Last Answer : Answer : B
Description : IDL have the density in the range of (A) 0.95–1.006 (B) 1.006–1.019 (C) 1.019–1.032 (D) 1.032–1.163
Description : β-lipoproteins have the density in the range of (A) 0.95–1.006 (B) 1.006–1.019 (C) 1.019–1.063 (D) 1.063–1.125
Last Answer : Answer : C
Description : When the torsional pendulum vibrating the observed amplitudes on the same side of neutral axis for successive cycles are found to decay 50% of the initial value determine logarithmic decrement. A 0.065 B 0.006 C 0.693 D 0.5
Last Answer : C 0.693
Description : When the torsional pendulum vibrating, the observed amplitudes on the same side of the neutral axis for successive cycles are found to decay 50% of the initial value determine logarithmic decrement. A 0.065 B 0.006 C 0.693 D 0.5
Description : Calculate the static deflection in μm of transverse vibrations if the frequency is 200Hz. A. 6.21 B. 0.621 C. 62.1 D. 0.006
Last Answer : A. 6.21
Description : Calculate the static deflection in μm of transverse vibrations if the frequency is 200Hz. a) 6 b) 0.6 c) 60 d) 0.006
Last Answer : a) 6
Description : The concrete is assumed to reach failure with a compression strain of [ A ] 0.002 [ B ] 0.0035 [ C ] 0.0045 [ D ] 0.006
Last Answer : [ B ] 0.0035
Description : The ultimate strain of concrete at failure is [ A ] 0.002 [ B ] 0.0035 [ C ] 0.0045 [ D ] 0.006
Description : HDL2 have the density in the range of (A) 1.006–1.019 (B) 1.019–1.032 (C) 1.032–1.063 (D) 1.063–1.125