What are the effects of single phasing?  

1 Answer

Answer :

a. Current will increase √3 times.

b. More heat in stator and rotor parts.

c. Insulation failure and short circuit & Ground fault may occur. 

Related questions

Description : Does over load relay give 100% guarantee against the single phasing?  

Last Answer : No. It depends on the motor load and the motor winding (star or delta).  

Description : What is the current in single phasing?

Last Answer : 2 times of rated current.

Description : The single phasing relays are used for the protection of (a) single phase motors only (b) two phase motors only (c) two single phase motors running in parallel (d) three phase motors

Last Answer : (d) three phase motors

Description : What is meant by ‘Single Phasing’?*

Last Answer : When one supply is open circuit in a three phase motor.

Description : What is single phasing?

Last Answer : Single phasing is a condition in three phase motors and transformers wherein the supply to one of the phases is cut off.

Description : Explain the working of single phasing preventer with neat diagram.

Last Answer : Working of single phasing preventer:  Single phasing preventers are generally used for small / medium capacity motors. Single phasing preventers are connected in secondary of line CTs. These ... contact gets opened which stops the motor to avoid further damage when single phasing occurs. 

Description : Explain single phasing preventer with neat sketch diagram.

Last Answer : Single phasing preventer: Single phasing preventers are generally used for small / medium capacity motors. Single phasing preventers are connected in secondaries of line CTs. These mainly contains ... command is given to circuit breaker or starter. Thus it protects motor from damage.

Description : Which one is not single phasing preventer? A. Frequency Sensing B. voltage sensing C. mechanical type D. Current sensing

Last Answer : Frequency Sensing is not single phasing preventer.

Last Answer : The single phasing relays are used for the protection of three phase motors.

Description : In your opinion, why are auto makers phasing out the manual transmission on a lot of their vehicles?

Last Answer : I know a few people will turn their nose up and huff, by saying automatic transmissions are now just as economical as a manual so why bother with a manual. BUT, that doesn’t really answer the question, are they scaling back or phasing out because people have lost the skill, or are to lazy?

Description : What is meant by antenna gain? A. The final amplifier gain minus the transmission line losses (including any phasing lines present) B. The ratio of the amount of power produced by the antenna ... D. The numeric ratio relating the radiated signal strength of an antenna to that of another antenna

Last Answer : D. The numeric ratio relating the radiated signal strength of an antenna to that of another antenna

Description : In which country, the recent international agreement on phasing out Hydro Fluoro Carbons (HFCs) was signed? (A) Rwanda (B) Morocco (C) South Africa (D) Algeria 

Last Answer : (A) Rwanda

Description : With the help of neat diagram, describe the procedure to carry out phasing out test on a 3 phase transformer. Also state the purpose of conducting this test on 3 phase transformer.

Last Answer : i) This test is carried out on 3-ph transformer to identify primary & secondary winding belonging to the same phase. ii) As shown in fig above all primary & secondary phases ... of this test is to check the respective phases of primary & secondary windings in 3-ph transformer

Description : Why phasing out and polarity test is carried out on three phase transformer?

Last Answer : The phasing out test is carried out to identify the windings (primary and secondary) of corresponding phase of the three phase transformer. The polarity test is carried out to identify the ... identical polarity of the primary and secondary windings of each phase of the three phase transformer.

Description : State what is the significance of conducting phasing out test on a 3-phase transformer? Explain its procedure with a suitable connection diagram.

Last Answer : -Short primary & secondary winding of other phases expect the one under test. -Connect voltmeter to secondary winding. -A small DC current is circulated through the primary winding through ... . -The test repeated for finding out remaining concerned secondary windings in the same manner.