Description : According to the recommendations of Nagpur Conference, the width formation of an ideal National Highway in hard rock cutting, is (A) 8.9 m (B) 7.9 m (C) 6.9 m (D) 6.5 m
Last Answer : Answer: Option B
Description : The width of different roads as recommended in Nagpur plan by the Indian Road Conference for hilly region, is (A) Same for National Highways (B) Different for National Highways (C) Same for State Highways (D) Same for Major District roads
Description : The width of pavement in addition to a gravelled berm 1 m on either side for a two directional traffic recommended by Nagpur Conference of Chief Engineers, is (A) 4.7 m (B) 5.7 m (C) 6.7 m (D) 7.7 m
Last Answer : Answer: Option C
Description : An exceptional grade may be provided upto 1 in 12 along hill roads, if the length does not exceed (A) 45 m per km (B) 60 m per km (C) 75 m per km (D) 90 m per km
Description : The minimum width of a septic tank is taken (A) 70 cm (B) 75 cm (C) 80 cm (D) 90 c
Last Answer : (B) 75 cm
Description : If the number of lanes on the carriageway of a road is more than two, the total width of lane ways is equal to 3.0 m (A) + 0.60 m (B) + 0.70 m (C) + 0.90 m (D) + 1.50 m
Description : According to IRC : 52-1973, for a single lane National Highway in hilly region, (A) Width of the carriageway must be 3.75 m (B) Shoulders on either side must be 1.25 m (C) Total width of the road-way must be 6.25 m (D) Total of the above
Last Answer : Answer: Option D
Description : According to Indian Road Congress, the width of carriageway, is (A) 3.75 m for single lane (B) 7.0 m for two lanes without raised kerbs (C) 7.5 m for two lanes with raised kerbs (D) All the above
Description : The normal road land width for a major district road in open area, is (A) 45 m (B) 25 m (C) 15 m (D) 12 m
Description : The normal road width of National and State highways (A) Is kept 45 m (B) In plain and rolling terrain built-up area, is 30 m (C) In mountainous built-up area is 20 m (D) All the above
Description : The normal road land width for a National or State highway, in open areas should be (A) 45 m (B) 30 m (C) 24 m (D) 20 m
Last Answer : Answer: Option A
Description : The minimum road width is taken (A) 9 m (B) 12 m (C) 16 m (D) 20 m
Description : On the recommendations of Indian Road Congress, the ruling gradient in plains, is (A) 1 in 15 (B) 1 in 20 (C) 1 in 30 (D) 1 in 45
Description : According to National Building Code, the hydrants in water mains is provided at minimum interval of (A) 50 m (B) 60 m (C) 75 m (D) 90 m
Last Answer : Option C
Description : Maximum allowable spacing of shear reinforcement for inclined stirrups with an inclination of 45° is restricted to [ A ] 0.75 d [ B ] 0.45 d [ C ] 0.90 d [ D ] d
Last Answer : [ D ] d
Description : Maximum allowable spacing of shear reinforcement for vertical stirrups is restricted to [ A ] d [ B ] 0.45 d [ C ] 0.75 d [ D ] 0.90 d
Last Answer : [ C ] 0.75 d
Description : High strength of concrete requires a water cement ratio of [ A ] 0.10 to 0.15 [ B ] 0.25 to 0.30 [ C ] 0.45 to 0.60 [ D ] 0.75 to 0.90
Last Answer : [ B ] 0.25 to 0.30
Description : A sample of natural gas containing 80% methane (CH4 ) and rest nitrogen (N2 ) is burnt with 20% excess air. With 80% of the combustibles producing CO2 and the remainder going to CO, the Orsat analysis in volume percent is (A) CO2 : 6 ... 96, N2 :72.06 (D) CO2 : 7.60, CO : 1.90, O2 : 4.75, N2 : 85.74
Last Answer : (B) CO2 : 7.42, CO : 1.86, O2 : 4.64, N2 :86.02
Description : The minimum compressive strength of 1st class bricks should be (A) 75 kg/cm2 (B) 90 kg/cm2 (C) 100 kg/cm2 (D) 120 kg/cm2
Description : The minimum compressive strength of 2nd class bricks should be (A) 75 kg/cm2 (B) 90 kg/cm2 (C) 100 kg/cm2 (D) 120 kg/cm
Description : For efficient working of a sewer, it must be ensured that A. Minimum velocity of 0.45 m/sec, is maintained at its minimum flow B. A maximum velocity of 0.90 m/sec, is maintained at its maximum flow C. Both A. and B. D. Neither A. nor B.
Last Answer : ANS: C
Description : Area of steel required per metre width of pavement for a length of 20 m for design wheel load 6300 kg and permissible stress in steel 1400 kg/cm2 , is (A) 70 kg/sq cm (B) 80 kg/sq cm (C) 90 kg/sq cm (D) 100 kg/sq cm
Description : A singly reinforced concrete beam of 25 cm width and 70 cm effective depth is provided with 18.75 cm2 steel. If the modular ratio (m) is 15, the depth of the neutral axis, is (A) 20 cm (B) 25 cm (C) 30 cm (D) 35 cm
Description : For a 6.6 m wide two lane pavement, berms are provided on either side having a width of (A) 1.00 m (B) 1.25 m (C) 1.50 m (D) 1.75 m
Description : Normal formation width of a hill road for one-way traffic, is (A) 3.6 m (B) 4.8 m (C) 6.6 m (D) 7.2 m
Description : Road width 8.8 m of two lane National highways or State highways in mountainous terrain (A) Excludes the width of parapet (0.6 m) (B) Excludes the width of side drain (0.6 m) (C) Excludes the width of parapet and side drain (D) Includes the width of parapet and side drain
Description : An R.C.C beam of 25 cm width has a clear span of 5 metres and carries a U.D.L. of 2000 kg/m inclusive of its self weight. If the lever arm of the section is 45 cm., the beam is ( ... shear (B) Is safe with stirrups (C) Is safe with stirrups and inclined members (D) Needs revision of the section
Description : Minimum horsepower of pump required for filling 50m3 water tank, 20 metres high from ground in 30 minutes by lifting water from a well 5 metres below the ground level is a.5.45 KW b.7.5 KW c.6.81 KW d.Tapered bearing e.66.8 KW
Last Answer : c. 6.81 KW
Description : According to the recommendations of International Navigational Congress in 1912, the ratio of length to width at the entrance for passenger vessels is: (A) 7.25 to 1 (B) 7.80 to 1 (C) 8.11 to 1 (D) 8.44 to 1
Last Answer : (D) 8.44 to 1
Description : According to the recommendations of International Navigational Congress in 1912, the ratio of length to width at the entrance for cargo vessels is (A) 5.5 and 6.0 to 1 (B) 6.2 and 6.8 to 1 (C) 7.4 and 7.8 to 1 (D) 8.2 and 8.5 to 1
Last Answer : (C) 7.4 and 7.8 to 1
Description : If the rate of change of the super-elevation along a curved portion of a 7 metre wide road is 1 in 150 and the maximum super-elevation allowed is 1 in 15, the maximum length of the transition curve to be provided at either end, is (A) 65 m (B) 70 m (C) 75 m (D) 80 m
Description : If the radius of curvature of a hill road is 50 m, the percentage grade compensation should be (A) 60/R (B) 70/R (C) 75/R (D) 80/R
Description : Pick up the correct statement from the following: (A) The height of head light above road surface, is taken as 0.75 m (B) The beam of head light is up to one degree upwards from the grade of road (C) While designing the valley curve, the height of the object is assumed nil (D) All the above
Description : A district road with a bituminous pavement has a horizontal curve of 1000 m for a design speed of 75 km ph. The super-elevation is (A) 1 in 40 (B) 1 in 50 (C) 1 in 60 (D) 1 in 70
Description : In India, which one of the following should be considered the right combination of the age in days and live body weight in kg for a lamb for its weaning ? (A) 20 days to 30 days and 6 kg to 7 kg (B) 45 days to 60 ... (D) 75 days to 90 days and 12 kg to 15 kg (E) 55 days to 70 days and 9 kg to 11 kg
Last Answer : (C) 105 days to 120 days and 18 kg to 21 kg
Description : Sub soilders are operated at maximum depth of (a) 30-40 cm (b) 45-75 cm (c) 75-90 cm (d) 10-20 cm
Last Answer : (b) 45-75 cm
Description : Avinash, Bala and Chandran invested Rs.45,000/-, Rs. 70, 000/- and Rs. 90,000/- respectively to start a business. At the end of two years, they earned a profit of Rs.1,64,000/-. What will be Bala’s share in the profit? a) Rs.56, 000/- b) Rs.46, 000/- c) Rs. 50, 000/- d) Rs.75, 000/- e) None of these
Last Answer : Profit sharing ratio of Avinash,Bala & Chandran = 45000 : 70000 : 90,000 = 45 : 70 : 90 = 9 : 14 : 18 Bala's share of profit after two year =Rs.164000 × 14 × 41 = Rs. 4000 ×14 = Rs. 56000 Answer: a)
Description : Which one of the following statements regarding septic tanks is wrong? A. A gap of 7.5 cm between the bottom of the covering slab and the top level of scum is provided B. The outlet invert level is kept ... . The minimum width of septic level is 90 cm D. The depth of tank is kept equal to its width
Last Answer : ANS: D
Description : The minimum width of the pavement of a National Highway should be (A) 4.7 m (B) 5.7 m (C) 6.7 m (D) 7.7 m
Description : Pick up the correct statement from the following: (A) Minimum desirable width of medians on rural highways is 5 metres (B) Minimum width of medians should be 3 metres (C) On long bridges and viaducts, the width of medians should be 1.5 m (D) All the above
Description : Minimum width of ship clearance shall be (A) B or 30 m (B) 1.5 B or 50 m (C) 1.5 B (D) 50 m
Last Answer : (A) B or 30 m
Description : The porosity of a soil sample having its void ratio equal unity would be (a) 33.33% (b) 50.0% (c) 66.66% (d) 75.0%
Last Answer : (b) 50.0%
Description : Any hotel recommendations in NYC near Greenwich Village?
Last Answer : …study the maps… take your pick !
Description : he minimum compressive strength of first class brick should be a) 75 kg per centimeter square b) 90 kg per centimeter square c) 100 kg per centimeter square* d) 120 kg per centimeter square
Last Answer : c) 100 kg per centimeter square*
Description : A masonry dam (density = 20,000 N/m3 ) 6 m high, one metre wide at the top and 4 m wide at the base, has vertical water face. The minimum stress at the base of the dam when the reservoir is full, will be (A) 75 N/m2 (B) 750 N/m2 (C) 7500 N/m2 (D) 75000 N/m
Last Answer : (C) 7500 N/m
Description : For a continuous slab of 3 m × 3.5 m size, the minimum overall depth of slab to satisfy vertical deflection limits is (A) 50 mm (B) 75 mm (C) 100 mm (D) 120 mm
Last Answer : (B) 75 mm
Description : For a continuous slab of 3 m x 35 m size, the minimum overall depth of slab to satisfy vertical deflection limits is (a) 120 mm (b) 100 mm (c) 75 mm (d) 50 mm
Last Answer : (a) 120 mm
Description : Minimum stopping distance for moving vehicles on road with a design speed of 80 km/hour, is (A) 80 m (B) 100 m (C) 120 m (D) 150 m
Description : The minimum vertical clearance of overhanging cliffs or any other structure above the surface of a hill road, should be (A) 3 m (B) 4 m (C) 5 m (D) 6 m
Description : Find the angle at which the torque is minimum. a) 30 b) 45 c) 60 d) 90
Last Answer : d) 90