Description : What is the total resistance of the circuit shown in figure 3- 60?
Last Answer : 25Ω
Description : What is the total resistance of the circuit shown in figure 3- 59? (Hint: Redraw the circuit to simplify and then use equivalent resistances to compute for RT.)
Last Answer : 4Ω
Description : In a circuit such as that shown in figure 3-16, if R1 has a value of 50 ohms and R2 has a value of 250 ohms and the input signal has a value of +10 millivolts, what is the value of the output signal?
Last Answer : 60 millivolts.
Description : In a circuit such as that shown in figure 3-15, if R1 has a value of 100 ohms and R2 has a value of 1 kilohm and the input signal is at a value of + 5 millivolts, what is the value of the output signal?
Last Answer : 50 millivolts.
Description : How is amplification achieved in the circuit shown in figure 2-43?
Last Answer : By varying the amount of capacitance in the circuit
Description : What is the name given to the "picture" of a circuit such as the one shown in figure 3-2?
Last Answer : A schematic diagram.
Description : . If the power distribution system shown in figure 2-22 uses selective tripping, what is the time delay rating for each of the circuit breakers shown?
Last Answer : CB1-long time delay; CB2, CB3-short time delay; CB4 through
Description : The emf of a cell E is 15 V as shown in the figure with an internal resistance of `0.5Omega`. Then the value of the current drawn from the cell is
Last Answer : The emf of a cell E is 15 V as shown in the figure with an internal resistance of `0.5Omega`. Then the value of ... A. `3A` B. `2A` C. `5A` D. `1A`
Description : A series circuit consisting of three resistors has a current of 3 amps. If R1 = 20 ohms, R2= 60 ohms, and R 3 = 80 ohms, what is the (a) total resistance and (b) source voltage of the circuit?
Last Answer : (a) 160 ohms. (b) 480 ohms
Description : For the circuit shown in figure given below, the equivalent resistance points A and B is
Last Answer : For the circuit shown in figure given below, the equivalent resistance points A and B is A. `10Omega` B. `5 Omega` C. `(10)/(3)Omega` D. `2Omega`
Description : In the circuit diagram shown in figure, potential difference across `3Omega` resistance is 20 V. Then, match the following two columns.
Last Answer : In the circuit diagram shown in figure, potential difference across `3Omega` resistance is 20 V. Then, match the following two columns.
Description : Assertion : In the circuit shown in figure, battery is ideal. If a resistance `R_(0)` is cannected in parallel with R, then power across R will increa
Last Answer : Assertion : In the circuit shown in figure, battery is ideal. If a resistance `R_(0)` is cannected ... . D. If Assertion is false but Reason is true.
Description : In the circuit shown in figure, the resistance R has a value that depends on the current. Specifically R is 20 `Omega` when `i` is zero and the amount
Last Answer : In the circuit shown in figure, the resistance R has a value that depends on the current. Specifically R is 20 `Omega` ... A B. `10A` C. 20 A D. `5A`
Description : The potential difference in volt across the resistance `R_(3)` in the circuit shown in figure, is `(R_(1)=15Omega,R_(2)=15Omega, R_(3)=30Omega, R_(4)=
Last Answer : The potential difference in volt across the resistance `R_(3)` in the circuit shown in figure, is `(R_(1)=15Omega,R_(2 ... 5 B. `7.5` C. 15 D. `12.5`
Description : In the circuit shown in figure switch S is closed at time t=0 At what time current through `3Omega` resistance and 1H inductor are equal?
Last Answer : In the circuit shown in figure switch S is closed at time t=0 At what time current through `3Omega` resistance and ... 5)/(3))` D. `Insqrt((8)/(3))`
Description : In the circuit shown in figure switch S is closed at time t=0 Potential difference across `3Omega` resistance at time t is given by
Last Answer : In the circuit shown in figure switch S is closed at time t=0 Potential difference across `3Omega` resistance at time t ... 2t)` D. `18(1-e^(-t//9))`
Description : Resistance between points A and B in the circuit shown in figure is a. 4 ohm b. 6ohm c. 10 ohm d. 8 ohm
Last Answer : c. 10 ohm
Description : In the circuit shown in Fig. 4.64, the battery has an emf of 12.0 V and an internal resistance of `5R//11`. If the ammeter reads 2.0 A, what is the va
Last Answer : In the circuit shown in Fig. 4.64, the battery has an emf of 12.0 V and an internal resistance of ` ... ammeter reads 2.0 A, what is the value of R ?
Description : Find the equivalent resistance of the circuit shown in Fig.4.60 between the points A and B. Each resistor has a resistance r.
Last Answer : Find the equivalent resistance of the circuit shown in Fig.4.60 between the points A and B. Each resistor has a resistance r.
Description : What would be the total power consumed in the circuit shown in the illustration if the source is 30 volts the resistance for R1 is 10 ohms, R2 is 10 ohms, and R3 is 10 ohms? EL-0032 A. 10 watts B. 40 watts C. 45 watts D. 60 watts
Last Answer : Answer: D
Description : What is the effect on total resistance and total current in a circuit if a short occurs in (a) a parallel branch, and (b) in a series portion?
Last Answer : (a) Total resistance decreases, total current increases (b) Total resistance decreases, total current increases
Description : What is the effect on total resistance and total current in a circuit if an open occurs in (a) a parallel branch, and (b) in a series portion?
Last Answer : (a) Total resistance increases, total current decreases (b) Total resistance becomes infinite, total current is equal to zero
Description : System shown in figure is released from rest . Pulley and spring is mass less and friction is absent everywhere. The speed of `5 kg` block when `2 kg`
Last Answer : System shown in figure is released from rest . Pulley and spring is mass less and friction is absent everywhere. The ... . 2 m/s D. `4sqrt(2) ` m/s
Description : If the fuse shown on the schematic (figure 3-10) opens, what lights will operate?
Last Answer : Only the brake lights.
Description : In the power amplifier shown in figure 2-10, what two signals are mixed to produce the output signal?
Last Answer : Local oscillator and coherent oscillator.
Description : A tape pack has gaps in the tape winding as shown in figure 2-5. What causes this condition?
Last Answer : Tape is loosely wound on reel.
Description : A tape pack is buckled and deformed as shown in figure 2- 4. What are three possible causes for this condition?
Last Answer : a. Reel has a distorted hub, b. tape wound over small particle deposited on hub, and c. tape wound on reel with tension increasing toward end of winding.
Description : A triode amplifier similar to the one shown in figure 1-19 has an Ebb -conditions, 1.5 milliamperes of current conducts through the tube. What w
Last Answer : +275 volts
Description : What happens to the path for current when S1 is open as shown in figure 3-2(A)?
Last Answer : The path for current is incomplete; or, there is no path for current with S1 open.
Description : Which connector should you use to connect the (a) power source and (b) load to the fuseholder shown in figure 2-12(A)?
Last Answer : a. Center connector b. Outside connector
Description : What type of frequency meter is shown and what is the value indicated for each meter in figure 1-52?
Last Answer : A) Vibrating-reed, 60Hz. (B) Moving-disk, 58 Hz.
Description : What type of meter is shown and what is the value of the quantity being measured for each meter in figure 1-51?
Last Answer : (A) Megger (megohmmeter), infinity; (B) Wattmeter, 9.5 kilowatts (9,500 watts). (C) Watt-hour meter, 2.693 megawatt-hours 2,693 kilowatt-hours) (2,693,000 watt-hours).
Description : What meter reading is shown on each multimeter in each part of figure 1-50?
Last Answer : (A) 410 mA dc; (B) 3.9 mA ac; (C) -22 V dc; (D) 600 V ac; (E) 1.4 V ac; (F) 1.9 kohms
Description : What is the quantity shown on the watt-hour meter in figure 1-46?
Last Answer : 5.945 megawatt-hours, or 5,945 kilowatt-hours, or 5,945, 000 watt-hours.
Description : If coils 'R1-R2-R3' at the receiver of figure 'B' shown in the illustration turned opposite of those in the transmitter by design, what corrective action should be taken? EL-0092 A. Reverse the 60 Hz supply ... is needed. C. Interchange leads 'R1' and 'R3'. D. Interchange leads 'R2' and 'R3'.
Last Answer : Answer: B
Description : If coils 'R1-R2-R3' at the receiver of figure 'B' shown in the illustration were in 180 degree error with those of the transmitter, what corrective action should be taken? EL-0092 A. Reverse the 60 Hz ... is proper operation. C. Interchange leads 'R1' and 'R3'. D. Interchange leads 'R2' and 'R3'.
Last Answer : Answer: A
Description : If coil 'R1-R2' at the receiver of figure 'A' shown in the illustration were in 180 degree error with respect to that of the transmitter, what corrective action should be taken? EL-0092 A. No action is ... and 'R2'. C. Interchange connections 'S1' and 'S2'. D. Interchange connections 'S1' and 'S3'.
Description : If coils 'R1-R2-R3' at the receiver of figure 'B' shown in the illustration turned opposite of those in the transmitter, what corrective action should be taken to have both turn in the same direction? EL-0092 A ... is needed. C. Interchange leads 'R1' and 'R3'. D. Interchange leads 'R2' and 'R3'.
Last Answer : Answer: C
Description : If coil 'R1-R2' at the receiver of figure 'A' shown in the illustration turned opposite of that in the transmitter, what corrective action should be taken? EL-0092 A. No action is necessary as this is ... . C. Interchange connections to 'S1' and 'S2'. D. Interchange connections to 'S1' and 'S3'.
Description : Using the graph in figure 3-8, what is the approximate value of current when the resistance is 3 ohms?
Last Answer : 4 amperes.
Description : What type of circuit is figure 3-27?
Last Answer : A scaling amplifier.
Description : The head driver circuit of a tape recorder’s FM record electronics (figure 5-4) performs what function?
Last Answer : It amplifies the frequency-modulated output from the record oscillator and sends it to the record head.
Description : The equalization and phase correction circuit in a tape recorder’s direct reproduce electronics (figure 5-2) performs what function?
Last Answer : It generates an equalization signal which corrects any frequency response problems in the input signal from the pre-amplifier circuit.
Description : The head driver circuit in a tape recorder’s direct record electronics component (figure 5-1) performs what function?
Last Answer : It takes the signal from the summing network, amplifies it, and sends it to the record head for recording.
Description : Refer to figure 3-55(A). If the following resistors were replaced with the values indicated: R1 = 900Ω, R3 = 1kΩ, what is the total power in the circuit? What is ER2?
Last Answer : PT = 60 W, ER2 = 10 V.
Description : Six resistance each of value `r=5 Omega` are connected between points A, B and C as shown in figure. If `R_(1), R_(2)` and `R_(3)` are the net resista
Last Answer : Six resistance each of value `r=5 Omega` are connected between points A, B and C as shown in figure. If `R_(1), R_(2) ... 1:2:3` C. `5:4:3` D. `4:3:2`
Description : The equivalent resistance resistance between A and B of network shown in figure is
Last Answer : The equivalent resistance resistance between A and B of network shown in figure is A. `(3R)/(4)` B. `(4R)/(3)` C. 6 R D. 2 R
Description : Six resistance are connected as shown in figure. If total current flowing is `0.5A`, then the potrential difference `V_(A)-V_(B)` is
Last Answer : Six resistance are connected as shown in figure. If total current flowing is `0.5A`, then the potrential difference `V_(A) ... V B. 6 V C. 2 V D. 4 V
Description : Each resistor shown in the figure has a resistance of `10 Omega` and the battery has the emf 6 V. What will be the current supplied by the battery ?
Last Answer : Each resistor shown in the figure has a resistance of `10 Omega` and the battery has the emf 6 V. What will be the ... 2 A` C. `1.8 A` D. `0.3 A`
Description : Assertion : Two resistance wires shown in figure are of same material. They have equal length. More heat is generated in wire A. Reason : In series `H
Last Answer : Assertion : Two resistance wires shown in figure are of same material. They have equal length. More ... . If Assertion is false but Reason is true.