What are two advantages that gas-filled tubes have over  conventional electron tubes?

1 Answer

Answer :

a. They can carry more current.  
b. They maintain a constant IR drop across the tube

Related questions

Description : Which gas is filled in element bulbs/tubes?

Last Answer : Which gas is filled in element bulbs/tubes? A. Ar B. `N_(2)` C. He D. `O_(2)`

Description : Once ionization has occurred in a thyratron, what control does the control grid have over the tube’s operation?

Last Answer : None.

Description : What main advantage does a bridge rectifier have over a conventional full-wave rectifier?

Last Answer : The bridge rectifier can produce twice the voltage with the same size transformer.

Description : What main advantage does a bridge rectifier have over a conventional full-wave rectifier?

Last Answer : The bridge rectifier can produce double the voltage with the same size transformer.

Description : A dumper is filled in 15hrs by 3 tubes P,Q,and R. the tube R is thrice as fast as Q and Q is thrice as fast as P. How much time will tube Q alone take to fill the tank? A) 195hrs B) 190hrs C) 185hrs D) 180hrs

Last Answer : A Suppose tube P alone takes x hrs to fill the tank Then tubes Q and R will take x/3 and x/9 hrs respectively to fill the dumper. Therefore 1/x + 3/x+ 9/x = 1/15 13x = 1/15 X = 195 hrs

Description : A tube can fill a cistern in 18hrs.After half the cistern is filled, three more similar tubes are opened. What is the total time taken to fill the cistern completely ? A) 9hrs 52min B) 10hrs 15 min C) 9hrs 45 min D) 10hrs 30min

Last Answer : Time taken to fill half of the cistern = 18/2 = 9 hrs After half the cistern is filled , three more similar tubes are opened. We know that one tube can in 18 hrs can fill = V litres(i.e. fully fill a cistern) ... V/2 will be 2 hrs 15 min Total time = 9 hrs + 2 hrs + 15 min = 11 hrs 15 min

Description : Give two advantages that non-conventional energy sources have over conventional energy sources. -Geography

Last Answer : 1. These are renewable sources of energy, e.g., solar energy, wind energy. 2. These do not cause any pollution.

Description : Mention any two advantages of E_mail over conventional mail. -Technology

Last Answer : Advantages1. E-mail is extremelycost effective.2. E-mail takes lesser time for transmitting data than conventional mail.Disadvantage1. Need of Internet connection to send/receive mail.

Description : What are the advantages of open end winding induction motor over conventional induction motor?

Last Answer : Open ended induction motor - i assume you are talking aboutsplit phase induction motor. With these motors old style speedcontrolling method using external resistors can be used. Howeverthis is now obsolete.

Description : What are the advantages of neural networks over conventional computers? (i) They have the ability to learn by example (ii) They are more fault tolerant (iii)They are more suited for real time operation due to their high ... true b) (i) and (iii) are true c) Only (i) d) All of the mentioned

Last Answer : d) All of the mentioned

Description : What are the advantages of neural networks over conventional computers? (i) They have the ability to learn by example (ii) They are more fault tolerant (iii)They are more suited for real time operation due to their high ... true b) (i) and (iii) are true c) Only (i) d) All of the mentioned

Last Answer : d) All of the mentioned

Description : State four advantages of CNC machines over conventional machines.

Last Answer : Advantages of CNC machines over conventional machines: 1) Greater machine utilization. 2) Complex machining operations can be easily done. 3) It gives high degree of accuracy. 4) It requires less ... is reduced. 15) Elimination of special jigs and fixtures. 16) Accurate costing & scheduling. 

Description : Advantages of membrane separation process over conventional separation process

Last Answer : 1.Because membrane processes can separate at the molecular scale up to a scale at which particles can actually be seen, this implies that a very large number of separation needs might ... the environment since the membrane approach require the use of relatively simple and non-harmful materials.

Description : The method used to produce electron emission in most vacuum tubes is known as ____________. A. photoelectric emission B. secondary electric emission C. cold cathodic electric emission D. thermionic emission

Last Answer : Answer: D

Description : Direction of conventional current is A. direction of neutron flow B. direction of electron flow C. direction of flow of positive charge D. same as that of electric current

Last Answer : direction of flow of positive charge

Description : The arrow direction in the diode symbol indicates a. Direction of electron flow. b. Direction of hole flow (Direction of conventional current) c. Opposite to the direction of hole flow d. None of the above

Last Answer : b. Direction of hole flow (Direction of conventional current)

Description : Is it true or false that electron flow and conventional current are in opposite directions? 

Last Answer : It is true because historically our field theory is developed through positive charges that is according to electro magnetic theory,but actual current flow is due to electrons only which can move freely where as positive charges bind to nuclear forces and can't move 

Description : Explain the difference between electron flow and conventional current.

Last Answer :  A motion of positive charges, in the opposite direction from electron fl ow, is considered conventional current.

Description : State two advantages and two drawbacks of liquid filled and gas filled thermometer.

Last Answer : Liquid filled thermometer  Advantages: 1) They are comparatively cheaper than other temperature measurement devices. 2) They are handy and convenient to use. 3) Unlike electrical thermometers, they do ... : 1) Larger bulb size. 2) Generates less deflection force for controlling device. 

Description : Cold-cathode tubes can be used as voltage regulators because of what characteristic?

Last Answer : They have the ability to maintain a constant voltage drop across the tube despite changes in current flow.

Description : Why can acorn and doorknob tubes NOT handle large amounts of power?

Last Answer : The close spacing of tube elements allows for the ready formation of arcs or short circuits.

Description : How do uhf tubes counter the effects of transit time?

Last Answer : By reducing the spacing between tube elements.

Description : Beam-forming tubes and power tubes are similar except that power pentodes lack what element?

Last Answer : Beam-forming plates.

Description : During which of the transmit or receive cycles are both the tr and atr tubes of a parallelconnected duplexer ionized (arcing)?

Last Answer : Transmit.

Description : How did vacuum tubes cause a problem for first generation computers

Last Answer : They were unreliable, required a lot of power to run, and produced so much heat that air conditioning was needed to protect computer parts.

Description : In electronic computers, vacuum tubes were replaced by transistors and transistors have been replaced by what device?

Last Answer : Integrated circuits.

Description : When designing vacuum-tube circuits, what characteristics of tubes must be taken into consideration?

Last Answer : Differences in performance of tubes of the same type

Description : Vacuum tubes are designed to operate in what portion of the Ep - Ip

Last Answer : The linear portion.

Description : Normally, how are high-power rf tubes tested?

Last Answer : In their circuit.

Description : What effect does transit time have on a conventional triode operated at uhf frequencies?

Last Answer : It causes the control grid to short to the cathode

Description : What is the major difference in grid construction between power pentodes and conventional pentodes?

Last Answer : Conventional pentodes have a staggered grid arrangement, while power pentodes have a shielded grid arrangement.

Description : What is the main disadvantage of a conventional full-wave rectifier?

Last Answer : Peak voltage is half that of the half-wave rectifier.

Description : What is the main disadvantage of the conventional full wave rectifier?

Last Answer : The peak voltage is half that of a half-wave rectifier.

Description : How many electron shells woul be completely filled by a neutral xenon atom?

Last Answer : Xenon has five electron shells.

Description : The elements with filled electron shells are called _______ a. Inert Elements. b. Active Elements. c. Radioactive Elements. d. Bonded Electrons.

Last Answer : d. Bonded Electrons.

Description : An inert element has electron shells that a. Overlap The Shells Of Other Atoms. b. Are Completely Filled With Electrons. c. Yield Hydrogen Ions. d. Form Covalent Bonds.

Last Answer : b. Are Completely Filled With Electrons.

Description : A characteristic of the noble gases is that they all: w) have eight electrons in the outer shell x) have low stability y) form many compounds z) have filled outer electron shells

Last Answer : ANSWER: Z -- HAVE FILLED OUTER ELECTRON SHELLS

Description : What are the advantages and disadvantages of large (conventional) venetian blinds and mini-blinds?

Last Answer : Since it depends entirely on the location, size and use of the area, I suggest you visit the window covering section of your local home improvement store and discuss it with them. We have a great department at the Lowe’s near us.

Description : Explain the advantages of non-conventional sources of energy. -Geography

Last Answer : Energy resources can be classified on a variety of basis like nature of their transaction, availability, etc. The most important classification is based on the conventionality in deriving the energy. According ... log run not only for individuals but the countries as well as the world as a whole.

Description : What are the advantages of a rotary system vs. other conventional systems?

Last Answer : The rotary system is more accurate. You can use the conventional system but I recommend the rotary.

Description : The Advantages And Disadvantages Of Financing With Conventional Loans?

Last Answer : A conventional loan is the name given to mortgage loans that are issued by private banks and lenders outside of the government regulated markets. The loans are not federally backed in the ... loan. Conventional loans that have excessive fees for services, processing or penalties should be avoided.

Description : The Advantages Of Conventional Loans ?

Last Answer : Most people need a loan in order to buy a new house. There are several types of loans available to finance your purchase. FHA is a loan that is guaranteed by the government. This type ... make your financial decisions based on sensible financing options and not because you must have this new home.

Description : List the advantages of non-conventional sources of energy

Last Answer : a) Non-conventional sources do not deplete. b) They are renewable sources of energy. c) They do not cause environmental pollution.

Description : The following are the advantages of the conventional methods of irrigation a. Low cost of construction b. Animals used for ploughing are utilised for drawing water c. Water can be lifted from great depths d. All of the above

Last Answer : d. All of the above

Description : What are two advantages of a two-motor reeling system over a take-up control reeling system?

Last Answer : The two-motor configuration runs in both directions and a holdback voltage helps control tape tension, but it does not properly control tape tension during starts and stops.

Description : What two components give a ssb receiver its advantages over an AM superheterodyne receiver?

Last Answer : A special type of detector and a carrier reinsertion oscillator

Description : State two advantages of using aluminum wire for carrying electricity over long distances.

Last Answer : It is light and reduces corona.

Description : State four advantages of copper over aluminum as a conductor.

Last Answer : It has higher conductivity, it is more ductile, it has relatively high tensile strength, and it can be easily soldered.

Description : List seven advantages of fiber optics over electrical systems.

Last Answer : Advantages of fiber optics are improved system performance, immunity to electrical noise, signal security, electrical isolation, reduced size and w

Description : Which of the two types of electron motion (orbital movement and electron spin) is more important in the explanation of magnetism?

Last Answer : Electron spin.