What is the first aid for snakebite?  

1 Answer

Answer :

Bath the wound and constrictive bandage. Give warm drinks and rest to the patient and artificial breathing if necessary. 

Related questions

Description : What is the first aid for snakebite? 

Last Answer : Bath the wound and constrictive bandage. Give warm drinks and rest to the patient and artificial breathing if necessary.

Description : How can I protect my dogs from snakebite?

Last Answer : Well the obvious answer is to just not expose them to snakes or environments with snakes. But if you must, I would imagine that any repellent that would work for a human will also work with a dog…. as well as any immediate care should the dog be bitten.

Description : What is the first aid for dog bite?

Last Answer : Suck the wound and spite out.  

Description : What is the first aid for chlorine inhaled victims?

Last Answer : Remove the victim from the source, fresh air and artificial respiration if necessary.  

Description : What is the first aid for burn cases?

Last Answer : Water, warm fluids should be given when the victim is conscious.  

Description : What is the first aid for bone injury?  

Last Answer : Support the injured part and painkillers.  

Description : For a bleeding what is the first aid?

Last Answer : Take care to stop the bleeding by giving pressure.  

Description : What is the golden rule of first aid?

Last Answer : Do first thing first, artificial respiration, stop bleeding and treat shock. Do not attempt too much, reassurance, avoid crowing and transfer.  

Description : According to Coast Guard Regulation (46 CFR) for emergency power and lighting systems, which of the listed items is the only permissible starting aid for the emergency diesel generator engine? A. Ether B. Lube oil heater C. Jacket water heater D. Fuel oil heater

Last Answer : Answer: C

Description : When troubleshooting an electronic circuit, a cold solder joint can be located with the aid of an ohmmeter. Once the problem has been located, you should _________________. A. reheat the circuit in an ... a soldering tool and recheck with an ohmmeter D. do nothing as this is the normal condition

Last Answer : Answer: C

Description : When replacing a power transistor fitted with a heat sink in a circuit, a coating of silicone grease is applied between the transistor case and the heat sink. This is done to ____________. A. lubricate ... the heat sink C. aid in the removal of the heat sink D. provide maximum heat transfer

Last Answer : Answer: D