Description : A tape pack has gaps in the tape winding as shown in figure 2-5. What causes this condition?
Last Answer : Tape is loosely wound on reel.
Description : . After rewinding a tape onto its supply reel, you examine the tape pack and notice pile-ups of tape resembling the example in figure 2-2. What causes this condition?
Last Answer : The tape is stopped too quickly when winding or rewinding.
Description : Tape winding errors can cause a deformed tape pack. What are four common types of tape pack deformation?
Last Answer : Cinching, pack slip, spoking, and windowing.
Description : You notice steps in the tape pack such as those in figure 2-3. What causes this and how does it damage the magnetic tape?
Last Answer : Pack slip. It's caused by loosely wound tape on a reel that is exposed to excessive vibration or heat. The vibration or heat causes the tape to shift, causing steps in the tape pack. The uneven tape will then rub against the reel's sides and the recorder's tape guides.
Description : Figure 'D' shown in the illustration represents a/an ____________. EL-0078 A. DIP IC chip B. integrated diac/triac envelope C. TO-5 flat pack D. 7-segment BCD display
Last Answer : Answer: A
Description : The head driver circuit of a tape recorder’s FM record electronics (figure 5-4) performs what function?
Last Answer : It amplifies the frequency-modulated output from the record oscillator and sends it to the record head.
Description : The equalization and phase correction circuit in a tape recorder’s direct reproduce electronics (figure 5-2) performs what function?
Last Answer : It generates an equalization signal which corrects any frequency response problems in the input signal from the pre-amplifier circuit.
Description : The head driver circuit in a tape recorder’s direct record electronics component (figure 5-1) performs what function?
Last Answer : It takes the signal from the summing network, amplifies it, and sends it to the record head for recording.
Description : An 8-year-old child presented with brownish discoloured and deformed anterior teeth. History of having received an antibiotic about 4 years earlier was obtained. Which antibiotic could be responsible for the condition ? (a) Chloramphenicol (b) Tetracycline (c) Erythromycin (d) Genetamicin
Last Answer : Ans: B
Description : An 8-year-old child presented with brownish discoloured and deformed anterior teeth. History of having received an antibiotic about 4 years earlier was obtained. Which antibiotic could be responsible for the condition: A. Chloramphenicol B. Tetracycline C. Erythromycin D. Gentamicin
Last Answer : Tetracycline
Description : What causes flutter in a tape recorder’s output?
Last Answer : Non-uniform tape motion caused by variations in tape speed.
Description : What are four main causes of tape failure?
Last Answer : Normal wear, accidental damage, environmental damage, and winding errors.
Description : What type of tape error causes noise to appear on the tape when no signal should appear? What causes this type of tape error?
Last Answer : Noise error is usually caused by a cut or a scratch on the magnetic tape.
Description : In a circuit such as that shown in figure 3-16, if R1 has a value of 50 ohms and R2 has a value of 250 ohms and the input signal has a value of +10 millivolts, what is the value of the output signal?
Last Answer : 60 millivolts.
Description : In a circuit such as that shown in figure 3-15, if R1 has a value of 100 ohms and R2 has a value of 1 kilohm and the input signal is at a value of + 5 millivolts, what is the value of the output signal?
Last Answer : 50 millivolts.
Description : If the fuse shown on the schematic (figure 3-10) opens, what lights will operate?
Last Answer : Only the brake lights.
Description : In the power amplifier shown in figure 2-10, what two signals are mixed to produce the output signal?
Last Answer : Local oscillator and coherent oscillator.
Description : How is amplification achieved in the circuit shown in figure 2-43?
Last Answer : By varying the amount of capacitance in the circuit
Description : A triode amplifier similar to the one shown in figure 1-19 has an Ebb -conditions, 1.5 milliamperes of current conducts through the tube. What w
Last Answer : +275 volts
Description : What effect does the internal resistance have on the rest of the circuit shown in figure 3-60?
Last Answer : Because of the 2-volt drop across the internal resistance, only 48 volts is available for the rest of the circuit.
Description : What is the total resistance of the circuit shown in figure 3- 60?
Last Answer : 25Ω
Description : What is the total resistance of the circuit shown in figure 3- 59? (Hint: Redraw the circuit to simplify and then use equivalent resistances to compute for RT.)
Last Answer : 4Ω
Description : What is the name given to the "picture" of a circuit such as the one shown in figure 3-2?
Last Answer : A schematic diagram.
Description : What happens to the path for current when S1 is open as shown in figure 3-2(A)?
Last Answer : The path for current is incomplete; or, there is no path for current with S1 open.
Description : . If the power distribution system shown in figure 2-22 uses selective tripping, what is the time delay rating for each of the circuit breakers shown?
Last Answer : CB1-long time delay; CB2, CB3-short time delay; CB4 through
Description : Which connector should you use to connect the (a) power source and (b) load to the fuseholder shown in figure 2-12(A)?
Last Answer : a. Center connector b. Outside connector
Description : What type of frequency meter is shown and what is the value indicated for each meter in figure 1-52?
Last Answer : A) Vibrating-reed, 60Hz. (B) Moving-disk, 58 Hz.
Description : What type of meter is shown and what is the value of the quantity being measured for each meter in figure 1-51?
Last Answer : (A) Megger (megohmmeter), infinity; (B) Wattmeter, 9.5 kilowatts (9,500 watts). (C) Watt-hour meter, 2.693 megawatt-hours 2,693 kilowatt-hours) (2,693,000 watt-hours).
Description : What meter reading is shown on each multimeter in each part of figure 1-50?
Last Answer : (A) 410 mA dc; (B) 3.9 mA ac; (C) -22 V dc; (D) 600 V ac; (E) 1.4 V ac; (F) 1.9 kohms
Description : What is the quantity shown on the watt-hour meter in figure 1-46?
Last Answer : 5.945 megawatt-hours, or 5,945 kilowatt-hours, or 5,945, 000 watt-hours.
Description : When computers use the cylinder method to store data on a hard disk pack, what three items make up the address that tells the computer where on a specific disk to store the data?
Last Answer : . a. Cylinder number. b. Recording surface number.
Description : A mass of 1 kg is attached to two identical springs each with stiffness k = 20 kN/m as shown in the figure. Under frictionless condition, the natural frequency of the system in Hz is close to * 1 point (A) 32 (B) 23 (C) 16 (D) 11
Last Answer : (A) 32
Description : what causes tomatoes & squash to grow deformed
Last Answer : Need Answer
Description : what causes stunted wrinkled deformed leaves on virginia creeper vine
Description : What causes fruit on pear tree to deformed.
Description : What are the three most commonly used tape reeling systems?
Last Answer : a. Take-up control. b. Two-motor reeling. c. Tape buffering.
Description : Technical manuals for tape recorders can state the SNR in what three different ways?
Last Answer : a. Root-mean-square (RMS) signal-to-RMS noise. b. Peak-to-peak signal-to-RMS noise. c. Peak signal-to-RMS noise.
Description : Magnetic tape recorders can have up to three different heads installed. What are the three functions performed by a recorder's heads?
Last Answer : Record, reproduce, and erase.
Description : If magnetic tape is stored in areas with temperature and humidity extremes, what are three types of tape damage that may occur?
Last Answer : Oxide shedding, layer-to-layer sticking, and tape deformation.
Description : Magnetic tape is made of what three basic materials?
Last Answer : a. Base material. b. Coating of magnetic oxide particles. c. Glue that bonds the particles to the base.
Description : Digital magnetic tape recorders used to store and retrieve digital data fall into what three categories?
Last Answer : a. Computer-compatible digital tape recorders. b. Telemetry digital tape recorders. c. Instrumentation digital tape recorders
Description : What three formats are used for digital magnetic tape recording?
Last Answer : 1) Serial, (2) parallel, and (3) serial-parallel.
Description : In digital magnetic tape recording, the series of recorded digital pulses can represent what three types of data?
Last Answer : a. Data used by digital computers. b. Pulsed squarewave signals. c. Digitized analog waveforms.
Description : What causes the specified condition to shift position?
Last Answer : The input, or clock pulse.
Description : Modes of a light pulse that enter the fiber at one time exit the fiber at different times. This condition causes the light pulse to spread. What is this condition called?
Last Answer : Modal dispersion.
Description : What condition causes a light ray to be totally reflected back into its medium of propagation?
Last Answer : Total internal reflection occurs when the angle of refraction approaches 90 degrees. This condition occurs when the angle of incidence increases to the point where no refraction is possible.
Description : How is a flat pack removed from a pcb?
Last Answer : Heat each lead and lift with tweezers.
Description : DIP and flat-pack pins are numbered consecutively in what direction?
Last Answer : Reference mark.
Last Answer : Counterclockwise.
Description : On DIP and flat-pack ICs viewed from the top, pin 1 is located on which side of the reference mark?
Last Answer : Left.