1 Answer

Answer :

Amp is ampere which is a unit of current.

Related questions

Description : Define the following terms related to Op-Amp: i) CMRR ii) SVRR

Last Answer : Definition:- i) SVRR: It is defined as the ratio of change of input offset voltage to the change in one supply voltage while keeping other supply voltage constant. Ideally,SVRR=0  ii)CMMR:-The ... gain should exceed common-mode gain, this will be a positive number, and the higher the better.

Description : State any two characteristics of an ideal Op-amp.

Last Answer : Characteristics of Op-amp: i) Input offset voltage ii) Input offset current iii) Input bias current iv) Differential input resistance v) Input capacitance vi) CMRR-common mode rejection ration vii) ... voltage rejection ratio(SVRR) viii) Output resistance ix) Voltage gain x) Bandwidth xi) Slew rate

Description : Draw and explain the Op-amp based subtractor

Last Answer : Working The subtractor circuit is a basic op-amp circuit whose output voltage is the difference between two input voltages.  In the above circuit, the two input voltages are V1 and V2.  The op amp is used ... When differential gain is 1, ie Rf = R,  the output voltage is Vo = (V2 - V1).

Description : Draw the diagram of zero crossing detector using op-amp and explain its working.

Last Answer : The zero crossing detector circuit is an important application of the op-amp comparator circuit. It can also be called as the sine to square wave converter. Anyone of the inverting or non-inverting ... the possibility of any false zero crossing due to noise voltages at the op-amp input.

Description : An OP amp has an open loop gain of 1,00,000. If the feedback fraction is 0.02, the approximate closed loop gain is (a) 1 (b) 1,00,000 (c) 50 (d) 0.02

Last Answer : The closed loop gain Ag = G/(1+G*f) Where G is the open loop gain and f is the feedback fraction  So Ag = 49.975

Description : An OP amp has a slew rate of 1V/µs. At a signal frequency of 0.1 MHz, the maximum undistorted sine wave amplitude is (a) 8V (b) 4.82 V (c) 2.02 V (d) 1.592 V

Last Answer : Slew rate = 2πfv where v is the amplitude V=(1/2π*0.1) = 1.592V

Description : A heater takes 4 Amp at 250 volts. How much power does it consume? A. 1 KWatt B. 2 KWatt C. 3 KWatt D. 4 KWatt 

Last Answer : Power= voltage* current             = 4 * 250             = 1000 watts             = 1KW

Description : What is the Output voltage of Op-amp for input voltage of Vi1=150 μV,Vi2=140 μV if the amplifier has differential gain of Ad=4000 and value of CMRR is 100. 

Last Answer : i don know

Last Answer : Amp hour is the unit for measuring Capacity of a cell.