Hello, could some engineer or expert in your field help me with the drawing. 1) How do I display rounded edges in a projection? Should I display them only by an imaginary line? 2) How do I dimension rounded edges? According to the textbook, I have to take the intended intersections and dimension them at the meeting point. 3) The body I received in the drawing has the same holes in the section. I can dimension holes, but there are a total of three. Two visible and one invisible - (it is not dimensioned in the section, is it?). How will they be listed? I have to dimension each or only one. And what about the third one? 4) In the lower part of the body, a part of the circle is "cut out" into the body. Can I roll her in a cut? When is half? Bottom view is not allowed. Can I turn the body 180 degrees? Input - http://goo.gl/YjyqPI (Page 15) Must have Adobe reader 9+ and saved on disk. If you would be willing, feel free to mark the kitten in painting and write, for example, RX, etc ... In the case, please send clippings to [email protected] I apologize for any grammatical errors . Thank you all for your help!     

1 Answer

Answer :

dimensioning deals with: dimensioning-on-mechanical-drawings-1-part.pdf dimensioning-on-mechanical-drawings-2-part.pdf dimensioning-on-mechanical-drawings-3-part.pdf workbook Technical drawing David Zeman.pdf DIMENSIONS ČSN 01 3130.pdf technicke-kresleni.wz.cz is not a problem for one-time help with homework, but without learning they will not gain the necessary knowledge.

Related questions

Description : Hello, I'm here again :-). After a short consultation with the teacher, I learned that the cut itself can be used as a front view. With new knowledge comes new questions.-). Freehand drawing: https:/ ... effort in the freehand ... If something is wrong, please inform me at [email protected]

Last Answer : They add that for those half-bodies I forgot to complete 2 dashes which indicate that the body is axially symmetric. written from the phone

Description : Hello, http://athena.zcu.cz/kurzy/tedo/000/HTML/57/test/index-06.htm / priklad kota 50 ../ I have trouble with one drawing. I have to anch the hole radius. The problem is that the size of the ... the line, indicated by thick or weak thickness. ? Thank you for your help ! Enjoy the rest of your day.

Last Answer : I quote from a technical drawing: Dimension lines They are parallel to the dimensioned dimension and are bounded by boundary arrows (outer, inner - we prefer inner) or a boundary line (the boundary ... lines. We place dimension lines and dimensions outside the image and draw them with a thin line.

Description : Why it is important to use a fixed common reference point for dimensioning of drawings and sketcher?

Last Answer : Need answer

Description : What is the difference between the conventional method of dimensioning and the baseline method of dimensiong?

Last Answer : What is the difference between the conventional method ofdimensioning and the baseline method of dimension